Superconducting nanowire single photon detectors (SNSPDs) are a rapidly maturing detector technology that offer superior performance relative to competing infrared photon counting technologies. The original experimental work presented here explores three novel methods of improving and analysing detector characteristics, employing low-temperature piezoelectric motors at temperatures below 4 K in a closed-cycle cryostat. Utilizing the low-temperature piezoelectric nanopositioners in tandem with a miniature confocal microscope, this work specifically shows a spatially-separable parallel-wire SNSPD demonstrating one- and two-pixel photon discrimination, with the detector responding more quickly when triggering two pixels. The work demonstrates nanoantenna-coupled SNSPDs, which are simulated, designed, and tested using the same nano-optical setup. In these an increased local absorption into the nanowire is seen at the antennas' resonant wavelengths, enhancing the efficiency of the detector by up to 130 %. Finally, a modified optical setup using a distributed Bragg reflector fibre in place of the microscope to form a tunable cavity around two configurations of SNSPD is demonstrated, improving absorption of the incident light into the nanowire across the whole active area. For these, enhancement in the system detection efficiency of up to 40 % is seen.
Superconducting nanowire single photon detectors (SNSPDs) are a rapidly maturing detector technology that offer superior performance relative to competing infrared photon counting technologies. The original experimental work presented here explores three novel methods of improving and analysing detector characteristics, employing low-temperature piezoelectric motors at temperatures below 4 K in a closed-cycle cryostat. Utilizing the low-temperature piezoelectric nanopositioners in tandem with a miniature confocal microscope, this work specifically shows a spatially-separable parallel-wire SNSPD demonstrating one- and two-pixel photon discrimination, with the detector responding more quickly when triggering two pixels. The work demonstrates nanoantenna-coupled SNSPDs, which are simulated, designed, and tested using the same nano-optical setup. In these an increased local absorption into the nanowire is seen at the antennas' resonant wavelengths, enhancing the efficiency of the detector by up to 130 %. Finally, a modified optical setup using a distributed Bragg reflector fibre in place of the microscope to form a tunable cavity around two configurations of SNSPD is demonstrated, improving absorption of the incident light into the nanowire across the whole active area. For these, enhancement in the system detection efficiency of up to 40 % is seen.
Single photon detection advanced rapidly in the last decade. The superconducting nanowire single-photon detector (SNSPD) is an emerging technology, which offers low dark count rates, broadband sensitivity from visible to mid-infrared wavelengths and very high quantum efficiency. All these features are appealing for future emerging applications in remote gas sensing, quantum key distribution and quantum information processing. By enclosing the detector in an optical cavity, tuned to the operating wavelength, the total system detection of the SNSPD is improved. Based on the cavity design, the detector absorption is boosted at the desired experimental wavelength. Devices have been fabricated and tested, in this thesis, with enhanced detection efficiency at near-infrared, infrared and mid-infrared wavelengths. NbTiN detectors fabricated on Ta2O5 / SiO2 distributed Bragg reflectors (DBR) for front-side coupling exhibit a system detection efficiency of ≈ 90% at λ = 940 nm for the best device measured. SNSPDs were also fabricated in NbTiN on metallic mirrors for back-side coupling for 1550 and 2333 nm experimental wavelengths. The first design exhibited a system detection efficiency of ≈ 84.5%, at λ = 1550 nm for the best device measured. The second exhibited low system detection efficiency since the device suffered from unexpectedly high dark count rate mainly due to blackbody radiation at 2.2 K. However, it was possible to measure the timing jitter of this device at 350 mK indicating a FWHM of 84 ps. Another technique to improve the total system detection efficiency of the SNSPD, is by fabricating a hairpin-shaped nanowire atop a single mode waveguide. In this design, photons travel through the waveguide and via evanescent coupling are absorbed in the nanowire. These SNSPD devices have been designed to thread along single mode Si ridge waveguides using a hairpin-shaped nanowire structure, which offers enhanced coupling and absorption efficiency via evanescent coupling. These ultra-thin superconducting MoSi detectors are precisely patterned on top of a single mode Si waveguide (600 nm) with alignment error less than 40 nm. Low temperature electrical and nano-optical characterization was carried out using a two-stage pulse tube (PT) coldhead, using an additional 4He / 3He sorption pump, low vibration characterization of SNSPD devices at 350 mK was carried out. Characterised devices exhibit low dark count rate <5 counts per second and timing jitter of ≈ 83 ps full width half maximum (FWHM) at wavelength (λ) = 1550 nm and at critical current ≈ 30 µA.
Single-photon detectors based on superconducting nanowires (SSPDs or SNSPDs) have rapidly emerged as a highly promising photon-counting technology for infrared wavelengths. These devices offer high efficiency, low dark counts and excellent timing resolution. In this review, we consider the basic SNSPD operating principle and models of device behaviour. We give an overview of the evolution of SNSPD device design and the improvements in performance which have been achieved. We also evaluate device limitations and noise mechanisms. We survey practical refrigeration technologies and optical coupling schemes for SNSPDs. Finally we summarize promising application areas, ranging from quantum cryptography to remote sensing. Our goal is to capture a detailed snapshot of an emerging superconducting detector technology on the threshold of maturity.
Superconducting nanowire single photon detectors (SNSPDs) are a highly promising emerging photon counting technology, offering infrared sensitivity combined with low dark count rates and sub-100 ps timing jitter [1]. These devices are under consideration for a wide variety of photon counting applications, from quantum cryptography to remote sensing. Next generation device designs based on optical cavities, ultra narrow wires, parallel wire arrays and nano-antenna enhanced devices are being evaluated to meet the demands of advanced photon counting applications.
Superconducting nanowire single-photon detectors (SNSPDs) are the leading technology for low noise, high efficiency infrared single-photon detection. The basic SNSPD consists of a nanowire patterned in an ultrathin superconducting thin film, which is cooled below its critical temperature and biased close to its critical current. The absorption of a single-photon creates a resistive region, triggering a fast output voltage pulse which can be readily amplified and registered. The excellent performance of SNSPDs at near-infrared and telecommunications wavelengths has led to their adoption in important applications such as quantum secure communications, single-photon spectroscopy and single-photon LIDAR. A clear challenge for the SNSPD community is to extend the spectral range of SNSPDs into the mid infrared, and to improve material uniformity to enable the realization of large area arrays for multimode or free space coupling. The aim of this work is to evaluate potential materials for next generation mid-infrared SNSPD arrays. In this work, thin films of polycrystalline NbN and amorphous MoSi have been optimized to test the uniformity of a multipixel array configuration composed of 8 nanowire meander structures covering 10 um x 10 um area, 100 nm width and 50% filling factor. The 8-pixels SNSPD arrays have been patterned on 8 nm thickness NbN grown on high resistivity silicon (HR Si) substrate at room temperature and at 800 °C exhibiting respectively 4.4 K and 7.3 K as mean critical temperature across the pixels. The 8- pixels SNSPD array patterned on 8 nm thickness MoSi cooling the HR Si substrate to -180 °C has exhibited a mean critical temperature of 3.2 K across the pixels. Optical properties have been measured by an attenuated 1550 nm laser diode source delivered by single mode optical fibre at a controlled distance from the chip in order to broadly illuminate the array. The optical properties have been studied only for the 8 nm thickness NbN SNSPD array grown at room temperature has demonstrated uniform optical properties across pixels exhibiting similar saturation of the internal efficiency over a large bias, similar dark count rate and similar timing jitter (about 137 ps) across pixels. In the single photon regime at 1550 nm, pixels 4 and 6 of the 8 nm thickness NbN SNSPD array exhibit 28.4% and 4.7% pixel detection efficiency as measured at the bias current 95% of their respective critical current at 2.2 K.
Superconducting Nanowire Single-Photon Detectors (SNSPDs) are the premier single-photon counting technology in the near-infrared regime. Operating via a photon-induced phase transition from the superconducting to the normal state, SNSPDs act as highly sensitive digital detectors that now play a critical role in quantum communication, deep-space optical communications, and direct dark matter detection. As the demand for these detectors scales, there is a pressing need to extend their performance capabilities toward longer wavelengths, larger active areas, and higher operating temperatures. However, advancing these metrics requires navigating complex physical trade-offs inherent to the detection mechanism. This thesis explores the material optimizations, novel detector architectures, and fundamental device physics required to push SNSPD technology beyond its current limits. The first thrust of this work focuses on extending SNSPD sensitivity into the mid-infrared (MIR) and far-infrared regimes. By developing a low-Tc (sub-1 K) WSi film engineered to reduce the characteristic detection energy, the threshold for long-wavelength detection is significantly lowered. Coupled with a novel detector architecture utilizing impedance-matching tapers and superconducting nanowire avalanche photon detectors (SNAPs), sensitivity is initially demonstrated at wavelengths up to 29um using a blackbody thermal source. Expanding beyond this limit, the implementation of quantum cascade lasers enables the demonstration of single-photon counting at wavelengths up to 88um, marking a major improvement over the current state of the art. To address the practical MIR detection challenges of low signal-to-noise ratio and restricted fill factors, this work also demonstrates a 1 mm x 1mm array of superconducting microwire single-photon detectors (SMSPDs) sensitive out to 3.7um, establishing a pathway for future antenna-coupled detectors. The second thrust investigates the development of micrometer-scale wires to simultaneously increase active area and operating temperature. Moving to microwire geometries raises fundamental questions regarding intrinsic detection mechanisms. Using a scanning lens setup, this work demonstrates the first direct observation of transverse coordinate effects in microwires, where the precise location of photon incidence across the wire width significantly alters the detector's slew rate and timing performance. To counteract this, new rectification schemes are introduced to produce a more uniform detection landscape. Specifically, the integration of a superconducting rail alongside the main detector is shown to successfully mitigate the transverse coordinate effect, improve timing performance, and increase the viable operating temperature of the detector. The third thrust explores the use of unconventional superconductors, namely MgB2 to achieve an appreciably higher-temperature single-photon detection pathway. This section details the distinct challenges associated with the growth and fabrication of detectors using air-sensitive materials and evaluates their long-term viability for the SNSPD platform. Ultimately, this thesis highlights the critical material and architectural parameters required to advance the field of single-photon detection. By elucidating the metrics and mechanisms that govern ideal detector performance, this work aims to broaden the understanding and future application of SNSPDs across diverse scientific disciplines. All the data presented here is my own unless otherwise mentioned.
Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.