Measurements of Quasiparticle Tunneling Dynamics in a Band-Gap-Engineered Transmon Qubit
Luyan Sun, L. DiCarlo, M. D. Reed, Gianluigi Catelani, Lev S. Bishop, David Schuster, Blake Johnson, Ge Yang, Luigi Frunzio, L. I. Glazman, Michel Devoret, Robert J. Schoelkopf
We have engineered the band gap profile of transmon qubits by combining oxygen-doped Al for tunnel junction electrodes and clean Al as quasiparticle traps to investigate energy relaxation due to quasiparticle tunneling. The relaxation time T1 of the qubits is shown to be insensitive to this band gap engineering. Operating at relatively low-E(J)/E(C) makes the transmon transition frequency distinctly dependent on the charge parity, allowing us to detect the quasiparticles tunneling across the qubit junction. Quasiparticle kinetics have been studied by monitoring the frequency switching due to even-odd parity change in real time. It shows the switching time is faster than 10 μs, indicating quasiparticle-induced relaxation has to be reduced to achieve T1 much longer than 100 μs.
We have engineered the band gap profile of transmon qubits by combining oxygen-doped Al for tunnel junction electrodes and clean Al as quasiparticle traps to investigate energy relaxation due to quasiparticle tunneling. The relaxation time T1 of the qubits is shown to be insensitive to this band gap engineering. Operating at relatively low-E(J)/E(C) makes the transmon transition frequency distinctly dependent on the charge parity, allowing us to detect the quasiparticles tunneling across the qubit junction. Quasiparticle kinetics have been studied by monitoring the frequency switching due to even-odd parity change in real time. It shows the switching time is faster than 10 μs, indicating quasiparticle-induced relaxation has to be reduced to achieve T1 much longer than 100 μs.
The performance of various superconducting devices operating at ultra-low temperatures is impaired by the presence of non-equilibrium quasiparticles. Inelastic quasiparticle (QP) tunneling across Josephson junctions in superconducting qubits results in decoherence and spurious excitations and, notably, can trigger correlated errors that severely impede quantum error correction. In this work, we use "gap engineering" to suppress the tunneling of low-energy quasiparticles in Al-based transmon qubits, a leading building block for superconducting quantum processors. By implementing potential barriers for QP, we strongly suppress QP tunneling across the junction and preserve charge parity for over 103 seconds. The suppression of QP tunneling also results in a reduction in the qubit energy relaxation rates. The demonstrated approach to gap engineering can be easily implemented in all Al-based circuits with Josephson junctions.
The tunnelling of quasiparticles across Josephson junctions in superconducting quantum circuits is an intrinsic decoherence mechanism for qubit degrees of freedom. Understanding the limits imposed by quasiparticle tunnelling on qubit relaxation and dephasing is of theoretical and experimental interest, particularly as improved understanding of extrinsic mechanisms has allowed crossing the 100 microsecond mark in transmon-type charge qubits. Here, by integrating recent developments in high-fidelity qubit readout and feedback control in circuit quantum electrodynamics, we transform a state-of-the-art transmon into its own real-time charge-parity detector. We directly measure the tunnelling of quasiparticles across the single junction and isolate the contribution of this tunnelling to qubit relaxation and dephasing, without reliance on theory. The millisecond timescales measured demonstrate that quasiparticle tunnelling does not presently bottleneck transmon qubit coherence, leaving room for yet another order of magnitude increase. Superconducting circuits are promising for quantum computing, but quasiparticle tunnelling across Josephson junctions introduces qubit decoherence. Ristè et al. convert a transmon qubit into its own real-time quasiparticle tunnelling detector and accurately measure induced decoherence in the millisecond range.
Quasiparticles are a prominent decoherence source in superconducting qubits, but their effects are notoriously difficult to isolate in fluxonium. Unlike the transmon, fluxonium is insensitive to offset charge, precluding charge-parity detection of quasiparticle tunneling. We address this challenge by measuring the excitation and de-excitation rates in a fluxonium qubit under controlled on-chip quasiparticle injection and isolating the quasiparticle-induced contribution by subtracting the background transition rates. We show that to accurately model the external magnetic flux dependence of the quasiparticle-induced transition rates, it is necessary to account for the superconducting gap asymmetry across the Josephson junctions. A comparison between theory and experiment constrains the relative quasiparticle densities in the small junction and the junction array and helps explain previously reported discrepancies between the bounds on the quasiparticle densities inferred for these two circuit elements.
Micro-fabricated superconducting circuits have emerged as a leading candidate for quantum computers. However, typical error rates of 10-3 for quantum gates remain a challenge for performing error correction and need to be further decreased for achieving practical quantum computation. Improving qubit coherence times for superconducting qubits is a continuous endeavor in order to decrease error rates. As part of this effort, a topic addressed in this dissertation is the study of the generation mechanism and dynamics of non-equilibrium quasiparticles (QPs), which are electron-like excitations of a superconductor. This source of decoherence was studied by measuring the rate of single-electron changes in the parity state of multiple charge-sensitive transmon qubits under different conditions. The presence of non-equilibrium QPs in superconducting resonators and qubits operating at millikelvin temperature has been known for decades. Understanding the sources and dynamics of these QPs is crucial to evaluate and improve the performance of the devices. Specifically, for superconducting qubits, a single QP tunneling across the Josephson junction changes the total charge parity from even to odd or vice versa, and can induce energy relaxation and dephasing, limiting the coherence of the device. To study the dynamics of non-equilibrium QPs, I utilized a Ramsey-like pulse sequence to measure the rate of single-electron parity changes in transmon qubits, which had a weak charge dispersion, with different shunting capacitor geometries and materials. I started out by measuring a charge parity rate of ~ 33 s-1 for a grounded "x-mon" qubit and ~ 17 s-1 for a galvanically isolated "two-pads" qubit with our standard setup. These rates decreased to ~ 5 s-1 and ~ 2 s-1 for the x-mon and two-pads respectively when IR-filters and extra layers of shielding were installed. From my measurements, I found that the charge parity rates are sensitive to the geometry of the shunting capacitor, weakly depend on the amount of shielding surrounding the device, and independent of using Al or Ta for the superconducting shunting capacitor. To distinguish between two possible mechanisms for the parity switching, I measured the parity rates after cooling one of the qubit devices in an external magnetic field to induce vortices in the superconducting electrodes. After increasing the magnetic field above 23 μT, I measured a faster QP trapping rate and a much smaller T1, suggesting that at least one vortex was added to the superconducting electrode near the Josephson junction. On the other hand, the measured charge parity rates exhibited no clear dependence on the background QP trapping rates. These data suggest that a large portion of parity switching events occurs from QPs being produced at the Josephson junction, where pair-breaking radiation is rectified into QPs by the junction, as opposed to tunneling of QPs residing in the electrodes. To understand the difference in the measured parity rates, I simulated the absorption efficiency of pair-breaking radiation for my two designs and observed a similar difference in absorption rates when a single-mode blackbody radiation with an effective temperature T* ~ 300 mK was assumed to be illuminating the devices. This large T*, which is significantly higher than the device's nominal temperature of 20 mK, is consistent with values reported in the literature. However, its physical origin remains not fully understood. For the other part of my dissertation, I developed a new simplified process for making superconducting air bridges. Air bridges are used to suppress unwanted extraneous high frequency chip modes parasitic to superconducting quantum circuits that can couple to qubits and cause decoherence. Traditional ways of making air bridges utilize thermal reflow to create arched photoresist scaffolds that are limited in heights. This results in insufficient mechanical strength of the bridges which tend to collapse when spanning to larger lengths. My simplified fabrication method that utilizes two-photon lithography, a technique that enables creation of three-dimensional micron-scale structures, relaxes this limitation and is capable of making mechanically stable bridges with lengths up to 100 μm. The resulting Al air bridges, having a superconducting transition temperature of Tc = 1.08 mK and a dc residual resistivity ratio of 3.85, were confirmed to form a good electrical contact with the base metal layers and exhibit a small measurable amount of rf loss when placed over coplanar waveguide resonators, on par with other air bridge fabrication methods.
We evaluate the quasiparticle contribution to the frequency shift and relaxation rates of a transmon with the Josephson junctions connecting superconductors that have unequal energy gaps. The gap difference substantially affects the transmon characteristics. We investigate their dependence on the density and effective temperature of the quasiparticles, and on the nominal (unperturbed by the quasiparticles) transmon frequency. At temperatures low compared to the qubit frequency, the gap difference can induce an anomalous positive frequency shift, resulting in a non-monotonic temperature dependence of the transmon frequency. The qubit relaxation rate exhibits a resonance when the qubit frequency matches the gap difference; the shape of the resonance is strongly temperature-dependent. We propose to use these effects to access the details of the quasiparticle energy distribution.
Superconducting quantum circuits underpin large-scale quantum processors and are increasingly interfaced with optical systems, yet they are vulnerable to quasiparticle poisoning from high-energy radiation and optical fields. Gap engineering of Josephson junctions suppresses quasiparticle-induced relaxation, but quasiparticles near the junction can still shift the qubit frequency and cause phase errors. Here, we extend gap engineering beyond the junction using a flux-tunable transmon with a gold-on-niobium ground plane and island and strongly gap-engineered aluminum junctions designed to keep quasiparticles away from the junction leads. Compared with an all-aluminum transmon with nominally identical junctions, we demonstrate that the niobium device withstands more than an order of magnitude higher near-infrared optical power before excess relaxation appears. The Nb transmon shows no resolvable quasiparticle-induced frequency shift over the same power range. At the same time, we observe that dephasing and state-preparation-and-measurement infidelity increase with optical power even while relaxation remains protected. These results suggest that engineering the quasiparticle energy landscape beyond the junction can substantially increase qubit resilience, not only to radiation-induced error bursts, but also to nearby optical fields.