arXiv:0908.1591 · Applied Physics Letters

Scalable arrays of rf Paul traps in degenerate Si

J. Britton, D. Leibfried, J. A. Beall, R. B. Blakestad, J. H. Wesenberg, D. J. Wineland

Published Oct 26, 2009• 43 citations

Abstract

We report techniques for the fabrication of multizone linear radio frequency Paul traps that exploit the machinability and electrical conductivity of degenerate silicon. The approach was tested by trapping and laser cooling M24g+ ions in the two following trap geometries: a single-zone two-layer trap and a multizone surface-electrode trap. From the measured ion motional heating rate we determine an electric field spectral density at the ion’s position of approximately 1×10−10 (V/m)2⋅Hz−1 at ωz/2π=1.125 MHz when the ion lies 40 μm above the trap surface. One application of these devices is controlled manipulation of atomic ion qubits, the basis of one form of quantum information processing.

DOI: 10.1063/1.3254188

Related papers

The development of microfabricated ion traps towards quantum information and simulation

Marcus Hughes

Trapped ions within Paul traps have shown to be a promising architecture in the realisation of a quantum information processor together with the ability of providing quantum simulations. Linear Paul traps have demonstrated long coherence times with ions being well isolated from the environment, single and multi-qubit gates and the high fidelity detection of states. The scalability to large number of qubits, incorporating all the previous achievements requires an array of linear ion traps. Microfabrication techniques allow for fabrication and micron level accuracy of the trap electrode dimensions through photolithography techniques. The first part of this thesis presents the experiential setup and trapping of Yb+ ions needed to test large ion trap arrays. This include vacuum systems that can host advanced symmetric and asymmetric ion traps with up to 90 static voltage control electrodes. Demonstration of a single trapped Yb+ ion within a two-layer macroscopic ion trap is presented. with an ion-electrode distance of 310(10) µm. The anomalous heating rate and spectral noise density of the trap was measured, a main form of decoherence within ion traps. The second half of this thesis presents the design and fabrication of multi-layer asymmetric ion traps. This allows for isolated electrodes that cannot be accessed via surface pathways, allowing for higher density of electrodes as well as creating novel trap designs that allow for the potential of quantum simulations to be demonstrated. These include two-dimensional lattices and ring trap designs in which the isolated electrodes provide more control in the ion position. For the microfabrication of these traps I present a novel high-aspect ratio electroplated electrode design that provides shielding of the dielectric layer. This provides a means to mitigate stray electric field due to charge build up on the dielectric surfaces. Electrical testing of the trap structures was performed to test bulk breakdown and surface flashover of the ion trap architectures. Results showed sufficient isolation between electrodes for both radio frequency and static breakdown. Surface flashover voltage measurements over the dielectric layer showed an improvement of more than double over previous results using a new fabrication technique. This will allow for more powerful ion trap chips needed for the next generation of microfabricated ion trap arrays for scalable quantum technologies.

Jun 16, 20130 citations

Microfabricated Surface-Electrode Ion Trap for Scalable Quantum Information Processing

Signe Louise Seidelin, John Chiaverini, R. Reichle +13 more

Individual laser-cooled 24Mg+ ions are confined in a linear Paul trap with a novel geometry where gold electrodes are located in a single plane and the ions are trapped 40 microm above this plane. The relatively simple trap design and fabrication procedure are important for large-scale quantum information processing (QIP) using ions. Measured ion motional frequencies are compared to simulations. Measurements of ion recooling after cooling is temporarily suspended yield a heating rate of approximately 5 motional quanta per millisecond for a trap frequency of 2.83 MHz, sufficiently low to be useful for QIP.

arXiv:quant-ph/0601173Physical Review LettersJun 30, 2006453 citations

Surface Planar Ion Chip for Linear Radio-Frequency Paul Traps

Jinyin Wan, Qu Qiu-Zhi, Zichao Zhou +3 more

We propose a surface planar ion chip which forms a linear radio frequency Paul ion trap. The electrodes reside in the two planes of a chip, and the trap axis is located above the chip surface. Its electric field and potential distribution are similar to the standard linear radio frequency Paul ion trap. This ion trap geometry may be greatly meaningful for quantum information processing.

Chinese Physics LettersMay 1, 20074 citations

Monolithic segmented three-dimensional ion trap for quantum technology applications

Anonymous, Michael Strauss, George Tomaras +12 more

Monolithic three-dimensional (3D) Paul traps combine the high-precision microfabrication of two-dimensional (2D) chip traps with the deep trapping potentials and low heating rates characteristic of macroscopic 3D Paul traps, which are typically machined by traditional means and mechanically assembled. However, achieving low motional heating rates and optical access with a high numerical aperture (NA) while maintaining the high radio-frequency (rf) voltages required for trapping heavy ionic species, such as Yb + and Ba + , remains a significant technical challenge. In this work, we present a fused silica, monolithic segmented 3D Paul trap with an ion-electrode distance of 250 μ m , and stable operation at high rf voltages. We benchmark the trap’s performance using Yb + ions, demonstrating axially homogeneous trapping potentials spanning over 200 μ m about the trap’s axial center, high multidirectional optical access (up to 0.7 NA), and radial motional heating as low as n ¯ ˙ = 1.1 ± 0.1 quanta / s at radial trap frequencies about 3 MHz near room temperature. Furthermore, we observe a motional Ramsey coherence time, T 2 , of about 96 ms for the radial center-of-mass mode. We demonstrate the generation of a two-qubit Bell state with a parity contrast of 99.3 − 1.5 + 0.7 % with state preparation and measurement correction. These results establish fused-silica monolithic 3D Paul traps as a scalable, modular platform for quantum simulation, computation, metrology, and networking with heavy ionic species.

Physical Review AppliedAug 17, 20260 citations

Surface trap with dc-tunable ion-electrode distance

Da An, Clemens Matthiesen, Ahmed Abdelrahman +5 more

We describe the design, fabrication, and operation of a novel surface-electrode Paul trap that produces a radio-frequency-null along the axis perpendicular to the trap surface. This arrangement enables control of the vertical trapping potential and consequentially the ion-electrode distance via dc-electrodes only. We demonstrate the confinement of single 40Ca+ ions at heights between 50 μm and 300 μm above planar copper-coated aluminum electrodes. Laser-cooling and coherent operations are performed on both the planar and vertical motional modes. This architecture provides a platform for precision electric-field noise detection and trapping of vertical ion strings without excess micromotion and may have applications for scalable quantum computers with surface ion traps.

arXiv:1807.06043Review of Scientific InstrumentsSep 1, 201813 citations

Sideband cooling and coherent dynamics in a microchip multi-segmented ion trap

Schulz, Stephan A., Ulrich Poschinger, Frank Ziesel +1 more

Miniaturized ion trap arrays with many trap segments present a promising architecture for scalable quantum information processing. The miniaturization of segmented linear Paul traps allows partitioning the microtrap into different storage and processing zones. The individual position control of many ions—each of them carrying qubit information in its long-lived electronic levels—by the external trap control voltages is important for the implementation of next generation large-scale quantum algorithms. We present a novel scalable microchip multi-segmented ion trap with two different adjacent zones, one for the storage and another dedicated to the processing of quantum information using single ions and linear ion crystals. A pair of radio-frequency-driven electrodes and 62 independently controlled dc electrodes allows shuttling of single ions or linear ion crystals with numerically designed axial potentials at axial and radial trap frequencies of a few megahertz. We characterize and optimize the microtrap using sideband spectroscopy on the narrow S1/2↔D5/2 qubit transition of the 40Ca+ ion, and demonstrate coherent single-qubit Rabi rotations and optical cooling methods. We determine the heating rate using sideband cooling measurements to the vibrational ground state, which is necessary for subsequent two-qubit quantum logic operations. The applicability for scalable quantum information processing is proved.

Apr 30, 200858 citations