Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0804.0442 · Superconductor Science and Technology

Single flux quantum circuits with damping based on dissipative transmission lines

E M Tolkacheva, D V Balashov, M I Khabipov, Alexander B Zorin

Published Oct 17, 2008• 3 citations
arXivHTMLPDF

Abstract

We propose and demonstrate the functioning of a special Rapid Single Flux Quantum (RSFQ) circuit with frequency-dependent damping. This damping is achieved by shunting individual Josephson junctions by pieces of open-ended RC transmission lines. Our circuit includes a toggle flip-flop cell, Josephson transmission lines transferring single flux quantum pulses to and from this cell, as well as DC/SFQ and SFQ/DC converters. Due to the desired frequency-dispersion in the RC line shunts which ensures sufficiently low noise at low frequencies, such circuits are well-suited for integrating with the flux/phase Josephson qubit and enable its efficient control.

DOI
10.1088/0953-2048/21/12/125010

Related papers

Low-noise RSFQ circuits for a Josephson Qubit control

M. Khabipov, D Balashov, E. Tolkacheva +1 more

We address the problem of reducing the noise of an RSFQ circuit, which may significantly decohere a Josephson qubit in the case of integration of these circuits. The main sources of such noise in traditional RSFQ circuits are low-ohmic shunting resistors ensuring sufficiently high damping. We developed the toggle flip-flop (TFF) cells with weakly-damped individual junctions due to high-ohmic shunts. The dominant part of necessary damping in this circuit was realized by applying an additional, so-called 'perpendicular', low-ohmic resistor connecting the centre of the storing TFF inductance to ground. The TFF circuits with junctions shunted by 50 Ω resistors and perpendicular resistor of 1.5 Ω, ensuring suppression of noise by more than one order, have been fabricated and demonstrated an operation range of ±20%. In order to make the circuit compact and, therefore, less sensitive to external noise, the passive frozen-flux-based phase shifting elements, replacing large quantizing inductances, were also included. The circuits were fabricated using PTB Nb trilayer process with critical current density j c = 100 A/cm 2 .

Journal of Physics Conference Series•Feb 1, 2008•1 citation

Rapid single flux quantum devices with selective dissipation for quantum information processing

Juha Hassel, P. Helistö, Heikki Seppä +3 more

The authors study the frequency dependent damping in rapid single flux quantum (RSFQ) circuits as means to reduce dissipation and consequent decoherence in RSFQ/qubit circuits. They show by simulations and experiments that stable RSFQ operation can be achieved by shunting the Josephson junctions with an RC circuit instead of a plain resistor. The authors derive criteria for the stability of such an arrangement and discuss the effect on decoherence.

arXiv:cond-mat/0510189•Applied Physics Letters•Oct 30, 2006•12 citations

Single flux quantum digital devices

V. P. Koshelets

A new generation of the Josephson digital circuits-rapid single flux quantum (RSFQ) devices-based on overdamped externally shunted high quality Nb-AlO x -Nb tunnel junctions have been designed, fabricated and experimentally investigated. All-refractory material 11-layer 5 mu m integrated technology has been successfully employed for the preparation of the RSFQ microcircuits. The T flip-flop has been demonstrated to operate properly up to clock frequencies of 100 GHz at 25% margins. The proper operation of the buffer stage for a one-directional SFQ pulse transmission at clock frequencies up to 125 GHz has been achieved. The possibilities to convert the information from the usual DC form to SFQ and vice versa have been demonstrated. An output signal in an SFQ/DC converter as high as 220 mu V has been measured. A new counter type A/D converter which includes a comparator and reversible binary counter with DC outputs has been fabricated and tested. The proposed ADC seems to be very promising for high-accuracy measurement of medium-bandwidth signals. The possibilities of creating a number of SFQ devices with outstanding parameters are discussed.

Superconductor Science and Technology•Nov 1, 1991•5 citations

Experimental realization of a resistive single flux quantum logic circuit

V. P. Koshelets, K. K. Likharev, V. V. Migulin +5 more

An integrated circuit including all basic components of the recently suggested Resistive Single Flux Quantum (RSFQ) logic family has been designed, fabricated and tested successfully. The circuit includes a generator of periodic SFQ pulses, four buffer/amplifier stages for splitting, channeling and regeneration of the pulses, a detector/load stage, and universal RSFQ logic gate (here performing the NOT function). The 10μm design rule circuit employs 13 active Nb - Al2O3- Nb Josephson junctions with the critical current density ∼ 0.5 kA/cm2. externally shunted by Mo resistors with R 1 Ohm. The shunting provided critical damping of the junctions (\beta_{c}\lsim 1) and reasonable (\sim 500 \muV) IcR product. The circuit operation has been tested by measurement of dc voltages\bar{V}_{i}across various Josephson junctions as functions of the dc current through the pulse generator. Correct and stable operation of the circuit for the clock frequencies from 0 to ∼30 GHz has been demonstrated.

IEEE Transactions on Magnetics•Mar 1, 1987•39 citations

Fluxon interaction in an overdamped Josephson transmission line

V. K. Kaplunenko

We have simulated fluxon propagation within a Josephson transmission line that is one of the elements of a rapid single flux quantum (RSFQ) circuit. This line is a parallel connection of damped Josephson junctions coupled by superconducting inductances. Geometries with and without mutual inductances between neighboring cells are considered. If the time interval between two fluxons is less than 0.3 φ0Vc−1 (Vc characteristic voltage) a repulsion between them was observed. The repulsion sets a specific time delay between the fluxons that impose a rigid limitation for high frequency performance of RSFQ logic. The delay depends on the shunting parameter, bias current, and values of interconnecting inductances.

Applied Physics Letters•Jun 12, 1995•48 citations

Underdamped long Josephson junction coupled to overdamped single-flux-quantum circuits

Y. M. Zhang, V. Borzenets, V. K. Kaplunenko +1 more

We report a circuit that integrates an underdamped long Josephson junction with overdamped single-flux-quantum (SFQ) circuits. We confirm that the resonant soliton modes in the long junction are not affected by SFQ cells coupled to the junction, and demonstrate that the radiation frequency and linewidth of the soliton resonances can be measured with SFQ T-flip-flops. Our experimental results also show that a 4π quantum mechanical phase leap at the end of the long junction, which is due to the reflection of a soliton, creates two single flux quanta propagating in the overdamped Josephson transmission line.

Applied Physics Letters•Sep 29, 1997•12 citations
We propose and demonstrate the functioning of a special Rapid Single Flux Quantum (RSFQ) circuit with frequency-dependent damping. This damping is achieved by shunting individual Josephson junctions by pieces of open-ended RC transmission lines. Our circuit includes a toggle flip-flop cell, Josephson transmission lines transferring single flux quantum pulses to and from this cell, as well as DC/SFQ and SFQ/DC converters. Due to the desired frequency-dispersion in the RC line shunts which ensures sufficiently low noise at low frequencies, such circuits are well-suited for integrating with the flux/phase Josephson qubit and enable its efficient control.
We address the problem of reducing the noise of an RSFQ circuit, which may significantly decohere a Josephson qubit in the case of integration of these circuits. The main sources of such noise in traditional RSFQ circuits are low-ohmic shunting resistors ensuring sufficiently high damping. We developed the toggle flip-flop (TFF) cells with weakly-damped individual junctions due to high-ohmic shunts. The dominant part of necessary damping in this circuit was realized by applying an additional, so-called 'perpendicular', low-ohmic resistor connecting the centre of the storing TFF inductance to ground. The TFF circuits with junctions shunted by 50 Ω resistors and perpendicular resistor of 1.5 Ω, ensuring suppression of noise by more than one order, have been fabricated and demonstrated an operation range of ±20%. In order to make the circuit compact and, therefore, less sensitive to external noise, the passive frozen-flux-based phase shifting elements, replacing large quantizing inductances, were also included. The circuits were fabricated using PTB Nb trilayer process with critical current density j c = 100 A/cm 2 .
A new generation of the Josephson digital circuits-rapid single flux quantum (RSFQ) devices-based on overdamped externally shunted high quality Nb-AlO x -Nb tunnel junctions have been designed, fabricated and experimentally investigated. All-refractory material 11-layer 5 mu m integrated technology has been successfully employed for the preparation of the RSFQ microcircuits. The T flip-flop has been demonstrated to operate properly up to clock frequencies of 100 GHz at 25% margins. The proper operation of the buffer stage for a one-directional SFQ pulse transmission at clock frequencies up to 125 GHz has been achieved. The possibilities to convert the information from the usual DC form to SFQ and vice versa have been demonstrated. An output signal in an SFQ/DC converter as high as 220 mu V has been measured. A new counter type A/D converter which includes a comparator and reversible binary counter with DC outputs has been fabricated and tested. The proposed ADC seems to be very promising for high-accuracy measurement of medium-bandwidth signals. The possibilities of creating a number of SFQ devices with outstanding parameters are discussed.
An integrated circuit including all basic components of the recently suggested Resistive Single Flux Quantum (RSFQ) logic family has been designed, fabricated and tested successfully. The circuit includes a generator of periodic SFQ pulses, four buffer/amplifier stages for splitting, channeling and regeneration of the pulses, a detector/load stage, and universal RSFQ logic gate (here performing the NOT function). The 10μm design rule circuit employs 13 active Nb - Al2O3- Nb Josephson junctions with the critical current density ∼ 0.5 kA/cm2. externally shunted by Mo resistors with R 1 Ohm. The shunting provided critical damping of the junctions (\beta_{c}\lsim 1) and reasonable (\sim 500 \muV) IcR product. The circuit operation has been tested by measurement of dc voltages\bar{V}_{i}across various Josephson junctions as functions of the dc current through the pulse generator. Correct and stable operation of the circuit for the clock frequencies from 0 to ∼30 GHz has been demonstrated.
We have simulated fluxon propagation within a Josephson transmission line that is one of the elements of a rapid single flux quantum (RSFQ) circuit. This line is a parallel connection of damped Josephson junctions coupled by superconducting inductances. Geometries with and without mutual inductances between neighboring cells are considered. If the time interval between two fluxons is less than 0.3 φ0Vc−1 (Vc characteristic voltage) a repulsion between them was observed. The repulsion sets a specific time delay between the fluxons that impose a rigid limitation for high frequency performance of RSFQ logic. The delay depends on the shunting parameter, bias current, and values of interconnecting inductances.
We report a circuit that integrates an underdamped long Josephson junction with overdamped single-flux-quantum (SFQ) circuits. We confirm that the resonant soliton modes in the long junction are not affected by SFQ cells coupled to the junction, and demonstrate that the radiation frequency and linewidth of the soliton resonances can be measured with SFQ T-flip-flops. Our experimental results also show that a 4π quantum mechanical phase leap at the end of the long junction, which is due to the reflection of a soliton, creates two single flux quanta propagating in the overdamped Josephson transmission line.