Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.
Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.
In this paper, we investigate slow light via stimulated Brillouin scattering (SBS) in a room temperature optical fiber that is pumped by a spectrally broadened laser. Broadening the spectrum of the pump field increases the linewidth Deltaomegapof the Stokes amplifying resonance, thereby increasing the slow-light bandwidth. One physical bandwidth limitation occurs when the linewidth becomes several times larger than the Brillouin frequency shift OmegaBso that the anti-Stokes absorbing resonance substantially cancels out the Stokes amplifying resonance and, hence, the slow-light effect. We find that partial overlap of the Stokes and anti-Stokes resonances can actually lead to an enhancement of the slow-light delay-bandwidth product when Deltaomegapsime1.3OmegaB. Using this general approach, we increase the Brillouin slow-light bandwidth to over 12 GHz from its nominal linewidth of ~30 MHz obtained for monochromatic pumping. We controllably delay 75-ps-long pulses by up to 47 ps and study the data-pattern dependence of the broadband SBS slow-light system
The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.
Frontiers in Guided Wave Optics and Optoelectronics 84 absorption is much too high to render the group effect useful.An exciting breakthrough happened in the early nineties when it was shown that group velocities of few tens of meters per second were possible with nonlinear resonance interactions (Hau et al., 1999).Two important features of nonlinear resonances make this possible: substantially reduced absorption, or even amplification, of radiation at a resonance, and sharpness of such resonances; the sharper a resonance, the higher dn/dω and so the stronger the enhancement of group index, and hence the greater the pulse is delayed.Widely ranging applications for slow light have been proposed, of which those for telecommunication systems and devices (optical delay lines, optical buffers, optical equalizers and signal processors) are currently of most interest (Gauthier, 2005).The essential demand of such devices is compatibility with existing telecommunication systems, that is they must be of wide enough bandwidth (≥10 GHz) and able to be integrated seamlessly into such systems.Of the various nonlinear resonance mechanisms and media, which allow sufficiently long induced delays, stimulated Brillouin and Raman scattering (SBS and SRS) in optical fiber are deemed to be among the best candidates.Currently SBS is the most actively investigated and many experimental and theoretical papers on pulse delaying via SBS in optical fiber have been published in the last few years, see the review paper (Thevenaz, 2008) and references therein.In this process the pulse to be delayed is a frequency down-shifted (Stokes) pulse.This is transmitted through an optical fiber through which continuous wave (CW) pump radiation is sent in the opposite direction to prime the delay process.It is supposed that the Stokes pulse is amplified by parametric coupling with the pump wave and a material (acoustic) wave in the medium (Kroll, 1965), and the amplification is characterised by a resonant-type gain profile.The dispersion of refractive index associated with this profile (which is similar to that in Fig. 1) can then be used to increase the group index for optical pulses at the Stokes frequency (Zeldovich, 1972).Along with obvious device compatibility, there are several other advantages of the SL via SBS approach for optical communications systems: slow-light resonance can be created at any wavelength by changing the pump wavelength; use of optical fibre allows for long interaction lengths and thus low powers for the pump radiation, the process runs at room temperature, it uses off the shelf telecom equipment, and SBS works in the entire transparency range of fibers and in all types of fiber.Currently a main obstacle to applications of this approach is the narrow SBS gain spectral bandwidth, (Thevenaz, 2008), which is typically ≈ 120-200 MHz in silica fiber in the spectral range of telecom optical radiation (~1.3-1.6 μm) (Agrawal, 2006).This chapter reviews our ongoing work on the physical mechanisms that give rise to pulse delay in SBS.In section 2 the theoretical background of the SBS phenomenon is given and the main working equations describing this nonlinear interaction are presented.In section 3 ways by which the SBS spectral bandwidth may be increased are addressed.Waveguide induced spectral broadening of SBS in optical fibre is considered as a means of increasing the bandwidth to the multi-GHz range.An alternative way widely discussed in the literature, (Thevenaz, 2008), is based on spectral broadening of the pump radiation.However it is shown through analytic analysis of the SBS equations converted to the frequency domain that pump radiation broadening by any reasonable amount has only a negligible effect on increasing the SBS bandwidth.Importantly in this section we show that, irrespective of the nature of the broadening considered, the SBS gain bandwidth remains www.intechopen.
ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.
ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.
Stimulated Brillouin scattering (SBS) has become a favorable underlying mechanism in many demonstrations of all-optical variable delay in standard fibers, often referred to as slow and fast light. Over 100 journal papers and numerous conference sessions have been dedicated to SBS slow light since 2005. In this paper, recent research in this area is reviewed. Following a short introduction to the topic, several specific trends in contemporary work are highlighted: the optimization of the SBS pump spectrum for extended slow light delay and reduced pulse distortion; SBS slow light demonstrations in nonstandard, highly nonlinear fibers; applications of SBS slow light to the delay of analog waveforms; and the role of polarization. Finally, a brief concluding perspective is provided.