Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Broadening-free SBS-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

Published Feb 21, 2014• 0 citations
Publisher

Abstract

To change the group velocity of optical signals has a lot of possible applications in telecommunications, sensing, nonlinear optics and so on. Especially the exploitation of the effect of stimulated Brillouin scattering (SBS) in optical fibers is of special interest since it just requires standard telecom equipment and low to moderate optical power. However, each delay in one single, low-gain SBS based slow-light system is accompanied by pulse broadening. This is a result of the inherent Kramers-Kronig relations between the gain, the phase-change and the accompanied group velocity. For an ideal flat gain the phase-change is non-ideal, and for an ideal phase-change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is broadened in order to adapt it to the signal, the delay will be reduced. Thus, for one single low-gain slow-light system the broadening can be reduced by several methods but it cannot be zero. Here we will show how a zero-broadening SBS based slow-light system can be achieved by two different methods. The basic idea is a reshaping of the original pulse by an adapted gain in a second stage. This adaptation is achieved by the superposition of two Gaussian gain profiles or by a single saturated gain. As will be shown, these systems show an almost ideal over-all gain and phase function over the bandwidth of the pulses. Thus, SBS based slow-light with a delaybandwidth product of more than 1 bit and zero distortion is possible.

DOI
10.1117/12.2047573

Related papers

Broadening-free stimulated Brillouin scattering-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.

Optical Engineering•Aug 25, 2014•0 citations

Zero-broadening SBS slow light propagation in an optical fiber using two broadband pump beams

Shihe Wang, Liyong Ren, Yu Liu +1 more

A new method of tailoring stimulated Brillouin scattering (SBS) gain spectrum for slow light propagation is proposed by use of two Gaussian-shaped broadband pump beams with different powers and spectral widths. The central frequency interval between the two pump beams are carefully set to be two inherent Brillouin frequency shift, ensuring that the gain spectrum of one pump has the same central frequency with the loss spectrum of the other one. Different gain profiles are obtained and analyzed. Among them a special gain profile is found that ensures a zero-broadening of the signal pulse independent of the Brillouin gain. This is owing to the compensation between the positive gain-dependent broadening and the negative GVD (group velocity dispersion) dependent broadening. The relationship of two pump beams is also found for constructing such a gain profile. It provides us a new idea of managing the broadening of SBS-based slow pulse by artificially constructing and optimizing the profile of gain spectrum.

Optics Express•May 20, 2008•41 citations

Optimisation of optical signal delay in slow-light systems based on stimulated brillouin scattering

Ronny Henker, Thomas Schneider, Andrzej Wiatrek +4 more

Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.

Irish Signals and Systems Conference•Jan 1, 2008•3 citations

A Review of Slow- and Fast-Light Based on Stimulated Brillouin Scattering in Future Optical Communication Networks

Ronny Henker, Andrzej Wiatrek, Kai-Uwe Lauterbach +4 more

Slow- and Fast-Light has been investigated during the last years as a powerful tool to reduce and increase the group velocity of light pulses by light. It has enjoyed much recent interest because of the practical applications for telecommunication and information systems. Among these are optical signal processing, radio frequency-photonics, nonlinear optics and time domain spectroscopy. Furthermore, it can be seen as a key technology for optical delay lines, buffers, equalizers and synchronizers in packet switched networks. For a realization, there are different methods and material systems possible. Among them the nonlinear effect of stimulated Brillouin scattering (SBS) is of special interest. This article gives an overview about the fundamentals and some experimental results of the Slow- and Fast-Light effect based on the SBS in optical fibers.

Communications - Scientific letters of the University of Zilina•Dec 31, 2008•3 citations

Distortion reduction in Slow Light systems based on stimulated Brillouin scattering

Thomas Schneider, Ronny Henker, Kai-Uwe Lauterbach +1 more

We show a simple method to reduce the distortions in SBS based slow light systems. The distortion reduction is simply based on a broadening and adaptation of the gain bandwidth. However, a broadened gain reduces the achievable fractional delay which cannot be compensated by higher pump powers. Here we will show that this compensation can be done by additional loss spectra. With the presented method low distortions for high fractional pulse delays are possible. We show the theory and experimental verifications of our method. For Gaussian pulses with a fractional delay of 1 Bit we achieved a distortion reduction of around 23%.

Optics Express•May 22, 2008•31 citations

Theoretical study on stimulated-Brillouin-scattering gain-spectrum broadening and pulse-distortion reduction of slow-light propagation using double broadband pump in optical fibers

Wang Shi-He, Ren Li-Yong, Liu Yu +1 more

We analyse the stimulated Brillouin scattering （SBS） slow light using double broadband pumps in a single mode fiber. A new SBS gain spectrum tailoring method is proposed using two Gaussian-shaped broadband pumps with different powers and spectral widths, and the central frequency interval of them is carefully set at two Brillouin frequency shifts to make sure that the gain of one pump has the same center with the loss of the other. The top of the gain spectrum of the strong pump beam can be counteracted by the loss spectrum of the weak pump beam to construct a flat top gain spectrum. We give the optimized conditions of the laser powers and spectral widths between two broadband pumps to obtain a flat gain. Distortions of signal pulse under this flat top gain are studied and compared with that obtained using a single broadband pump. We find that the flat top gain profile can effectively reduce the pulse distortions.

Acta Physica Sinica•Jan 1, 2009•4 citations
To change the group velocity of optical signals has a lot of possible applications in telecommunications, sensing, nonlinear optics and so on. Especially the exploitation of the effect of stimulated Brillouin scattering (SBS) in optical fibers is of special interest since it just requires standard telecom equipment and low to moderate optical power. However, each delay in one single, low-gain SBS based slow-light system is accompanied by pulse broadening. This is a result of the inherent Kramers-Kronig relations between the gain, the phase-change and the accompanied group velocity. For an ideal flat gain the phase-change is non-ideal, and for an ideal phase-change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is broadened in order to adapt it to the signal, the delay will be reduced. Thus, for one single low-gain slow-light system the broadening can be reduced by several methods but it cannot be zero. Here we will show how a zero-broadening SBS based slow-light system can be achieved by two different methods. The basic idea is a reshaping of the original pulse by an adapted gain in a second stage. This adaptation is achieved by the superposition of two Gaussian gain profiles or by a single saturated gain. As will be shown, these systems show an almost ideal over-all gain and phase function over the bandwidth of the pulses. Thus, SBS based slow-light with a delaybandwidth product of more than 1 bit and zero distortion is possible.
The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.
A new method of tailoring stimulated Brillouin scattering (SBS) gain spectrum for slow light propagation is proposed by use of two Gaussian-shaped broadband pump beams with different powers and spectral widths. The central frequency interval between the two pump beams are carefully set to be two inherent Brillouin frequency shift, ensuring that the gain spectrum of one pump has the same central frequency with the loss spectrum of the other one. Different gain profiles are obtained and analyzed. Among them a special gain profile is found that ensures a zero-broadening of the signal pulse independent of the Brillouin gain. This is owing to the compensation between the positive gain-dependent broadening and the negative GVD (group velocity dispersion) dependent broadening. The relationship of two pump beams is also found for constructing such a gain profile. It provides us a new idea of managing the broadening of SBS-based slow pulse by artificially constructing and optimizing the profile of gain spectrum.
Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.
Slow- and Fast-Light has been investigated during the last years as a powerful tool to reduce and increase the group velocity of light pulses by light. It has enjoyed much recent interest because of the practical applications for telecommunication and information systems. Among these are optical signal processing, radio frequency-photonics, nonlinear optics and time domain spectroscopy. Furthermore, it can be seen as a key technology for optical delay lines, buffers, equalizers and synchronizers in packet switched networks. For a realization, there are different methods and material systems possible. Among them the nonlinear effect of stimulated Brillouin scattering (SBS) is of special interest. This article gives an overview about the fundamentals and some experimental results of the Slow- and Fast-Light effect based on the SBS in optical fibers.
We show a simple method to reduce the distortions in SBS based slow light systems. The distortion reduction is simply based on a broadening and adaptation of the gain bandwidth. However, a broadened gain reduces the achievable fractional delay which cannot be compensated by higher pump powers. Here we will show that this compensation can be done by additional loss spectra. With the presented method low distortions for high fractional pulse delays are possible. We show the theory and experimental verifications of our method. For Gaussian pulses with a fractional delay of 1 Bit we achieved a distortion reduction of around 23%.
We analyse the stimulated Brillouin scattering （SBS） slow light using double broadband pumps in a single mode fiber. A new SBS gain spectrum tailoring method is proposed using two Gaussian-shaped broadband pumps with different powers and spectral widths, and the central frequency interval of them is carefully set at two Brillouin frequency shifts to make sure that the gain of one pump has the same center with the loss of the other. The top of the gain spectrum of the strong pump beam can be counteracted by the loss spectrum of the weak pump beam to construct a flat top gain spectrum. We give the optimized conditions of the laser powers and spectral widths between two broadband pumps to obtain a flat gain. Distortions of signal pulse under this flat top gain are studied and compared with that obtained using a single broadband pump. We find that the flat top gain profile can effectively reduce the pulse distortions.