Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Solid-State Circuits

A Cryogenic CMOS Frequency-Comb-Based Quad-Channel Quantum State Controller

Fengen Yuan, Yatao Peng, Hao Su, Xianglong Zhang, Yue Wu, Zhuo Xu, Hou Ian, Jun Yin, Rui Paulo Martins, Pui‐In Mak

Published Jan 1, 2026• 0 citations
Publisher
DOI
10.1109/jssc.2026.3750435

Related papers

CMOS-based cryogenic control of silicon quantum circuits

Bishnu Patra, Xiao Xue, Jeroen P. G. van Dijk +21 more

Bulletin of the American Physical Society•Mar 17, 2021•0 citations

CMOS-based cryogenic control of silicon quantum circuits

Xiao Xue, Bishnu Patra, Jeroen P. G. van Dijk +22 more

arXiv:2009.14185•Nature•May 12, 2021•343 citations

Cryogenic CMOS Control Circuits for Scalable Quantum Computing Architecture

Neeraj kumar, Aijaz Mehdi Zaidi, Balwinder Raj +1 more

Journal of Low Temperature Physics•Oct 30, 2026•0 citations

13.4 A 1GS/s 6-to-8b 0.5mW/Qubit Cryo-CMOS SAR ADC for Quantum Computing in 40nm CMOS

Gerd Kiene, Alessandro Catania, Ramon W. J. Overwater +4 more

Quantum computers (QCs) promise significant speedup for relevant computational problems that are intractable by classical computers. QCs process information stored in quantum bits (qubits) that must be typically cooled down to cryogenic temperatures. Since state-of-the-art QCs employ only a few qubits, those qubits can be driven and read out by room-temperature electronics connected to the cryogenic qubits by only a few wires. However, practical QCs will require more than thousands of qubits, making this approach impractical due to system complexity and reliability concerns. Although frequency multiplexing would reduce the interconnects to room temperature by fitting many qubit channels in the same physical interconnect, an excessive number of interconnects would still be required. An alternative, more scalable solution is a cryogenic electronic interface operating very close to the quantum processor to keep the whole control loop at cryogenic temperature, hence avoiding any high-speed interconnect to room temperature. This system must comprise drivers, readout circuits (LNAs, ADCs), and a digital controller to steer the quantum-algorithm execution [1]. While cryogenic CMOS (cryo-CMOS) wideband drivers and LNAs supporting qubit frequency multiplexing have been shown before [1] -[3], no wideband cryo-CMOS ADC has been demonstrated yet.

Digest of technical papers/Digest of technical papers - IEEE International Solid-State Circuits Conference•Feb 13, 2021•38 citations

Cryogenic microwave frequency combs based on quantum paraelectric superconducting resonators

Prasad Muragesh, H. Sundaresan, Madhu Thalakulam

A frequency comb, known for its precision as an “optical ruler,” features an evenly spaced spectral pattern. While these combs are vital in integrated photonics, their microwave counterparts are now highly sought in cryogenic quantum technologies, including semiconducting and superconducting qubits as well as quantum electrical metrology. However, microwave combs are still largely underexplored. Existing studies mostly rely on complex, high-power optical systems incompatible with the low-power, cryogenic on-chip architecture. In this manuscript, we present an all-electrical, on-chip, cryogenic microwave frequency comb on strontium titanate (SrTiO3), exploiting its Pockels-like effect in its quantum paraelectric phase. Our device utilizes a superconducting microwave cavity to generate the frequency comb via cavity phase modulation enabled by the field-induced effective χ(2) of SrTiO3. The ability to continuously vary the dielectric constant of SrTiO3 by the application of an electric field, in its quantum paraelectric phase, makes it possible to control the comb's operating frequency span. The exceptionally high dielectric constant of SrTiO3, > 20 000 at low temperatures, enables an ultra-miniature design and on-chip integration with cryogenic quantum technologies.

arXiv:2605.13571•Applied Physics Letters•Aug 17, 2026•2 citations

0.25 mW/qubit, 5.7-7.5 GHz Cryogenic CMOS Microwave Signal Selector Using Dual-Stage Injection-Locked Oscillator for Frequency-Multiplexed Qubit Control

Hiroshi Fuketa, Ippei Akita, Tomohiro Ishikawa +2 more

Cryogenic CMOS (cryo-CMOS) quantum bit (qubit) control circuits are expected to overcome the interconnect complexity problem in large-scale quantum computers. However, since each qubit has a unique frequency for control, many power-hungry oscillators are needed to generate the frequencies at the cryogenic temperature stage of a refrigerator. In this paper, to remove the oscillators from the refrigerator, we propose a cryo-CMOS signal selector consisting of two injection-locked oscillators that extract the specified frequency tone for qubit control from the multi-tone microwave signal. This can realize an efficient frequency-multiplexed qubit control system with 1/30 power consumption of the conventional systems.

IEEE Symposium on VLSI Technology and Circuits (VLSI Technology and Circuits)•Jun 8, 2025•1 citation
Quantum computers (QCs) promise significant speedup for relevant computational problems that are intractable by classical computers. QCs process information stored in quantum bits (qubits) that must be typically cooled down to cryogenic temperatures. Since state-of-the-art QCs employ only a few qubits, those qubits can be driven and read out by room-temperature electronics connected to the cryogenic qubits by only a few wires. However, practical QCs will require more than thousands of qubits, making this approach impractical due to system complexity and reliability concerns. Although frequency multiplexing would reduce the interconnects to room temperature by fitting many qubit channels in the same physical interconnect, an excessive number of interconnects would still be required. An alternative, more scalable solution is a cryogenic electronic interface operating very close to the quantum processor to keep the whole control loop at cryogenic temperature, hence avoiding any high-speed interconnect to room temperature. This system must comprise drivers, readout circuits (LNAs, ADCs), and a digital controller to steer the quantum-algorithm execution [1]. While cryogenic CMOS (cryo-CMOS) wideband drivers and LNAs supporting qubit frequency multiplexing have been shown before [1] -[3], no wideband cryo-CMOS ADC has been demonstrated yet.
A frequency comb, known for its precision as an “optical ruler,” features an evenly spaced spectral pattern. While these combs are vital in integrated photonics, their microwave counterparts are now highly sought in cryogenic quantum technologies, including semiconducting and superconducting qubits as well as quantum electrical metrology. However, microwave combs are still largely underexplored. Existing studies mostly rely on complex, high-power optical systems incompatible with the low-power, cryogenic on-chip architecture. In this manuscript, we present an all-electrical, on-chip, cryogenic microwave frequency comb on strontium titanate (SrTiO3), exploiting its Pockels-like effect in its quantum paraelectric phase. Our device utilizes a superconducting microwave cavity to generate the frequency comb via cavity phase modulation enabled by the field-induced effective χ(2) of SrTiO3. The ability to continuously vary the dielectric constant of SrTiO3 by the application of an electric field, in its quantum paraelectric phase, makes it possible to control the comb's operating frequency span. The exceptionally high dielectric constant of SrTiO3, > 20 000 at low temperatures, enables an ultra-miniature design and on-chip integration with cryogenic quantum technologies.
Cryogenic CMOS (cryo-CMOS) quantum bit (qubit) control circuits are expected to overcome the interconnect complexity problem in large-scale quantum computers. However, since each qubit has a unique frequency for control, many power-hungry oscillators are needed to generate the frequencies at the cryogenic temperature stage of a refrigerator. In this paper, to remove the oscillators from the refrigerator, we propose a cryo-CMOS signal selector consisting of two injection-locked oscillators that extract the specified frequency tone for qubit control from the multi-tone microwave signal. This can realize an efficient frequency-multiplexed qubit control system with 1/30 power consumption of the conventional systems.