An off-resonant Raman memory trades optical depth and control energy for bandwidth: it can accept short photons that a narrowband memory cannot, at the price of a noise floor set by spontaneous scattering from the control field. This study computes the quantities that follow from stated assumptions for a warm caesium vapour Raman memory, photon duration 1 ns, detuning 1 to 5 GHz, control energies spanning an order of magnitude, using the relations set out in the Methods. The headline results are efficiency E4 D2 = 0.8347, noise E4 D2 = 0.08, efficiency E10 D5 = 0.5132, noise E10 D5 = 5.120e-03, bandwidth E4 D2 GHz = 1.5. Further computed values are operating points meeting both = 1. The central question is stated as follows: For stated control pulse energies and detunings, what acceptance bandwidth, storage efficiency and noise photons per pulse follow, and is there an operating point with efficiency above one half and noise below one hundredth of a photon? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Raman memories have demonstrated gigahertz bandwidths with efficiencies of tens of percent and noise levels that remain the main obstacle to single-photon operation. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
An off-resonant Raman memory trades optical depth and control energy for bandwidth: it can accept short photons that a narrowband memory cannot, at the price of a noise floor set by spontaneous scattering from the control field. This study computes the quantities that follow from stated assumptions for a warm caesium vapour Raman memory, photon duration 1 ns, detuning 1 to 5 GHz, control energies spanning an order of magnitude, using the relations set out in the Methods. The headline results are efficiency E4 D2 = 0.8347, noise E4 D2 = 0.08, efficiency E10 D5 = 0.5132, noise E10 D5 = 5.120e-03, bandwidth E4 D2 GHz = 1.5. Further computed values are operating points meeting both = 1. The central question is stated as follows: For stated control pulse energies and detunings, what acceptance bandwidth, storage efficiency and noise photons per pulse follow, and is there an operating point with efficiency above one half and noise below one hundredth of a photon? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Raman memories have demonstrated gigahertz bandwidths with efficiencies of tens of percent and noise levels that remain the main obstacle to single-photon operation. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Design blueprint derived from the source paper (DOI 10.5281/zenodo.24159685): An off-resonant Raman memory trades optical depth and control energy for bandwidth: it can accept short photons that a narrowband memory cannot, at the price of a noise floor set by spontaneous scattering from the control field. This study computes the quantities that follow from stated assumptions for a warm caesium vapour Raman memory, photon duration 1 ns, detuning 1 to 5 GHz, control energies spanning an order of magnitude, using the relations set out in the Methods. The headline results are efficiency E4 D2 = 0.8347, noise E4 D2 = 0.08, efficiency E10 D5 = 0.5132, noise E10 D5 = 5.120e-03, bandwidth E4 D2 GHz = 1.5. Further computed values are operating points meeting both = 1. The central question is stated as follows: For stated control pulse energies and detunings, what acceptance bandwidth, storage efficiency and noise photons per pulse follow, and is there an operating point with efficiency above one half and noise below one hundredth of a photon? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Raman memories have demonstrated gigahertz bandwidths with efficiencies of tens of percent and noise levels that remain the main obstacle to single-photon operation. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
Quantum memories are key components in quantum information networks. Their ability to store and retrieve information on demand makes repeat-until-success strategies scalable. Warm alkali-metal vapours are interesting candidates for the implementation of such memories, thanks to their long storage times and experimental simplicity. Operation with the Raman protocol enables high time-bandwidth products, which allows for multiple synchronisation trials of probabilistically operating quantum gates via memory-based temporal multiplexing. This makes the Raman memory a promising tool, whose broad spectral bandwidth facilitates direct interfacing with other photonic primitives, such as single photon sources. Here, such a light-matter interface is implemented in a warm caesium vapour. Firstly, we study the storage of polarisation-encoded information in the memory. High quality polarisation preservation for bright coherent state input signals can be achieved, when operating the Raman memory in a dual-rail configuration inside a polarisation interferometer. Secondly, heralded single photons are stored in the memory. To this end, the memory is operated on-demand by feed-forward of source heralding events, which is a key technological capability. Prior to storage, single photons are produced in a spontaneous parametric down conversion source, whose bespoke design spectrally tailors the photons to the memory acceptance line. The faithful retrieval of stored single photons is found to be currently limited by noise in the memory, with a signal-to-noise ratio of 0.3 in the memory output. Nevertheless, a clear influence of the input's quantum nature is observed in the retrieved light by measuring signal's photon statistics. Finally, the memory noise processes are examined in detail. Four-wave-mixing noise is determined as the sole important noise source for the Raman memory.
Broadband quantum memories hold great promise as multiplexing elements in future photonic quantum information protocols. Alkali-vapor Raman memories combine high-bandwidth storage, on-demand readout, and operation at room temperature without collisional fluorescence noise. However, previous implementations have required large control pulse energies and have suffered from four-wave-mixing noise. Here, we present a Raman memory where the storage interaction is enhanced by a low-finesse birefringent cavity tuned into simultaneous resonance with the signal and control fields, dramatically reducing the energy required to drive the memory. By engineering antiresonance for the anti-Stokes field, we also suppress the four-wave-mixing noise and report the lowest unconditional noise floor yet achieved in a Raman-type warm vapor memory, (15±2)×10^{-3} photons per pulse, with a total efficiency of (9.5±0.5)%.
We propose a scenario of quantum memory for light based on Raman scattering. The storage medium is a vapor and the different spectral components of the input pulse are stored in different atomic velocity classes. One uses appropriate pulses to reverse the resulting Doppler phase shift and to regenerate the input pulse, without distortion, in the backward direction. The different stages of the protocol are detailed and the recovery efficiency is calculated in the semiclassical picture. Since the memory bandwidth is determined by the Raman transition Doppler width, it can be adjusted by changing the angle between the input pulse wave vector and the control beams. The optical depth also depends on the beam angle. As a consequence the available optical depth can be optimized depending on the needed bandwidth. The predicted recovery efficiency is close to 100% for large optical depth.
An optical quantum memory, a device which can store and retrieve on demand an arbitrary quantum state at the single photon level, has been identified as a significant cornerstone of photonic quantum technologies. The development of such a memory would allow the creation and development of a large number of quantum technologies. These would range from the ability to synchronise processing steps in an optical quantum computer, to the construction of a quantum repeater which would allow faithful transmission of quantum states over arbitrarily long distances. In this thesis I investigate broadband light storage in a room-temperature Raman memory for purposes of quantum information processing with photons. During the course of this thesis, a novel scheme to suppress four-wave mixing noise is simulated, based on equations derived to describe the physics of the memory interaction. The experimental arrangement to test the suppression method is described and an original method using photon statistics is demonstrated. The results of these experiments prove the ability of the memory to retrieve and maintain the non-classicality of the state, given a single photon input. Following the affirmation that, using this noise suppression technique, the memory can function at the single-photon level, I go on to consider how the temporal-spectral properties of a pulsed mode of light may be manipulated using the memory. There are two primary reasons for this investigation: 1) Increasing the efficiency of the read-in process by carving the optimum mode of the memory 2) Using the memory as a device operating in a high dimensional quantum information basis. The restrictions of such applications are considered and a method to test the efficacy of transformations in this basis is devised and experimentally tested. I also perform demonstrations of light storage using conventional temporal modes using a novel method of velocity selection within warm vapour. Finally I detail further experiments that are achievable with the Raman quantum memory given the progress that has been achieved during my DPhil research. The results show that the Raman memory is a viable candidate for a practical route towards low-noise quantum storage and for manipulation of temporal modes of light.
Room-temperature, easy-to-operate quantum memories are essential building blocks for future long distance quantum information networks operating on an intercontinental scale, because devices like quantum repeaters, based on quantum memories, will have to be deployed in potentially remote, inaccessible locations. Here we demonstrate controllable, broadband and efficient storage and retrieval of weak coherent light pulses at the single-photon level in warm atomic cesium vapor using the robust far off-resonant Raman memory scheme. We show that the unconditional noise floor of this technically simple quantum memory is low enough to operate in the quantum regime, even in a room-temperature environment.