A photon reflected from a cavity that contains a coupled emitter acquires a phase that depends on the emitter state. That conditional phase is the working principle of a photon router and of several photon-photon gate proposals, and its usefulness is set by the cooperativity. This study computes the quantities that follow from stated assumptions for a one-sided cavity coupled to a two-level emitter, probed on resonance by a narrowband single photon, using the relations set out in the Methods. The headline results are fidelity at C 5 = 0.9091, fidelity at C 20 = 0.9756, fidelity at C 100 = 0.995, reflection at C 5 = 0.8182, loss at C 20 = 0.09518. The central question is stated as follows: For cooperativities from one half to one hundred, what reflection amplitudes, conditional phase error and routing fidelity follow in the standard input-output model? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Conditional phase shifts approaching pi and gate fidelities limited mainly by cooperativity are the standard theoretical expectations for this geometry, with experiments reporting smaller shifts where cooperativity is modest. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
A photon reflected from a cavity that contains a coupled emitter acquires a phase that depends on the emitter state. That conditional phase is the working principle of a photon router and of several photon-photon gate proposals, and its usefulness is set by the cooperativity. This study computes the quantities that follow from stated assumptions for a one-sided cavity coupled to a two-level emitter, probed on resonance by a narrowband single photon, using the relations set out in the Methods. The headline results are fidelity at C 5 = 0.9091, fidelity at C 20 = 0.9756, fidelity at C 100 = 0.995, reflection at C 5 = 0.8182, loss at C 20 = 0.09518. The central question is stated as follows: For cooperativities from one half to one hundred, what reflection amplitudes, conditional phase error and routing fidelity follow in the standard input-output model? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Conditional phase shifts approaching pi and gate fidelities limited mainly by cooperativity are the standard theoretical expectations for this geometry, with experiments reporting smaller shifts where cooperativity is modest. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Design blueprint derived from the source paper (DOI 10.5281/zenodo.24159486): A photon reflected from a cavity that contains a coupled emitter acquires a phase that depends on the emitter state. That conditional phase is the working principle of a photon router and of several photon-photon gate proposals, and its usefulness is set by the cooperativity. This study computes the quantities that follow from stated assumptions for a one-sided cavity coupled to a two-level emitter, probed on resonance by a narrowband single photon, using the relations set out in the Methods. The headline results are fidelity at C 5 = 0.9091, fidelity at C 20 = 0.9756, fidelity at C 100 = 0.995, reflection at C 5 = 0.8182, loss at C 20 = 0.09518. The central question is stated as follows: For cooperativities from one half to one hundred, what reflection amplitudes, conditional phase error and routing fidelity follow in the standard input-output model? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Conditional phase shifts approaching pi and gate fidelities limited mainly by cooperativity are the standard theoretical expectations for this geometry, with experiments reporting smaller shifts where cooperativity is modest. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs. Status: DESIGN BLUEPRINT — SIMULATED, NOT MEASURED — NOT BUILT. All numbers are simulated values from the source paper's computation, deposited with this blueprint as compute.py and results.json. AI-use disclosure: Dave, an AI research system, assisted with the computation and drafting under the author's direction; author of record William Alexander Aldred.
Linking a superconducting circuit to an optical fibre requires converting a microwave photon into an optical photon. In an electro-optic or optomechanical converter the efficiency is set by two cooperativities, one on each side of the device, and by how well they are matched. This study computes the quantities that follow from stated assumptions for a bidirectional converter with internal efficiency formula stated in the text, external coupling 0.9 on each side, and a thermal occupation of 0.1 microwave photons, using the relations set out in the Methods. The headline results are eta at C 10 10 = 0.907, eta external at C 10 10 = 0.7347, eta at C 10 100 = 0.3246, eta at C 1 1 = 0.4444, eta at C 100 100 = 0.9901. The central question is stated as follows: What conversion efficiency and added noise follow for cooperativity pairs from below unity to one hundred, and how much efficiency is lost when the two cooperativities differ by a factor of ten? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Reported conversion efficiencies span many orders of magnitude, from very small values in early devices to tens of percent in the most advanced, with added noise often the stricter criterion. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
Strong coupling appears when the coherent exchange rate between one emitter and one cavity mode exceeds both the cavity decay rate and the emitter decay rate. Because the exchange rate grows as the mode volume shrinks, the threshold can be expressed as a maximum volume for stated decay rates. This study computes the quantities that follow from stated assumptions for a single two-level emitter at 780 nm, dipole moment 3e-29 coulomb metre, cavity quality factor 20000 and emitter decay rate 1 GHz in angular-frequency units as stated, using the relations set out in the Methods. The headline results are cooperativity at V 1 lambda3 = 1.616, cooperativity at V 10 lambda3 = 0.1616, V for C1 in lambda3 = 1.616, V for C10 in lambda3 = 0.1616, V for C100 in lambda3 = 0.01616. Further computed values are g at V 1 lambda3 rad s = 4.952e+10, kappa rad s = 1.207e+11. The central question is stated as follows: What mode volume, in cubic wavelengths, is required for strong coupling and for a cooperativity of ten and of one hundred, for an emitter with a 1 GHz linewidth in a cavity of quality factor twenty thousand? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Cooperativities from near unity to several hundred are reported across atom, ion, quantum-dot and colour-centre platforms, which makes the threshold volume a useful common yardstick. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.
In this paper we analyze the performance of photonic CZ gates based on N waveguide-coupled cavities containing two-level emitters. We derive single- and two-photon scattering matrices for one cavity using the input-output formalism of quantum optics and for N>1 cavities using the SLH formalism, allowing us to compute the CZ gate fidelity. We consider two input Gaussian wave packets that are centered on a two-photon transition of the emitter-cavity system, and find a trade-off between optimizing the single-photon and two-photon wave packet shape. While the single-photon wave packet is preserved for large emitter-cavity coupling rates, where there is little overlap with the single-photon transitions, the two-photon wave packet acquires the necessary π phase shift for smaller coupling rates, comparable to the cavity decay rate multiplied by the number of cavities. We find that this trade-off limits the CZ gate fidelity to approximately 60% when averaging over all input states.
We demonstrate theoretically that waveguide-coupled cavities with embedded two-level emitters can act as a highly efficient, high-fidelity single-photon switch. The photon switch is an optical router triggered by a classical signal—the propagation direction of single input photons in the waveguide is controlled by changing the emitter-cavity coupling parameters , for example, using applied fields. The switch reflects photons in the weak emitter-cavity coupling regime and transmits photons in the strong coupling regime. By calculating transmission and reflection spectra using the input-output formalism of quantum optics and the transfer matrix approach, we obtain the fidelity and efficiency of the switch with a single-photon input in both regimes. We find that a single waveguide-coupled cavity can route input photon wave packets with near-unity efficiency and fidelity if the wave packet width is smaller than the cavity mode linewidth. We also find that using multiple waveguide-coupled cavities increases the switching bandwidth, allowing wider wave packets to be routed with high efficiency and fidelity. For example, an array of three waveguide-coupled cavities can reflect an input Gaussian wave packet with a full width at half-maximum of 1 nm (corresponding to a few-picosecond pulse) with an efficiency E r = 96.4 % and a fidelity F r = 97.7 % , or transmit the wave packet with an efficiency E t = 99.7 % and a fidelity F t = 99.8 % . Such efficient, high-fidelity single-photon routing is essential for scalable photonic quantum technologies. Published by the American Physical Society 2024
When a cavity is strongly coupled to a two-level emitter, its energy levels cease to be equally spaced. A drive tuned to the first transition is then detuned from the second, so a second photon is largely excluded: the photon blockade. This study computes the quantities that follow from stated assumptions for a Jaynes-Cummings system with cavity decay corresponding to quality factor 20000 at 780 nm and coupling rates from 5 to 100 GHz in ordinary frequency units, using the relations set out in the Methods. The headline results are kappa GHz = 19.22, anharmonicity at g 20 GHz = 11.72, g2 at g 20 = 0.4021, g2 at g 5 = 0.915, g2 at g 100 = 0.0262. The central question is stated as follows: How large is the anharmonicity, and the resulting suppression of two-photon occupation, for coupling rates spanning the strong-coupling range, and at what coupling does the suppression reach a factor of one hundred? The answer obtained here is conditional on the assumptions listed in the paper and in the deposited calculation; changing an assumption changes the numbers in the way the sensitivity discussion describes. Blockade experiments report a second-order correlation well below one, often near 0.1 or lower, in systems where the anharmonicity exceeds the linewidth by a clear margin. The work is a computation, not a laboratory measurement, and it is labelled accordingly. Where the computed result is unfavourable to the device or effect under study, that outcome is reported in the same terms as a favourable one, because a bound that only appears when it is welcome is not a bound at all. All numerical statements in this abstract are reproduced by the deposited script from the stated inputs.