Passive Transmission Lines at Ultimate Clock Frequencies of SFQ Circuits

Tahereh Jabbari, Gleb Krylov, Stephen R. Whiteley +2 more

Superconductive passive transmission lines (PTL) are widely used for signal routing in large-scale rapid single flux quantum (RSFQ) circuits. Due to the imperfect matching of the transmission lines between the driver and receiver, single flux quantum (SFQ) pulses are partially reflected. The round trip propagation time of these reflections can coincide with the following SFQ pulse, resulting in a decrease in bias margins or incorrect circuit behavior. This resonant effect depends upon the length of the PTL and the clock frequency of the signal. A methodology to reduce and manage this effect is the focus of this article. A closed-form expression describing the dependence of the resonance frequency on the length of the PTL is presented. This expression describes a set of forbidden lengths for PTL interconnect segments in RSFQ circuits. The proposed methodology and algorithm insert active PTL-based repeaters into long superconductive interconnect while ensuring the length of the line segment is outside the forbidden region and increasing bias margins.

Takahiro Kawaguchi, Kazuyoshi Takagi, Takagi Naofumi

Kazunori Miyahara, Shuichi Nagasawa, H. Hasegawa +3 more

Y.. Kameda, Shinichi Yorozu, Y. Hashimoto

The introduction of passive-transmission-line (PTL) wiring to large-scale SFQ logic circuits offers several advantages over traditional Josephson-transmission-line (JTL) wiring, such as smaller wiring area, less delay, lower power consumption, and more freedom in routing. PTL wiring can drastically change the style of designing SFQ logic circuits. We propose a new methodology for designing large-scale SFQ circuits using PTL wiring. Aiming at generalizing SFQ circuit design, we chose synchronous clocking. We developed a placer that was suitable for SFQ circuit design to assist us with the new design methodology. The placer first synthesizes an H-tree clock distribution network, placing SFQ pulse splitter cells at each branch. It then places logic cells to minimize the maximum length of data PTL wires, aiming at higher operating speeds. Finally, a router completes the PTL wiring. To evaluate the design methodology we designed an 8-bit general purpose RISC processor. Within twelve hours, we obtained a 15-mm-square SFQ circuit that could operate up to 27.6 GHz. We adopted an advanced Nb process, which was characterized by a critical current density of 10 kA/cm2, two 5-mum-wide PTL wiring layers, and a minimum cell size of 30 mum times 30 mum. The circuit consisted of about 20,000 logic cells, which approximated more than 400,000 Josephson junctions including splitters to distribute the clock signal.

T. Van Duzer, L Zheng, Xiangchao Meng +6 more

Yoshihito Hashimoto

To enable the use of passive transmission lines (PTLs) for the interconnection of single-flux-quantum (SFQ) circuits, we have implemented a driver and a receiver and have developed a method for designing SFQ circuits with passive interconnections. Basic components and properties of passive interconnections, such as the frequency characteristics of the driver and receiver, the PTL delay, and the crosstalk between PTLs, have been experimentally verified. Our developed components and design method have been applied to actual SFQ circuits, such as a 4 x 4 switch having block-to-block passive interconnections and a 2 x 2 switch having gate-to-gate passive interconnections. We have also shown the advantages of PTLs over Josephson transmission lines (JTLs). We also discuss the prospects of SFO circuits having passive interconnections.