Superconducting quantum circuits are a leading hardware candidate for realizing a large-scale fault-tolerant quantum computer. However, scaling superconducting quantum computers will soon approach the physical limits imposed by their cryogenic operating environments. Consequently, interconnects between multiple processor modules will become increasingly necessary for scaling quantum computers. Optical fiber is a particularly promising candidate for these interconnects due to its low loss and negligible thermal noise at room temperature. However, interfacing microwave-frequency superconducting circuits with optical fibers presents several challenges. In this thesis, we present a modular architecture which addresses many of the current challenges in building this interface. We develop an optomechanical quantum transducer which is capable of generating microwave- and optical-frequency photons in pairs, and demonstrate quantum entanglement between these microwave-optical photon pairs. Further, we develop a superconducting qubit module optimized for efficient absorption of itinerant microwave photons, and demonstrate a high-efficiency photon catch protocol. Finally, we connect the superconducting qubit module to the transducer module via a superconducting microwave cable. We drive the microwave-optical photon pair generation process in the transducer module and employ the photon catch protocol in the qubit module to facilitate state transfer between the qubit and the flying microwave photon from the transducer. We observe correlations between the final qubit state and the detection of an optical photon, demonstrating a crucial step toward establishing quantum entanglement between superconducting qubits and light. We discuss ongoing progress and challenges in realizing hybrid entanglement and in extending this approach to entangle remote superconducting qubits over optical networks.
Superconducting quantum circuits are a leading hardware candidate for realizing a large-scale fault-tolerant quantum computer. However, scaling superconducting quantum computers will soon approach the physical limits imposed by their cryogenic operating environments. Consequently, interconnects between multiple processor modules will become increasingly necessary for scaling quantum computers. Optical fiber is a particularly promising candidate for these interconnects due to its low loss and negligible thermal noise at room temperature. However, interfacing microwave-frequency superconducting circuits with optical fibers presents several challenges. In this thesis, we present a modular architecture which addresses many of the current challenges in building this interface. We develop an optomechanical quantum transducer which is capable of generating microwave- and optical-frequency photons in pairs, and demonstrate quantum entanglement between these microwave-optical photon pairs. Further, we develop a superconducting qubit module optimized for efficient absorption of itinerant microwave photons, and demonstrate a high-efficiency photon catch protocol. Finally, we connect the superconducting qubit module to the transducer module via a superconducting microwave cable. We drive the microwave-optical photon pair generation process in the transducer module and employ the photon catch protocol in the qubit module to facilitate state transfer between the qubit and the flying microwave photon from the transducer. We observe correlations between the final qubit state and the detection of an optical photon, demonstrating a crucial step toward establishing quantum entanglement between superconducting qubits and light. We discuss ongoing progress and challenges in realizing hybrid entanglement and in extending this approach to entangle remote superconducting qubits over optical networks.
Superconducting circuits are important technological tools that have found various applications, notably hypothetical future superconducting quantum computers. Scaling such systems further is, however, proving challenging because of thermal heat load and space constraints in cryostats. One way of improving the scalability of such systems would be to resort to optical fibers for controlling the circuits in cryostats, as well as mediating long-distance interaction between them while preserving quantum coherence. Such a strategy relies on building a coherent interface between GHz frequencies and optical frequencies. This interface, referred to as "microwave-optical transducer", would need to exhibit high photon conversion efficiencies and very low added noise, ideally less than a quantum, in a cryogenic environment. Since the prospects of weaving networks of optically connected superconducting quantum processors have now attracted the attention of the scientific community for more than a decade, very efficient transducers have already been proposed and realized. However, despite their impressive performances against selected metrics, often equivalent to optimizing the on-chip conversion efficiency alone, none of the approaches pursued so far really solved the qubit interconnection problems in ways that could be applied to large-scale systems in the near future. The aim of this thesis was to develop transduction approaches that would ultimately enable optical driving of superconducting circuits and quantum state transfer between microwave and optical frequencies, while at the same time ensuring good scalability, both in terms of wafer manufacturability and integration in cryogenic environments. Integrated photonic circuits based on silicon nitride appeared as a promising platform, as silicon nitride is a CMOS-certified material, has a transparency window compatible with optical fibers and lacks two photon absorption. Realizing the coupling between microwave and optical frequencies in a way similar to what is done in optomechanics is desirable, because the field of optomechanics has seen the establishement of techniques that enable control of the low frequency degree of freedom at the quantum mechanical level, including ground state cooling, control of the susceptibility by dynamical backaction, quantum state transfer and entanglement. The heterogeneous integration of nonlinear crystalline thin films, such as lithium niobate and lithium tantalate, onto silicon nitride photonic circuitry endows it with an electro-optic activity that emulates the optomechanical interaction, while offering an inherent access to the microwave degree of freedom. However, material nonlinearities, including photorefraction, charge screening, and hysteresis, introduce complications that motivate exploring alternative approaches. Here, alongside an electro-optic implementation, a transducer that leverages the interaction of bulk acoustic resonances excited by micro-electromechanical systems with whispering-gallery-like modes of microresonators is presented. Coherent transduction between microwave and optical fields is demonstrated, and optomechanical dynamical backaction is observed. The transducers fast bandwidth, compatibility with multiplexing and ability to down-convert microwaves suggest interesting prospects, particularly upon further improvements of the optomechanical coupling.
Superconducting quantum circuits operate at millikelvin temperatures, typically requiring independent microwave cables for each qubit for connecting room-temperature control and readout electronics. However, scaling to large-scale processors hosting hundreds of qubits faces a severe input/output (I/O) bottleneck, as the dense cable arrays impose prohibitive constraints on physical footprint, thermal load, wiring complexity, and cost. Here we demonstrate a complete optical I/O architecture for superconducting quantum circuits, in which all control and readout signals are transmitted exclusively via optical photons. Employing a broadband traveling-wave Brillouin microwave-to-optical transducer, we achieve simultaneous frequency-multiplexed optical readout of two qubits. Combined with fiber-integrated photodiode arrays for control signal delivery, this closed-loop optical I/O introduces no measurable degradation to qubit coherence times, with an optically driven single-qubit gate fidelity showing only a 0.19% reduction relative to standard microwave operation. These results establish optical interconnects as a viable path toward large-scale superconducting quantum processors, and open the possibility of networking multiple superconducting quantum computers housed in separate dilution refrigerators through a centralized room-temperature control infrastructure.
Abstract The quantum transduction, or equivalently quantum frequency conversion, is vital for realizing, e.g., quantum networks and distributed quantum computing. The microwave-to-optical quantum transduction is of interest in the field of superconducting quantum computing, since interconnecting dilution refrigerators is considered inevitable for realizing large-scale quantum computers with fault-tolerance. In this review, we overview recent theoretical and experimental studies on the quantum transduction between microwave and optical photons. We describe a generic theory for the quantum transduction employing the input-output formalism, from which the essential quantities characterizing the transduction, i.e., expressions for the transduction efficiency, added noise, and transduction bandwidth, are derived. We review major transduction methods that have been experimentally demonstrated, including the optomechanical, electro-optic, and ensemble-based transducers. We also briefly review recent experiments on the quantum transduction from superconducting qubit to optical photon, which is an important step toward quantum state transfer between distant superconducting qubits interconnected over optical fibers.
Quantum networks linking quantum computers are predicted to be extremely useful for a wide range of applications. At the hardware level, superconducting quantum computers have emerged as one of the most promising scalable platforms for general quantum computation, and optical networks are clearly the best choice for long distance communication due to their minimal loss. To leverage the strengths of these two dissimilar platforms, quantum transducers, which are reachingquantum-enabled operation, are needed. This thesis presents progress towards designing a long distance optical network which will entangle two superconducting qubits and the implementation of the optical portion of this network. We have found simple, application independent, necessary and sufficient conditions for transducers to work in quantum networks, and we conclude that some previously demonstrated devices are ready for integration into a quantum network. Optimizing the integration of two transducers into a network is explored and it is found that the most robust topology to transmission loss consists of generating optical Gaussian entanglement and then using the two transducers to down-convert this entanglement to the microwave domain. To implement this topology we have constructed a tunable source of optical two-mode squeezing and two ultra-low noise photodetectors. Finally a new method for transferring and distilling Gaussian entanglement to qubits using the dispersive Jaynes-Cummings interaction is presented. This proof-of-principle two-node network should be able to entangle superconducting qubits at a rate of 5 ebits/second over 4 km of optical fiber using currently available technology.
A quantum network that distributes and processes entanglement would enable powerful new computers and sensors. Optical photons with a frequency of a few hundred terahertz are perhaps the only way to distribute quantum information over long distances. Superconducting qubits on the other hand, which are one of the most promising approaches for realizing large-scale quantum machines, operate naturally on microwave photons that have roughly 40,000 times less energy. To network these quantum machines across appreciable distances, we must bridge this frequency gap and learn how to generate entanglement across widely disparate parts of the electromagnetic spectrum. Here we implement and demonstrate a transducer device that can generate entanglement between optical and microwave photons, and use it to show that by detecting an optical photon we add a single photon to the microwave field. We achieve this by using a gigahertz nanomechanical resonance as an intermediary, and efficiently coupling it to optical and microwave channels through strong optomechanical and piezoelectric interactions. We show continuous operation of the transducer with 5% frequency conversion efficiency, and pulsed microwave photon generation at a heralding rate of 15 hertz. Optical absorption in the device generates thermal noise of less than two microwave photons. Joint measurements on optical photons from a pair of transducers would realize entanglement generation between distant microwave-frequency quantum nodes. Improvements of the system efficiency and device performance, necessary to realize a high rate of entanglement generation in such networks are within reach.