Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optica

All-dielectric resonant cavity electro-optic transduction between microwave and telecom

Mihir Khanna, Yang Hu, Thomas Purdy

Published May 29, 2026• 0 citations
Publisher

Abstract

Achieving efficient microwave–optical transduction is a critical challenge for quantum networks where information is shared optically across disparate microwave systems and for coherent optical detection and manipulation of microwave states. Resonant electro-optic systems are being pursued as a means of efficiently bridging these frequencies. Here, we present a platform that employs a bulk lithium niobate crystal whose large dielectric constant creates wavelength-scale confinement of microwave photons. By incorporating this crystal within a high-finesse Fabry–Pérot optical cavity, microwave photons couple to optical photons through the electro-optic effect. We demonstrate the ability to tune our system into triply resonant operation, where microwave photons, optical pump photons, and upconverted optical photons are simultaneously resonant with high quality factor electromagnetic modes of the system. The device achieves photon-number conversion efficiency at the percent level, comparable to that of state-of-the-art devices at room temperature—sufficient to resolve the thermal occupation of the microwave mode—by taking advantage of the high-power handling, low loss, and low noise of all-dielectric devices. These results establish our all-dielectric devices as a promising platform for high-precision sensing of optically detected microwave fields and as a viable route toward single-photon-level microwave–optical quantum transduction.

DOI
10.1364/optica.591190

Related papers

All-Dielectric Resonant Cavity Electro-Optic Transduction Between Microwave and Telecom

Mihir Khanna, Yang Hu, Thomas P. Purdy

We present a resonant electro-optic transducer for efficient conversion between microwave and telecom wavelength photons. Our platform employs a bulk lithium niobate crystal whose large dielectric constant creates wavelength-scale confinement of microwave photons. By incorporating this crystal within a high-finesse Fabry - Perot optical cavity, microwave photons couple to optical photons through the electro-optic effect. We demonstrate the ability to tune our system into triply resonant operation, where microwave photons, optical pump photons, and upconverted optical photons are simultaneously resonant with high quality factor electromagnetic modes of the system. The device achieves photon number conversion efficiency at the percent level, comparable to state-of-the-art devices at room temperature -- sufficient to resolve the thermal occupation of the microwave mode -- while avoiding the noise and loss associated with metal electrodes. These results establish our all-dielectric devices as a promising platform for high-precision sensing of optically detected microwave fields and as a viable route toward single-photon-level microwave - optical quantum transduction.

quant-pharXiv:2601.13199•Jan 20, 2026•0 citations

Methods for microwave characterization of electro-optic crystals for quantum transduction

Silvia Zorzetti, Changqing Wang, I. Gonin +3 more

Microwave-optic quantum transducers are essential devices to develop distributed quantum networks and implement related quantum communication protocols. Three dimensional high-coherence time microwave cavities embedded with electro-optic nonlinear dielectric materials provide promising platforms to boost the efficiency of the microwave-optic frequency conversion. However, so far, the properties for such dielectric crystals operating at milli-Kelvin cryogenic temperatures have not been well understood. Here, we propose a scheme to precisely measure and benchmark the dielectric constant and analyze the dissipation mechanisms of electro-optic materials, such as Lithium Niobate, at the quantum threshold. We will use Fermilab’s three dimensional superconducting cavities with long coherence time. The proposed method of microwave characterization lays the foundations for engineering quantum transduction devices and quantum sensors with high conversion efficiency and fidelity.

IEEE International Conference on Quantum Computing and Engineering (QCE)•Sep 1, 2022•0 citations

Stable, bidirectional electro-optic transduction in thin film lithium tantalate

Christopher J. Axline, Stephan Gamper, Phoebe M. Tengdin +6 more

Efficient and stable microwave-optical transduction is a key enabling technology for distributed superconducting quantum computing and heterogeneous quantum networks. Electro-optic transducers based on thin-film lithium niobate (TFLN) have shown strong promise, but demonstrations to date have been limited by various factors such as low frequency bias drift, low efficiency, fabrication complexity, and scalability. Here we demonstrate the first integrated electro-optic microwave-optical transducers realized in thin-film lithium tantalate (TFLT), a material platform offering Pockels nonlinearity comparable to TFLN together with improved bias stability and high-power handling. We fabricate superconducting microwave resonators coupled to tunable photonic-molecule optical resonators using wafer-scale deep ultraviolet lithography, offering high-throughput production of hundreds of devices per wafer. Across six devices we observe coherent bidirectional conversion between C-band optical photons and 4.9-5.5 GHz microwave photons, with measured on-chip efficiencies and inferred single-photon coupling rates g_0/2π ~ 1 kHz consistent with theory. Continuous operation over multiple days is achieved using a static bias field with minimal feedback, demonstrating a major operational advantage. We further characterize optical loss statistics, microwave resonator performance, and optically induced added noise under pulsed pumping, finding less than one added photon for 100 microsecond pulses at the highest measured efficiencies. These results establish TFLT as a scalable and robust electro-optic platform for future quantum interconnects and modular quantum processors.

quant-pharXiv:2606.12726•Jun 12, 2026•0 citations

Bulk Lithium Niobate Cavity Electro-Optic Transducers

Mihir Khanna, Thomas Purdy

We demonstrate all-dielectric bulk lithium niobate cavity electro-optic transducers achieving 1% microwave to optical photon conversion efficiency at room temperature. We are working toward devices that enable quantum sensing of microwave fields.

•Jan 1, 2026•0 citations

Electro-Optic Cavities for Quantum Transducers

Mihir Khanna, Yang Hu, Thomas Purdy

We explore resonant cavity electro-optic transduction systems, where the electromagnetic field of a small mode volume, high dielectric microwave resonator interacts with a Fabry-Pérot optical cavity filled with LiNbO3 to interconvert microwave and optical photons.

•Jan 1, 2023•0 citations

High-efficiency microwave-optical quantum transduction based on a cavity electro-optic superconducting system with long coherence time

Changqing Wang, I. Gonin, Anna Grassellino +4 more

Abstract Frequency conversion between microwave and optical photons is a key enabling technology to create links between superconducting quantum processors and to realize distributed quantum networks. We propose a microwave-optical transduction platform based on long-coherence time superconducting radio-frequency (SRF) cavities coupled to electro-optic optical cavities to mitigate the loss mechanisms that limit the attainment of high conversion efficiency. We optimize the microwave-optical field overlap and optical coupling losses in the design while achieving long microwave and optical photon lifetime at milli-Kelvin temperatures. This represents a significant enhancement of the transduction efficiency up to 50% under incoming pump power of 140 μW, which allows the conversion of few-photon quantum signals. Furthermore, this scheme exhibits high resolution for optically reading out the dispersive shift induced by a superconducting transmon qubit coupled to the SRF cavity. We also show that low microwave losses enhance the fidelity of heralded entanglement generation between two remote quantum systems. Finally, high precision in quantum sensing can be reached below the standard quantum limit.

arXiv:2206.15467•npj Quantum Information•Dec 21, 2022•36 citations
Achieving efficient microwave–optical transduction is a critical challenge for quantum networks where information is shared optically across disparate microwave systems and for coherent optical detection and manipulation of microwave states. Resonant electro-optic systems are being pursued as a means of efficiently bridging these frequencies. Here, we present a platform that employs a bulk lithium niobate crystal whose large dielectric constant creates wavelength-scale confinement of microwave photons. By incorporating this crystal within a high-finesse Fabry–Pérot optical cavity, microwave photons couple to optical photons through the electro-optic effect. We demonstrate the ability to tune our system into triply resonant operation, where microwave photons, optical pump photons, and upconverted optical photons are simultaneously resonant with high quality factor electromagnetic modes of the system. The device achieves photon-number conversion efficiency at the percent level, comparable to that of state-of-the-art devices at room temperature—sufficient to resolve the thermal occupation of the microwave mode—by taking advantage of the high-power handling, low loss, and low noise of all-dielectric devices. These results establish our all-dielectric devices as a promising platform for high-precision sensing of optically detected microwave fields and as a viable route toward single-photon-level microwave–optical quantum transduction.
We present a resonant electro-optic transducer for efficient conversion between microwave and telecom wavelength photons. Our platform employs a bulk lithium niobate crystal whose large dielectric constant creates wavelength-scale confinement of microwave photons. By incorporating this crystal within a high-finesse Fabry - Perot optical cavity, microwave photons couple to optical photons through the electro-optic effect. We demonstrate the ability to tune our system into triply resonant operation, where microwave photons, optical pump photons, and upconverted optical photons are simultaneously resonant with high quality factor electromagnetic modes of the system. The device achieves photon number conversion efficiency at the percent level, comparable to state-of-the-art devices at room temperature -- sufficient to resolve the thermal occupation of the microwave mode -- while avoiding the noise and loss associated with metal electrodes. These results establish our all-dielectric devices as a promising platform for high-precision sensing of optically detected microwave fields and as a viable route toward single-photon-level microwave - optical quantum transduction.
Microwave-optic quantum transducers are essential devices to develop distributed quantum networks and implement related quantum communication protocols. Three dimensional high-coherence time microwave cavities embedded with electro-optic nonlinear dielectric materials provide promising platforms to boost the efficiency of the microwave-optic frequency conversion. However, so far, the properties for such dielectric crystals operating at milli-Kelvin cryogenic temperatures have not been well understood. Here, we propose a scheme to precisely measure and benchmark the dielectric constant and analyze the dissipation mechanisms of electro-optic materials, such as Lithium Niobate, at the quantum threshold. We will use Fermilab’s three dimensional superconducting cavities with long coherence time. The proposed method of microwave characterization lays the foundations for engineering quantum transduction devices and quantum sensors with high conversion efficiency and fidelity.
Efficient and stable microwave-optical transduction is a key enabling technology for distributed superconducting quantum computing and heterogeneous quantum networks. Electro-optic transducers based on thin-film lithium niobate (TFLN) have shown strong promise, but demonstrations to date have been limited by various factors such as low frequency bias drift, low efficiency, fabrication complexity, and scalability. Here we demonstrate the first integrated electro-optic microwave-optical transducers realized in thin-film lithium tantalate (TFLT), a material platform offering Pockels nonlinearity comparable to TFLN together with improved bias stability and high-power handling. We fabricate superconducting microwave resonators coupled to tunable photonic-molecule optical resonators using wafer-scale deep ultraviolet lithography, offering high-throughput production of hundreds of devices per wafer. Across six devices we observe coherent bidirectional conversion between C-band optical photons and 4.9-5.5 GHz microwave photons, with measured on-chip efficiencies and inferred single-photon coupling rates g_0/2π ~ 1 kHz consistent with theory. Continuous operation over multiple days is achieved using a static bias field with minimal feedback, demonstrating a major operational advantage. We further characterize optical loss statistics, microwave resonator performance, and optically induced added noise under pulsed pumping, finding less than one added photon for 100 microsecond pulses at the highest measured efficiencies. These results establish TFLT as a scalable and robust electro-optic platform for future quantum interconnects and modular quantum processors.
Abstract Frequency conversion between microwave and optical photons is a key enabling technology to create links between superconducting quantum processors and to realize distributed quantum networks. We propose a microwave-optical transduction platform based on long-coherence time superconducting radio-frequency (SRF) cavities coupled to electro-optic optical cavities to mitigate the loss mechanisms that limit the attainment of high conversion efficiency. We optimize the microwave-optical field overlap and optical coupling losses in the design while achieving long microwave and optical photon lifetime at milli-Kelvin temperatures. This represents a significant enhancement of the transduction efficiency up to 50% under incoming pump power of 140 μW, which allows the conversion of few-photon quantum signals. Furthermore, this scheme exhibits high resolution for optically reading out the dispersive shift induced by a superconducting transmon qubit coupled to the SRF cavity. We also show that low microwave losses enhance the fidelity of heralded entanglement generation between two remote quantum systems. Finally, high precision in quantum sensing can be reached below the standard quantum limit.