Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Fiber Lasers: Technology and Systems

871nm single-frequency fiber laser source for quantum computing applications

Khawlah AlYahyaei, Xiushan Zhu, Nasser N. Peyghambarian, Robert A. Norwood

Published Jan 15, 2026• 0 citations
Publisher
DOI
10.1117/12.3081724

Related papers

Native 780 nm all-fiber laser system for quantum sensing

Brian L. Kasch

Optical and Quantum Sensing and Precision Metrology II•Mar 9, 2022•0 citations

Comparative study of squeezed vacuum states prepared by using 1064-nm solid-state and fiber-laser as pump source

Wenhai Yang, Wenting Diao, Chun-Xiao Cai +4 more

Squeezed states, which have fewer fluctuations in one quadrature than vacuum noise at the expense of increasing fluctuations in the other quadrature, can be used to enhance measurement accuracy, increase detection sensitivity, and improve fault tolerance performance for quantum information and quantum computation. In this paper, the influences of relative intensity noise (RIN) of all-solid-state single-frequency laser and single-frequency fiber laser on the squeezing factor of squeezed vacuum states are experimentally and theoretically studied. Here, an all-solid-state single-frequency laser and a single-frequency fiber laser each are used as a light source of the system generating squeezed vacuum states. The homodyne detection is used to compare the RIN of all-solid-state single-frequency laser and that of single-frequency fiber laser at the analysis frequency of 1 MHz. The results show that the RIN of the all-solid-state single-frequency laser and single-frequency fiber laser are higher than those of the shot noise limitation 2.3 dB and 30 dB at the analysis frequency of 1 MHz, respectively. The RIN of all-solid-state single-frequency laser is far less than that of the single-frequency fiber laser. As a result, squeezed vacuum state with maximum quantum noise reduction of (13.2 ± 0.2) dB and (10 ± 0.2) dB are directly detected. Theoretical calculation shows that the influence of the RIN on the measurement accuracy is the major factor of degrading the squeezing factor with the fiber laser as the pump source. The measurement error of squeezed vacuum state caused by the RIN of single-frequency fiber laser is about 2.6 dB. The discrepancy of the pump power between the two lasers is another factor of affecting the squeezing factor, corresponding to 0.6 dB quantum noise difference. The theoretical calculations are consistent with the experimental results, which provides some guidance for developing the practical squeezed states with highly squeezing level.

Acta Physica Sinica•Jan 1, 2019•0 citations

High-power 1762 nm single-frequency fiber laser system for trapped barium ion qubits

Andrei Fedotov, Iuliia Zalesskaia, Petteri Uusimaa

Quantum Computing, Communication, and Simulation•Mar 19, 2025•0 citations

Fiber laser-pumped Ti:sapphire laser with ultra-low-intensity noise and frequency stabilization for quantum precision measurement applications

Yingjie Ma, Yutong Wang, Xinxiu Zhou +2 more

We developed a fiber-laser-pumped Ti:sapphire laser system designed for quantum precision measurement applications. By employing a 35 W single-frequency 532 nm fiber laser as the pump source, the system delivered continuous-wave output powers of 4.12 W at 770.108 nm (D 1 line, K), 4.72 W at 780.244 nm (D 2 line, Rb), and 5.29 W at 794.982 nm (D 1 line, Rb), thereby fulfilling the requirements for optical pumping and probing of alkali atoms. To enhance frequency stability, saturated absorption spectroscopy was used to lock the laser frequency, resulting in frequency drifts below 1 MHz over two hours. Furthermore, since low-frequency intensity noise (DC-100 Hz) critically affects spin-relaxation-free quantum sensing, we carried out a theoretical analysis which identified the pump laser as the dominant noise source. By implementing feedback control to the pump source as well as an external noise suppression, both methods achieved over 30 dB of intensity noise suppression within the DC-4kHz frequency range. In addition, improved beam pointing stability further reduced noise below 3 Hz. These results collectively demonstrate the system’s strong potential for quantum sensing applications.

Optics Express•Aug 19, 2025•4 citations

Femtosecond fiber lasers for various aspects of quantum technologies

Jun Tan, Ben Stein, Benjamin Sprenger +2 more

Photonics Russia•Jan 1, 2018•0 citations

Spectral characterization of a narrow linewidth, single-frequency 780 nm fiber laser source for atom cooling applications

Alain Mugnier, E. Lemercier, R. Lebref +2 more

We propose and experiment in the following an alternative method for laser linewidth determination at 780 nm based on frequency noise spectrum measurement.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2011•0 citations
Squeezed states, which have fewer fluctuations in one quadrature than vacuum noise at the expense of increasing fluctuations in the other quadrature, can be used to enhance measurement accuracy, increase detection sensitivity, and improve fault tolerance performance for quantum information and quantum computation. In this paper, the influences of relative intensity noise (RIN) of all-solid-state single-frequency laser and single-frequency fiber laser on the squeezing factor of squeezed vacuum states are experimentally and theoretically studied. Here, an all-solid-state single-frequency laser and a single-frequency fiber laser each are used as a light source of the system generating squeezed vacuum states. The homodyne detection is used to compare the RIN of all-solid-state single-frequency laser and that of single-frequency fiber laser at the analysis frequency of 1 MHz. The results show that the RIN of the all-solid-state single-frequency laser and single-frequency fiber laser are higher than those of the shot noise limitation 2.3 dB and 30 dB at the analysis frequency of 1 MHz, respectively. The RIN of all-solid-state single-frequency laser is far less than that of the single-frequency fiber laser. As a result, squeezed vacuum state with maximum quantum noise reduction of (13.2 ± 0.2) dB and (10 ± 0.2) dB are directly detected. Theoretical calculation shows that the influence of the RIN on the measurement accuracy is the major factor of degrading the squeezing factor with the fiber laser as the pump source. The measurement error of squeezed vacuum state caused by the RIN of single-frequency fiber laser is about 2.6 dB. The discrepancy of the pump power between the two lasers is another factor of affecting the squeezing factor, corresponding to 0.6 dB quantum noise difference. The theoretical calculations are consistent with the experimental results, which provides some guidance for developing the practical squeezed states with highly squeezing level.
We developed a fiber-laser-pumped Ti:sapphire laser system designed for quantum precision measurement applications. By employing a 35 W single-frequency 532 nm fiber laser as the pump source, the system delivered continuous-wave output powers of 4.12 W at 770.108 nm (D 1 line, K), 4.72 W at 780.244 nm (D 2 line, Rb), and 5.29 W at 794.982 nm (D 1 line, Rb), thereby fulfilling the requirements for optical pumping and probing of alkali atoms. To enhance frequency stability, saturated absorption spectroscopy was used to lock the laser frequency, resulting in frequency drifts below 1 MHz over two hours. Furthermore, since low-frequency intensity noise (DC-100 Hz) critically affects spin-relaxation-free quantum sensing, we carried out a theoretical analysis which identified the pump laser as the dominant noise source. By implementing feedback control to the pump source as well as an external noise suppression, both methods achieved over 30 dB of intensity noise suppression within the DC-4kHz frequency range. In addition, improved beam pointing stability further reduced noise below 3 Hz. These results collectively demonstrate the system’s strong potential for quantum sensing applications.