Single photon sources use anti-bunched light to produce single photons, and in this article an application is described. With a light emitter diode (LED) as a low cost single photon source using weak light coherent pulses, the appropriate use of radiofrequency (RF) circuits to control the LED depletion zone, it could achieve an emission of optical pulses appropriat to the electrical pulses in the LED excitation to generate single photons. Nevertheless, the switching circuits for the LED control fail when the time of commutation is under 10ns, which then provokes a non-desired photon emission. This experiment shows that a controlled LED can generate a single photon.
Single photon sources use anti-bunched light to produce single photons, and in this article an application is described. With a light emitter diode (LED) as a low cost single photon source using weak light coherent pulses, the appropriate use of radiofrequency (RF) circuits to control the LED depletion zone, it could achieve an emission of optical pulses appropriat to the electrical pulses in the LED excitation to generate single photons. Nevertheless, the switching circuits for the LED control fail when the time of commutation is under 10ns, which then provokes a non-desired photon emission. This experiment shows that a controlled LED can generate a single photon.
Among various implementations of single-photon sources, faint-pulse single-photon sources provide a simple and practical approach based on attenuated coherent laser pulses. This work presents an experimental realization of a faint-pulse single-photon source using a 785-nm Grating Stabilized Laser Diode system, driven by a laser diode controller and modulated by a Field Programmable Gate Array (FPGA). The system's performance was evaluated by analyzing the photon detection rate as a function of pulse width and driving current. Results indicated a linear relationship between the single-photon detection rate and pulse width and an exponential dependence on driving current. The system achieved a photon emission probability of 10% per pulse, aligning with the requirements of practical quantum key distribution systems. This implementation demonstrates a cost-effective, scalable, and accessible platform for single-photon experiments, providing a foundation for future implementations of quantum communication protocols.
The generation of non-classical states of light [1] is an important scientific challenge with many potential applications. For example, squeezed states of light [2] have generated much interest in the past decade, because measurements can be performed with noise levels that are lower than those available with classical light. A particularly novel non-classical source of light is a triggered single-photon source: a source that has the property to emit with a high degree of certainty one (and only one) photon at a user-specified time. Such a deterministic source of single photons can be important for quantum information processing [3], quantum cryptography [4] and certain quantum computation problems [5]. A single quantum emitter such as a molecule or an atom is a good potential source because it can emit only one photon at a time. The emitted light is antibunched [6, 7] and consists of single photons separated by random time intervals, which depend on the excited state lifetime and on the pumping rate. Thus triggered emission of single photons can be obtained with controlled excitation of a single emitter. The first demonstration of a single photons source [8] using a single molecule in a solid is based on a rapid adiabatic passage method [9] to excite the molecule. In the effective spin picture, the Bloch vector follows the driving magnetic field adiabatically if the laser-molecule frequency detuning is swept slowly through the resonance. Since the passage inverts the field, the system goes from the ground to the excited state. From this fluorescent state the molecule can emit only a single photon. The molecular resonance is swept by Stark effect at fixed laser frequency. This is done easily by applying a radio frequency electric field to the molecule. The results showed photon states with statistics that differ radically from those of coherent states. But this method requires cryogenic temperatures (2K) since narrow zero phonon lines are needed for the adiabatic following. At room temperature a source of triggered single photons based on the concept of pulsed optical excitation of a single highly fluorescent molecule has been demonstrated [10]. A short pulse of green laser light pumps the molecule from the ground state to a vibronically excited level of the first electronic excited state. After fast (ps) relaxation to the lowest electronic excited state, the molecule subsequently emits a single photon. A frequency-doubled mode-locked Nd-YAG laser is used to pump highly stable single terrylene molecules contained in a p-terphenyl molecular crystal where they are protected from exposure to diffusing quenchers (such as oxygen). The result shows that the photons are emitted after the laser pulses at times separated by the laser repetition time within the lifetime of terrylene in p-terphenyl. Since the pump pulse width is very short compared to the fluorescence lifetime, the probability of two (or more) photon emission per pulse is always zero. At the maximum laser power, 90% of the laser pulses lead to a single photon emission. The parameters of this source (repetition rate and single photon generation probability) were limited only by the laser system used; nevertheless, this performance already surpasses that of previous work. The high performance combined with the vanishing two photon emission probability and the simplicity of this source suggests that it can be considered for a variety of quantum optical experiments and for secure quantum cryptography [11]. Semiconductor quantum dots (QD) are other potential systems for single photon generation [12]. QDs are often referred to as “artificial atoms” because many of their optical properties, such as ultranarrow transitions, arise from discrete, atomic-like energy levels [13, 14]. To reinforce this analogy a study of the photon antibunching in this system was needed. QDs differ from atoms and molecules since the creation of multiple excitons is possible in QDs. Consequently, if two electron-hole pairs can radiatively recombine, the simultaneous emission of two photons from a QD is then possible. Thus different regimes of photon statistics were expected because the probability of multiple exciton creation depends on excitation intensity. The fluorescence intensity correlation function of a single CdSe quantum dot has been investigated [15] using a coincidence setup (start-stop experiment). A strong photon antibunching has been observed over a large range of intensities (0.1-100 kW/cm2). The lack of coincidence at zero time delay indicates a highly efficient Auger ionization process [16], which suppresses multi-photon emission in these colloidal quantum dots. This result shows that room temperature single photon sources can be achieved with colloidal nanoparticles.
Abstract A simple short-pulse generator circuit based on electronic gates is designed for short electric pulse of about 12 ns at Full Width at Half Maximum (FWHM) and 3.6 Volt amplitude for driving a laser diode. Using our circuit with a 780 nm laser diode designed and fabricated for producing short light pulses. The circuit utilizes an AND gate, a XOR gate, and a common function generator, provides a repetition rate from DC up to 1 MHz. The laser pulses were generated and then detected via an avalanche photodiodes (APD). This finding can benefit the field of light-based quantum information including single photon experiments.
Sources of entangled pairs of photons can be used for encoding signals in quantum-encrypted communications, allowing a sender, Alice, and a receiver, Bob, to exchange keys without the possibility of eavesdropping. In fact, any quantum information system would require single and entangled photons to serve as qubits. For this purpose, semiconductor quantum dots (QD) have been extensively studied for their ability to produce entangled light and function as single photon sources. The quality of such sources is evaluated based on three criteria: high efficiency, small multi-photon probability, and quantum indistinguishability. In this work, a simple quantum dot-based LED (E-LED) was used as a quantum light source for on-demand emission, indicating the potential for use as quantum information devices. Limitations of the device include the fine-structure splitting of the quantum dot excitons, their coherence lengths and charge carrier interactions in the structure. The quantum dot-based light emitting diode was initially shown to operate in pulsed mode under AC bias frequencies of up to several hundreds of MHz, without compromising the quality of emission. In a Hong-ou-Mandel interference type experiment, the quantum dot photons were shown to interfere with dissimilar photons from a laser, achieving high two-photon interference (TPI) visibilities. Quantum entanglement from a QD photon pair was also measured in pulsed mode, where the QD-based entangled-LED (E-LED) was electrically injected at a frequency of 203 MHz. After verifying indistinguishability and good entanglement properties from the QD photons under the above conditions, a quantum relay over 1km of fibre was demonstrated, using input qubits from a laser source. The average relay fidelity was high enough to allow for error correction for this BB84-type scheme. To improve the properties of the QD emission, an E-LED was developed based on droplet epitaxy (D-E) QDs, using a different QD growth technique. The relevant chapter outlines the process of QD growth and finally demonstration of quantum entanglement from an electrically injected diode, yielding improvements compared to previous E-LED devices. For the same reason, an alternative method of E-LED operation based on resonant two-photon excitation of the QD was explored. Analysis of Rabi oscillations in a quantum dot with a bound exciton state demonstrated coupling of the ground state and the biexciton state by the external oscillating field of a laser, therefore allowing the transition between the two states. The results include a considerable improvement in the coherence length of the QD emission, which is crucial for future quantum network applications. We believe that extending this research can find application in quantum cryptography and in realising the interface of a quantum network, based on semiconductor nanotechnology.
On demand single-photon and entangled-photon sources are key building-blocks for many proposed photonic quantum technologies. For practical device applications, epitaxially grown quantum dots (QDs) are of increasing importance due to their bright photon emission with sharp line width. Particularly, they are solid-state systems and can be easily embedded within a light-emitting diode (LED) to achieve electrically driven sources. Therefore, one would expect a full-fledged optoelectronic quantum network that is running on macroscopically separated, QD-based single- and entangled-photon devices. An all-electrically operated wavelength-tunable on demand single-photon source (SPS) is demonstrated first. The device consists of a LED in the form of self-assembled InGaAs QDs containing nanomembrane integrated onto a piezoelectric crystal. Triggered single photons are generated via injection of ultra-short electrical pulses into the diode, while their energy can be precisely tuned over a broad range of about 4.8 meV by varying the voltage applied to the piezoelectric crystal. High speed operation of this single-photon emitting diode up to 0.8 GHz is demonstrated. In the second part of this thesis, a fast strain-tunable entangled-light-emitting diode (ELED) is demonstrated. It has been shown that the fine structure splitting of the exciton can be effectively overcome by employing a specific anisotropic strain field. By injecting ultra-fast electrical pulses to the diode, electrically triggered entangled-photon emission with high degree of entanglement is successfully realized. A statistical investigation reveals that more than 30% of the QDs in the strain-tunable quantum LED emit polarization-entangled photon-pairs with entanglement-fidelities up to f+ = 0.83(5). Driven at the highest operation speed ever reported so far (400 MHz), the strain-tunable quantum LED emerges as unique devices for high-data rate entangled-photon applications. In the end of this thesis, on demand and wavelength-tunable LH single-photon emission from strain engineered GaAs QDs is demonstrated. Fourier-transform spectroscopy is performed, from which the coherence time of the LH single-photon emission is studied. It is envisioned that this new type of LH exciton-based SPS can be applied to realize an all-semiconductor based quantum interface in the foreseeable distributed quantum networks.
Linear quantum computation and teleportation requires interference of two single photons pulses. These photons must be indistinguishable i.e. must have same pulse width, arrival time etc. Moreover, "if the radiative transition between two quantum states of a single emitter is broadened due to spontaneous emission, single photon pulse width is Fourier transform limited" and can generate indistinguishable photons[4]. Resonant fluorescence does not have any jitter in photon emission due to the absence of non-radiative relaxation process. "Nonclassical light can be generated by resonant excitation of individual emitters to scatter single photon with coherence property determine by laser source". This creates a prototype quantum optical circuit and provide a test bed for all optical generation, distribution, and detection of nonclassical light on a common photonic chip for semiconductor based photonic information technology[Reithmaier et al.]. Moreover, resonance fluorescence is used in high fidelity readout of trapped ion qubits, and "resonant coherent excitation on quantum dot has proven to be very efficient for achieving on high degree of indistinguishability and coherence"[4].