Sources of entangled pairs of photons can be used for encoding signals in quantum-encrypted communications, allowing a sender, Alice, and a receiver, Bob, to exchange keys without the possibility of eavesdropping. In fact, any quantum information system would require single and entangled photons to serve as qubits. For this purpose, semiconductor quantum dots (QD) have been extensively studied for their ability to produce entangled light and function as single photon sources. The quality of such sources is evaluated based on three criteria: high efficiency, small multi-photon probability, and quantum indistinguishability. In this work, a simple quantum dot-based LED (E-LED) was used as a quantum light source for on-demand emission, indicating the potential for use as quantum information devices. Limitations of the device include the fine-structure splitting of the quantum dot excitons, their coherence lengths and charge carrier interactions in the structure. The quantum dot-based light emitting diode was initially shown to operate in pulsed mode under AC bias frequencies of up to several hundreds of MHz, without compromising the quality of emission. In a Hong-ou-Mandel interference type experiment, the quantum dot photons were shown to interfere with dissimilar photons from a laser, achieving high two-photon interference (TPI) visibilities. Quantum entanglement from a QD photon pair was also measured in pulsed mode, where the QD-based entangled-LED (E-LED) was electrically injected at a frequency of 203 MHz. After verifying indistinguishability and good entanglement properties from the QD photons under the above conditions, a quantum relay over 1km of fibre was demonstrated, using input qubits from a laser source. The average relay fidelity was high enough to allow for error correction for this BB84-type scheme. To improve the properties of the QD emission, an E-LED was developed based on droplet epitaxy (D-E) QDs, using a different QD growth technique. The relevant chapter outlines the process of QD growth and finally demonstration of quantum entanglement from an electrically injected diode, yielding improvements compared to previous E-LED devices. For the same reason, an alternative method of E-LED operation based on resonant two-photon excitation of the QD was explored. Analysis of Rabi oscillations in a quantum dot with a bound exciton state demonstrated coupling of the ground state and the biexciton state by the external oscillating field of a laser, therefore allowing the transition between the two states. The results include a considerable improvement in the coherence length of the QD emission, which is crucial for future quantum network applications. We believe that extending this research can find application in quantum cryptography and in realising the interface of a quantum network, based on semiconductor nanotechnology.
Sources of entangled pairs of photons can be used for encoding signals in quantum-encrypted communications, allowing a sender, Alice, and a receiver, Bob, to exchange keys without the possibility of eavesdropping. In fact, any quantum information system would require single and entangled photons to serve as qubits. For this purpose, semiconductor quantum dots (QD) have been extensively studied for their ability to produce entangled light and function as single photon sources. The quality of such sources is evaluated based on three criteria: high efficiency, small multi-photon probability, and quantum indistinguishability. In this work, a simple quantum dot-based LED (E-LED) was used as a quantum light source for on-demand emission, indicating the potential for use as quantum information devices. Limitations of the device include the fine-structure splitting of the quantum dot excitons, their coherence lengths and charge carrier interactions in the structure. The quantum dot-based light emitting diode was initially shown to operate in pulsed mode under AC bias frequencies of up to several hundreds of MHz, without compromising the quality of emission. In a Hong-ou-Mandel interference type experiment, the quantum dot photons were shown to interfere with dissimilar photons from a laser, achieving high two-photon interference (TPI) visibilities. Quantum entanglement from a QD photon pair was also measured in pulsed mode, where the QD-based entangled-LED (E-LED) was electrically injected at a frequency of 203 MHz. After verifying indistinguishability and good entanglement properties from the QD photons under the above conditions, a quantum relay over 1km of fibre was demonstrated, using input qubits from a laser source. The average relay fidelity was high enough to allow for error correction for this BB84-type scheme. To improve the properties of the QD emission, an E-LED was developed based on droplet epitaxy (D-E) QDs, using a different QD growth technique. The relevant chapter outlines the process of QD growth and finally demonstration of quantum entanglement from an electrically injected diode, yielding improvements compared to previous E-LED devices. For the same reason, an alternative method of E-LED operation based on resonant two-photon excitation of the QD was explored. Analysis of Rabi oscillations in a quantum dot with a bound exciton state demonstrated coupling of the ground state and the biexciton state by the external oscillating field of a laser, therefore allowing the transition between the two states. The results include a considerable improvement in the coherence length of the QD emission, which is crucial for future quantum network applications. We believe that extending this research can find application in quantum cryptography and in realising the interface of a quantum network, based on semiconductor nanotechnology.
Semiconductor Quantum dots are potentially an attractive source of non-classical light. They can confine bound electron-hole pairs, excitons, in all three spatial dimensions giving them discrete optical emission energies, much like the electronic states in atomic systems. The semiconductor nature of the system allows quantum dots to be integrated into complicated device structures including optical cavities [1] and electrical injection [2]. The radiative exciton emission from a semiconductor quantum dot can provide the simplest form of quantum light, a single photon source [2]. The finite re-excitation time following the radiative decay of an exciton in a quantum dot prevents the dot from emitting more than one photon if excited with a short optical or electronic pulse. In a similar fashion excitation of the biexciton state, consisting of two electrons and holes, in the quantum dot results in the emission of a pair of photons at the energy of the biexciton and exciton transitions. The biexciton state was, in fact, proposed as a possible source of polarisation-entangled photons in 2000 by Benson et al. [3] as it consists of two polarisation-correlated decay paths which could potentially be indistinguishable. The condition of indistinguishability is fundamental to the generation of entangled photons and is, in general, not true of the two decay paths from the biexciton state in a quantum dot; physical anisotropy causes the intermediate exciton states to hybridise and separate in energy providing ‘which-path’ information about the route taken through the biexciton decay. We demonstrate how the splitting between the intermediate exciton states in a single InAs quantum dot can be controlled by growth [4], rapid thermal annealing [5] and the application of an external magnetic field [6]. Each of these three techniques can be used to make the intermediate exciton states degenerate allowing the biexciton decay to produce singe pairs of entangled photons triggered by short laser pulses [7,8]. Entangled photon pair sources are essential for applications such as entanglement based quantum key distribution, and optical quantum computing. For these applications it is important that no more than one entangled photon pair is generated in a cycle, a requirement met by our quantum dot source which is not possible with traditional methods for generating entangled pairs of photons. Entanglement also enables quantum interferometry and metrology, the basis of image resolution beyond that possible with equivalent classical light. Biphoton interferometry using entangled emission from the biexciton decay reveals fringes with half the period of classical light [9], and less that that of the laser. In addition, interferometry suggests that this type of entangled light source is not limited by decoherence, we fine the biphoton is surprising robust against dephasing, in stark contrast to the devastating effect of decoherence upon single photons emitted by similar structures.
On demand single-photon and entangled-photon sources are key building-blocks for many proposed photonic quantum technologies. For practical device applications, epitaxially grown quantum dots (QDs) are of increasing importance due to their bright photon emission with sharp line width. Particularly, they are solid-state systems and can be easily embedded within a light-emitting diode (LED) to achieve electrically driven sources. Therefore, one would expect a full-fledged optoelectronic quantum network that is running on macroscopically separated, QD-based single- and entangled-photon devices. An all-electrically operated wavelength-tunable on demand single-photon source (SPS) is demonstrated first. The device consists of a LED in the form of self-assembled InGaAs QDs containing nanomembrane integrated onto a piezoelectric crystal. Triggered single photons are generated via injection of ultra-short electrical pulses into the diode, while their energy can be precisely tuned over a broad range of about 4.8 meV by varying the voltage applied to the piezoelectric crystal. High speed operation of this single-photon emitting diode up to 0.8 GHz is demonstrated. In the second part of this thesis, a fast strain-tunable entangled-light-emitting diode (ELED) is demonstrated. It has been shown that the fine structure splitting of the exciton can be effectively overcome by employing a specific anisotropic strain field. By injecting ultra-fast electrical pulses to the diode, electrically triggered entangled-photon emission with high degree of entanglement is successfully realized. A statistical investigation reveals that more than 30% of the QDs in the strain-tunable quantum LED emit polarization-entangled photon-pairs with entanglement-fidelities up to f+ = 0.83(5). Driven at the highest operation speed ever reported so far (400 MHz), the strain-tunable quantum LED emerges as unique devices for high-data rate entangled-photon applications. In the end of this thesis, on demand and wavelength-tunable LH single-photon emission from strain engineered GaAs QDs is demonstrated. Fourier-transform spectroscopy is performed, from which the coherence time of the LH single-photon emission is studied. It is envisioned that this new type of LH exciton-based SPS can be applied to realize an all-semiconductor based quantum interface in the foreseeable distributed quantum networks.
Semiconductor quantum dots (QDs) are well established as sub-Poissonian sources of entangled photon pairs. To improve the utility of a QD light source, it would be advantageous to extend their emission further into the near infrared, into the low absorption wavelength windows utilised in long-haul optical telecommunication. Initial experiments succeeded in interfering O-band (1260—1360 nm) photons from an InAs/GaAs QD with dissimilar photons from a laser, an important mechanism for quantum teleportation. Interference visibilities as high as 60 ± 6 % were recorded, surpassing the 50 % threshold imposed by classical electrodynamics. Later, polarisation-entanglement of a similar QD was observed, with pairs of telecom-wavelength photons from the radiative cascade of the biexciton state exhibiting fidelities of 92.0 ± 0.2 % to the Bell state. Subsequently, an O-band telecom-wavelength quantum relay was realised. Again using an InAs/GaAs QD device, this represents the first implementation of a sub-Poissonian telecom-wavelength quantum relay, to the best knowledge of the author. The relay proved capable of implementing the famous four-state BB84 protocol, with a mean teleportation fidelity as high as 94.5 ± 2.2 %, which would contribute 0.385 secure bits per teleported qubit. After characterisation by way of quantum process tomography, the performance of the relay was also evaluated to be capable of implementing a six-state QKD protocol. In an effort to further extend the emitted light from a QD into the telecom C-band (1530—1565 nm), alternative material systems were investigated. InAs QDs on a substrate of InP were shown to emit much more readily in the fibre-telecom O- and C-bands than their InAs/GaAs counterparts, largely due to the reduced lattice mismatch between the QD and substrate for InAs/InP (~3 %) compared to InAs/GaAs (~7 %). Additionally, to minimize the fine structure splitting (FSS) of the exciton level, which deteriorates the observed polarisation-entanglement, a new mode of dot growth was investigated. Known as droplet epitaxy (D-E), QDs grown in this mode showed a fourfold reduction in the FSS compared to dots grown in the Stranski-Krastanow mode. This improvement would allow observation of polarisation-entanglement in the telecom C-band. In subsequent work performed by colleagues at the Toshiba Cambridge Research Labs, these D-E QDs were embedded in a p-i-n doped optical cavity, processed with electrical contacts, and found to emit entangled pairs of photons under electrical excitation. The work of this thesis provides considerable technological advances to the field of entangled-light sources, that in the near future may allow for deterministic quantum repeaters operating at megahertz rates, and in the further future could facilitate the distribution of coherent multipartite states across a distributed quantum network.
Quantum communication networks are formed of secure links, where information can be transmitted with security guaranteed by the quantum nature of light. An essential building block of such a network is a source of single photons and entangled photon pairs, compatible with the low-loss fibre telecom window around 1550 nm. Previous work based on semiconductor quantum dots (QDs), colour centres in diamond and single atoms has been limited by emission wavelengths unsuitable for long distance applications. Efforts have been made to use standard gallium arsenide based QDs by extending their operating wavelength range, however, electrically driven quantum light emission from quantum dots in this telecommunication window has not yet been demonstrated. In this work, indium phosphide based QD devices have been developed to address this problem. The industry favoured growth method, metalorganic vapour phase epitaxy (MOVPE), has been used to create droplet QDs with low fine structure splitting (FSS). This growth scheme allows us to produce the first optoelectronic devices for single and entangled photon emission in the 1550 nm telecom window. We show single-photon emission with multi-photon events suppressed to 0.11±0.02. Furthermore, we obtain entangled light from the biexciton cascade with a maximum fidelity of 0.87± 0.04 which is sufficient for error correction protocols. We also show extended device operating temperature up to 93 K, allowing operation with liquid nitrogen or simple closed-cycle coolers. Our device can be directly integrated with existing long distance quantum communication, cryptography and quantum relay systems providing a new platform for developing quantum networks.
Abstract Quantum cryptography allows confidential information to be communicated between two parties, with secrecy guaranteed by the laws of nature alone. However, upholding guaranteed secrecy over networks poses a further challenge, as classical receive-and-resend routing nodes can only be used conditional of trust by the communicating parties, which arguably diminishes the value of the underlying quantum cryptography. Quantum relays offer a potential solution by teleporting qubits from a sender to a receiver, without demanding additional trust from end users. Here we demonstrate the operation of a quantum relay over 1 km of optical fibre, which teleports a sequence of photonic quantum bits to a receiver by utilising entangled photons emitted by a semiconductor light-emitting diode. The average relay fidelity of the link is 0.90±0.03, exceeding the classical bound of 0.75 for the set of states used, and sufficiently high to allow error correction. The fundamentally low multiphoton emission statistics and the integration potential of the source present an appealing platform for future quantum networks.