The key components in superconducting quantum computing architectures are qubits, couplers, microwave elements and low-noise amplifiers among others. In a variety of these subsystems, nonlinear circuit elements are an essential ingredient which enables their functionality. In this thesis, we study two different superconducting elements used to implement nonlinear capacitors. First we simulated a novel Josephson-junction-based tuneable nonlinear capacitor to couple flux qubits. Such a device implements a YY interaction, which has the potential to enhance the performance and extend the capabilities of current generation quantum annealers. We show that the interaction strength of the YY coupling is on the order of MHz and tuneable across zero. We discuss experimental realisations of this device to verify its function. Next, we present our study of a low temperature parametric amplifier utilizing the nonlinear capacitance of quantum phase-slip nanowires. We have fabricated a single-nanowire and two-nanowire variants which shunt a quarter-wavelength superconducting coplanar waveguide resonator. We characterised the nonlinear properties of the first variant such as the power-dependent resonance frequency, idler generation and signal gain, while in the second variant we developed a lock-in detection method to investigate the gate voltage response and demonstrate that the device acts as a gate-voltage-tuneable resonator. We also report on the progress towards a fabrication process for sputtered Al overlap junctions in the LCN cleanroom. Back-sputter and in-situ oxide growth techniques are developed as an alternative to shadow evaporation. These techniques are better suited for large-scale integration as they do not rely on angular deposition, but they require better control over the interfaces due to patterning the two electrodes separately. We characterised the processes using resistance measurements and characterised their low temperature properties. We show that our junctions exhibit overdamped dynamics and the critical current is suppressed with RF radiation.
The key components in superconducting quantum computing architectures are qubits, couplers, microwave elements and low-noise amplifiers among others. In a variety of these subsystems, nonlinear circuit elements are an essential ingredient which enables their functionality. In this thesis, we study two different superconducting elements used to implement nonlinear capacitors. First we simulated a novel Josephson-junction-based tuneable nonlinear capacitor to couple flux qubits. Such a device implements a YY interaction, which has the potential to enhance the performance and extend the capabilities of current generation quantum annealers. We show that the interaction strength of the YY coupling is on the order of MHz and tuneable across zero. We discuss experimental realisations of this device to verify its function. Next, we present our study of a low temperature parametric amplifier utilizing the nonlinear capacitance of quantum phase-slip nanowires. We have fabricated a single-nanowire and two-nanowire variants which shunt a quarter-wavelength superconducting coplanar waveguide resonator. We characterised the nonlinear properties of the first variant such as the power-dependent resonance frequency, idler generation and signal gain, while in the second variant we developed a lock-in detection method to investigate the gate voltage response and demonstrate that the device acts as a gate-voltage-tuneable resonator. We also report on the progress towards a fabrication process for sputtered Al overlap junctions in the LCN cleanroom. Back-sputter and in-situ oxide growth techniques are developed as an alternative to shadow evaporation. These techniques are better suited for large-scale integration as they do not rely on angular deposition, but they require better control over the interfaces due to patterning the two electrodes separately. We characterised the processes using resistance measurements and characterised their low temperature properties. We show that our junctions exhibit overdamped dynamics and the critical current is suppressed with RF radiation.
With a large portfolio of elemental quantum components, superconducting quantum circuits have contributed to dramatic advances in microwave quantum optics. Of these elements, quantum-limited parametric amplifiers have proven to be essential for low noise readout of quantum systems whose energy range is intrinsically low (tens of µeV). They are also used to generate non classical states of light that can be a resource for quantum enhanced detection. Superconducting parametric amplifiers, like quantum bits, typically utilize a Josephson junction as a source of magnetically tunable and dissipation-free nonlinearity. The magnetic control is not an industry standard for devices and starts already to be an issue in large scale circuits. In recent years, efforts have been made to introduce semiconductor weak links as electrically tunable nonlinear elements, with demonstrations of microwave resonators and quantum bits using semiconductor nanowires, a two dimensional electron gas, carbon nanotubes and graphene. However, given the challenge of balancing nonlinearity, dissipation, participation, and energy scale, parametric amplifiers have not yet been implemented with a semiconductor weak link. The work presented in this PhD thesis demonstrates the design, fabrication and performances of a parametric amplifier leveraging a graphene Josephson junction.The graphene is encapsulated in between hBN flakes in order to improve its quality. Using such high quality junctions, we demonstrate amplification with 20 dB gain which is the milestone for overcoming noise of the classical amplifiers in the rest of the amplification chain. The Josephson parametric amplifier being based on a resonant structure (around 6 GHz) suffers from the gain bandwidth product limiting the amplification to a few MegaHertz frequency range. The use of a side gate to electrically tune the graphene gives control of the Josephson junction inductance and thus the resonant frequency of the amplifier. We demonstrate a near 1 GHz tunability of the amplification frequency with the use of a side gate which is as good as the tunability offered by using a magnetic flux on a SQUID for similar amplifier designs. Moreover, graphene has shown to exhibit nonlinear loss under a strong microwave irradiation arising because of dynamics in the Andreev states. Dissipation is known to add intrinsic noise on quantum amplifiers and could be a problem for quantum limited parametric amplification. We demonstrate that despite the presence of nonlinear loss, graphene based Josephson parametric amplifiers can reach near quantum limited amplification. A two photon loss model was used to describe the behaviour of the device but we show that a more complex model is required in order to take into account the nonlinear dissipation and the non-sinusoidal current phase relation. We also studied the dynamic range and showed that the graphene based Josephson parametric amplifier can reach a 1 dB compression point of -123 dBm which is as good as single tunnel junctions based parametric amplifiers. Our results expand the toolset for electrically tunable superconducting quantum circuits and offer new opportunities for the development of quantum technologies such as quantum computing, quantum sensing and fundamental science.
The topic of superconducting nanowires has recently been an interesting field of research which has included the study of the superconductor to insulator transition (SIT), the observation of macroscopic quantum behavior such as quantum phase slips (QPS), and the potential use of nanowires as qubits. Superconducting coplanar microwave waveguide resonators have also become a popular way of studying superconducting junctions and qubits, as they provide an extremely low noise environment. For example, superconducting two-dimensional Fabry-Perot resonators have been used by other groups to make non-demolition measurements of a qubit. The motivation of this thesis will be the merging of the fields of superconducting nanowires and the technique of using superconducting microwave resonators to study junctions by incorporating a nanowire into the resonator itself at a current anti-node. By doing this, the nonlinear effects of the nanowire can be studied which may find application in single photon detectors, mixers, and the readout of qubits. We also employ the technique of molecular templating to fabricate some of the thinnest superconducting nanowires ever studied (down to ~ 5 nm in diameter in some cases). In this thesis, we extend the understanding of the nonlinear properties of a nanowire- resonator system and investigate a new type of nonlinearity that involves a pulsing regime between the superconducting and normal phases of the nanowire. We develop a model, which describes the results quantitatively and by modeling the system, we are able to extract information regarding the relaxation time of the nanowire back into the superconducting state. We also study double nanowire-resonator systems where two closely spaced parallel nanowires interrupt the resonator center conductor and form a loop where vortex tunneling processes can occur. Using a double nanowire-resonator we are able to observe the Little-Parks effect at low temperatures (where the resistance of the wires is immeasurably low) and are able to confirm the multivalued nature of the current phase relationship (CPR) in nanowires. Additionally, we observe an anomalous transmission regime where the periodic pulsing is replaced by stochastic amplitude fluctuations. In addition to microwave measurements on nanowires, we also study the normal state in resistively shunted nanowires with dc measurements where the inclusion of a shunt resistor is observed to change the nature of the normal state from the Joule heated state to a state that preserves phase coherence. Finally, the statistics on switching current events in graphene proximity junctions are analyzed and compared to the well known results for Josephson junctions. Only thermal activation (and no macroscopic quantum tunneling) is observed in graphene proximity superconducting junctions down to temperatures of ~ 300 mK.
Josephson junctions are a fundamental building block of superconducting quantum circuits. They provide the nonlinearity required to realize quantum bits and enable a wide range of nonlinear phenomena central to quantum technologies. This thesis explores two superconducting systems in which this nonlinearity plays a central role. In the first part, we investigate a superconducting resonator terminated by a superconducting quantum interference device (SQUID), an arrangement of two Josephson junctions connected in parallel. The SQUID provides a tunable Kerr nonlinearity and allows the resonator to be driven parametrically. Under the combined action of the parametric drive, Kerr nonlinearity, and dissipation to the environment, the state of the resonator can undergo abrupt changes as the pump frequency or amplitude is varied. We interpret these changes within the framework of dissipative phase transitions (DPTs). By implementing a finite-component thermodynamic limit, we experimentally and theoretically investigate both first- and second-order DPTs in this system. We characterize their steady-state and dynamical signatures, including squeezing below vacuum, phase coexistence, hysteresis, spontaneous symmetry breaking, and critical slowing down. Finally, we exploit the enhanced susceptibility near the second-order critical point to implement a frequency-estimation protocol. We show that the estimation precision scales quadratically with the effective system size, demonstrating that finite-component DPTs can provide a quantum advantage in a sensing protocol. In the second part, we investigate a novel architecture for the readout of superconducting qubits. Conventional dispersive readout relies on a transverse interaction between a transmon and a resonator, which can lead to Purcell decay and measurement-induced state transitions, ultimately limiting the readout fidelity. To overcome these limitations, we implement a nonlinear coupling by galvanically connecting the transmon and resonator through a Josephson junction. This interaction provides a strong cross-Kerr coupling for clear state discrimination, but also introduces a detrimental transverse interaction. We experimentally show that the exchange part of the transverse interaction can be suppressed by adding a capacitor in parallel with the coupling junction while preserving the strong cross-Kerr coupling. In addition, we show that the same circuit acts as an intrinsic Purcell filter, protecting the qubit against Purcell decay. The coupling junction also induces a Kerr nonlinearity in the resonator, which we exploit to implement a bifurcation readout with a 99.4 % fidelity in a 68 ns integration time. This performance is achieved without a dedicated Purcell filter or a near-quantum-limited amplifier. Overall, this thesis demonstrates the engineering of nonlinear superconducting circuits to investigate dissipative phase transitions, exploit criticality for enhanced quantum sensing, and develop a novel qubit readout architecture enabling fast, high-fidelity measurement.
Recent progress in physics has increased the necessity for ultra-low noise amplifiers capable of operating at the quantum limit performance. These amplifiers are essential to enhance astronomical detection, dark-matter search, and qubit readout in quantum computing, among other applications. Superconducting Josephson junction Travelling Wave Parametric Amplifiers (JTWPAs) operated in the microwave range, have demonstrated high gain over several gigahertz (GHz) bandwidth, with quantum-limited noise performance and minimal heat dissipation. These excellent properties make JTWPAs an ideal solution for ultra-low noise amplification. This thesis delves into the design, fabrication and characterisation of JTWPAs operated in the microwave (1-16 GHz) and the W-band (70-115GHz) regimes. A generalised coupled-mode equations (CME) framework describing JTWPAs based on Josephson junctions and DC superconducting quantum interference devices (SQUIDs) is introduced. This framework can be combined with electromagnetic (EM) simulation softwares to model the JTWPAs, facilitating their design. It is therefore used to model two microwave JTWPA designs, using parallel plate capacitors (PPCs) and interdigitated capacitors (IDCs). The fabrication and characterisation of both designs are presented, and possible fabrication and design issues are carefully discussed. Despite these issues, we observed broadband gain in the JTWPA with PPCs, achieving > 20 dB gain at several frequency points, and a measured P1dB = −95.8dBm when operated at 17.3 dB. The RF properties of a 500-junction Josephson array are also presented in this manuscript. The device creates a Fabry-Perot cavity, leading to non-travelling wave parametric effects, such as narrow-band gain. We also observed indications of efficient phase-sensitive amplification. The thesis is concluded with the first — to the best of our knowledge — experimental attempt to extend the operational frequency of a JTWPA to the W-band. The novel design, fabrication techniques and characterisation of the W-band JTWPA are discussed in detail in this manuscript, leading to promising results suggesting that JTWPA could operate at high frequencies.
Recently the exploration of nonlinear microwave response in superconducting circuits has been extended to Nb nanobridges that can operate at higher magnetic fields, frequencies, and temperatures than their conventional Al counterparts. Nb nanobridge-based Superconducting Quantum Interference Devices (SQUIDs) have shown potential applications in quantum information processing, weak signal detection, and single spin detection. Combining such non-linear elements with circuit Quantum Electrodynamic (QED) elements like coplanar waveguide (CPW) resonators allows the study of the nonlinearity of such systems. In this work we report on the design, fabrication and dispersive microwave readout of a Nb DC nanoSQUID embedded in a superconducting quarter-wavelength resonator. The measured flux-tuneability of the resonance shows a modulation of a few MHz and fits simulations, giving a critical current of 330 μA and a screening parameterβLof 4.07. Following this we present results showing Kerr-type detuning with a pump tone applied to the device.
Voltage-tunable superconductor-semiconductor devices offer a unique platform to realize dynamic tunability in superconducting quantum circuits. By galvanically connecting a gated InAs-Al Josephson junction to a coplanar waveguide resonator, we demonstrate the use of a superconducting element with wideband gate tunability. We show that the resonant frequency is controlled via a gate-tunable Josephson inductance and that the nonlinearity of the InAs-Al junction is nondissipative as is the case with conventional AlOx-Al junctions. As the gate voltage is decreased, the inductive participation of the junction increases up to $44\mathrm{%}$, resulting in the resonant frequency being tuned by over 2GHz. Utilizing the wide tunability of the device, we demonstrate that two resonant modes can be adjusted such that they strongly hybridize, exhibiting an avoided-level crossing with a coupling strength of 51MHz. Implementing such voltage-tunable resonators is the first step toward realizing wafer-scale continuous voltage control in superconducting circuits for qubit-qubit coupling, quantum limited amplifiers, and quantum memory platforms.