This Master thesis first reviews the current state of different kinds of qubit, providing a comprehensive analysis of the development progress and future directions of qubit control and readout schemes, which are key components of quantum computers. Special emphasis is placed on analyzing and designing the cryo-CMOS qubit state controller (QSC) chips for transmon qubits, followed by an analysis of the performance of the current state-of-the-art chips, summarizing the development directions and challenges faced. Subsequently, the progress and achievements of previous work, based on 28-nm CMOS, are presented. This work utilizes submodules that are more power-efficient and better suited to cryogenic temperature (CT). Based on our modeling work, we simulate the chip at both room temperature (RT) and 4 K. The results, showing an SFDR of 45 dB, an SNR of 58 dB, and a power consumption of 6 mW per channel under active control at 4 K, with minimal performance degradation compared to RT, suggest that this work is a strong candidate compared to the previous state of the art.
This Master thesis first reviews the current state of different kinds of qubit, providing a comprehensive analysis of the development progress and future directions of qubit control and readout schemes, which are key components of quantum computers. Special emphasis is placed on analyzing and designing the cryo-CMOS qubit state controller (QSC) chips for transmon qubits, followed by an analysis of the performance of the current state-of-the-art chips, summarizing the development directions and challenges faced. Subsequently, the progress and achievements of previous work, based on 28-nm CMOS, are presented. This work utilizes submodules that are more power-efficient and better suited to cryogenic temperature (CT). Based on our modeling work, we simulate the chip at both room temperature (RT) and 4 K. The results, showing an SFDR of 45 dB, an SNR of 58 dB, and a power consumption of 6 mW per channel under active control at 4 K, with minimal performance degradation compared to RT, suggest that this work is a strong candidate compared to the previous state of the art.
This article will review recent progress in cryogenic CMOS designs for future scaled quantum computing applications. After introducing the scaling challenges associated with qubit control and readout electronics operating at room temperature, approaches taken to date to cryogenic control electronics design will be discussed, focusing on the most recent relevant publications. Elements of ultra-low power circuit and system design approaches for cryogenic controllers in scaled CMOS nodes (40nm to 14nm) will be reviewed, including a discussion of current state-of-the art cryogenic controller performance and power efficiency. Note that leading designs, when operated as transmon qubit state controllers, have achieved gate error rates in the range of 10-4 to 10-3 achieving spurious free dynamic range (SFDR) of ~40dB while consuming 4-23mW of power per qubit under active control, with power efficiency strongly driven by the complexity of the digital processor integrated in the controller design. These demonstrations, while significant, are just the first steps toward achieving the performance, efficiency, and scalability that will be required for future systems. This review article will discuss fundamental tradeoffs in CMOS cryogenic designs in order to address the needs of future scaled quantum computing systems.
Quantum computers hold a promise to solve intractable problems that can not be solved with classical computers. In quantum computers, information is processed in qubits as opposed to bits. The proper operation of qubits requires them to be operated in a quantum state; hence they need to be cooled down to temperatures well below l1K. Using qubits and their quantum mechanical property, quantum computers can achieve exponential speedup in solving certain computing problems compared to classical computers. However, this can only be achieved by employing thousands of qubits. At the current state of play, quantum computers are still far from practical. The current state-of-the-art solution dictates that each qubit needs multiple interconnects towards room temperature and requires bulky room temperature instruments for qubit readout and control. Clearly, this current solution will not scale well for a quantum computer with many qubits. In an effort to solve this issue, it has been proposed to realize dedicated integrated circuits for control and readout of the qubits and operate them closer to the qubits' operating temperature to enable scalability. The thesis presents the implementation of an integrated RF receiver for spin and superconducting qubit readout applications. The work aims to replace the bulky room temperature electronics with an integrated solution that operates at 4K to enable scalability and simplification of the quantum computing architecture. The receiver has been designed in the TSMC 40nm CMOS technology and has been characterized in room temperature and 4K. The measured performance shows that the receiver features a gain of 58 dB and a minimum double-sideband noise figure of 0.6 dB at 4K with an operating frequency of 6-8 GHz; a comparable performance to the current state-of-the-art room temperature electronics used for qubit readout. Moreover, this work demonstrates a qubit readout experiment with the integrated receiver in both room temperature and 4K. The qubit readout experiment shows a comparable qubit readout performance with the integrated receiver at room temperature. However, due to oscillation problems, a degradation in qubit readout performance with the chip operating at 4K is observed.
A scalable, non-multiplexed cryogenic 14-nm FinFET quantum bit (qubit) state controller (QSC) for use in the semi-autonomous control of superconducting transmon qubits is reported. The QSC includes an augmented general-purpose digital processor that supports waveform generation and phase rotation operations combined with a low-power current-mode single sideband upconversionI/Qmixer-based RF arbitrary waveform generator (AWG). Implemented in the 14-nm CMOS FinFET technology, the QSC generates control signals in its target 4.5–5.5-GHz-frequency range, achieving an spurious free dynamic range (SFDR) > 50 dB for a signal bandwidth of 500 MHz. With the controller operating in the 4 K stage of a cryostat and connected to a transmon qubit in the cryostat’s millikelvin stage, measured transmonT1andT2coherence times were 75.7 and 73μs, respectively, in each case comparable to results achieved using conventional room temperature (RT) controls. In further tests with transmons, a qubit-limited error rate of 7.76 × 10−4 per Clifford gate is achieved, again comparable to the results achieved using RT controls. The QSC’s maximum RF output power is −18 dBm, and power dissipation per qubit under active control is 23 mW.
A fault tolerant scalable quantum computer requires more than 1000 Qubits to perform real time state correction and to improve the Qubit coherence time. The dense wiring connections required between the quantum processor placed at a 100 mK temperature and the room temperature control and readout electronics serve as a limiting factor in this system. Qubit control and readout electronics operating at 4 K temperature, placed closer to a quantum processor inside the dilution refrigerator avoids the dense wiring connections to room temperature electronics, and hence, serve as a potential solution to realize a scalable quantum computer. However, with no CMOS process technology models available at cryogenic temperatures, the design of a fully integrated, ultra-low power Qubit control and readout electronics at a sub-1 mW power consumption proves to be extremely challenging. In recent years, there has been a huge rise in interest among the research communities to understand and solve the device and circuit level challenges at deep cryogenic temperatures. This paper presents an overview of the recently published active and passive device nonidealities, circuit design challenges and solutions, and the future research directions in the Qubit control and readout electronics operating at deep cryogenic temperatures.
Quantum computing promises to revolutionize our lives, achieving unprecedented computational powers and unlocking new possibilities in drug discovery, chemical simulations and cryptography. The fundamental unit of computation of a quantum computer is the quantum bit (qubit). It can be implemented in a number of technologies, such as superconducting qubits, spin qubits, photonic systems, trapped ions and NV-centers. Solid-state superconducting qubits and spin qubits seem to be the most promising ones, as shown by the recent demonstration of quantum supremacy with a superconducting qubit processor. Such quantum processors, to operate in the quantum regime, require very low temperatures around 10 mK, and they are hence kept inside dilution fridges. The electronics required to read out and control such processors is typically realized by discrete components or bulky scientific instruments at room temperature wired into the dilution fridge. Such approach is only feasible until few (< 100) qubits are handled, but it is not scalable for million-qubit processors required for fault-tolerant operation. In this thesis, readout and control electronics is proposed to be integrated and operated directly at cryogenic temperatures, in close proximity with the qubits and potentially even co-integrated. CMOS technology is advocated for its scalability, compactness and low prototyping cost, to create a comprehensive cryo-CMOS class of fully-integrated transceivers to read out and control solid-state qubits. In particular, the thesis focuses on cryo-CMOS radio-frequency integrated circuits for the readout of silicon quantum computers, looking to integrate the whole readout system, from the quantum layer to the room temperature user interface. Cryogenic CMOS devices are explored first, to lay the foundations of integrated circuit design. The realization of quantum dots in standard CMOS technology is explored as a platform to realize solid-state qubit arrays, demonstrating functionality at 50 mK and good reproducibility. Moreover, the operation of integrated transistors at 50 mK and 4.2 K is explored to understand their basic cryogenic functionality, through characterization and modeling. Then also integrated passives, such as capacitors, inductors and transformers, are studied and modeled at cryogenic temperatures. Then, a fully-integrated readout platform spanning across all the blocks needed for dispersive readout is proposed. A fully-integrated matrix of quantum dots with radio-frequency gate-based readout capabilities is demonstrated along with time- and frequency-multiplexing. This quantum-classical circuit shows all the features for a scalable approach and is the core of the platform following it. A cryogenic CMOS circulator based on a new all-pass filter architecture is demonstrated, to be used as integrated replacement for current bulky counterparts; it allows power reduction, insertion loss and bandwidth enhancement with respect to state-of-the-art integrated circulators. The rest of the front-end is also explored with dedicated test multiplexers, a low noise-amplifier and an oscillator, that are finally merged in a single fully-integrated low-noise receiver with frequency synthesizer operating at 3.5 K for scalable multiplexed readout of silicon qubits. The platform presented in this thesis, across temperature boundaries, carries all the features required for future scalable silicon quantum computing platforms and could therefore form their core.
Abstract Realizing a practically useful superconducting quantum computer will require a dramatic scale-up of quantum control electronics to meet the growth in required qubit counts. Conventional rack-based room-temperature control electronics impose severe constraints on wiring density, cost, and system footprint, creating a barrier to large-scale and fault-tolerant quantum computing. Here we demonstrate a hybrid quantum control architecture that combines cryogenic complementary metal-oxide semiconductor (cryo‑CMOS) application-specific integrated circuits (ASICs) for two‑qubit flux control with room‑temperature radio‑frequency electronics for single‑qubit control and readout. The resulting system achieves high density and scalable quantum control without compromising two‑qubit gate fidelity. Deployed on a 156‑qubit quantum processor, the cryo-CMOS subsystem achieves two‑qubit gate errors at the {10}^{-3} level, with a best randomized benchmarking error per gate of 8.4\times{10}^{-4}, stable operation over multi‑day timescales, and no measurable performance degradation as we increase the temperature of the cryo-CMOS ASICs from 7 to 20 K. Thermal analysis identifies cryo-CMOS chip operation near 20 K as a favorable regime, enabling efficient cooling of a large number of channels per cryostat. Compared against rack‑based flux-control, the cryo-CMOS subsystem achieves statistically indistinguishable two-qubit gate fidelities under matched gate settings and enables a tenfold improvement in system spatial footprint. These results establish cryo‑CMOS flux control as a practical and scalable foundation for large‑scale and fault-tolerant superconducting quantum systems.