This poster proposes an on-chip optical pulse modulation system for scalable superconducting quantum computers. Towards the scalable design, qubit control systems need to be located in the cryogenic environment to reduce the number of interconnections across the room temperature and the cryogenic regions. The cryogenic CMOS-based qubit control system is a promising approach, yet it is a bottleneck that exhausts the cooling capacity of the dilution refrigerator. In order to eliminate this bottleneck while providing the ability to control multiple quibits with a minimum necessary number of interconnections, this poster extends the RoF (Radio-over-Fiber) system where optical signals are directly fed from the Room Temperature (RT) region to a PD (PhotoDetector) mounted near the transmon qubit through low-loss and high-speed fibers. Unlike the conventional RoF system, the proposed system employs cryogenic silicon photonics-based modulators in the intermediate part for executing gate operations individually at each transmon qubit with a minimum necessary number of fibers across the RT and the cryogenic regions. Evaluation results show that the proposed system eliminates the power consumption by 79.5% compared with the cryogenic CMOS-based design. The proposed system achieves comparable gate fidelity to the control system generating fully customized RF pulses in the RT environment.
This poster proposes an on-chip optical pulse modulation system for scalable superconducting quantum computers. Towards the scalable design, qubit control systems need to be located in the cryogenic environment to reduce the number of interconnections across the room temperature and the cryogenic regions. The cryogenic CMOS-based qubit control system is a promising approach, yet it is a bottleneck that exhausts the cooling capacity of the dilution refrigerator. In order to eliminate this bottleneck while providing the ability to control multiple quibits with a minimum necessary number of interconnections, this poster extends the RoF (Radio-over-Fiber) system where optical signals are directly fed from the Room Temperature (RT) region to a PD (PhotoDetector) mounted near the transmon qubit through low-loss and high-speed fibers. Unlike the conventional RoF system, the proposed system employs cryogenic silicon photonics-based modulators in the intermediate part for executing gate operations individually at each transmon qubit with a minimum necessary number of fibers across the RT and the cryogenic regions. Evaluation results show that the proposed system eliminates the power consumption by 79.5% compared with the cryogenic CMOS-based design. The proposed system achieves comparable gate fidelity to the control system generating fully customized RF pulses in the RT environment.
In today's mainstream superconducting quantum computing platforms in a dilution refrigerator, the qubits work at a cryogenic temperature (CT) of a few tens of mK, while the qubit controller hardware works on plates with temperature ranging from a few K to room temperature (RT). The highly-integrated cryo-CMOS qubit controller ASIC that can fully work at 3-4K has been proven to be the most feasible way to scale down the quantum computing system [1–5]. In [1], a pulse modulator is implemented with a limited qubit driving capability, which can only generate fixed length symmetric driving pulse. The controllers in [2], [3] generated the RF driving pulse with a frequency division multiplexing (FDM) mode, with the power dissipation of 192mW/qubit and 46.5mW/qubit, respectively. In [4], a local oscillator (LO) was included to improve the controller integration level, and the chip power consumption was 24.1mW/qubit. An arbitrary waveform generation (AWG) functionality digital design was presented in [5] with a power consumption of 23.1mW/qubit. Nevertheless, with continuously increasing number of qubits to integrate, it remains as one of the major tasks to further reduce the power consumption and size of controller.
Scaling superconducting quantum computers toward thousands of control channels remains a difficult hardware problem. This requires reducing room-temperature-to-cryogenic interconnects and 4 K power while retaining channel-specific programmability. We develop a hybrid photonic/CMOS control architecture in which optical fibers distribute shared Gaussian and derivative pulse templates, while local cryogenic CMOS circuits provide event-rate amplitude programming, pulse blocking, hold-duration control, photodetection, and microwave upconversion. The architecture supports template-based XY/DRAG control and smooth-edged flat-top envelopes for two-qubit control through separate local signal paths. Compared with full-waveform Cryo-CMOS, it moves high-speed sampled-waveform generation out of each cryogenic channel. Compared with per-channel photonic waveform delivery, it retains a programmable endpoint after optical distribution for applying updated channel coefficients and control states. We evaluate the architecture using post-layout circuit simulations, optical and interconnect models, and system-level power scaling under a common 4 K output boundary. The modeled downlink power is below 1 mW per qubit-control channel at the thousand-channel scale, substantially below the normalized full-waveform Cryo-CMOS result and in the same range as the strict 50-ohm direct-detection WDM reference. Simulated I- and Q-path outputs are propagated through a five-level transmon model, while the simulated sample-and-hold output is evaluated in a coupled-transmon model. The tested single-qubit cases remain below the 10^-3 worst-state error reference, and the representative two-qubit result remains near the same scale after model-level calibration. These results support low-power photonic delivery with limited in-fridge programmability for template-compatible superconducting-qubit control.
Abstract The most promising quantum algorithms require quantum processors that host millions of quantum bits when targeting practical applications1. A key challenge towards large-scale quantum computation is the interconnect complexity. In current solid-state qubit implementations, an important interconnect bottleneck appears between the quantum chip in a dilution refrigerator and the room-temperature electronics. Advanced lithography supports the fabrication of both control electronics and qubits in silicon using technology compatible with complementary metal oxide semiconductors (CMOS)2. When the electronics are designed to operate at cryogenic temperatures, they can ultimately be integrated with the qubits on the same die or package, overcoming the ‘wiring bottleneck’3–6. Here we report a cryogenic CMOS control chip operating at 3 kelvin, which outputs tailored microwave bursts to drive silicon quantum bits cooled to 20 millikelvin. We first benchmark the control chip and find an electrical performance consistent with qubit operations of 99.99 per cent fidelity, assuming ideal qubits. Next, we use it to coherently control actual qubits encoded in the spin of single electrons confined in silicon quantum dots7–9 and find that the cryogenic control chip achieves the same fidelity as commercial instruments at room temperature. Furthermore, we demonstrate the capabilities of the control chip by programming a number of benchmarking protocols, as well as the Deutsch–Josza algorithm10, on a two-qubit quantum processor. These results open up the way towards a fully integrated, scalable silicon-based quantum computer.
While quantum processors are typically cooled to1,000 physical qubits will be required to encode one error-corrected qubit [1]. Implementing a system with 1,000 error-corrected qubits will likely require moving from the contemporary paradigm where control and readout of the quantum processor is carried out using racks of room temperature electronics to one in which integrated control/readout circuits are located within the cryogenic environment and connected to the quantum processor through superconducting interconnects [2]. This is a major challenge, as the cryo ICs must be high performance and very low power (eventually <; 1 mW/qubit). In this paper, we report the design and system-level characterization of a prototype cryo-CMOS IC for performing XY gate operations on transmon (XMON) qubits.
Quantum computing promises exponential speed-up in solving certain complex problems that would be intractable by classical computers. However, thousands or millions of qubits might be required to solve useful problems. High-precision and low-noise electrical signals are required to manipulate and read the state of a qubit and to control qubit-to-qubit interactions. Current systems use room temperature electronics with many coax cables routed to the qubit chip inside a dilution refrigerator. This approach does not scale to large number of qubits, due to form factor, cost, power consumption and thermal load to the fridge. To address this challenge, a cryogenic qubit controller has been proposed [1]. The first integrated implementation of a cryogenic pulse modulator has been presented in [2], demonstrating the capability of manipulating (drive) the state of superconducting qubits. The work in [3] extends the capability of the controller with 3 main features: frequency-multiplexing to reduce the number of RF cables per qubit, an arbitrary I/Q pulse generation for improved control fidelity and a digitally-intensive architecture with integrated instruction set to enable integration in existing quantum control stacks. This work further advances the prior art by integrating the capability of reading the qubit state and generating the voltage pulses required for drive, readout, 2-qubit operations and qubit characterization. The SoC can drive up to 16 spin qubits by frequency multiplexing over a single RF line, read the state of up to 6 qubits simultaneously and control up to 22 gate potentials. The SoC also integrates a μ-controller for increased flexibility in implementing the control instruction set. The proposed cryogenic controller can replace all the high-speed control electronics used in conventional solutions today, paving the way towards scalable quantum computers.
Quantum computing promises to revolutionize our lives, achieving unprecedented computational powers and unlocking new possibilities in drug discovery, chemical simulations and cryptography. The fundamental unit of computation of a quantum computer is the quantum bit (qubit). It can be implemented in a number of technologies, such as superconducting qubits, spin qubits, photonic systems, trapped ions and NV-centers. Solid-state superconducting qubits and spin qubits seem to be the most promising ones, as shown by the recent demonstration of quantum supremacy with a superconducting qubit processor. Such quantum processors, to operate in the quantum regime, require very low temperatures around 10 mK, and they are hence kept inside dilution fridges. The electronics required to read out and control such processors is typically realized by discrete components or bulky scientific instruments at room temperature wired into the dilution fridge. Such approach is only feasible until few (< 100) qubits are handled, but it is not scalable for million-qubit processors required for fault-tolerant operation. In this thesis, readout and control electronics is proposed to be integrated and operated directly at cryogenic temperatures, in close proximity with the qubits and potentially even co-integrated. CMOS technology is advocated for its scalability, compactness and low prototyping cost, to create a comprehensive cryo-CMOS class of fully-integrated transceivers to read out and control solid-state qubits. In particular, the thesis focuses on cryo-CMOS radio-frequency integrated circuits for the readout of silicon quantum computers, looking to integrate the whole readout system, from the quantum layer to the room temperature user interface. Cryogenic CMOS devices are explored first, to lay the foundations of integrated circuit design. The realization of quantum dots in standard CMOS technology is explored as a platform to realize solid-state qubit arrays, demonstrating functionality at 50 mK and good reproducibility. Moreover, the operation of integrated transistors at 50 mK and 4.2 K is explored to understand their basic cryogenic functionality, through characterization and modeling. Then also integrated passives, such as capacitors, inductors and transformers, are studied and modeled at cryogenic temperatures. Then, a fully-integrated readout platform spanning across all the blocks needed for dispersive readout is proposed. A fully-integrated matrix of quantum dots with radio-frequency gate-based readout capabilities is demonstrated along with time- and frequency-multiplexing. This quantum-classical circuit shows all the features for a scalable approach and is the core of the platform following it. A cryogenic CMOS circulator based on a new all-pass filter architecture is demonstrated, to be used as integrated replacement for current bulky counterparts; it allows power reduction, insertion loss and bandwidth enhancement with respect to state-of-the-art integrated circulators. The rest of the front-end is also explored with dedicated test multiplexers, a low noise-amplifier and an oscillator, that are finally merged in a single fully-integrated low-noise receiver with frequency synthesizer operating at 3.5 K for scalable multiplexed readout of silicon qubits. The platform presented in this thesis, across temperature boundaries, carries all the features required for future scalable silicon quantum computing platforms and could therefore form their core.