Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Superconducting nanowire single photon detectors based on NbRe nitride ultrathin films

Francesco Avitabile, Francesco Colangelo, M. Yu. Mikhaı̆lov, Z. Makhdoumi Kakhaki, Abhishek Kumar, Iman Esmaeil Zadeh, C. Attanasio, C. Cirillo

Published Oct 23, 2025• 2 citations
Publisher

Abstract

The influence of the reactive DC sputtering parameters on the superconducting properties of NbReN ultrathin films was investigated. A detailed study of the current–voltage characteristics of the plasma was performed to optimize the superconducting critical temperature, Tc. The thickness dependence of Tc for the films deposited under different conditions was analyzed down to the ultrathin limit. Optimized films were used to fabricate superconducting nanowire single photon detectors which, at T=3.5 K, show saturated internal detection efficiency (IDE) up to a wavelength of 1301 nm and 95% IDE at 1548 nm with recovery times and timing jitter of about 8 ns and 28 ps, respectively.

DOI
10.1063/5.0282478

Related papers

Superconducting Nanowire Single Photon Detectors based on NbRe nitride ultrafilms

Francesco Avitabile, Francesco Colangelo, M. Yu. Mikhaı̆lov +5 more

The influence of the reactive DC sputtering parameters on the superconducting properties of NbReN ultrathin films was investigated. A detailed study of the current-voltage characteristics of the plasma was performed to optimize the superconducting critical temperature, Tc. The thickness dependence of Tc for the films deposited under different conditions was analyzed down to the ultrathin limit. Optimized films were used to fabricate superconducting nanowire single photon detectors which, at T=3.5 K, show saturated internal detection efficiency (IDE) up to a wavelength of 1301 nm and 95% IDE at 1548 nm with recovery times and timing jitter of about 8 ns and 28 ps, respectively.

arXiv:2510.05910•Oct 7, 2025•0 citations

Optimizing the stoichiometry of ultrathin NbTiN films for high-performance superconducting nanowire single-photon detectors

Julien Zichi, Jin Chang, Stephan Steinhauer +8 more

N superconducting films and show that a Nb fraction of x = 0.62 allows for the fabrication of detectors from films as thick as 9 nm and covering an active area of 20 µm, with a wide detection saturation plateau at telecom wavelengths and in particular at 1550 nm. This is a signature of an internal detection efficiency saturation, achieved while maintaining the high time resolution associated with NbTiN and operation at 2.5K. With our optimized recipe, we reliably fabricated detectors with high critical current densities reaching a saturation plateau at 1550 nm with 80% system detection efficiency and with a FWHM timing jitter as low as 19.5 ps.

Optics Express•Sep 9, 2019•58 citations

Sputtered NbN films for ultrahigh performance superconducting nanowire single-photon detectors

Ilya A. Stepanov, Aleksandr S. Baburin, Danil V. Kushnev +7 more

At the present time, ultrahigh performance superconducting nanowire single-photon detectors are the key elements in a variety of devices from biological research to quantum communications and computing. Accurate tuning of superconducting material properties is a powerful resource for fabricating single-photon detectors with desired properties. Here, we report on the major theoretical relations between ultrathin niobium nitride (NbN) film properties and superconducting nanowire single-photon detector characteristics, as well as the dependence of ultrathin NbN film properties on reactive magnetron sputtering recipes. Based on this study, we formulate the exact requirements for ultrathin NbN films for ultrahigh performance superconducting nanowire single-photon detectors. Then, we experimentally studied the properties of ultrathin NbN films (morphology, crystalline structure, critical temperature, and sheet resistance) on silicon, sapphire, silicon dioxide, and silicon nitride substrates sputtered with various recipes. We demonstrate ultrathin NbN films (obtained with more than 100 films deposition) with a wide range of critical temperature from 2.5 to 12.1 K and sheet resistance from 285 to 2000 Ω/sq and report a sheet resistance evolution of more than 40% within two years. Finally, we found out that one should use ultrathin NbN films with a specific critical temperature near 9.5 K and a sheet resistance of about 350 Ω/sq for ultrahigh performance state-of-the-art superconducting nanowire single-photon detectors at 1550 nm wavelength.

arXiv:2311.17000•APL Materials•Feb 1, 2024•17 citations

Superconducting MoN thin films prepared by DC reactive magnetron sputtering for nanowire single-photon detectors

Lily Hallett, Ilya Charaev, Akshay Agarwal +4 more

Abstract We present a comprehensive study of molybdenum nitride (MoN) thin film deposition using direct current reactive magnetron sputtering. We have investigated the effect of various deposition conditions on the superconducting and electrical properties of the films. Furthermore, we have shown that meander-shaped single-photon detectors made from 5 nm MoN films have saturated quantum detection efficiency at the telecom wavelength of 1550 nm. Our results indicate that MoN may be a material of interest for practical applications of low-temperature superconductors, including single-photon detectors and transition-edge sensors.

arXiv:2010.10634•Superconductor Science and Technology•Jan 13, 2021•17 citations

Superconducting nanowire single-photon detectors fabricated from atomic-layer-deposited NbN

Risheng Cheng, Sihao Wang, Hong X. Tang

High-quality ultrathin films of niobium nitride (NbN) are developed by the plasma-enhanced atomic layer deposition (PEALD) technique. Superconducting nanowire single-photon detectors patterned from this material exhibit high switching currents and saturated internal efficiencies over a broad bias range at a telecommunication wavelength of 1550 nm. Statistical analyses on hundreds of fabricated devices show a near-unity throughput yield due to the exceptional homogeneity of the films. The ALD-NbN material represents an ideal superconducting material for fabricating large single-photon detector arrays combining high efficiency, low jitter, and low dark counts.

arXiv:1910.07010•Applied Physics Letters•Dec 9, 2019•43 citations

Superconducting nanowire single photon detectors based on disordered NbRe films

C. Cirillo, Jin Chang, M. Caputo +4 more

Superconducting Nanowire Single Photon Detectors (SNSPDs) based on Nb0.15Re0.85 disordered nanowires are developed. The devices have a meander structure of wires 50–100 nm wide and cover a circular detection area with a diameter of about 10–16 μm. The main figures of merit of the detectors are extracted from a flood illumination process at 2.8 K, featuring a saturated internal efficiency up to λ= 1301 nm, recovery times between about 8 and 19 ns, and a jitter of about 35 ps. These results confirm that Nb0.15Re0.85 is a promising candidate for the realization of fast SNSPDs, as recently suggested.

Applied Physics Letters•Oct 26, 2020•32 citations
The influence of the reactive DC sputtering parameters on the superconducting properties of NbReN ultrathin films was investigated. A detailed study of the current–voltage characteristics of the plasma was performed to optimize the superconducting critical temperature, Tc. The thickness dependence of Tc for the films deposited under different conditions was analyzed down to the ultrathin limit. Optimized films were used to fabricate superconducting nanowire single photon detectors which, at T=3.5 K, show saturated internal detection efficiency (IDE) up to a wavelength of 1301 nm and 95% IDE at 1548 nm with recovery times and timing jitter of about 8 ns and 28 ps, respectively.
The influence of the reactive DC sputtering parameters on the superconducting properties of NbReN ultrathin films was investigated. A detailed study of the current-voltage characteristics of the plasma was performed to optimize the superconducting critical temperature, Tc. The thickness dependence of Tc for the films deposited under different conditions was analyzed down to the ultrathin limit. Optimized films were used to fabricate superconducting nanowire single photon detectors which, at T=3.5 K, show saturated internal detection efficiency (IDE) up to a wavelength of 1301 nm and 95% IDE at 1548 nm with recovery times and timing jitter of about 8 ns and 28 ps, respectively.
N superconducting films and show that a Nb fraction of x = 0.62 allows for the fabrication of detectors from films as thick as 9 nm and covering an active area of 20 µm, with a wide detection saturation plateau at telecom wavelengths and in particular at 1550 nm. This is a signature of an internal detection efficiency saturation, achieved while maintaining the high time resolution associated with NbTiN and operation at 2.5K. With our optimized recipe, we reliably fabricated detectors with high critical current densities reaching a saturation plateau at 1550 nm with 80% system detection efficiency and with a FWHM timing jitter as low as 19.5 ps.
At the present time, ultrahigh performance superconducting nanowire single-photon detectors are the key elements in a variety of devices from biological research to quantum communications and computing. Accurate tuning of superconducting material properties is a powerful resource for fabricating single-photon detectors with desired properties. Here, we report on the major theoretical relations between ultrathin niobium nitride (NbN) film properties and superconducting nanowire single-photon detector characteristics, as well as the dependence of ultrathin NbN film properties on reactive magnetron sputtering recipes. Based on this study, we formulate the exact requirements for ultrathin NbN films for ultrahigh performance superconducting nanowire single-photon detectors. Then, we experimentally studied the properties of ultrathin NbN films (morphology, crystalline structure, critical temperature, and sheet resistance) on silicon, sapphire, silicon dioxide, and silicon nitride substrates sputtered with various recipes. We demonstrate ultrathin NbN films (obtained with more than 100 films deposition) with a wide range of critical temperature from 2.5 to 12.1 K and sheet resistance from 285 to 2000 Ω/sq and report a sheet resistance evolution of more than 40% within two years. Finally, we found out that one should use ultrathin NbN films with a specific critical temperature near 9.5 K and a sheet resistance of about 350 Ω/sq for ultrahigh performance state-of-the-art superconducting nanowire single-photon detectors at 1550 nm wavelength.
Abstract We present a comprehensive study of molybdenum nitride (MoN) thin film deposition using direct current reactive magnetron sputtering. We have investigated the effect of various deposition conditions on the superconducting and electrical properties of the films. Furthermore, we have shown that meander-shaped single-photon detectors made from 5 nm MoN films have saturated quantum detection efficiency at the telecom wavelength of 1550 nm. Our results indicate that MoN may be a material of interest for practical applications of low-temperature superconductors, including single-photon detectors and transition-edge sensors.
High-quality ultrathin films of niobium nitride (NbN) are developed by the plasma-enhanced atomic layer deposition (PEALD) technique. Superconducting nanowire single-photon detectors patterned from this material exhibit high switching currents and saturated internal efficiencies over a broad bias range at a telecommunication wavelength of 1550 nm. Statistical analyses on hundreds of fabricated devices show a near-unity throughput yield due to the exceptional homogeneity of the films. The ALD-NbN material represents an ideal superconducting material for fabricating large single-photon detector arrays combining high efficiency, low jitter, and low dark counts.
Superconducting Nanowire Single Photon Detectors (SNSPDs) based on Nb0.15Re0.85 disordered nanowires are developed. The devices have a meander structure of wires 50–100 nm wide and cover a circular detection area with a diameter of about 10–16 μm. The main figures of merit of the detectors are extracted from a flood illumination process at 2.8 K, featuring a saturated internal efficiency up to λ= 1301 nm, recovery times between about 8 and 19 ns, and a jitter of about 35 ps. These results confirm that Nb0.15Re0.85 is a promising candidate for the realization of fast SNSPDs, as recently suggested.