This paper presents the results of a performance evaluation of a photonic link in a cryogenic environment. The transmission from room temperature to 4.7 K was achieved using a 904 nm and 1310 nm lasers with a bandwidth exceeding 1 GHz using both silicon-based and InGaAs-based commercial photodiodes. A reduction in DC photocurrent was observed. Moreover, the frequency response measurements demonstrate that both photodiodes improve their maximum bandwidth even when unbiased at cryogenic environment. Furthermore, this work presents a demonstration of photonic control of cryogenic electronics for quantum computing applications.
This paper presents the results of a performance evaluation of a photonic link in a cryogenic environment. The transmission from room temperature to 4.7 K was achieved using a 904 nm and 1310 nm lasers with a bandwidth exceeding 1 GHz using both silicon-based and InGaAs-based commercial photodiodes. A reduction in DC photocurrent was observed. Moreover, the frequency response measurements demonstrate that both photodiodes improve their maximum bandwidth even when unbiased at cryogenic environment. Furthermore, this work presents a demonstration of photonic control of cryogenic electronics for quantum computing applications.
We investigate short pulse illumination of a high-speed extended-InGaAs photodiode at cryogenic temperatures toward its use in control and readout of superconducting qubits. First, we demonstrate high detector responsivity at 1550 nm illumination at 20 mK, a wavelength band unavailable to cryogenic standard InGaAs detectors due to the temperature-dependent bandgap shift. Second, we demonstrate an improved signal-to-noise ratio (SNR) at the shot noise limit for cryogenic short optical pulse detection when compared with conventional modulated continuous-wave laser detection. At 40 μA of photocurrent and a detector temperature of 4 K, short pulse detection yields an SNR improvement of 20 dB and 3 dB for phase and amplitude quadratures, respectively. Last, we discuss how short pulse detection offers a path for signal multiplexing, with a demonstration of simultaneous production of microwave pulses at two different carrier frequencies. Together, these advancements establish a path toward low noise and power efficient multiplexed photonic links for quantum computing with a large number of superconducting qubits.
Integrated circuit technology enables the scaling of circuit complexity and functionality while maintaining manufacturability and reliability. Integration is expected to play an important role in quantum information technologies, including in the highly demanding task of producing the classical signals to control and measure quantum circuits at scales needed for fault-tolerant quantum computation. Here, we experimentally characterize the cryogenic performance of a miniaturized photonic integrated circuit fabricated by a commercial foundry that downconverts classical optical signals into microwave signals. The circuit consists of waveguide-integrated germanium PIN photodiodes packaged using a scalable photonic wire bonding approach to a multi-channel optical fiber array that provides the optical excitation. We find the peak optical-to-microwave conversion response to be ∼150 ± 13 mA/W in the O-band at 4.2 K, well below the temperature the circuit was designed for and tested at in the past, for two different diode designs. The second diode design operates to over 6 GHz of 3 dB bandwidth, making it suitable for controlling quantum circuits, with improvements in bandwidth and response expected from improved packaging. The demonstrated miniaturization and integration offers new perspectives for wavelength-division multiplexed control of microwave quantum circuits and scalable processors using light delivered by optical fiber arrays.
Cryogenic systems necessitate extensive data transmission between room-temperature and cryogenic environments, as well as within the cryogenic temperature domain. High-speed, low-power data transmission is pivotal to enabling the deployment of larger-scale cryogenic systems, including the scalable quantum computing systems and the high-performance cryogenic computing systems fully immersed in liquid nitrogen. In contrast to wireline and microwave links, optical communication links are emerging as a solution characterized by high data rates, high energy efficiency, low signal attenuation, absence of thermal conduction, and superior scalability. In this work, a 4K heat-insulated high-speed (56Gbps) low-power (1.6pJ/b) transceiver (TRX) that achieves a complete link between 4K systems and room temperature (RT) equipment is presented. Copackaged with a PIN photodiode (PD), the RX uses an inverter-based analog front-end and an analog half-rate clock data recovery loop. Connecting to a Mach-Zehnder modulator (MZM), the TX contains a voltage-mode driver with current-mode injection for low-power output-swing-boosting and 3-tap feed-forward equalization (FFE). This link has been demonstrated in the control and readout of a complete superconducting quantum computing system.
Quantum devices have the potential to revolutionize applications in computing, communications, and sensing; however, current state-of-art resources must operate at extremely low temperatures, making the routing of microwave control and readout signals challenging to scale. Interest in microwave photonic solutions to this problem has grown in recent years, in which control signals are delivered to the cold stage via optical fiber, where they are converted to electrical signals through photodetection. Overall link performance depends strongly on the characteristics of the photodiode, yet detailed measurements of many detector properties remain lacking at cold temperatures. In this work, we examine and compare the performance of a modified uni-traveling carrier photodiode (MUTC-PD) at both room (300 K) and liquid nitrogen (80 K) temperatures, focusing in particular on responsivity, bandwidth, and linearity. In line with previous work, we find a sharp reduction in responsivity at 1550 nm as temperature decreases, while RF bandwidth remains steady. Interestingly, our linearity tests reveal that the RF output saturates more quickly at 80 K, suggesting reduced linearity with lower temperature, the cause of which is still under investigation. Our results should help contribute to the understanding and future design of highly linear cryogenic quantum links.
Quantum devices present the potential for unparalleled computing and communications capabilities; however, the cryogenic temperatures required to successfully control and read out many qubit platforms can prove to be very challenging to scale. Recently, there has emerged an interest in using microwave photonics to deliver control signals down to ultracold stages via optical fiber, thereby reducing thermal load and facilitating dense wavelength multiplexing. Photodetectors can then convert this optical energy to electrical signals for qubit control. The fidelity of the quantum operations of interest therefore depend heavily upon the characteristics of the photodiode, yet experimental demonstrations of fiber-coupled photodetection systems at low temperatures are relatively few in number, leaving important open questions regarding how specific detectors may perform in real-world cryogenic settings. In this work, we examine a highly linear modified uni-traveling carrier photodiode (MUTC-PD) under C-band illumination (1530–1565 nm) at three temperature regimes (300 K, 80 K, and ∼4 K) and multiple bias conditions. Our findings of reduced responsivity but preserved bandwidth are consistent with previous studies, while our saturation tests suggest a variety of potential applications for MUTC-PDs in cryogenic microwave photonics with and without electrical bias. Overall, our results should provide a valuable foundation for the continued and expanding use of this detector technology in quantum information processing.
Superconducting quantum computing has the potential to revolutionize computational capabilities. However, scaling up large quantum processors is limited by the cumbersome and heat-conductive electronic cables that connect room-temperature control electronics to quantum processors, leading to significant signal attenuation. Optical fibers provide a promising solution, but their use has been restricted to controlling simple two-level quantum systems over short distances. Here, we demonstrate optical control of a bosonic quantum processor, achieving universal operations on the joint Hilbert space of a transmon qubit and a storage cavity. Using an array of cryogenic fiber-integrated uni-traveling-carrier photodiodes, we prepare Fock states containing up to ten photons. Additionally, remote control of bosonic modes over a transmission distance of 15 km has been achieved, with fidelities exceeding 95%. The combination of high-dimensional quantum control, multi-channel operation, and long-distance transmission addresses the key requirements for scaling superconducting quantum computers and enables architectures for distributed quantum data centers.