Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Precision Electromagnetic Measurements

Measuring VHF Detector Linearity using a Quantum-Based Source

Jeremy N. Thomas, Nathan E. Flowers-Jacobs, Anna E. Fox, Alain Rüfenacht, Paul D. Dresselhaus

Published Jul 8, 2024• 1 citation
Publisher

Abstract

We demonstrate the use of a Josephson Arbitrary Waveform Synthesizer (JAWS) for linearity measurements of two instruments: an RF power sensor and a fast ADC. The VHF-JAWS source consists of a chip with 12,810 Josephson junctions located in a cryocooler and driven to produce quantum-based ac waveforms at frequencies up to 50.05 MHz and power up to -19 dBm. We first confirm that the device is operating correctly by measuring the dc bias current quantum-locking range and then measure the system output power with an RF power sensor and a high-speed digitizer. After removing an overall scale factor, the ten-nanowatt scale differences between the programmed JAWS values and the measured values indicate better than ±0.5 % DUT linearity for frequencies in the VHF band.

DOI
10.1109/cpem61406.2024.10646166

Related papers

VHF Josephson Arbitrary Waveform Synthesizer

Jeremy N. Thomas, Nathan E. Flowers-Jacobs, Anna E. Fox +3 more

We report on the design, fabrication, and measurement of a very high frequency band Josephson arbitrary waveform synthesizer (VHF-JAWS) at frequencies from 1 kHz to 50.05 MHz. The VHF-JAWS chip is composed of a series array of 12 810 Josephson junctions (JJs) embedded in a superconducting coplanar waveguide. Each JJ responds to a pattern of current pulses by creating a corresponding pattern of voltage pulses, each with a time-integrated area related to fundamental constants as${{h/2e}}$. The pulse patterns are chosen to produce quantum-based single-tone voltage waveforms with an open-circuit voltage of 50 mV rms (–19.03 dBm output power into 50$\Omega$load impedances) at frequencies up to 50.05 MHz, which is more than twice the voltage that has been generated by previous RF-JAWS designs at 1 GHz. The VHF-JAWS is “quantum-locked,” that is, it generates one quantized output voltage pulse per input current pulse per JJ while varying the dc current through the JJ array by at least 0.4 mA and the amplitude of the bias pulses by at least 10 %. We use the large bias pulse quantum-locking range to investigate one source of error in detail: the direct feedthrough of the current bias pulses into the DUT at VHF frequencies, which adds an unwanted, in-band component to the measured voltage. We reduce this error by high-pass filtering the current bias pulses and measure the error as a function of input pulse amplitude using two techniques: 1) by measuring small changes over the quantum-locking range and 2) by passively attenuating the input pulse amplitude so that the nonlinear JJs no longer generate voltage pulses while the error is only linearly scaled.

IEEE Transactions on Applied Superconductivity•Jul 1, 2024•8 citations

VHF Josephson Arbitrary Waveform Synthesizer

Jeremy N. Thomas, Nathan E. Flowers-Jacobs, Anna E. Fox +3 more

We report on the design of a Very High Frequency band Josephson Arbitrary Waveform Synthesizer (VHF-JAWS) and measurements of quantum-based single-tone voltage waveforms at frequencies up to 50.05 MHz. This design and measurements are directly applicable for linearity measurements in VHF systems and are a starting point for creating a quantum-based RF power source.

United States National Committee of URSI National Radio Science Meeting•Jan 9, 2024•1 citation

RF Waveform Synthesizers With Quantum-Based Voltage Accuracy for Communications Metrology

P. F. Hopkins, Justus A. Brevik, Manuel A. Castellanos-Beltran +6 more

We review our development of Josephson-junction-based programmable reference sources to synthesize spectrally pure waveforms with quantum-based voltage accuracy for characterizing and improving future communication devices and systems. The goal is to provide sources that together span the entire radio frequency band, equivalent to seven orders of magnitude in frequency (20 kHz to 300 GHz). To synthesize waveforms in the microwave frequency band, we are extending the existing Josephson arbitrary waveform synthesizer (JAWS) technology used for ac voltage metrology at audio frequencies (<;20 kHz). Using new microwave circuits and experimental techniques, we demonstrate JAWS-based synthesis of single-tone waveforms at 1 GHz, with -49 dBm output power and 79 dBc spur-free dynamic range (SFDR). To synthesize waveforms in the millimeter-wave frequency band, we are exploiting single flux quantum (SFQ) superconducting digital technology to design circuits that amplify SFQ pulses using a network of pulse splitters. With our initial SFQ-based circuit, we demonstrate synthesis of a 4-GHz sine wave with -74 dBm output power and 70 dBc SFDR.

IEEE Transactions on Applied Superconductivity•Mar 8, 2019•22 citations

Pulse-Bias Electronics and Techniques for a Josephson Arbitrary Waveform Synthesizer

Samuel P. Benz, Steven B. Waltman

The Josephson arbitrary waveform synthesizer (JAWS) is a series array of thousands of superconducting Josephson junctions that are biased by current pulses such that the array produces voltage waveforms with quantum accuracy. Intrinsically accurate voltage waveforms synthesized with the quantized pulses from Josephson junctions were first demonstrated in 1996. Ten years later, a commercial ac standard was calibrated at an output root-mean-square (RMS) amplitude of 100 mV with the first practical superconducting digital-to-analog converter. Since then, many different bias techniques, pulse-drive electronics, and device technology have been developed and improved in order to achieve a maximum of 138 mV output RMS voltage per Josephson array. In this paper, we report new bias electronics and demonstrate two new pulse-bias techniques. The first technique has demonstrated 250 mV output RMS voltage per 6400-junction array and may enable a practical 1 V system with only four arrays. The second bias technique reduces inductance-related error signals at the signal frequency and should reduce systematic errors for waveforms with frequencies greater than 1 MHz.

IEEE Transactions on Applied Superconductivity•Jul 11, 2014•40 citations

Two-Volt Josephson Arbitrary Waveform Synthesizer Using Wilkinson Dividers

Nathan E. Flowers-Jacobs, Anna E. Fox, Paul D. Dresselhaus +2 more

The root-mean-square (rms) output voltage of the NIST Josephson arbitrary waveform synthesizer (JAWS) has been doubled from 1 V to a record 2 V by combining two new 1 V chips on a cryocooler. This higher voltage will improve calibrations of ac thermal voltage converters and precision voltage measurements that require state-of-the-art quantum accuracy, stability, and signal-to-noise ratio. We achieved this increase in output voltage by using four on-chip Wilkinson dividers and eight inner-outer dc blocks, which enable biasing of eight Josephson junction (JJ) arrays with high-speed inputs from only four high-speed pulse generator channels. This approach halves the number of pulse generator channels required in future JAWS systems. We also implemented on-chip superconducting interconnects between JJ arrays, which reduces systematic errors and enables a new modular chip package. Finally, we demonstrate a new technique for measuring and visualizing the operating current range that reduces the measurement time by almost two orders of magnitude and reveals the relationship between distortion in the output spectrum and output pulse sequence errors.

IEEE Transactions on Applied Superconductivity•Feb 19, 2016•76 citations

Development and Applications of a Four-Volt Josephson Arbitrary Waveform Synthesizer

Nathan E. Flowers-Jacobs, Alain Rüfenacht, Anna E. Fox +5 more

We have recently created a 4 V rms cryocooled JAWS (Josephson Arbitrary Waveform Synthesizer) using 204,960 nearly identical Josephson junctions (JJs) that are embedded in coplanar-wave guides. The JJs are pulse-biased at repetition rates up to 16×109pulses per second to create quantum-accurate, calculable AC waveforms at frequencies from DC to greater than 1 MHz. This system has metrological applications including in precision ac voltage calibrations, comparisons of arbitrary impedances, and ac power measurements.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2019•16 citations
We demonstrate the use of a Josephson Arbitrary Waveform Synthesizer (JAWS) for linearity measurements of two instruments: an RF power sensor and a fast ADC. The VHF-JAWS source consists of a chip with 12,810 Josephson junctions located in a cryocooler and driven to produce quantum-based ac waveforms at frequencies up to 50.05 MHz and power up to -19 dBm. We first confirm that the device is operating correctly by measuring the dc bias current quantum-locking range and then measure the system output power with an RF power sensor and a high-speed digitizer. After removing an overall scale factor, the ten-nanowatt scale differences between the programmed JAWS values and the measured values indicate better than ±0.5 % DUT linearity for frequencies in the VHF band.
We report on the design, fabrication, and measurement of a very high frequency band Josephson arbitrary waveform synthesizer (VHF-JAWS) at frequencies from 1 kHz to 50.05 MHz. The VHF-JAWS chip is composed of a series array of 12 810 Josephson junctions (JJs) embedded in a superconducting coplanar waveguide. Each JJ responds to a pattern of current pulses by creating a corresponding pattern of voltage pulses, each with a time-integrated area related to fundamental constants ash/2e{{h/2e}}h/2e. The pulse patterns are chosen to produce quantum-based single-tone voltage waveforms with an open-circuit voltage of 50 mV rms (–19.03 dBm output power into 50Ω\OmegaΩload impedances) at frequencies up to 50.05 MHz, which is more than twice the voltage that has been generated by previous RF-JAWS designs at 1 GHz. The VHF-JAWS is “quantum-locked,” that is, it generates one quantized output voltage pulse per input current pulse per JJ while varying the dc current through the JJ array by at least 0.4 mA and the amplitude of the bias pulses by at least 10 %. We use the large bias pulse quantum-locking range to investigate one source of error in detail: the direct feedthrough of the current bias pulses into the DUT at VHF frequencies, which adds an unwanted, in-band component to the measured voltage. We reduce this error by high-pass filtering the current bias pulses and measure the error as a function of input pulse amplitude using two techniques: 1) by measuring small changes over the quantum-locking range and 2) by passively attenuating the input pulse amplitude so that the nonlinear JJs no longer generate voltage pulses while the error is only linearly scaled.
We review our development of Josephson-junction-based programmable reference sources to synthesize spectrally pure waveforms with quantum-based voltage accuracy for characterizing and improving future communication devices and systems. The goal is to provide sources that together span the entire radio frequency band, equivalent to seven orders of magnitude in frequency (20 kHz to 300 GHz). To synthesize waveforms in the microwave frequency band, we are extending the existing Josephson arbitrary waveform synthesizer (JAWS) technology used for ac voltage metrology at audio frequencies (<;20 kHz). Using new microwave circuits and experimental techniques, we demonstrate JAWS-based synthesis of single-tone waveforms at 1 GHz, with -49 dBm output power and 79 dBc spur-free dynamic range (SFDR). To synthesize waveforms in the millimeter-wave frequency band, we are exploiting single flux quantum (SFQ) superconducting digital technology to design circuits that amplify SFQ pulses using a network of pulse splitters. With our initial SFQ-based circuit, we demonstrate synthesis of a 4-GHz sine wave with -74 dBm output power and 70 dBc SFDR.
The Josephson arbitrary waveform synthesizer (JAWS) is a series array of thousands of superconducting Josephson junctions that are biased by current pulses such that the array produces voltage waveforms with quantum accuracy. Intrinsically accurate voltage waveforms synthesized with the quantized pulses from Josephson junctions were first demonstrated in 1996. Ten years later, a commercial ac standard was calibrated at an output root-mean-square (RMS) amplitude of 100 mV with the first practical superconducting digital-to-analog converter. Since then, many different bias techniques, pulse-drive electronics, and device technology have been developed and improved in order to achieve a maximum of 138 mV output RMS voltage per Josephson array. In this paper, we report new bias electronics and demonstrate two new pulse-bias techniques. The first technique has demonstrated 250 mV output RMS voltage per 6400-junction array and may enable a practical 1 V system with only four arrays. The second bias technique reduces inductance-related error signals at the signal frequency and should reduce systematic errors for waveforms with frequencies greater than 1 MHz.
The root-mean-square (rms) output voltage of the NIST Josephson arbitrary waveform synthesizer (JAWS) has been doubled from 1 V to a record 2 V by combining two new 1 V chips on a cryocooler. This higher voltage will improve calibrations of ac thermal voltage converters and precision voltage measurements that require state-of-the-art quantum accuracy, stability, and signal-to-noise ratio. We achieved this increase in output voltage by using four on-chip Wilkinson dividers and eight inner-outer dc blocks, which enable biasing of eight Josephson junction (JJ) arrays with high-speed inputs from only four high-speed pulse generator channels. This approach halves the number of pulse generator channels required in future JAWS systems. We also implemented on-chip superconducting interconnects between JJ arrays, which reduces systematic errors and enables a new modular chip package. Finally, we demonstrate a new technique for measuring and visualizing the operating current range that reduces the measurement time by almost two orders of magnitude and reveals the relationship between distortion in the output spectrum and output pulse sequence errors.
We have recently created a 4 V rms cryocooled JAWS (Josephson Arbitrary Waveform Synthesizer) using 204,960 nearly identical Josephson junctions (JJs) that are embedded in coplanar-wave guides. The JJs are pulse-biased at repetition rates up to 16×109pulses per second to create quantum-accurate, calculable AC waveforms at frequencies from DC to greater than 1 MHz. This system has metrological applications including in precision ac voltage calibrations, comparisons of arbitrary impedances, and ac power measurements.