Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE photonics journal

Frequency Stabilization Technology of 1560 nm Fiber Laser Based on Rubidium Modulation Transfer Spectroscopy

Yang Bai, Jun Ruan, Dandan Liu, Sichen Fan, Yong Guan, Pengyue Lei

Published May 20, 2024• 5 citations
Publisher

Abstract

The modulation transfer spectroscopy (MTS) technique used to stabilize two different transition lines of rubidium, required for laser cooling of atoms, is investigated. The laser source is based on a 1560 nm semiconductor laser diode that is amplified by an erbium doped fiber amplifier (EDFA). The laser output is frequency doubled with a fiber coupled periodically poled Lithium Niobate (PPLN) crystal to 780 nm. To address the weak spectral features of repumping laser, a theoretical study is conducted followed by experimental verification. The 87Rb D2 line F = 1 → F' = 0 transition temperature-enhanced MTS signal is observed, which provides a choice to stabilize the repumping laser frquency on the F = 1 → F ' = 2 transition using frequency shifting with acousto-optic modulators (AOMs). Compared with the orignal MTS signal, this method is shown to be more stable and accurate for laser frequency locking. Laer frequency locking is realized by controlling the driving current of the seed laser using digital PID feedback. After locking, the laser linewidth is 35.36 kHz.

DOI
10.1109/jphot.2024.3402742

Related papers

Fiber modulation transfer spectroscopy for laser stable frequency

Jinzhu Feng, Jun Ruan, Yang Bai +3 more

The laser uses a 1560nm distributed feedback semiconductor laser as the seed source, which is then amplified by an erbium-doped fiber amplifier (EDFA). The amplified laser is subsequently frequency-doubled to 780nm using a periodically poled lithium niobate (PPLN) crystal. A fully fiber-optic modulation transfer spectroscopy (MTS) frequency stabilization system was constructed, locking onto the crossover peak for the 87Rb 5𝑆1/2, 𝐹g = 1 → 5𝑆3/2, 𝐹e = 0, 1. The system's performance was evaluated by beat measurements with a commercial MTS module locking onto the 87Rb D2 transition line 5𝑆1/2, 𝐹g = 1 → 5𝑆3/2, 𝐹e = 0.The final result shows a beat signal linewidth of 29kHz. The frequency stability at an integration time of one second is 8 × 10-11, and the frequency stability reaches 3 × 10-11 at an integration time of up to 1000 seconds.

International Conference on Optoelectronic Information and Optical Engineering (OIOE)•Jun 10, 2025•0 citations

Frequency Modulation Spectroscopy and Modulation Transfer Spectroscopy for Laser Stabilization to Rubidium Atomic Resonances

Jinni Wu, Ningxuan Zheng, Wenhui Li

We make a detailed comparison of frequency modulation spectroscopy (FMS) and modulation transfer spectroscopy (MTS) and of their applications in stabilizing laser frequency. In both FMS and MTS, intensity modulations of probe beam are observed in saturated absorption spectroscopy of 87Rb atoms. However, the two modulation profiles appear different due to their distinct origins. Demodulation gives rise to frequency discrimination spectra, which can serve as error signals for frequency locking. The optimal error signal of FMS has a larger linear slope but also a slanted baseline, in contrast to that of MTS. We apply FMS and MTS to stabilize two 780 nm external cavity diode lasers to D2 lines of 87Rb atoms. We measure laser linewidth and stability using beat notes of two independently locked lasers. A laser linewidth as narrow as 12.9 kHz is achieved in FMS locking, compared to 70.8 kHz in MTS locking. A laser stability at the level of 10−12 is reached in both schemes. Nevertheless, FMS locking offers a better short-term stability, whereas MTS locking yields a smaller long-term drift. Our investigation of FMS and MTS would be valuable for making a choice of these spectroscopy techniques for laser stabilization as well as other relevant applications.

Photonics•Oct 21, 2026•0 citations

Modulation transfer spectroscopy for D1 transition line of rubidium

Bin Wu, Yin Zhou, Kanxing Weng +5 more

Modulation transfer spectroscopy (MTS) is widely used in an optical laboratory for laser frequency stabilization. There have been many theoretical and experimental papers on this spectroscopic method. However, most of the works focus on the cycling transitions like the D2 line of rubidium. In this paper, the MTS for noncycling transitions is investigated. We consider the D1 line of rubidium whose modulation transfer spectrum has been determined and compared to the polarization spectrum. It is found that the slope of the modulation transfer signal is sharper than the polarization spectrum. The performance of laser frequency locking based on the MTS method is better than that of the polarization spectroscopy method. The dependence of the signal amplitude on the temperature of the vapor cell was analyzed, and the high signal-to-noise-ratio spectra are achieved for D1 open transitions. The obtained results provide an effective spectroscopic method for the robust frequency locking of a laser at a wavelength of 795 nm.

Journal of the Optical Society of America B•Oct 8, 2018•30 citations

Zeeman-tunable Modulation Transfer Spectroscopy

Chloe So

Active frequency stabilization of a laser to an atomic or molecular resonance underpins many modern-day AMO physics experiments. With a flat background and high signal-to-noise ratio, modulation transfer spectroscopy (MTS) offers an accurate and stable method for laser locking. Despite its benefits, however, the four-wave mixing process that is inherent to the MTS technique entails that the strongest modulation transfer signals are only observed for closed transitions, excluding MTS from numerous applications. Here, we report for the first time the observation of a magnetically tunable MTS error signal. Using a simple two-magnet arrangement, we show that the error signal for the 87Rb F = 2 → F' = 3 cooling transition can be Zeeman-shifted over a range of ~10 GHz to any arbitrary point on the rubidium D2 spectrum. Modulation transfer signals for locking to the 87Rb F = 1 → F' = 2 repumping transition as well as 1 GHz red-detuned to the cooling transition are presented to demonstrate the versatility of this technique, which can readily be extended to the locking of Raman and lattice lasers.

•Jan 1, 2020•3 citations

Efficient frequency doubling of a telecom 1560 nm laser in a waveguide and frequency stabilization to Rb D2 line

Yashuai Han, Shanlong Guo, 王杰 Wang Jie +3 more

We experimentally demonstrate efficient frequency doubling of a telecom 1560 nm distributed feedback diode laser with a 3 cm long MgO:PPLN waveguide with a conversion coefficient of 114%/W.We investigate optical inhomogeneities by measuring the quasi-phase-matching temperature curve.The ~2.7 mW of second-harmonic power at 780 nm is sufficient to detect the Rb D 2 features using modulation transfer spectroscopy.The laser frequency is locked to a hyperfine transition of Rb D 2 line and typical residual frequency fluctuation of ±86 kHz (rms) is achieved within 30 min.Our experimental scheme can be used for realizing robust, compact, and highly accurate Rb stabilized 1560 nm laser systems for fiber-optic communication applications.

Chinese Optics Letters•Jan 1, 2014•11 citations

Frequency stabilization and linewidth narrowing with modulation transfer spectroscopy

Xi Zhang, Hui Liu, Kunliang Jiang +4 more

We report laser frequency stabilization with modulation transfer spectroscopy (MTS) on 85 Rb atoms. With both PZT (piezo-electric transducer) slow-loop feedback and current fastloop feedback to the laser head, we get a linewidth narrowing less than 5 kHz simultaneously. Laser injection to a laser diode and frequency beating with another polarization spectroscopy based stabilization setup are also employed to check the narrow linewidth property. With the help of the technique, a linewidth around kHz-level laser is obtained and pave the way for the locking of the lattice laser of ytterbium clock with transfer cavity technique. The setup can be used as a frequency reference for precise frequency control of atomic clock system.

Wuhan University Journal of Natural Sciences•Jan 12, 2018•0 citations
The modulation transfer spectroscopy (MTS) technique used to stabilize two different transition lines of rubidium, required for laser cooling of atoms, is investigated. The laser source is based on a 1560 nm semiconductor laser diode that is amplified by an erbium doped fiber amplifier (EDFA). The laser output is frequency doubled with a fiber coupled periodically poled Lithium Niobate (PPLN) crystal to 780 nm. To address the weak spectral features of repumping laser, a theoretical study is conducted followed by experimental verification. The 87Rb D2 line F = 1 → F' = 0 transition temperature-enhanced MTS signal is observed, which provides a choice to stabilize the repumping laser frquency on the F = 1 → F ' = 2 transition using frequency shifting with acousto-optic modulators (AOMs). Compared with the orignal MTS signal, this method is shown to be more stable and accurate for laser frequency locking. Laer frequency locking is realized by controlling the driving current of the seed laser using digital PID feedback. After locking, the laser linewidth is 35.36 kHz.
The laser uses a 1560nm distributed feedback semiconductor laser as the seed source, which is then amplified by an erbium-doped fiber amplifier (EDFA). The amplified laser is subsequently frequency-doubled to 780nm using a periodically poled lithium niobate (PPLN) crystal. A fully fiber-optic modulation transfer spectroscopy (MTS) frequency stabilization system was constructed, locking onto the crossover peak for the 87Rb 5𝑆1/2, 𝐹g = 1 → 5𝑆3/2, 𝐹e = 0, 1. The system's performance was evaluated by beat measurements with a commercial MTS module locking onto the 87Rb D2 transition line 5𝑆1/2, 𝐹g = 1 → 5𝑆3/2, 𝐹e = 0.The final result shows a beat signal linewidth of 29kHz. The frequency stability at an integration time of one second is 8 × 10-11, and the frequency stability reaches 3 × 10-11 at an integration time of up to 1000 seconds.
We make a detailed comparison of frequency modulation spectroscopy (FMS) and modulation transfer spectroscopy (MTS) and of their applications in stabilizing laser frequency. In both FMS and MTS, intensity modulations of probe beam are observed in saturated absorption spectroscopy of 87Rb atoms. However, the two modulation profiles appear different due to their distinct origins. Demodulation gives rise to frequency discrimination spectra, which can serve as error signals for frequency locking. The optimal error signal of FMS has a larger linear slope but also a slanted baseline, in contrast to that of MTS. We apply FMS and MTS to stabilize two 780 nm external cavity diode lasers to D2 lines of 87Rb atoms. We measure laser linewidth and stability using beat notes of two independently locked lasers. A laser linewidth as narrow as 12.9 kHz is achieved in FMS locking, compared to 70.8 kHz in MTS locking. A laser stability at the level of 10−12 is reached in both schemes. Nevertheless, FMS locking offers a better short-term stability, whereas MTS locking yields a smaller long-term drift. Our investigation of FMS and MTS would be valuable for making a choice of these spectroscopy techniques for laser stabilization as well as other relevant applications.
Modulation transfer spectroscopy (MTS) is widely used in an optical laboratory for laser frequency stabilization. There have been many theoretical and experimental papers on this spectroscopic method. However, most of the works focus on the cycling transitions like the D2 line of rubidium. In this paper, the MTS for noncycling transitions is investigated. We consider the D1 line of rubidium whose modulation transfer spectrum has been determined and compared to the polarization spectrum. It is found that the slope of the modulation transfer signal is sharper than the polarization spectrum. The performance of laser frequency locking based on the MTS method is better than that of the polarization spectroscopy method. The dependence of the signal amplitude on the temperature of the vapor cell was analyzed, and the high signal-to-noise-ratio spectra are achieved for D1 open transitions. The obtained results provide an effective spectroscopic method for the robust frequency locking of a laser at a wavelength of 795 nm.
Active frequency stabilization of a laser to an atomic or molecular resonance underpins many modern-day AMO physics experiments. With a flat background and high signal-to-noise ratio, modulation transfer spectroscopy (MTS) offers an accurate and stable method for laser locking. Despite its benefits, however, the four-wave mixing process that is inherent to the MTS technique entails that the strongest modulation transfer signals are only observed for closed transitions, excluding MTS from numerous applications. Here, we report for the first time the observation of a magnetically tunable MTS error signal. Using a simple two-magnet arrangement, we show that the error signal for the 87Rb F = 2 → F' = 3 cooling transition can be Zeeman-shifted over a range of ~10 GHz to any arbitrary point on the rubidium D2 spectrum. Modulation transfer signals for locking to the 87Rb F = 1 → F' = 2 repumping transition as well as 1 GHz red-detuned to the cooling transition are presented to demonstrate the versatility of this technique, which can readily be extended to the locking of Raman and lattice lasers.
We experimentally demonstrate efficient frequency doubling of a telecom 1560 nm distributed feedback diode laser with a 3 cm long MgO:PPLN waveguide with a conversion coefficient of 114%/W.We investigate optical inhomogeneities by measuring the quasi-phase-matching temperature curve.The ~2.7 mW of second-harmonic power at 780 nm is sufficient to detect the Rb D 2 features using modulation transfer spectroscopy.The laser frequency is locked to a hyperfine transition of Rb D 2 line and typical residual frequency fluctuation of ±86 kHz (rms) is achieved within 30 min.Our experimental scheme can be used for realizing robust, compact, and highly accurate Rb stabilized 1560 nm laser systems for fiber-optic communication applications.
We report laser frequency stabilization with modulation transfer spectroscopy (MTS) on 85 Rb atoms. With both PZT (piezo-electric transducer) slow-loop feedback and current fastloop feedback to the laser head, we get a linewidth narrowing less than 5 kHz simultaneously. Laser injection to a laser diode and frequency beating with another polarization spectroscopy based stabilization setup are also employed to check the narrow linewidth property. With the help of the technique, a linewidth around kHz-level laser is obtained and pave the way for the locking of the lattice laser of ytterbium clock with transfer cavity technique. The setup can be used as a frequency reference for precise frequency control of atomic clock system.