Cooper pair box circuits (two-qubit gate, single-shot readout, and current to frequency conversion)

François Nguyen, ESTEVE, Daniel

Published Jan 1, 2008• 0 citations

Abstract

During this thesis, we have used superconducting circuits with Josephson junctions, derived from the Cooper pair box, in order to implement quantum bits (qubits). To implement two-qubit gates, we have developed a new circuit, the quantroswap, which consists in two capacitively coupled Cooper pair box, each of them being manipulated and read separately. We have demonstrated coherent exchange of energy between them, but we have also observed a problem of qubit instability. In order to avoid this spurious effect, we have implemented another circuit based on a charge insensitive split Cooper pair box coupled to a non-linear resonator for readout-out purpose. We have measured large coherence time, and obtained large readout fidelity (90%) using the bifurcation phenomenon. For metrological purpose, microwave reflectometry measurement on a quantronium also allowed us to relate an applied current I to the frequency f=I/2e of induced Bloch oscillations.

Related papers

Cooper pair box circuits: two-qubit gate, qubit single-shot readout, and current to frequency conversion

François Nguyen

Cette thèse porte sur le développement de circuits supraconducteurs à jonctions Josephson, issus de la boîte à paire de Cooper, pour réaliser des bits quantiques (qubits). La version quantronium de ce circuit avait déjà démontré une cohérence quantique assez bonne pour faire des portes logiques à un qubit. Pour réaliser des portes logiques à deux qubits, nous avons développé un circuit, le quantroswap, fait de deux quantroniums couplés, chaque qubit pouvant être piloté et mesuré séparément. Nous avons démontré l'échange cohérent d'état entre les deux qubits, mais aussi observé un effet rédhibitoire d'instabilité dans ces qubits. Pour l'éviter, nous avons réalisé un nouveau circuit fait d'une boite à paires de Cooper insensible au bruit en charge électrique et stable, couplée à un résonateur non linéaire pour sa lecture. Nous avons obtenu un temps de cohérence long (~1 μs), et une très bonne fidélité de lecture (90%) du qubit en utilisant le phénomène de bifurcation. Dans un but métrologique, la mesure par réflectométrie microonde du quantronium a aussi permis de relier un courant I injecté dans le circuit à la fréquence f=I/2e des oscillations de Bloch induites.

Dec 15, 20081 citation

Experiments on a Quantum Gate Based on Charge-Current Superconducting Qubit

Michel Devoret

During this grant, we have invented, designed and successfully operated a new type of readout for charge-phase superconducting qubits. This new readout is based on the bifurcation of an RF-driven Josephson junction inserted in the loop of a split Cooper pair box. When the amplitude of the RF drive is in the vicinity of the bifurcation points a small change in the effective critical current of the junction is amplified into a large phase change in the reflected signal. The performance reached by the device is in agreement with theoretical predictions. The speed of this readout is unprecedented: we measure in 20ns the critical current increment corresponding to the transition between the 2 states of the qubit. The repetition rate is 10Mz. We have performed a series of experiments showing that the amplification mechanism behaves as expected. No quasiparticles are produced during the readout and the back-action on the qubit when the readout is OFF is minimal. We have performed decoherence measurements at dilution refrigerator temperatures on the quantronium qubit integrated with RF readout. These measurements involve all possible 1-qubit gate operations. Compared with the DC readout method we have gained in repetition rate (factor of 100), signal-to-noise ration on all coherence signals (factor of 10) but most importantly, on readout fidelity which now attains more than 60% (compared to 15%). This last improvement is very important for showing the entanglement produced by two-bit gate operations. The T1 has also been improved by 250%. We still have comparable T2 as before but we suspect this is due to insufficient filtering on the listening lines of our measurement apparatus and this problem is technically solvable. In parallel with this work on readout and decoherence of the quantronium qubit, we have designed a new 2-bit gate based on capacitive coupling between qubits and worked out the complete protocol of pulses.

Aug 31, 20050 citations

Quantum coherent dynamics of two coupled superconducting charge qubits

Yu. A. Pashkin, O. V. Astafiev, Tsuyoshi Yamamoto +5 more

We have analyzed and measured the quantum coherent dynamics of a circuit containing two coupled superconducting charge qubits. Each qubit is based on a Cooper pair box connected to a reservoir electrode through a Josephson junction. Two qubits are coupled electrostatically by a small island overlapping both Cooper pair boxes. Quantum state manipulation ofthe qubit circuit is done by applying non-adiabatic voltage pulses to the common gate. We read out each qubit by means of probe electrodes connected to Cooper pair boxes through high-Ohmic tunnel junctions. With such a setup the measured pulse-induced probe currents are proportional to the probability for each qubit to have an extra Cooper pai1r after the manipulation. As expected from theory and observed experimentally the measured pulse-induced current in each probe has two frequency components whose position on the frequency axis can be externally controlled. This is a result ofthe inter-qubit coupling which is also responsible for the avoided level crossing that we observed in the qubits' spectra. Our simulations show that in the absence of decoherence and with a rectangular pulse shape the system remains entangled most ofthe time reaching maximally entangled states at certain instances.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIEJun 1, 20050 citations

The Single Cooper Pair Box - a Quantum-Mechanical Electronic Circuit

David Gunnarsson

In this thesis the single Cooper pair box (SCB) is investigated with a radio frequency single electron transistor (RF-SET). The RF-SET is used as an electrometer to detect the charge of the SCB. The SCB can be regarded as a quantum two-level system and could therefore be a possible qubit. Both the SCB and the RF-SET have been fabricated with e-beam lithography followed by two-angle shadow evaporation of aluminium. The system has been measured in a dilution refrigerator at temperatures of ~30 mK. A charge sensitivity of 2.3 μe/square root of Hz was measured for an optimized RF-SET with a bandwidth of 7 MHz, operated in the superconducting state. In a phase sensitive measurement of the RF-SET reflected signal, the gate dependence of the quantum capacitance, due to avoided level crossing, was detected in a superconducting SET. Coulomb staircases for the SCB were obtained by changing the charge of the SCB by ramping a gate voltage and continuously measuring the charge with the RF-SET. To prevent quasiparticle poisoning of the SCB island, we have used a method of graded gaps. Here we exploit the greater reduction of the superconducting gap for the connecting leads with an external magnetic field applied, resulting in a higher gap for the island. This creates an effective barrier against quasiparticle tunnelling. The charging energy and the Josephson coupling energy of the SCB were measured with microwave spectroscopy. The SCBs were fabricated in a SQUID geometry, which made it possible to tune the Josephson coupling energy of the box. This tuning was verified through microwave spectroscopy. The effect of tuning could also be seen in the pure 2e Coulomb staircase, as a predicted smearing of the staircase, which was in excellent agreement with the independent spectroscopy data. Coherent quantum oscillation of the SCB charge state was measured by applying nonadiabatic DC-pulses to the SCB gate. The measured amplitude of the charge oscillations was higher than 70%. The deviation from 100% can be explained by the initial charge state purity and the finite rise time of the pulses. The longest decoherence time of the charge oscillations was T2 = 9 ns at the charge degeneracy point. It was found to be limited by relaxation. Away from the degeneracy point the decoherence time was limited by pure dephasing, due to low frequency charge fluctuators.

Jan 1, 20050 citations

Quantum Coherence in the Single Cooper Pair Box

Kevin Bladh

This thesis presents measurements of quantum coherence in a single Cooper pair box, where quantum oscillations of charge between a reservoir and a small superconducting island have been observed. The single Cooper pair box (SCB) consists of a small metallic island which is connected to a reservoir via a tunnel junction. In the superconducting state, Cooper pairs are free to tunnel to and from the island, whose potential can be controlled by a gate voltage. A graded gap method was used to prevent quasiparticles from tunneling onto the island. For this purpose, a magnetic field suppressed the superconducting gap in the SCB leads more than in the island. This created an additional energy barrier for quasiparticles to tunnel to the island, making the gate voltage modulation periodic in Cooper pair charge. For a limited range of gate voltage, the SCB was found to behave as a model two-level quantum mechanical system. A non-adiabatic change in the induced island charge was used to bring two charge states into resonance. The resulting time evolution showed clear charge oscillations between the ground and excited state, with a frequency given by the energy level separation divided by Planck's constant. These oscillations had a longest coherence time of T2=9 ns at a point where the pure charge states are degenerate. The coherence time at this point was found to be limited by the relaxation rate, ?1. Away from this point, the coherence time was limited by the dephasing rate, ??. Away from the charge degeneracy, the dependence of T2 on gate charge suggested that low frequency fluctuators were the main source of dephasing. The charge of the Cooper pair box was measured by coupling the SCB capacitively to a radio frequency single electron transistor (RF-SET). The RF-SET was used as an electrometer by measuring the amount of reflection from a resonant microwave circuit in which a single electron transistor (SET) was embedded. A best charge sensitivity of 2.3·10-6 e/sqrt(Hz) and a 7 MHz bandwidth was reached in an improved setup. Another part of this thesis concerns an investigation of electrical filters for use in single electronics experiments. The characteristics of seven different types of cryogenic filters were evaluated.

Jan 1, 20053 citations

Read-out of superconducting qubits - a quantum measurement process

Lars Tornberg

In this work we consider measurements on quantum systems emphasizing\non read-out of superconducting qubits. The qubit is always coupled to an\nenvironment, containing a macroscopic number of degrees of freedom. This\nperturbs the qubit and destroys the phase coherence of the quantum state.\nOne tries to minimize this destructive effect by encoding the quantum information in quantum states which do not couple strongly to the dominant\nnoise sources. It is therefore necessary to design read-out methods that can\ndistinguish these states.\n\nWe focus primarily on the single Cooper-pair box (SCB) charge qubit, whose\nproperties are based on the Josephson effect and Coulumb blockade in superconducting electrical circuits. By encoding the information in the qubit\nenergy eigenstates, it is possible to protect it from the most dangerous decoherence source - charge fluctuations in the environment. We investigate\nthe measurement setup, where the SCB is coupled to a lumped element LCoscillator whose resonance frequency is orders of magnitude smaller than the qubit energy splitting. In this regime the SCB will act as an effective positive or negative capacitance, depending on the quantum state. This quantum capacitance then shifts the oscillator resonance frequency, which can be detected in a homodyne phase measurement.\n\nWe have found that reading out a charge qubit by measuring its quantum\ncapacitance in this manner is quantum limited, independently of the oscillator\nquality factor Q. Moreover, we have found that the low-Q oscillator\nis advantageous for the measurement in two ways: first, such an oscillator\nbetter protects the qubit from thermal dephasing, and, second, it allows to\nincrease the speed of the read-out, making it possible to distinguish the qubit states in a single shot measurement.

Jan 1, 20070 citations