Tailoring Superconducting Nanowire Single-Photon Detectors for Quantum Technologies
Lucio Zugliani, Christian Schmid, Fabian Wietschorke, Björn Jonas, Simone Spedicato, Stefan Strohauer, Stefanie Grotowski, Rasmus Flaschmann, Manuel Müller, Matthias Althammer, Rudolf Groß, Jonathan James Finley, Kai Müller
Superconducting nanowire single-photon detectors (SNSPDs) are a key building block for photonic quantum technologies, as they provide a means for efficient readout of optical circuits with low timing jitter, dark counts and dead time. In this contribution we give a general overview of the working principle of these devices and look into several engineering aspects. We discuss the influence of the stoichiometry of NbTiN thin-films on detector performance and find that a ratio of 65:35 Nb:Ti results in the highest saturation of SNSPDs fabricated from these films. Furthermore, we study the impact of helium ion irradiation on the efficiency of SNSPDs. We show that with this technique the efficiency of an SNSPD can be improved from below 1% to 42%. Finally, we discuss the impact of embedding the SNSPDs into an optical cavity on the system detection efficiency. By employing a half-cavity under the detector we are able to boost the efficiency from 30% to 50% for a detector with a fill factor of 0.33.
Superconducting nanowire single-photon detectors (SNSPDs) are a key building block for photonic quantum technologies, as they provide a means for efficient readout of optical circuits with low timing jitter, dark counts and dead time. In this contribution we give a general overview of the working principle of these devices and look into several engineering aspects. We discuss the influence of the stoichiometry of NbTiN thin-films on detector performance and find that a ratio of 65:35 Nb:Ti results in the highest saturation of SNSPDs fabricated from these films. Furthermore, we study the impact of helium ion irradiation on the efficiency of SNSPDs. We show that with this technique the efficiency of an SNSPD can be improved from below 1% to 42%. Finally, we discuss the impact of embedding the SNSPDs into an optical cavity on the system detection efficiency. By employing a half-cavity under the detector we are able to boost the efficiency from 30% to 50% for a detector with a fill factor of 0.33.
Single photon detection advanced rapidly in the last decade. The superconducting nanowire single-photon detector (SNSPD) is an emerging technology, which offers low dark count rates, broadband sensitivity from visible to mid-infrared wavelengths and very high quantum efficiency. All these features are appealing for future emerging applications in remote gas sensing, quantum key distribution and quantum information processing. By enclosing the detector in an optical cavity, tuned to the operating wavelength, the total system detection of the SNSPD is improved. Based on the cavity design, the detector absorption is boosted at the desired experimental wavelength. Devices have been fabricated and tested, in this thesis, with enhanced detection efficiency at near-infrared, infrared and mid-infrared wavelengths. NbTiN detectors fabricated on Ta2O5 / SiO2 distributed Bragg reflectors (DBR) for front-side coupling exhibit a system detection efficiency of ≈ 90% at λ = 940 nm for the best device measured. SNSPDs were also fabricated in NbTiN on metallic mirrors for back-side coupling for 1550 and 2333 nm experimental wavelengths. The first design exhibited a system detection efficiency of ≈ 84.5%, at λ = 1550 nm for the best device measured. The second exhibited low system detection efficiency since the device suffered from unexpectedly high dark count rate mainly due to blackbody radiation at 2.2 K. However, it was possible to measure the timing jitter of this device at 350 mK indicating a FWHM of 84 ps. Another technique to improve the total system detection efficiency of the SNSPD, is by fabricating a hairpin-shaped nanowire atop a single mode waveguide. In this design, photons travel through the waveguide and via evanescent coupling are absorbed in the nanowire. These SNSPD devices have been designed to thread along single mode Si ridge waveguides using a hairpin-shaped nanowire structure, which offers enhanced coupling and absorption efficiency via evanescent coupling. These ultra-thin superconducting MoSi detectors are precisely patterned on top of a single mode Si waveguide (600 nm) with alignment error less than 40 nm. Low temperature electrical and nano-optical characterization was carried out using a two-stage pulse tube (PT) coldhead, using an additional 4He / 3He sorption pump, low vibration characterization of SNSPD devices at 350 mK was carried out. Characterised devices exhibit low dark count rate <5 counts per second and timing jitter of ≈ 83 ps full width half maximum (FWHM) at wavelength (λ) = 1550 nm and at critical current ≈ 30 µA.
In recent years, Superconducting Nanowire Single-Photon Detectors (SNSPDs) have obtained tremendous attention as a possible key technology for photonic quantum processing and faint light detection. Here, we present our recent progress on engineering of the properties of NbTiN SNSPDs fabricated on various substrates measured. We discuss approaches to simultaneously improve the most important figures of merit (DCR, dead time, timing jitter, efficiency) as well as efficient characterization methods. Specifically, for the latter we investigate the impact of the substrate material on the performance parameters as well as the fundamental interrelation of the resulting voltage pulse properties, such as pulse height, rise time and timing jitter, and their dependence on the applied bias current.
Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.
We present an overview of recent results for new generation of infrared and optical superconducting nanowire single-photon detectors (SNSPDs) that has already demonstrated a performance that makes them devices-of-choice for many applications. SNSPDs provide high efficiency for detecting individual photons while keeping dark counts and timing jitter minimal. Besides superior detection performance over a broad optical bandwidth, SNSPDs are also compatible with an integrated optical platform as a crucial requirement for applications in emerging quantum photonic technologies. By embedding SNSPDs in nanophotonic circuits we realize waveguide integrated single photon detectors which unite all desirable detector properties in a single device.
In the field of quantum technologies, the superconducting nanowire single photon detector(SNSPD) is nowadays well recognized as a key enabling device. SNSPDs combine high detectionefficiency in the visible and near IR spectral ranges, timing jitter as low as 10 ps, low dark count rate(<100 s−1) and cut-off frequency above 100 MHz. These features make it particularly attractive e.g. forfundamental quantum optics experiments and quantum communications.Plug-and-play SNSPDs with fibered optical access, as shown in Figure 1, are based on a meandernanowire defined by patterning an ultrathin (<10 nm) superconducting film. The device is designedso that absorption of a single photon is enough to brake locally the superconducting order, and toinduce a measurable change of the wire’s resistance. Until recently, such devices displayed two mainlimitations: (1) their efficiency did not exceed ~40% due to the limited optical absorption of the thinfilm; and (2) their response was strongly polarization-sensitive, due to the optical anisotropy of thenanowire. I will present two different approaches which enable to get very high (>90% [1]) andpolarization-insensitive [2,3] detection efficiency. We consider designs based on the integration of thenanowire within an optical microcavity (compatible with the plug-and-play configuration) or on topof an optical waveguide (preferred approach for integration in photonic circuits). I will finally discussnovel application prospects of such detectors, with emphasis on photon-number resolution.
Increasing the detection efficiency (DE) is a hot issue in the development of the superconducting nanowire single photon detector (SNSPD). In this work, a cavity-integrated structure coupled to the SNSPD is used to enhance the light absorption of nanowire. Ultra-thin Nb films are successfully prepared by magnetron sputtering, which are used to fabricate Nb/Al SNSPD with the curve of 100 nm and the square area of 4 × 4 μm 2 by sputtering and the lift-off method. To characterize the optical and electrical performance of the cavity-integrated SNSPD, a reliable cryogenic research system is built up based on a He 3 system. To satisfy the need of light coupling, a packaging structure with collimator is conducted. Both DE and the dark count rates increase with l b . It is also found that the DE of SNSPD with cavities can be up to 0.17% at the temperature of 0.7K under the infrared light of 1550 nm, which is obviously higher than that of the SNSPD directly fabricated upon silicon without any cavity structure.