Controlling a superconducting quantum processor

Vsevolod A. Vozhakov, M. V. Bastrakova, N. V. Klenov +5 more

Xiang Fu, Michiel Adriaan Rol, Cornelis Christiaan Bultink +10 more

This article proposes a quantum microarchitecture, QuMA. Flexible programmability of a quantum processor is achieved by multilevel instructions decoding, abstracting analog control into digital control, and translating instruction execution with non-deterministic timing into event trigger with precise timing. QuMA is validated by several single-qubit experiments on a superconducting qubit.

Yongcheng He, Jianshe Liu, Changhao Zhao +3 more

Peng Zhao, Ruixia Wang, Mengjun Hu +4 more

Accurate control of qubits is the central requirement for building functional quantum processors. For the current superconducting quantum processor, high-fidelity control of qubits is mainly based on independently calibrated microwave pulses, which could differ from each other in frequencies, amplitudes, and phases. With this control strategy, the needed physical resource could be challenging, especially when scaling up to large-scale quantum processors is considered. Inspired by Kane's proposal for spin-based quantum computing, here, we explore theoretically the possibility of baseband flux control of superconducting qubits with only shared and always-on microwave drives. In our strategy, qubits are by default far detuned from the drive during system idle periods, qubit readout and baseband flux-controlled two-qubit gates can thus be realized with minimal impacts from the always-on drive. By contrast, during working periods, qubits are tuned on resonance with the drive and single-qubit gates can be realized. Therefore, universal qubit control can be achieved with only baseband flux pulses and always-on shared microwave drives. We apply this strategy to the qubit architecture where tunable qubits are coupled via a tunable coupler, and the analysis shows that high-fidelity qubit control is possible. Besides, the baseband control strategy needs fewer physical resources, such as control electronics and cooling power in cryogenic systems, than that of microwave control. Of note, the flexibility of baseband flux control could be employed for addressing the nonuniformity issue of superconducting qubits, potentially allowing the realization of multiplexing and cross-bar technologies and thus controlling large numbers of qubits with fewer control lines. We thus expect that baseband control with shared microwave drives can help build large-scale superconducting quantum processors.

B. L. T. Plourde

Superconducting qubits based on Josephson junctions are one of the leading candidates for building a largescale quantum information processor. There have been significant advances in the performance of superconducting qubits over the past decade and there is currently rapid progress in the development of systems with up to tens of qubits. In order to build to yet larger systems, new techniques will need to be developed to address the overhead requirements for room-temperature electronics hardware and cryostat wiring for controlling and reading out large numbers of qubits. One approach to this challenge involves implementing more of the qubit control and readout in the low-temperature environment. I will describe our efforts on integrating superconducting classical digital circuitry with superconducting qubits for coherent control and readout.

Rutian Huang, Xiao Geng, Xinyu Wu +4 more

This paper proposes a scheme and design of cryogenic multiplexing control chip (MCC) which enables one microwave cable to control many superconducting qubits. Designed based on adjustable inductor, MCC is a non-reciprocal device which generates microwave signals between 4 and 8 GHz and constructs XY control circuit to operate qubits. The effects of filters, isolators, power splitters, qubits and load impedance on MCC are analyzed in the frequency-domain simulation. And in time-domain simulation, the response time, Gaussian pulses, single-sideband, amplitude and frequency compensation of MCC are examined. The MCC can be integrated with the superconducting qubits on the same package at 20 mK temperature stage, and output specific microwave pulses used to drive the superconducting qubits without crosstalks. The MCC can greatly reduce the number of microwave control lines and is beneficial to the development of large-scale superconducting quantum processor.