Recently, cold atoms in lattices blossomed as good candidates to mimic the prop- erties of electrons in solid state systems and to simulate other quantum systems. However, experimental techniques currently use optical lattices in the far-field. This limit the lattice spacing to λ/2, thus the relevant energy scale (tunneling and interaction), making it difficult to enter deeply into the proper quantum regimes to observe magnetic quantum correlations or strongly correlated phases. Our project aims at reducing the lattice period to bridge the gap between solid state ( ̊A) and far field lattice (500nm) by developing an hybrid quantum system of Bose and Fermi quantum gas in close proximity of a nano-structured surface generating sub-wavelength lattice potentials. To push toward this goal, we first developed a novel method to transport and then trap an ultracold atomic cloud in close vicinity of a surface. We will discuss about the early stage atom-chip produced, and report on some tests about the transport sequence. By measuring the power spectral density of the trap parameters, we can predict the noise- induce heating of the trapped cloud. In order to work with such system, one need to be able to address individually each sites with a resolution under the standard PSF limit. We implemented a tunable sub-wavelength imaging system with a theoretical resolution of 30nm that we used to resolve the wave-packet of a cloud in a single lattice site. This scheme involves two superimposed optical lattices, one at 1064nm and one at 1529nm, whose interfringe can be tuned. We present hereafter the experimental setup in detail and show interesting results we obtained.
Recently, cold atoms in lattices blossomed as good candidates to mimic the prop- erties of electrons in solid state systems and to simulate other quantum systems. However, experimental techniques currently use optical lattices in the far-field. This limit the lattice spacing to λ/2, thus the relevant energy scale (tunneling and interaction), making it difficult to enter deeply into the proper quantum regimes to observe magnetic quantum correlations or strongly correlated phases. Our project aims at reducing the lattice period to bridge the gap between solid state ( ̊A) and far field lattice (500nm) by developing an hybrid quantum system of Bose and Fermi quantum gas in close proximity of a nano-structured surface generating sub-wavelength lattice potentials. To push toward this goal, we first developed a novel method to transport and then trap an ultracold atomic cloud in close vicinity of a surface. We will discuss about the early stage atom-chip produced, and report on some tests about the transport sequence. By measuring the power spectral density of the trap parameters, we can predict the noise- induce heating of the trapped cloud. In order to work with such system, one need to be able to address individually each sites with a resolution under the standard PSF limit. We implemented a tunable sub-wavelength imaging system with a theoretical resolution of 30nm that we used to resolve the wave-packet of a cloud in a single lattice site. This scheme involves two superimposed optical lattices, one at 1064nm and one at 1529nm, whose interfringe can be tuned. We present hereafter the experimental setup in detail and show interesting results we obtained.
The entry into the new millennium was marked in the quantum community by the first experimental realizations of the Bose-Einstein condensation of atoms in a vapor, achieved in different research groups. Twenty-five years later, such systems are 'routinely' produced and are the core of many experiments. At the frontier between condensed matter their y, quantum optics, and atomic physics, ultra-cold atoms are subjects of high scientific interest.Ultra-cold gas can be trapped in optical lattices, giving a realistic way of experimentally realizing a new range of lattice Hamiltonians, that are used to simulate condensed matter systems. In these simulations, ultra-cold atoms are used to mimic the behavior of electrons in a solid-state material and could be used to simulate a wide range of complex condensed matter phenomena, such as the fractional quantum Hall effect, topological insulators, and high-temperature superconductivity.In order to study such systems, diffraction-limited quantum gas microscopes have emerged as a way to manipulate and detect atoms trapped in lattice potentials. Using far-field interference, experiments have mainly been restricted to a lattice spacing of 500 nm. This limits the speed of dynamics of all physical processes.Higher energy regimes could be accessed by reducing the lattice spacing. For this purpose, one of the long-term goals of the team is to trap atoms in the near-field of a surface and to make use of the Casimir-Polder forces to shape sub-wavelength potentials. Thanks to nano-fabrication capabilities, the spacing can be reduced to a few tens of nanometers. However, this requires to adapt the imaging techniques to observe cold-atoms with sub-wavelength spatial resolutions.In this PhD thesis, I report first on the advances toward implementing an atom chip in our experiment, which will serve as an integrated platform to manipulate the quantum gas. I present simulations and study an experimental solution allowing the cloud to be transported to the near-field. The method is based on the interference of a laser radiation in the near field of a rotating surface. It has been fully simulated, and the limitations have been numerically and experimentally assessed. I conclude this part by presenting the first model of chip that has been fabricated.In a second part, I report on the development of a sub-wavelength imaging method of cold Rubidium 87 atoms which is based on excited state dressing. I detail the concept of this nano-metric spatial resolution method and apply it to super-resolve a single longitudinal wave function trapped in a tight lattice that exhibits a width below 30 nm.
Quantum gas microscopes have become a major element for quantum simulations using ultra-cold atoms in optical lattices. They are for example used to observe long-range order such as anti-ferromagnetic correlations in far field optical lattices using density and spin resolved microscopy. Decreasing the period of such lattice offer interesting perspective to increase atom-atom interaction energies and engineer atom-light coupling that our group tackles via the hybridization of cold atoms and nano-structured surfaces.In this poster, we will present how such type of sub-wavelength lattice potentials can be generated by trapping atoms in proximity (tens to hundreds of nanometers) of a nano-structured surface. At such atom to surface distance, the attractive Casimir-Polder force can be compensated by a doubly dressed state trapping method that I will discuss. Such method additionally offers solutions to overcome the diffraction limit of conventional imaging that become critical for sub-wavelength lattices. In this work, I will present the experimental characterization of a sub-wavelength resolution absorption imaging applicable to quantum gas detection. This method requires a quantitative determination of the atom number of dense clouds which has been characterized in this work and demonstrate that the scattering cross section reduces linearly with the optical density. Modelling the propagation of light in dense cloud we show that this reduction can be attributed to re-scattering of the incoherent part of the resonant fluorescence spectrum.The poster will additionally present an update on our recent work on the spectroscopy of Acetylene in sealed hollow core fibers.
Ultracold atomic gases can be utilised as extremely sensitive probes of their surrounding environment. In particular, samples of ultracold atoms confined using chip-based microtraps are an ideal tool for mapping electric and magnetic field landscapes. Over the course of this thesis, a new experiment capable of performing surface microscopy using magnetically trapped clouds of cold rubidium-87 atoms has been built. The focus of the work is on the design and construction of the experimental system, which must incorporate many different aspects for manipulating thermal atomic gases, with a view to positioning them at sub-micron distances from special surfaces. This reduced atom-surface separation is necessary for implementing a high resolution, high sensitivity magnetic field sensor with cold atoms. Although current microfabrication techniques easily enable trapping at distances on the order of micrometres, several distance-dependent surface effects - such as the Casimir-Polder force, Johnson-Nyquist noise, and stray potentials - eventually impede magnetic trapping at the sub-micron level. These surface effects can greatly modify the confining potentials, which reduces the trap depth and consequently leads to an additional loss rate of atoms from the trap. We have explored the possibility of using special surfaces such as nano-membranes of silicon nitride and graphene, which have reduced atom- surface interactions, to enable trapping distances at the sub-micron level. A multilayer printed circuit board chip has been designed to form an initial magnetic trap and then transport the cloud of atoms to a desired location over the samples. This chip, along with various samples, is mounted on a custom-made electrical feedthrough designed to make connections to all conductor that are inside the vacuum chamber. The initial cloud of cold atoms can then be prepared in the central region of the chip and delivered to the location of the samples on either side. The experimental system is able to routinely capture over 10^8 rubidium-87 atoms at a temperature of 80 micro-Kelvin in a magneto-optical trap using a novel scheme of five laser beams. A method is demonstrated for enhancing the atom number in the magneto-optical traps by a factor of two by using laser beams with two slightly different frequencies. Atoms from the magneto-optical trap are then transferred to a purely magnetic trap formed by the wires on the printed circuit board chip. Time-dependent currents in the chip wires then create a dynamic potential, which is shown to successfully transport the atomic sample over a distance of 12 millimetre with minimal atom loss. This thesis describes the development of the apparatus in detail, along with careful characterisation of the cold cloud at various stages of the experimental sequence. Initial results on the long distance atom transport are presented. Finally, the experimental results of the two frequency magneto-optical trap for atom number improvement are discussed.
Cold atoms are a quantum system well-isolated from the environment. Since the 80s, they have been used to make high-sensitivity atomic sensors and to deepen the understanding of quantum physics phenomena. At low temperatures, degenerate atomic gas regimes can be reached. They are characterized by a macroscopic quantum state that can be manipulated and controlled by lasers. Placing such atomic wave function in optical lattices provide a way to study the dynamics of complex many-body systems. In this context, diffraction-limited quantum gas microscopes have emerged as standard tools to probe such complex systems and to measure atomic density correlations between lattice sites. By further reducing the optical lattices dimensions, the energy scales are strongly enhanced and favor novel quantum phases. Such reduction of optical lattice dimensions requires novel trapping and imaging techniques to manipulate cold-atoms with subwavelength spatial resolutions.In this PhD thesis, we experimentally perform subwavelength imaging of ultra-cold atoms of Rubidium 87 using a dressed excited state method, initially proposed for generating subwavelength trapping potentials. The measurement are performed using in situ absorption imaging. A quantitative comparison of data and theory lead us to reinterprete and modify a method for atom number calibrations that is commonly used in the community. This reinterpretation requires a fine understanding of the interaction of a single quantum multi-level system and a coherent saturating field. The measurement of the in situ transmission of a coherent probe shows a linear reduction of the single-atom scattering cross-section with the optical density for which we propose a physical interpretation and a model. Once calibrated, we use our subwavelength imaging method that reaches down to 20 nm resolution in a few microseconds to super-resolve a tiny quantum object : the longitudinal wave function of a BEC in a very tight lattice.
Ultra-cold atoms systems used as quantum simulators offer an alternative way to simulate many-body systemsbehaviour in condensed matter. Indeed, we can create artificial matter with optical lattices : the stationnarywave reproduces the potential wells in the crystalline structure. Moreover, the big advantage of using cold atomsis that the parameters of the simulated crystal can be well controlled so that we can understand the electricaland magnetism properties of the condensed matter such as conductivity, ferromagnetism ...The commonapproach for generating optical lattices is interfering two laser beams in one dimension. The lattice spacing islimited by the interfringe, which is half the wavelength. However, the more the lattice spacing decreases, themore the interaction energies increase [3].In the new ongoing project, we are going to produce subwavelengthlattices by irradiating a nanostructure gold layer. The subwavelength potential is got thanks to the control ofthe interactions between the beams, the atomic cloud, and the nanostructured surface. This system will be ableto study new interaction regimes with very high tunability (different lattice geometries, impurities...).
Abstract Ultracold atoms in optical lattices are a very promising quantum simulation platform, as they provide a very clean system (almost defect free) and allow control over many parameters such as tunneling coupling or interaction strength. Because the typical lattice spacing lies in the sub-micron range, it is technically demanding to resolve exactly the position of the atoms in the lattice using high-resolution optics such as quantum gas microscopy. Here we review the matter-wave protocol of quantum gas magnification that we developed for magnifying the atomic density distribution in the lattice (Asteria et al 2021 Nature 599 571). The atomic cloud, thus magnified by a factor of up to ∼ 90 , can then be imaged in a single-shot even with sub-lattice resolution with standard absorption imaging techniques. Furthermore, the protocol was demonstrated for 3D systems with high filling factors, which are typically impossible to measure with high-resolution imaging. In this tutorial, we will review how this technique can be used for high-resolution imaging of the density distribution and present the results obtained using it as a method to access new observables. We conclude with an outlook focusing on how this technique could be beneficial for a wide variety of physical systems which can be realized using cold atoms. This tutorial expands on the topic of my presentation for the SAMOP 2023 PhD Prize finalist symposium.