Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Annual Meeting Optical Society of America

Phase conjugate resonators and bistabilities in BaTiO3

Mostafa Dokhanian, Putcha Venkateswarlu, P. Chandra Sekhar

Published Jan 1, 1991• 0 citations
Publisher

Abstract

We report our observations of optical bistabilities and hysteresis1 in photorefractive passive phase conjugate resonators with BaTiO3, caused by grating erasure effects between two resonators in three different configurations. Bistable oscillations have been observed between two semilinear oscillators, two ring resonators, and also between a ring and a semilinear resonator. In the experimental arrangement used for bistability studies, a single-mode argon ion laser beam (4880 Å) entered the crystal in a face appropriate for self-pumped phase conjugation. However, the orientation is kept in such a way that no self-pumped phase conjugation is observable if none of the resonators is in operation. In this geometry, bistability and hysteresis were observed in the signal intensity of one resonator as the reflectivity of the variable beam reflector in the second resonator was increased and then decreased in a cycle. Bistability was also seen in the signal intensity of a single resonator as a function of the reflectivity of the external mirror.

DOI
10.1364/oam.1991.thmm42

Related papers

Optical bistability and hysteresis with a photorefractive self-pumped ring phase conjugate resonator

Bo Su Chen, Putcha Venkateswarlu

Optical bistability and hysteresis in BaTiO3 have been observed in a self-pumped ring resonator (SPRR). The SPRR can be controlled with an additional He–Ne laser erasing beam that makes an angle with the ring pump beam. The erasing beam could be coherent or incoherent with the pump beam. By injecting the erasing beam into the crystal in such a way as to partially erase the index grating and/or take energy from the pump beam, the coupling strength is modified. In either case, the output of the ring shows bistability and hystersis in the complete cycle of the on-off-on operation by monitoring the intensity of the erasing beam. The intensity change and the time interval between each change step of the erasing beam have effects on the hysteresis behavior. The hysteresis observed when it is controlled by a coherent erasing beam is more than the one by an incoherent erasing beam. Some fluctuations exist in the hysteresis loop when the coherent erasing beam is used.

Annual Meeting Optical Society of America•Jan 1, 1992•0 citations

Phase Conjugate Resonators and Bistable Oscillations in BaTiO3

Putcha Venkateswarlu, Mostafa Dokhanian, P. Chandra Sekhar +2 more

Kwang and Yariv(1) used a single domain BaTiO3 crystal to form a ring passive phase conjugator (RPPC) and auxiliary resonators pumped by a multi-mode Ar+ laser at 4880Å. The auxiliary resonators were bistable. Jagannath et. Al(2) from this laboratory, reported the operation of a unidirectional ring resonator (UDRR) in addition to the RPPC and found bistability between the two. They also observed a linear passive phase conjugator (LPPC) which is bistable with the RPPC. It was found that auxiliary oxci nations between the crystal and a mirror are bistable separately with the UDRR and the LPPC.

Photorefractive Effects, Materials, and Devices•Jan 1, 1990•0 citations

Optical bistability in self-pumped phase-conjugate ring resonators

H. Jagannath, Putcha Venkateswarlu, Merin George

Bistable oscillations have been observed in BaTiO(3) pumped by a single-mode 30-mW (488-nm) argon-ion laser, which is used simultaneously as a ring passive phase conjugator (RPPC) and as a unidirectional ring resonator (UDRR). Strong oscillations in the UDRR increase the threshold coupling strength required for oscillation in the RPPC. The oscillations in the RPPC reduce the fanning in the crystal necessary for the startup of oscillation in the UDRR. Auxiliary resonators pumped by the RPPC are also bistable with the UDRR. Similar bistable oscillations have been observed when the crystal is used simultaneously as a RPPC and as a linear passive phase conjugator.

Optics Letters•Dec 1, 1987•7 citations

Optical bistability and hysteresis with a photorefractive self-pumped phase conjugate mirror

Sze-Keung Kwong, Mark Cronin‐Golomb, Amnon Yariv

Bistability and hysteresis have been observed in a photorefractive passive phase conjugate mirror. A threshold basis for the effect is presented and the results of an experimental demonstration of the device are given.

Applied Physics Letters•Nov 15, 1984•58 citations

Bistable resonator utilizing saturable photorefractive gain and loss

Diana M. Lininger, Peter J. Martin, Dana Z. Anderson

We report the observation of bistability in a unidirectional ring resonator that employs photorefractive barium titanate for gain and also for saturated loss. One photorefractive crystal provides gain via two-beam coupling in a conventional unidirectional ring configuration.1 A second crystal is arranged to couple light out of the resonator using two-beam coupling, thereby producing loss. The orientations of the two crystals are chosen so that the magnitude of the small signal loss is greater than the magnitude of the small signal gain. Thus the oscillation in the ring cannot build up from noise since there is no net gain. However, the pump intensity for the gain medium is made larger than that for the loss medium. This means that the loss saturates at a lower signal level. Hence, at large intensities, gain can exceed net loss so oscillation can occur.

Annual Meeting Optical Society of America•Jan 1, 1988•0 citations

Bistable phase-conjugate resonator using an intracavity saturable absorber

M. B. Klein, Gilmore J. Dunning, Stephen W. McCahon +1 more

Phase-conjugate resonators have several attractive properties for image processing and storage. In the work described here, we demonstrate improved thresholding and storage properties of a phase-conjugate resonator (PCR) by the addition of an intracavity saturable absorber. It can be shown that the resonator will be bistable if (1) the small-signal absorption of the saturable absorber exceeds the small-signal gain of the phase-conjugate mirror, and (2) the absorption saturates more readily than the gain (i.e., reflectivity) of the PCM. Recently, a saturable absorber was used inside a PCR to control the transverse modes,1 but no evidence of bistability was obtained. In our experiment, we used a PCR bounded at one end by a conventional mirror and at the other end by an externally pumped BaTiO3 PCM. The saturable absorber was a solid film of fluorescein- doped boric acid glass.2 By adjustment of the total intensity and beam ratio at the PCM, we were able to demonstrate bistability. The input in our experiment was an incoherent control beam incident noncollinearly onto the intracavity saturable absorber. In the absence of a control beam, no oscillation was observed. When the control beam was turned on, the resonator switched to the on state in ~5 sec. The control beam could then be removed, and the cavity oscillation continued. To return to the off state, the resonator path was blocked.

Annual Meeting Optical Society of America•Jan 1, 1991•0 citations
We report our observations of optical bistabilities and hysteresis1 in photorefractive passive phase conjugate resonators with BaTiO3, caused by grating erasure effects between two resonators in three different configurations. Bistable oscillations have been observed between two semilinear oscillators, two ring resonators, and also between a ring and a semilinear resonator. In the experimental arrangement used for bistability studies, a single-mode argon ion laser beam (4880 Å) entered the crystal in a face appropriate for self-pumped phase conjugation. However, the orientation is kept in such a way that no self-pumped phase conjugation is observable if none of the resonators is in operation. In this geometry, bistability and hysteresis were observed in the signal intensity of one resonator as the reflectivity of the variable beam reflector in the second resonator was increased and then decreased in a cycle. Bistability was also seen in the signal intensity of a single resonator as a function of the reflectivity of the external mirror.
Optical bistability and hysteresis in BaTiO3 have been observed in a self-pumped ring resonator (SPRR). The SPRR can be controlled with an additional He–Ne laser erasing beam that makes an angle with the ring pump beam. The erasing beam could be coherent or incoherent with the pump beam. By injecting the erasing beam into the crystal in such a way as to partially erase the index grating and/or take energy from the pump beam, the coupling strength is modified. In either case, the output of the ring shows bistability and hystersis in the complete cycle of the on-off-on operation by monitoring the intensity of the erasing beam. The intensity change and the time interval between each change step of the erasing beam have effects on the hysteresis behavior. The hysteresis observed when it is controlled by a coherent erasing beam is more than the one by an incoherent erasing beam. Some fluctuations exist in the hysteresis loop when the coherent erasing beam is used.
Kwang and Yariv(1) used a single domain BaTiO3 crystal to form a ring passive phase conjugator (RPPC) and auxiliary resonators pumped by a multi-mode Ar+ laser at 4880Å. The auxiliary resonators were bistable. Jagannath et. Al(2) from this laboratory, reported the operation of a unidirectional ring resonator (UDRR) in addition to the RPPC and found bistability between the two. They also observed a linear passive phase conjugator (LPPC) which is bistable with the RPPC. It was found that auxiliary oxci nations between the crystal and a mirror are bistable separately with the UDRR and the LPPC.
Bistable oscillations have been observed in BaTiO(3) pumped by a single-mode 30-mW (488-nm) argon-ion laser, which is used simultaneously as a ring passive phase conjugator (RPPC) and as a unidirectional ring resonator (UDRR). Strong oscillations in the UDRR increase the threshold coupling strength required for oscillation in the RPPC. The oscillations in the RPPC reduce the fanning in the crystal necessary for the startup of oscillation in the UDRR. Auxiliary resonators pumped by the RPPC are also bistable with the UDRR. Similar bistable oscillations have been observed when the crystal is used simultaneously as a RPPC and as a linear passive phase conjugator.
We report the observation of bistability in a unidirectional ring resonator that employs photorefractive barium titanate for gain and also for saturated loss. One photorefractive crystal provides gain via two-beam coupling in a conventional unidirectional ring configuration.1 A second crystal is arranged to couple light out of the resonator using two-beam coupling, thereby producing loss. The orientations of the two crystals are chosen so that the magnitude of the small signal loss is greater than the magnitude of the small signal gain. Thus the oscillation in the ring cannot build up from noise since there is no net gain. However, the pump intensity for the gain medium is made larger than that for the loss medium. This means that the loss saturates at a lower signal level. Hence, at large intensities, gain can exceed net loss so oscillation can occur.
Phase-conjugate resonators have several attractive properties for image processing and storage. In the work described here, we demonstrate improved thresholding and storage properties of a phase-conjugate resonator (PCR) by the addition of an intracavity saturable absorber. It can be shown that the resonator will be bistable if (1) the small-signal absorption of the saturable absorber exceeds the small-signal gain of the phase-conjugate mirror, and (2) the absorption saturates more readily than the gain (i.e., reflectivity) of the PCM. Recently, a saturable absorber was used inside a PCR to control the transverse modes,1 but no evidence of bistability was obtained. In our experiment, we used a PCR bounded at one end by a conventional mirror and at the other end by an externally pumped BaTiO3 PCM. The saturable absorber was a solid film of fluorescein- doped boric acid glass.2 By adjustment of the total intensity and beam ratio at the PCM, we were able to demonstrate bistability. The input in our experiment was an incoherent control beam incident noncollinearly onto the intracavity saturable absorber. In the absence of a control beam, no oscillation was observed. When the control beam was turned on, the resonator switched to the on state in ~5 sec. The control beam could then be removed, and the cavity oscillation continued. To return to the off state, the resonator path was blocked.