To realize a neutral mercury lattice clock, an experimental setup is in developing in SIOM. With two stable cooling lasers and a new vacuum system, an enhanced cold mercury atom source is implemented based on a two-dimensional magneto-optical trap (2D-MOT). By applying a hybrid frequency stabilization method and optimization of the 2D-MOT, about 1.3×106cold mercury atoms are obtained with a loading rate of 1.0×106atoms/s. And a high power injection-locked Ti:sapphire laser at 725 nm is developed for optical lattice at magic-wavelength.
To realize a neutral mercury lattice clock, an experimental setup is in developing in SIOM. With two stable cooling lasers and a new vacuum system, an enhanced cold mercury atom source is implemented based on a two-dimensional magneto-optical trap (2D-MOT). By applying a hybrid frequency stabilization method and optimization of the 2D-MOT, about 1.3×106cold mercury atoms are obtained with a loading rate of 1.0×106atoms/s. And a high power injection-locked Ti:sapphire laser at 725 nm is developed for optical lattice at magic-wavelength.
Neutral mercury atom is one of good candidates of optical lattice clock. Due to its large atomic number, mercury atom is insensitive to black body radiation, which is the severe limitation for the development of optical clocks. However, the challenge of neutral mercury lattice clock is the requirement of high power deep-UV lasers, especially for both the cooling laser and the lattice laser. Here, we report the recent progress of neutral mercury lattice clock in SIOM, including the development for laser cooling of mercury atom and the cooling laser system with fiber laser amplifier. We have realized the magneto-optical trap of mercury atoms and measured the parameters of cold mercury atoms. A home-made external cavity diode laser works as a seed laser for a room temperature 1014.8 nm fiber laser amplifier. A new efficient frequency-doubling cavity from 1015 nm to 507 nm has been developed.
A cold atom source is important for quantum metrology and precision measurement. To reduce the quantum projection noise limit in optical lattice clock, one can increase the number of cold atoms and reduce the dead time by enhancing the loading rate. In this work, we realize an enhanced cold mercury atom source based on a two-dimensional (2D) magneto-optical trap (MOT). The vacuum system is composed of two titanium chambers connected with a differential pumping tube. Two stable cooling laser systems are adopted for the 2D-MOT and the three-dimensional (3D)-MOT, respectively. Using an optimized 2D-MOT and push beam, about 1.3×106 atoms, which are almost an order of magnitude higher than using a pure 3D-MOT, are loaded into the 3D-MOT for 202Hg atoms. This enhanced cold mercury atom source is helpful in increasing the frequency stability of a neutral mercury lattice clock.
The optical lattice clock develops fast in recent years, and its stability and accuracy has already surpassed the microwave fountain clock and the optical clock based on ion trap. The mercury (Hg) lattice clock has the possibility to make a breakthrough in the limitation of blackbody radiation shift for strontium (Sr) and ytterbium (Yb) lattice clock, and reach the uncertainty in E-18 level at room temperature. For the purposes of laser cooling of mercury atoms and interrogating of the clock transition from1S0state to3P0state, a high-power cooling laser at 253.7 nm and an ultra-stable Hz-level linewidth laser at 265.6 nm are required, respectively. Here, we report our development of these laser sources for a neutral Hg lattice clock.
Optics lattice clock is a hot topic in the researches of frequency standard and metrology. Neutral mercury atom is one of the most promising candidates for optical lattice clock. Due to its large atomic number, mercury atom is insensitive to black body radiation, which is the severe limitation for developing the optical lattice clocks. To realize the optical lattice clock of neutral mercury atoms, the first step is to implement laser-cooling and trapping of neutral mercury atoms. The cooling transition of mercury atom is 1S0-3P1 transition. The wavelength is 253.7 nm, the line width is 1.27 MHz, and the saturation intensity is 10.2 mW/cm2. Quantum projection noise (QPN) is an important parameter that affects optical lattice clock. Increasing the loading rate of magneto-optical trap (MOT) can help lower the QPN, thereby improving the performance of optical lattice clock. In this work, we calculate the scattering force of deep UV cooling laser, which is exerted on mercury atom in our single chamber MOT, and numerically simulate the one-dimensional motion of the atom in the MOT. It gives us the capture velocity under optimized parameters of the MOT. Then we calculate the loading rate of three-dimensional MOT by a high efficient random sampling method. According to the rate equation of MOT, the loading rate is proportional to the atom number of the steady state, which is the accessible parameter in the experiment. An experimental setup of MOT is established with a high vacuum system and a frequency quadrupled semiconductor laser system. The fluorescence imaging on an EMCCD gives the atom number in the MOT. We also calibrate the vapor density of background mercury gas in the vacuum, and measure the atom number in a steady MOT. We numerically simulate and experimentally study the influences on the atom number on the parameters of MOT, such as laser intensity, laser detuning and magnetic field gradient. The calculated results are in consistent with the experimental results. We also find the optimized parameters to maximize the loading rate. The numerical simulation also gives some results beyond current experimental condition, especially for laser intensity. From the simulations we obtain the optimized MOT parameter and relation for laser cooling of neutral mercury atom. Especially, current deep UV cooling laser with 20 mW of power does not have enough power to enhance the loading rate. These results are rather valuable for designing the next generation of optical lattice clocks for neutral mercury atoms.
We are investigating the possibilities of using neutral mercury as a new species to realize a highly accurate atomic clock using the non-perturbing dipole lattice trapping scheme. Typically, accuracy below 10-17 is targeted, which would make neutral mercury an interesting candidate for a redefinition of the SI second. This paper presents our on-going work towards the realization of an optical lattice clock using neutral mercury. We will describe a 254 nm laser source delivering several hundreds of milliWatts at this wavelength with a suitably low frequency noise for laser cooling and magneto-optic trapping. We will describe our vacuum system for magneto-optic trap and report on the status of our work regarding magneto-optic trapping of mercury. We will also describe our clock laser at 266 nm.
Mercury is the heaviest stable atom that could be laser cooled, and have a large nuclear charge number. So it has a distinct advantage in quantum precision measurement such as fine-structure constant α and permanent electric dipole moment. Due to its insensitivity of black body radiation, atomic mercury is a good candidate of optical clock. Here we report our recent development of laser cooling of neutral mercury atom. By cooling the mercury source to about -70°C, an ultra-high vacuum system was realized to produce ultracold mercury atoms. The commercial frequency quadrupled semiconductor laser is locked on the cooling transition (1S0-3P1 transition, wavelength of 253.7 nm) by sub-Doppler frequency modulation spectroscopy. By the modification with feed-forward method, the UV laser becomes faster tunable and more stable. A folded beam configuration was used to realize the magneto-optical trap (MOT) because of the shortage of cooling laser power, and the ultracold mercury atoms were observed by fluorescence detection. All of six rich abundant isotopes have been observed, and the atom number is about 1.5×106 with density of 3.5×109 /cm3 for 202Hg. With optical shutter and the programmable system to control the time sequence, the temperature of ultracold atoms can be measured by time of flight method. To enhance the laser power, a 1014.8 nm fiber laser amplifier was developed, which can work at room temperature. After two stages of frequency doubling, about 75 mW of 253.7 nm UV laser were generated, and the saturated absorption spectroscopy of mercury atom was also observed. More power of UV laser could help to trap more atoms in the future. These works laid a good foundation to realize the mercury lattice clock.