We present a planar qubit design based on a superconducting circuit that we call concentric transmon. While employing a straightforward fabrication process using Al evaporation and lift-off lithography, we observe qubit lifetimes and coherence times in the order of 10 μs. We systematically characterize loss channels such as incoherent dielectric loss, Purcell decay and radiative losses. The implementation of a gradiometric SQUID loop allows for a fast tuning of the qubit transition frequency and therefore for full tomographic control of the quantum circuit. Due to the large loop size, the presented qubit architecture features a strongly increased magnetic dipole moment as compared to conventional transmon designs. This renders the concentric transmon a promising candidate to establish a site-selective passive direct Ẑ coupling between neighboring qubits, being a pending quest in the field of quantum simulation.
We present a planar qubit design based on a superconducting circuit that we call concentric transmon. While employing a straightforward fabrication process using Al evaporation and lift-off lithography, we observe qubit lifetimes and coherence times in the order of 10us. We systematically characterize loss channels such as incoherent dielectric loss, Purcell decay and radiative losses. The implementation of a gradiometric SQUID loop allows for a fast tuning of the qubit transition frequency and therefore for full tomographic control of the quantum circuit. Due to the large loop size, the presented qubit architecture features a strongly increased magnetic dipole moment as compared to conventional transmon designs. This renders the concentric transmon a promising candidate to establish a site-selective passive direct Z coupling between neighboring qubits, being a pending quest in the field of quantum simulation.
Flux tuning of qubit frequencies in superconducting quantum processors is fundamental for implementing single and multi-qubit gates in quantum algorithms. Typical architectures involve the use of DC or fast RF lines. However, these lines introduce significant heat dissipation and undesirable decoherence mechanisms, leading to a severe bottleneck for scalability. Among different solutions to overcome this issue, we propose integrating tunnel Superconductor-Insulating-thin superconducting interlayer-Ferromagnet-Superconductor Josephson junctions (SIsFS JJs) into a novel transmon qubit design, the so-called ferrotransmon. SIsFS JJs provide memory properties due to the presence of ferromagnetic barriers and preserve at the same time the low-dissipative behavior of tunnel-insulating JJs, thus promoting an alternative tuning of the qubit frequency. In this work, we discuss the fundamental steps towards the implementation of this hybrid ferromagnetic transmon. We will give a special focus on the design, simulations, and preliminary experimental characterization of superconducting lines to provide in-plane magnetic fields, fundamental for an on-chip control of the qubit frequencies in the ferrotransmon.
We present an experimental study of flux- and gate-tunable nanowire transmons with state-of-the-art relaxation time allowing quantitative extraction of flux and charge noise coupling to the Josephson energy. We evidence coherence sweet spots for charge, tuned by voltage on a proximal side gate, where first order sensitivity to switching two-level systems and background 1/f noise is minimized. Next, we investigate the evolution of a nanowire transmon in a parallel magnetic field up to 70 mT, the upper bound set by the closing of the induced gap. Several features observed in the field dependence of qubit energy relaxation and dephasing times are not fully understood. Using nanowires with a thinner, partially covering Al shell will enable operation of these circuits up to 0.5 T, a regime relevant for topological quantum computation and other applications.
Abstract Superconducting quantum circuits are a leading platform for quantum-information processing, but their development requires expertise spanning device design, microfabrication, cryogenic operation, microwave control, and quantum characterization. In this work, we report the realization of a flux-tunable superconducting transmon platform and present an integrated workflow encompassing design, fabrication, measurement, and numerical modeling. The device consists of an
Al/AlOx/Al transmon coupled to a three-dimensional microwave cavity operating in the circuit quantum electrodynamics (cQED) dispersive regime. Two-tone spectroscopy reveals a fundamental transition frequency of
ω01=5.0122 GHz and an anharmonicity of
α/2π=−202.4 MHz , corresponding to
EJ/EC≈82.9 . Flux spectroscopy yields a cavity-qubit coupling strength of
g/2π=260 MHz , while the cavity linewidth gives a loaded quality factor of
QL=6127 and a Purcell limit of
T1Purcell≈82 μs . Time-domain measurements yield coherence times of
T1=17.4 μs and
T2∗=5.8 μs . To investigate coherence and dissipation in the device, the experimental observations are analyzed within a Lindblad master-equation framework describing cavity photon loss and thermal excitation, qubit energy relaxation, and pure dephasing processes. Using a set of experimentally extracted parameters, the model reproduces the measured spectroscopic and time-domain observables, providing a quantitative description of the open-system dynamics of the transmon-cavity platform. The analysis shows that the measured coherence is primarily limited by pure dephasing and energy-relaxation processes, whereas thermal excitation plays a minor role under the experimental conditions. Inspired by the broader framework of quantum dissipation in macroscopic quantum systems pioneered by Caldeira and collaborators, this approach enables a quantitative analysis of relaxation and dephasing processes in superconducting quantum circuits. Beyond the characterization of a single device, the present work demonstrates the establishment of the expertise, infrastructure, and experimental workflow required for the design, fabrication, measurement, and modeling of superconducting quantum circuits, contributing to the development of quantum technologies in Brazil and related applications.