We report on a fractal superconducting nanowire avalanche photodetector simultaneously with 60% system efficiency, 1.05 polarization sensitivity, 4-ns recovery time, and 45-ps timing jitter. The efficiency is the highest among polycrystalline SNSPDs with polarization-insensitive designs.
Superconducting nanowire (nanostrip) single-photon detectors (SNSPDs) have shown unprecedented detection efficiency and timing properties, but simultaneously achieving polarization-insensitive high detection efficiency, low dark-count rate (DCR), fast speed, and low timing jitter remains a challenge. Here we report on our design, fabrication, and characterization of a cascaded superconducting avalanche photodetector composed of 40 nm wide NbTiN nanowires patterned into fractal curves. At the base temperature of 2.7 K, the device exhibits 60±3% system detection efficiency at the wavelength of 1550 nm, 1.05 polarization sensitivity, 220 cps DCR, 4 ns recovery time, and 45 ps timing jitter. This Letter not only demonstrates these combined properties on a single detector that was unobtainable previously, but also shows that that current-crowding effect remarkably permits decent internal detection efficiency. These counter-intuitive results expand the understanding pertaining to the device physics of SNSPDs.
Superconducting nanowire single-photon detectors (SNSPDs) have become a mainstream photon-counting technology that has been used in various applications. So far, most multi-channel SNSPD systems, either reported in literature or been commercially available, are polarization sensitive, that is, the system detection efficiency (SDE) of each channel is dependent on the state of polarization of the to-be-detected photons. Here, we report on an eight-channel system with fractal superconducting nanowire single-photon detectors working in the wavelength range of 930-940 nm that all feature low polarization sensitivity. In a close-cycled Gifford-McMahon cryocooler system with the base temperature of 2.2 K, we install and compare the performance of two types of devices: (1) SNSPD, composed of a single, continuous nanowire, and (2) superconducting nanowire avalanche photodetector (SNAP), composed of 16 cascaded units of two nanowires electrically connected in parallel. The highest system detection efficiency (SDE) among the eight channels reaches 96−5+4%, with polarization sensitivity of 1.02 and dark-count rate of 13 counts per second. The average SDE for eight channels for all states of polarization is estimated to be 90 ± 5%. We conclude that both the SNSPDs and the SNAPs can reach saturated, high SDE at the wavelength of interest, and the SNSPDs show lower dark- (false-) count rates while the SNAPs show better properties in the time domain. Using this system, we showcase the measurements of the second-order photon-correlation functions of light emission from a single-photon source based on a semiconductor quantum dot and from a pulsed laser. We believe that our work provides new choices of systems with single-photon detectors combining the merits of high SDE, low polarization sensitivity, and low noise that can be tailored for different applications.
The near-unity system detection efficiency (SDE) and excellent timing resolution of superconducting nanowire single-photon detectors (SNSPDs), combined with their other merits, have enabled many classical and quantum photonic applications. However, the prevalent design based on meandering nanowires makes SDE dependent on the polarization states of the incident photons; for unpolarized light, the major merit of high SDE would get compromised, which could be detrimental to photon-starved applications. Here, we create SNSPDs with an arced fractal geometry that almost completely eliminates this polarization dependence of the SDE, and we experimentally demonstrate 84 ± 3% SDE, 1.02 –0.02 +0.06 polarization sensitivity at the wavelength of 1575 nm, and 20.8 ps timing jitter in a 0.1 W closed-cycle Gifford–McMahon cryocooler, at the base temperature of 2.0 K. This demonstration provides a novel, practical device structure of SNSPDs, allowing for operation in the visible, near-infrared, and mid-infrared spectral ranges, and paves the way for polarization-insensitive single-photon detection with high SDE and high timing resolution.
The near-unity detection efficiency and excellent timing resolution of superconducting nanowire single-photon detectors (SNSPDs), combined with their other merits, have enabled many classical and quantum photonic applications. However, the prevalent design based on meandering nanowires makes the detection efficiency dependent on the polarization states of the incident photons; for unpolarized light, the major merit of high detection efficiency would get compromised, which could be detrimental for photon-starved applications. In quantum-key distribution systems, the polarization dependence of detection efficiency of the SNSPDs could also be a vulnerable security loophole. Here, we create SNSPDs with an arced fractal topology that almost completely eliminates this polarization dependence of the detection efficiency while preserving other major merits of the SNSPDs. We experimentally demonstrated 91$\pm$2% system detection efficiency at the wavelength of 1590 nm for photons in any polarization state and 19 ps timing jitter. The detector was fiber-coupled and fully packaged in a 0.1-W close-cycled Gifford-McMahon cryocooler. This demonstration provides a novel, practical device structure of SNSPDs, allowing for operation in the visible, near- and mid-infrared spectral ranges, and paves the way for polarization-insensitive single-photon detection with high detection efficiency and high timing resolution.
We demonstrate superconducting nanowire single-photon detectors (SNSPDs) based on a fractal design of the nanowires to reduce the polarization sensitivity of detection efficiency. We patterned niobium titanium nitride thin films into Peano curves with a linewidth of 100 nm and integrated the nanowires with optical microcavities to enhance their optical absorption. At a base temperature of 2.6 K, the fractal SNSPD exhibited a polarization-maximum device efficiency of 67% and a polarization-minimum device efficiency of 61% at a wavelength of 1550 nm. Therefore, the polarization sensitivity, defined as their ratio, was 1.1, lower than the polarization sensitivity of the SNSPDs in the meander design. The reduced polarization sensitivity of the detector could be maintained for higher-order spatial modes in multimode optical fibers and could tolerate misalignment between the optical mode and the detector. This fractal design is applicable to both amorphous and polycrystalline materials that are commonly used for making SNSPDs.