Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IOP Conference Series Materials Science and Engineering

Investigation of WSi and NbN superconducting single-photon detectors in mid-IR range

A.V. Antipov, Vadim Aleksandrovich Seleznev, Yu. B. Vakhtomin, Pavel Morozov, Д.Д. Васильев, Elizaveta I. Malevannaya, Konstantin M. Moiseev, Смирнов Константин Владимирович

Published Apr 1, 2020• 0 citations
Publisher

Abstract

Abstract Spectral characteristics of WSi and NbN superconducting single-photon detectors with different surface resistance and width of nanowire strips have been investigated in the wavelength range of 1.3-2.5 μm. WSi structures with narrower strips demonstrated better performance for detection of single photons in longer wavelength range. The difference in normalized photon count rate for such structures reaches one order of magnitude higher in comparison with structures based on NbN thin films at 2.5 μm.

DOI
10.1088/1757-899x/781/1/012011

Related papers

NbN Nanowire Superconducting Single-Photon Detector for Mid-Infrared

Alexander A. Korneev, Yu. P. Korneeva, Irina Florya +2 more

Superconducting single-photon detectors (SSPD) is typically 100 nm-wide supercondiucting strip in a shape of meander made of 4-nm-thick film. To reduce response time and increase voltage response a parallel connection of the strips was proposed. Recently we demonstrated that reduction of the strip width improves the quantum effciency of such a detector at wavelengths longer than 1.5 μm. Being encourage by this progress in quantum effciency we improved the fabrication process and made parallel-wire SSPD with 40-nm-wide strips covering total area of 10 μm x 10 μm. In this paper we present the results of the characterization of such a parallel-wire SSPD at 10.6 μm wavelength and demonstrate linear dependence of the count rate on the light power as it should be in case of single-photon response.

Physics Procedia•Jan 1, 2012•28 citations

New Generation of Nanowire NbN Superconducting Single-Photon Detector for Mid-Infrared

Yu. P. Korneeva, Irina Florya, Alexander V. Semenov +2 more

We present a break-through approach to mid-infrared single-photon detection based on nanowire NbN superconducting single-photon detectors (SSPD). Although SSPD became a mature technology for telecom wavelengths (1.3-1.55 μm) its further expansion to mid-infrared wavelength was hampered by low sensitivity above 2 μm. We managed to overcome this limit by reducing the nanowire width to 50 nm, while retaining high superconducting properties and connecting the wires in parallel to produce a voltage response of sufficient magnitude. The new device exhibits 10 times better quantum efficiency at 3.5 μm wavelength than the “standard” SSPD.

IEEE Transactions on Applied Superconductivity•Nov 18, 2010•26 citations

Spectral sensitivity of narrow strip NbN superconducting single-photon detector

Alexander A. Korneev, Yu. P. Korneeva, Irina Florya +2 more

Superconducting single-photon detector (SSPD) is patterned from 4-nm-thick NbN film deposited on sapphire substrate as a 100-nm-wide strip. Due to its high detection efficiency, low dark counts, and picosecond timing jitter SSPD has become a competitor to the InGaAs avalanche photodiodes at 1550 nm and longer wavelengths. Although the SSPD is operated at liquid helium temperature its efficient single-mode fibre coupling enabled its usage in many applications ranging from single-photon sources research to quantum cryptography. In our strive to increase the detection efficiency at 1550 nm and longer wavelengths we developed and fabricated SSPD with the strip almost twice narrower compared to the standard 100 nm. To increase the voltage response of the device we utilized cascade switching mechanism: we connected 50-nm-wide and 10-μm-long strips in parallel covering the area of 10 μmx10 μm. Absorption of a photon breaks the superconductivity in a strip leading to the bias current redistribution between other strips followed their cascade switching. As the total current of all the strips about is 1 mA by the order of magnitude the response voltage of such an SSPD is several times higher compared to the traditional meander-shaped SSPDs. In middle infrared (about 3 μm wavelength) these devices have the detection efficiency several times higher compared to the traditional SSPDs.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 29, 2011•3 citations

Development of high-effective superconducting single-photon detectors aimed for mid-IR spectrum range

Philipp I. Zolotov, Alexander V. Divochiy, Yu. B. Vakhtomin +3 more

We report on development of superconducting single-photon detectors (SSPD) with high intrinsic quantum efficiency in the wavelength range 1.31 – 3.3 μm. By optimization of the NbN film thickness and its compound, we managed to improve detection efficiency of the detectors in the range up to 3.3 μm. Optimized devices showed intrinsic quantum efficiencies as high as 10% at mid-IR range.

Journal of Physics Conference Series•Nov 1, 2017•7 citations

Superconducting nanowire materials for mid infrared single photon detection (Conference Presentation)

D. Morozov, Archan Banerjee, Kleanthis Erotokritou +5 more

Superconducting nanowire single photon detectors (SNSPD) offer excellent performance for infrared single photon detection, combining high efficiency, low timing jitter, low dark count rates and high photon counting rates. Promising application areas for SNSPDs include quantum key distribution, space-to-ground communications and single photon remote sensing [1]. SNSPDs are typically made with ultrathin niobium nitride (NbN) films with thickness 4 nm and a superconducting transition temperature above 9 K. NbN offers high performance in the near infrared but their sensitivity drops at wavelengths beyond 2 um. There is growing interest in potential photon counting applications in the mid infrared domain (for example remote sensing of greenhouse gases in the atmosphere [2]). One way to overcome the wavelength limit in NbN SNSPDs is to use films with a lower superconducting energy gap [3]. Here we report on the study of SNSPDs fabricated with thin films of titanium nitride (TiN). We compare TiN films deposited by atomic layer deposition (ALD) and by magnetron sputtering. The TiN films range in thickness from 5 to 60 nm, with superconducting transition temperatures from ~1 K to 3.5 K. We have analyzed the films via transmission electron microscopy and variable angle spectroscopic ellipsometry. We characterize TiN SNSPDs performance from near to mid-infrared at wavelengths (1-4 um) with fast optical parametric oscillator (OPO) source. We compare the performance of TiN SNSPDs to devices based on other lower gap materials: MoSi, NbTiN, WSi. [1] Natarajan et al Superconductor Science and Technology 25 063001 (2012) [2] Abshire et al Laser Applications to Chemical, Security and Environmental Analysis, (Optical Society of America, 2008) paper LMA4 [3] Verma et al Applied Physics Letters 105 022602 (2014)

Advanced Photon Counting Techniques•May 14, 2018•3 citations

Superconducting nanowire single-photon detector made of ultrathin γ -Nb 4 N 3 film for mid-infrared wavelengths

Yiming Pan, Hui Zhou, Lu Zhang +6 more

Abstract Superconducting nanowire single-photon detectors (SNSPDs) made of ultrathin δ -NbN films have been widely applied in both visible and infrared wavelengths. For mid-infrared (MIR) wavelengths, SNSPDs made of tungsten silicide films with a lower critical temperature were reported up to 9.9 μ m wavelength. In this study, we demonstrate the potential of NbN-SNSPDs for use in MIR applications. SNSPDs made of γ -Nb 4 N 3 films (critical temperature of 5.1 K for 6.5 nm thick films) instead of δ -NbN films were fabricated. The dependence of the normalized detection efficiency on the bias current indicated a clear trend toward a saturated plateau for wavelengths up to 2145 nm. The calculated cut-off wavelengths indicated the possibility of using γ -Nb 4 N 3 SNSPDs for longer MIR wavelengths.

Superconductor Science and Technology•Apr 15, 2021•12 citations
Abstract Spectral characteristics of WSi and NbN superconducting single-photon detectors with different surface resistance and width of nanowire strips have been investigated in the wavelength range of 1.3-2.5 μm. WSi structures with narrower strips demonstrated better performance for detection of single photons in longer wavelength range. The difference in normalized photon count rate for such structures reaches one order of magnitude higher in comparison with structures based on NbN thin films at 2.5 μm.
Superconducting single-photon detectors (SSPD) is typically 100 nm-wide supercondiucting strip in a shape of meander made of 4-nm-thick film. To reduce response time and increase voltage response a parallel connection of the strips was proposed. Recently we demonstrated that reduction of the strip width improves the quantum effciency of such a detector at wavelengths longer than 1.5 μm. Being encourage by this progress in quantum effciency we improved the fabrication process and made parallel-wire SSPD with 40-nm-wide strips covering total area of 10 μm x 10 μm. In this paper we present the results of the characterization of such a parallel-wire SSPD at 10.6 μm wavelength and demonstrate linear dependence of the count rate on the light power as it should be in case of single-photon response.
We present a break-through approach to mid-infrared single-photon detection based on nanowire NbN superconducting single-photon detectors (SSPD). Although SSPD became a mature technology for telecom wavelengths (1.3-1.55 μm) its further expansion to mid-infrared wavelength was hampered by low sensitivity above 2 μm. We managed to overcome this limit by reducing the nanowire width to 50 nm, while retaining high superconducting properties and connecting the wires in parallel to produce a voltage response of sufficient magnitude. The new device exhibits 10 times better quantum efficiency at 3.5 μm wavelength than the “standard” SSPD.
Superconducting single-photon detector (SSPD) is patterned from 4-nm-thick NbN film deposited on sapphire substrate as a 100-nm-wide strip. Due to its high detection efficiency, low dark counts, and picosecond timing jitter SSPD has become a competitor to the InGaAs avalanche photodiodes at 1550 nm and longer wavelengths. Although the SSPD is operated at liquid helium temperature its efficient single-mode fibre coupling enabled its usage in many applications ranging from single-photon sources research to quantum cryptography. In our strive to increase the detection efficiency at 1550 nm and longer wavelengths we developed and fabricated SSPD with the strip almost twice narrower compared to the standard 100 nm. To increase the voltage response of the device we utilized cascade switching mechanism: we connected 50-nm-wide and 10-μm-long strips in parallel covering the area of 10 μmx10 μm. Absorption of a photon breaks the superconductivity in a strip leading to the bias current redistribution between other strips followed their cascade switching. As the total current of all the strips about is 1 mA by the order of magnitude the response voltage of such an SSPD is several times higher compared to the traditional meander-shaped SSPDs. In middle infrared (about 3 μm wavelength) these devices have the detection efficiency several times higher compared to the traditional SSPDs.
Superconducting nanowire single photon detectors (SNSPD) offer excellent performance for infrared single photon detection, combining high efficiency, low timing jitter, low dark count rates and high photon counting rates. Promising application areas for SNSPDs include quantum key distribution, space-to-ground communications and single photon remote sensing [1]. SNSPDs are typically made with ultrathin niobium nitride (NbN) films with thickness 4 nm and a superconducting transition temperature above 9 K. NbN offers high performance in the near infrared but their sensitivity drops at wavelengths beyond 2 um. There is growing interest in potential photon counting applications in the mid infrared domain (for example remote sensing of greenhouse gases in the atmosphere [2]). One way to overcome the wavelength limit in NbN SNSPDs is to use films with a lower superconducting energy gap [3]. Here we report on the study of SNSPDs fabricated with thin films of titanium nitride (TiN). We compare TiN films deposited by atomic layer deposition (ALD) and by magnetron sputtering. The TiN films range in thickness from 5 to 60 nm, with superconducting transition temperatures from ~1 K to 3.5 K. We have analyzed the films via transmission electron microscopy and variable angle spectroscopic ellipsometry. We characterize TiN SNSPDs performance from near to mid-infrared at wavelengths (1-4 um) with fast optical parametric oscillator (OPO) source. We compare the performance of TiN SNSPDs to devices based on other lower gap materials: MoSi, NbTiN, WSi. [1] Natarajan et al Superconductor Science and Technology 25 063001 (2012) [2] Abshire et al Laser Applications to Chemical, Security and Environmental Analysis, (Optical Society of America, 2008) paper LMA4 [3] Verma et al Applied Physics Letters 105 022602 (2014)
Abstract Superconducting nanowire single-photon detectors (SNSPDs) made of ultrathin δ -NbN films have been widely applied in both visible and infrared wavelengths. For mid-infrared (MIR) wavelengths, SNSPDs made of tungsten silicide films with a lower critical temperature were reported up to 9.9 μ m wavelength. In this study, we demonstrate the potential of NbN-SNSPDs for use in MIR applications. SNSPDs made of γ -Nb 4 N 3 films (critical temperature of 5.1 K for 6.5 nm thick films) instead of δ -NbN films were fabricated. The dependence of the normalized detection efficiency on the bias current indicated a clear trend toward a saturated plateau for wavelengths up to 2145 nm. The calculated cut-off wavelengths indicated the possibility of using γ -Nb 4 N 3 SNSPDs for longer MIR wavelengths.