Background Limited Superconducting Quantum Detector for Astronomy

Alexei D. Semenov, Heinz‐Wilhelm Hübers, Gregory N Gol'tsman +1 more

Alexei D. Semenov, Heinz‐Wilhelm Hübers, Gregory N Gol'tsman +1 more

Gregory N Gol'tsman, Alexei D. Semenov, Konstantin Smirnov +1 more

Alexei D. Semenov, Andreas Engel, Heinz‐Wilhelm Hübers +2 more

We extend the concept of the superconducting quantum counter in order to develop a new quantum detector for submillimeter astronomy. The detector exploits a cumulative detection mechanism, in which the response appears due to successive formation of the normal spot and a resistive domain in a narrow strip carrying sub-critical supercurrent. The intrinsic recovery time of the counter is partly determined by diffusion of nonequilibrium electrons and, thus, depends on the energy of detected photons. Depending on the superconducting material used and operation conditions, such detector may have cut-off wavelengths for the single-photon regime ranging from terahertz waves to visible light and simultaneously provide a moderate energy resolution. We simulated performance of the background-limited submillimeter direct detector from Ti having the 100-micrometer cut-off wavelength, low dark count rate and intrinsic 10-21 W Hz-1/2 noise equivalent power for 4-K background radiation. We present first results obtained with a detector prototype fabricated from ultra-thin Nb film.

Alexei D. Semenov, Andreas Engel, K. Ilin +3 more

We analyze the ultimate performance of a superconducting quantum detector in order to meet requirements for applications in near-infrared astronomy and X-ray spectroscopy. The detector exploits a combined detection mechanism, in which avalanche quasiparticle multiplication and the supercurrent jointly produce a voltage response to a single absorbed photon via successive formation of a photon-induced and a current-induced normal hotspot in a narrow superconducting strip. The response time of the detector should increase with the photon energy providing energy resolution. Depending on the superconducting material and operation conditions, the cut-off wavelength for the single-photon detection regime varies from infrared waves to visible light. We simulated the performance of the background-limited infrared direct detector and X-ray photon counter utilizing the above mechanism. Low dark count rate and intrinsic low-frequency cut-off allow for realizing a background limited noise equivalent power of 10−20 W Hz−1/2 for a far-infrared direct detector exposed to 4-K background radiation. At low temperatures, the intrinsic response time of the counter is rather determined by diffusion of nonequilibrium electrons than by the rate of energy transfer to phonons. Therefore, thermal fluctuations do not hamper energy resolution of the X-ray photon counter that should be better than 10−3 for 6-keV photons. Comparison of new data obtained with a Nb based detector and previously reported results on NbN quantum detectors support our estimates of ultimate detector performance.

R. M. J. Janssen, J. J. A. Baselmans, Akira Endo +4 more

In the next decades millimeter and sub-mm astronomy requires large format imaging arrays and broad-band spectrometers to complement the high spatial and spectral resolution of the Atacama Large Millimeter/submillimeter Array. The desired sensors for these instruments should have a background limited sensitivity and a high optical efficiency and enable arrays thousands of pixels in size. Hybrid microwave kinetic inductance detectors consisting of NbTiN and Al have shown to satisfy these requirements. We present the second generation hybrid NbTiN-Al MKIDs, which are photon noise limited in both phase and amplitude readout for loading levels P850GHz < 10 fW. Thanks to the increased responsivity, the photon noise level achieved in phase allows us to simultaneously read out approximately 8000 pixels using state-of-the-art electronics. In addition, the choice of superconducting materials and the use of a Si lens in combination with a planar antenna gives these resonators the flexibility to operate within the frequency range 0:09 < v < 1:1 THz. Given these specifications, hybrid NbTiN-Al MKIDs will enable astronomically usable kilopixel arrays for sub-mm imaging and moderate resolution spectroscopy.