Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Optics

Large-area multispectral superconducting nanowire single-photon detector

Heqing Wang, Hao Li, Lixing You, Peng Hu, Xingyu Zhang, Yong Wang, Weijun Zhang, Xiaoyan Yang, Lu Zhang, Hui Zhou, Zhen Wang, Xiaoming Xie

Published Oct 14, 2019• 10 citations
Publisher

Abstract

In this work, we report a large-active-area multispectral superconducting nanowire single-photon detector for free-space applications. The detector is realized by fabricating NbTiN nanowire with an active area of 35 µm diameter on two serially connected dielectric mirrors that can simultaneously and efficiently detect single photons at the three typical wavelengths employed in free-space applications, namely, 532, 850, and 1064 nm. Maximal system detection efficiencies (SDEs) of 80.0% at 532 nm and 850 nm and 75.8% at 1064 nm are achieved for polarized light obtained by coupling the detector with an SMF-28 fiber. Upon coupling with a 50 µm multimode fiber, SDEs of 68.6%, 59.6%, and 47.0%, are achieved for 532, 850, and 1064 nm wavelength unpolarized light, respectively. Moreover, the detector shows timing jitters of 37.1 and 41.0 ps when coupled with SMF-28 fiber and 50 µm multimode fiber. This type of detector with a large active area and multiwavelength detection capability is promising for both single and multiwavelength free-space applications.

DOI
10.1364/ao.58.008148

Related papers

Multimode fiber-coupled superconducting nanowire single-photon detector with 70% system efficiency at visible wavelength

Dengkuan Liu, Shigehito Miki, Taro Yamashita +3 more

We report the development of the multimode fiber-coupled superconducting nanowire single-photon detector with high system detection efficiency at visible wavelength. The detector consists of a 10.5-nm-thick and 150-nm-wide NbN nanowire meander fabricated on a Si substrate with a multilayer dielectric mirror and a quarter wavelength cavity for obtaining high optical absorptance. The meander area was 35 µm in diameter and coupled with the GRIN-lensed multimode optical fiber with a core diameter of 50 µm. The system reached detection efficiency of 70% with dark count rate of 100 Hz at the wavelength of 635 nm, 3 dB roll-off response counting rate of 8.5 Mcps, and timing jitter of 76 ps.

Optics Express•Aug 25, 2014•37 citations

Large-sensitive-area superconducting nanowire single-photon detector at 850 nm with high detection efficiency

Hao Li, Lu Zhang, Lixing You +6 more

Satellite-ground quantum communication requires single-photon detectors of 850-nm wavelength with both high detection efficiency and large sensitive area. We developed superconducting nanowire single-photon detectors (SNSPDs) on one-dimensional photonic crystals, which acted as optical cavities to enhance the optical absorption, with a sensitive-area diameter of 50 μm. The fabricated multimode fiber coupled NbN SNSPDs exhibited a maximum system detection efficiency (DE) of up to 82% and a DE of 78% at a dark count rate of 100 Hz at 850-nm wavelength as well as a system jitter of 105 ps.

arXiv:1506.07922•Optics Express•Jun 24, 2015•43 citations

High efficiency, large-active-area superconducting nanowire single-photon detectors

顾敏, 张蜡宝, 康琳 +7 more

Niobium nitride superconducting nanowire single-photon detectors were fabricated on thermally oxidized silicon substrates with large active areas of 30 μm× 30 μm.To achieve non-constricted detectors,we improved the film growth and electron beam lithography process to fabricate uniform 100-nm wide Nb N nanowires with a fill factor of 50%.The devices showed 72.4% system detection efficiency(SDE) at 100-Hz dark count rate(DCR) and 74-ps timing jitter,measured at the fiber communication wavelength of 1550 nm.The highest SDE which is 81.2% when the DCR is ～ 700 c/s appears at the wavelength of 1650 nm.

中国物理B：英文版•Jan 1, 2015•0 citations

Multispectral superconducting nanowire single photon detector

Hao Li, Heqing Wang, Lixing You +8 more

In this work, we report multispectral superconducting nanowire single photon detectors (SNSPDs) that can simultaneously detect single photons at multiple wavelengths with high efficiency. The superconducting nanowires are fabricated on an all-dielectric mirror consisting of two quarter-wave stack reflectors with separated central wavelengths. The unique optical structure results in serially coupled optical cavities, leading to multiple resonant absorption bands that are utilized for high-efficiency single photon detection. The fabricated detector shows system detection efficiencies of >80% at the three target wavelengths of 1550 nm, 1310 nm, and 1064 nm. The multispectral detector may eliminate the need for multiple SNSPDs for different wavelengths in a system, potentially resulting in a reduction in size, weight, and power, as well as in the cost of the overall detection system. The detector may also find interesting use for applications such as multispectral ranging or imaging.

Optics Express•Feb 8, 2019•19 citations

Superconducting nanowire single-photon detectors at a wavelength of 940 nm

W. J. Zhang, Hao Li, Lixing You +9 more

We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.

arXiv:1506.07921•AIP Advances•Jun 1, 2015•7 citations

Multimode Fiber Coupled Superconductor Nanowire Single-Photon Detector

Labao Zhang, Ming Gu, Tao Jia +5 more

High-performance superconductor nanowire single-photon detectors (SNSPDs) coupled by 50-μm multimode fiber were designed and fabricated for the purpose of space applications. Microlens coupling between multimode fiber and detector chip was proposed, resulting in coupling efficiency of 86% at the chips with detection area of 15 x 15 μm2. An optical structure for enhancing the photons absorption and superconductor nanowires with low critical current of 3 μA were fabricated on the chips. A cryogenic amplifier was adopted to increase the signal-to-noise ratio and time jitter of output pulse. The SNSPD exhibited system efficiency (1550 nm) of 56% at a dark count rate of 100 cps, 50% at a dark count rate of 5 cps, and 40% at a dark count rate of 1 cps. The time jitter was 46 ps at full-width at half-maximum. The multimode fiber coupling system with high performance will promote its applications in free space.

IEEE photonics journal•Sep 25, 2014•16 citations
In this work, we report a large-active-area multispectral superconducting nanowire single-photon detector for free-space applications. The detector is realized by fabricating NbTiN nanowire with an active area of 35 µm diameter on two serially connected dielectric mirrors that can simultaneously and efficiently detect single photons at the three typical wavelengths employed in free-space applications, namely, 532, 850, and 1064 nm. Maximal system detection efficiencies (SDEs) of 80.0% at 532 nm and 850 nm and 75.8% at 1064 nm are achieved for polarized light obtained by coupling the detector with an SMF-28 fiber. Upon coupling with a 50 µm multimode fiber, SDEs of 68.6%, 59.6%, and 47.0%, are achieved for 532, 850, and 1064 nm wavelength unpolarized light, respectively. Moreover, the detector shows timing jitters of 37.1 and 41.0 ps when coupled with SMF-28 fiber and 50 µm multimode fiber. This type of detector with a large active area and multiwavelength detection capability is promising for both single and multiwavelength free-space applications.
We report the development of the multimode fiber-coupled superconducting nanowire single-photon detector with high system detection efficiency at visible wavelength. The detector consists of a 10.5-nm-thick and 150-nm-wide NbN nanowire meander fabricated on a Si substrate with a multilayer dielectric mirror and a quarter wavelength cavity for obtaining high optical absorptance. The meander area was 35 µm in diameter and coupled with the GRIN-lensed multimode optical fiber with a core diameter of 50 µm. The system reached detection efficiency of 70% with dark count rate of 100 Hz at the wavelength of 635 nm, 3 dB roll-off response counting rate of 8.5 Mcps, and timing jitter of 76 ps.
Satellite-ground quantum communication requires single-photon detectors of 850-nm wavelength with both high detection efficiency and large sensitive area. We developed superconducting nanowire single-photon detectors (SNSPDs) on one-dimensional photonic crystals, which acted as optical cavities to enhance the optical absorption, with a sensitive-area diameter of 50 μm. The fabricated multimode fiber coupled NbN SNSPDs exhibited a maximum system detection efficiency (DE) of up to 82% and a DE of 78% at a dark count rate of 100 Hz at 850-nm wavelength as well as a system jitter of 105 ps.
Niobium nitride superconducting nanowire single-photon detectors were fabricated on thermally oxidized silicon substrates with large active areas of 30 μm× 30 μm.To achieve non-constricted detectors,we improved the film growth and electron beam lithography process to fabricate uniform 100-nm wide Nb N nanowires with a fill factor of 50%.The devices showed 72.4% system detection efficiency(SDE) at 100-Hz dark count rate(DCR) and 74-ps timing jitter,measured at the fiber communication wavelength of 1550 nm.The highest SDE which is 81.2% when the DCR is ～ 700 c/s appears at the wavelength of 1650 nm.
In this work, we report multispectral superconducting nanowire single photon detectors (SNSPDs) that can simultaneously detect single photons at multiple wavelengths with high efficiency. The superconducting nanowires are fabricated on an all-dielectric mirror consisting of two quarter-wave stack reflectors with separated central wavelengths. The unique optical structure results in serially coupled optical cavities, leading to multiple resonant absorption bands that are utilized for high-efficiency single photon detection. The fabricated detector shows system detection efficiencies of >80% at the three target wavelengths of 1550 nm, 1310 nm, and 1064 nm. The multispectral detector may eliminate the need for multiple SNSPDs for different wavelengths in a system, potentially resulting in a reduction in size, weight, and power, as well as in the cost of the overall detection system. The detector may also find interesting use for applications such as multispectral ranging or imaging.
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.
High-performance superconductor nanowire single-photon detectors (SNSPDs) coupled by 50-μm multimode fiber were designed and fabricated for the purpose of space applications. Microlens coupling between multimode fiber and detector chip was proposed, resulting in coupling efficiency of 86% at the chips with detection area of 15 x 15 μm2. An optical structure for enhancing the photons absorption and superconductor nanowires with low critical current of 3 μA were fabricated on the chips. A cryogenic amplifier was adopted to increase the signal-to-noise ratio and time jitter of output pulse. The SNSPD exhibited system efficiency (1550 nm) of 56% at a dark count rate of 100 cps, 50% at a dark count rate of 5 cps, and 40% at a dark count rate of 1 cps. The time jitter was 46 ps at full-width at half-maximum. The multimode fiber coupling system with high performance will promote its applications in free space.