Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Large active area superconducting single-nanowire photon detector with a 100 μ m diameter

Chaolin Lv, Hong Zhou, Hao Li, Lixing You, Xinlei Liu, Ying Wang, Weijun Zhang, S J Chen, Zehua Wang, X. M. Xie

Published Sep 21, 2017• 25 citations
Publisher

Abstract

Abstract We demonstrate a large active area superconducting single-nanowire photon detector with a diameter of Φ100 μ m. The detector was fabricated on a Si substrate with distributed Bragg reflector acting as an optical cavity and coupled with a 105 μ m multi-mode optical fiber. Owing to the extensive kinetic inductor caused by the large sensitive area of the detector, the response waveform exhibited a large overshoot, causing the device to latch with the increasing bias current. By adding a resistor in series with the device, the overshoot was suppressed, and the maximal bias current increased from 25 to 31 μ A. A well-saturated detection efficiency with a maximal value of 65% was achieved at the wavelength of 532 nm. Moreover, the maximal counting rate improved from 1 to 10 MHz.

DOI
10.1088/1361-6668/aa8e28

Related papers

Superconducting nanowire single-photon detectors at a wavelength of 940 nm

W. J. Zhang, Hao Li, Lixing You +9 more

We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.

arXiv:1506.07921•AIP Advances•Jun 1, 2015•7 citations

Large-sensitive-area superconducting nanowire single-photon detector at 850 nm with high detection efficiency

Hao Li, Lu Zhang, Lixing You +6 more

Satellite-ground quantum communication requires single-photon detectors of 850-nm wavelength with both high detection efficiency and large sensitive area. We developed superconducting nanowire single-photon detectors (SNSPDs) on one-dimensional photonic crystals, which acted as optical cavities to enhance the optical absorption, with a sensitive-area diameter of 50 μm. The fabricated multimode fiber coupled NbN SNSPDs exhibited a maximum system detection efficiency (DE) of up to 82% and a DE of 78% at a dark count rate of 100 Hz at 850-nm wavelength as well as a system jitter of 105 ps.

arXiv:1506.07922•Optics Express•Jun 24, 2015•43 citations

NbN superconducting nanowire single-photon detector with an active area of 300 μm-in-diameter

Chengjun Zhang, Weijun Zhang, Jia Huang +8 more

Superconducting nanowire single-photon detectors (SNSPDs) with both an ultra-large-active area and a high count rate (CR) are challenging from the design and fabrication. Here, we develop a NbN SNSPD with a circular active area of 300 μm-in-diameter and use multiple approaches to boost the maximal count rate (MCR). This large-active-area SNSPD is divided into nine pixels (parts). Each pixel consists of serially connected two superconducting nanowire avalanche photodetectors (SC-2SNAP), which yielded a four-fold reduction in the kinetic inductance of a single pixel. To further increase MCR, an optimized series resistance of about 380 Ω is added to each pixel, reducing the full recovery time of each pixel from a few microseconds to approximately 90 ns. All nine pixels show uniform superconducting critical temperatures of ∼7.4 K and switching currents in the range of 15.3–16.7 μA. When the detector coupled to a single-mode fiber and illuminated with 1064-nm photons, the single-pixel exhibits a well-saturated system detection efficiency (SDE) of 67% at a dark CR of 30 Hz, and its CR exceeds 10 MHz with an SDE of 50%. When coupled to a 200-μm multi-mode fiber, the total SDE of nine pixels is approximately 42% and the total MCR exceeds 43 MHz.

AIP Advances•Jul 1, 2019•26 citations

Multimode fiber-coupled superconducting nanowire single-photon detector with 70% system efficiency at visible wavelength

Dengkuan Liu, Shigehito Miki, Taro Yamashita +3 more

We report the development of the multimode fiber-coupled superconducting nanowire single-photon detector with high system detection efficiency at visible wavelength. The detector consists of a 10.5-nm-thick and 150-nm-wide NbN nanowire meander fabricated on a Si substrate with a multilayer dielectric mirror and a quarter wavelength cavity for obtaining high optical absorptance. The meander area was 35 µm in diameter and coupled with the GRIN-lensed multimode optical fiber with a core diameter of 50 µm. The system reached detection efficiency of 70% with dark count rate of 100 Hz at the wavelength of 635 nm, 3 dB roll-off response counting rate of 8.5 Mcps, and timing jitter of 76 ps.

Optics Express•Aug 25, 2014•37 citations

Large-area multispectral superconducting nanowire single-photon detector

Heqing Wang, Hao Li, Lixing You +9 more

In this work, we report a large-active-area multispectral superconducting nanowire single-photon detector for free-space applications. The detector is realized by fabricating NbTiN nanowire with an active area of 35 µm diameter on two serially connected dielectric mirrors that can simultaneously and efficiently detect single photons at the three typical wavelengths employed in free-space applications, namely, 532, 850, and 1064 nm. Maximal system detection efficiencies (SDEs) of 80.0% at 532 nm and 850 nm and 75.8% at 1064 nm are achieved for polarized light obtained by coupling the detector with an SMF-28 fiber. Upon coupling with a 50 µm multimode fiber, SDEs of 68.6%, 59.6%, and 47.0%, are achieved for 532, 850, and 1064 nm wavelength unpolarized light, respectively. Moreover, the detector shows timing jitters of 37.1 and 41.0 ps when coupled with SMF-28 fiber and 50 µm multimode fiber. This type of detector with a large active area and multiwavelength detection capability is promising for both single and multiwavelength free-space applications.

Applied Optics•Oct 14, 2019•10 citations

High efficiency, large-active-area superconducting nanowire single-photon detectors

顾敏, 张蜡宝, 康琳 +7 more

Niobium nitride superconducting nanowire single-photon detectors were fabricated on thermally oxidized silicon substrates with large active areas of 30 μm× 30 μm.To achieve non-constricted detectors,we improved the film growth and electron beam lithography process to fabricate uniform 100-nm wide Nb N nanowires with a fill factor of 50%.The devices showed 72.4% system detection efficiency(SDE) at 100-Hz dark count rate(DCR) and 74-ps timing jitter,measured at the fiber communication wavelength of 1550 nm.The highest SDE which is 81.2% when the DCR is ～ 700 c/s appears at the wavelength of 1650 nm.

中国物理B：英文版•Jan 1, 2015•0 citations
Abstract We demonstrate a large active area superconducting single-nanowire photon detector with a diameter of Φ100 μ m. The detector was fabricated on a Si substrate with distributed Bragg reflector acting as an optical cavity and coupled with a 105 μ m multi-mode optical fiber. Owing to the extensive kinetic inductor caused by the large sensitive area of the detector, the response waveform exhibited a large overshoot, causing the device to latch with the increasing bias current. By adding a resistor in series with the device, the overshoot was suppressed, and the maximal bias current increased from 25 to 31 μ A. A well-saturated detection efficiency with a maximal value of 65% was achieved at the wavelength of 532 nm. Moreover, the maximal counting rate improved from 1 to 10 MHz.
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.
Satellite-ground quantum communication requires single-photon detectors of 850-nm wavelength with both high detection efficiency and large sensitive area. We developed superconducting nanowire single-photon detectors (SNSPDs) on one-dimensional photonic crystals, which acted as optical cavities to enhance the optical absorption, with a sensitive-area diameter of 50 μm. The fabricated multimode fiber coupled NbN SNSPDs exhibited a maximum system detection efficiency (DE) of up to 82% and a DE of 78% at a dark count rate of 100 Hz at 850-nm wavelength as well as a system jitter of 105 ps.
Superconducting nanowire single-photon detectors (SNSPDs) with both an ultra-large-active area and a high count rate (CR) are challenging from the design and fabrication. Here, we develop a NbN SNSPD with a circular active area of 300 μm-in-diameter and use multiple approaches to boost the maximal count rate (MCR). This large-active-area SNSPD is divided into nine pixels (parts). Each pixel consists of serially connected two superconducting nanowire avalanche photodetectors (SC-2SNAP), which yielded a four-fold reduction in the kinetic inductance of a single pixel. To further increase MCR, an optimized series resistance of about 380 Ω is added to each pixel, reducing the full recovery time of each pixel from a few microseconds to approximately 90 ns. All nine pixels show uniform superconducting critical temperatures of ∼7.4 K and switching currents in the range of 15.3–16.7 μA. When the detector coupled to a single-mode fiber and illuminated with 1064-nm photons, the single-pixel exhibits a well-saturated system detection efficiency (SDE) of 67% at a dark CR of 30 Hz, and its CR exceeds 10 MHz with an SDE of 50%. When coupled to a 200-μm multi-mode fiber, the total SDE of nine pixels is approximately 42% and the total MCR exceeds 43 MHz.
We report the development of the multimode fiber-coupled superconducting nanowire single-photon detector with high system detection efficiency at visible wavelength. The detector consists of a 10.5-nm-thick and 150-nm-wide NbN nanowire meander fabricated on a Si substrate with a multilayer dielectric mirror and a quarter wavelength cavity for obtaining high optical absorptance. The meander area was 35 µm in diameter and coupled with the GRIN-lensed multimode optical fiber with a core diameter of 50 µm. The system reached detection efficiency of 70% with dark count rate of 100 Hz at the wavelength of 635 nm, 3 dB roll-off response counting rate of 8.5 Mcps, and timing jitter of 76 ps.
In this work, we report a large-active-area multispectral superconducting nanowire single-photon detector for free-space applications. The detector is realized by fabricating NbTiN nanowire with an active area of 35 µm diameter on two serially connected dielectric mirrors that can simultaneously and efficiently detect single photons at the three typical wavelengths employed in free-space applications, namely, 532, 850, and 1064 nm. Maximal system detection efficiencies (SDEs) of 80.0% at 532 nm and 850 nm and 75.8% at 1064 nm are achieved for polarized light obtained by coupling the detector with an SMF-28 fiber. Upon coupling with a 50 µm multimode fiber, SDEs of 68.6%, 59.6%, and 47.0%, are achieved for 532, 850, and 1064 nm wavelength unpolarized light, respectively. Moreover, the detector shows timing jitters of 37.1 and 41.0 ps when coupled with SMF-28 fiber and 50 µm multimode fiber. This type of detector with a large active area and multiwavelength detection capability is promising for both single and multiwavelength free-space applications.
Niobium nitride superconducting nanowire single-photon detectors were fabricated on thermally oxidized silicon substrates with large active areas of 30 μm× 30 μm.To achieve non-constricted detectors,we improved the film growth and electron beam lithography process to fabricate uniform 100-nm wide Nb N nanowires with a fill factor of 50%.The devices showed 72.4% system detection efficiency(SDE) at 100-Hz dark count rate(DCR) and 74-ps timing jitter,measured at the fiber communication wavelength of 1550 nm.The highest SDE which is 81.2% when the DCR is ～ 700 c/s appears at the wavelength of 1650 nm.