All resonant systems throughout science and engineering, independent of their physical implementation have a bandwidth that is inversely related to the decay time. A similar relation exists in all slow-light systems, where the group index (and therefore the delay for a given footprint) is inversely related to the bandwidth. Therefore, resonant or slow-light systems can either store a broad signal for a short time, or a narrow signal for a long time, but cannot achieve large delay for broad bandwidth signals.Here we discuss our recent work on non-reciprocal optical systems that are not constrained by the delay-bandwidth limit. We show that large, broadband optical delay is not a pipe dream and is achievable with current optical technology. We discuss the underlying physics of delay and bandwidth in non-reciprocal optical systems and present an experimental implementation, based on a figure-9 cavity. We demonstrate a delay-bandwidth product 30 times above the seemingly fundamental time-bandwidth limit of traditional systems. Furthermore, we show that the optical pulse can be released after an arbitrary number of round trips, providing the control and tunability lacking from conventional spiral waveguide or fibre loop delay lines.
All resonant systems throughout science and engineering, independent of their physical implementation have a bandwidth that is inversely related to the decay time. A similar relation exists in all slow-light systems, where the group index (and therefore the delay for a given footprint) is inversely related to the bandwidth. Therefore, resonant or slow-light systems can either store a broad signal for a short time, or a narrow signal for a long time, but cannot achieve large delay for broad bandwidth signals.Here we discuss our recent work on non-reciprocal optical systems that are not constrained by the delay-bandwidth limit. We show that large, broadband optical delay is not a pipe dream and is achievable with current optical technology. We discuss the underlying physics of delay and bandwidth in non-reciprocal optical systems and present an experimental implementation, based on a figure-9 cavity. We demonstrate a delay-bandwidth product 30 times above the seemingly fundamental time-bandwidth limit of traditional systems. Furthermore, we show that the optical pulse can be released after an arbitrary number of round trips, providing the control and tunability lacking from conventional spiral waveguide or fibre loop delay lines.
As a potential enabling technology, slow light has captured much research interest over the past few years for achieving a continuously tunable optical delay line [1]. In principle, slow light is generated by tailoring an enhanced group-index resonance within a given nonlinear medium. This effective refractive index change is experienced by the data stream passing through and thus induces a controllable group delay onto the signal. Themain feature of a slow-light-based optical delay line is the capability for fine-grain temporal manipulation of optical pulses. This fine tunable delay element is envisioned to be useful for various high-bandwidth signal processing functions and applications.
Typical, reciprocal resonant systems are always limited to a time-bandwidth product of 1, causing a fundamental trade-off between long storage times and large acceptance bandwidths. A recent theory suggests that this limit may be arbitrarily overcome by breaking Lorentz reciprocity. We report an experimental realization of this concept using a time-variant fiber-optic cavity, where we can completely open the cavity, injecting a pulse of large bandwidth, and then close the cavity, storing the pulse and releasing it on-demand at a later time. We attain a time-bandwidth product of 30 and show that, although in practice it is only limited by experimental constraints, there is virtually no upper theoretical limit. Our results open the path for designing resonant systems that are broadband and ultrafast, while simultaneously allowing long interaction times, thereby unleashing fundamentally new functionalities in wave physics and light-matter interactions.
The possibility of dynamically controlling the speed of light can be extremely useful in all the optical applications where a variable delay is needed, such as bit and frame synchronization and optical storage. To this aim, coupled resonator slow-wave structures (SWSs) represent a promising approach to slow down the propagation of optical signals with as large bandwidths as required by optical communication systems. We show that by suitably setting the rings' resonances, SWSs can act efficiently as tunable delay lines, with the overall time delay being continuously adjustable from zero to a maximum value, typically limited by the effects of loss and dispersion. Every ring of the structure can be used as an optical gate and optical pulses can also be trapped and released by the SWS, so as to realize an optical memory or buffer. A time delay of 300 ps and a slowing ratio of 7.5 over a 3.3 GHz bandwidth are experimentally demonstrated in SWSs realized in silicon oxynitride technology
This paper presents an analysis of optical buffers based on slow-light optical delay lines. The focus of this paper is on slow-light delay lines in which the group velocity is reduced using linear processes, including electromagnetically induced transparency (EIT), population oscillations (POs), and microresonator-based photonic-crystal (PC) filters. We also consider slow-light delay lines in which the group velocity is reduced by an adiabatic process of bandwidth compression. A framework is developed for comparing these techniques and identifying fundamental physical limitations of linear slow-light technologies. It is shown that slow-light delay lines have limited capacity and delay-bandwidth product. In principle, the group velocity in slow-light delay lines can be made to approach zero. But very slow group velocity always comes at the cost of very low bandwidth or throughput. In many applications, miniaturization of the delay line is an important consideration. For all delay-line buffers, the minimum physical size of the buffer for a given number of buffered data bits is ultimately limited by the physical size of each stored bit. We show that in slow-light optical buffers, the minimum achievable size of 1 b is approximately equal to the wavelength of light in the buffer. We also compare the capabilities and limitations of a range of delay-line buffers, investigate the impact of waveguide losses on the buffer capacity, and look at the applicability of slow-light delay lines in a number of applications.
Frontiers in Guided Wave Optics and Optoelectronics 84 absorption is much too high to render the group effect useful.An exciting breakthrough happened in the early nineties when it was shown that group velocities of few tens of meters per second were possible with nonlinear resonance interactions (Hau et al., 1999).Two important features of nonlinear resonances make this possible: substantially reduced absorption, or even amplification, of radiation at a resonance, and sharpness of such resonances; the sharper a resonance, the higher dn/dω and so the stronger the enhancement of group index, and hence the greater the pulse is delayed.Widely ranging applications for slow light have been proposed, of which those for telecommunication systems and devices (optical delay lines, optical buffers, optical equalizers and signal processors) are currently of most interest (Gauthier, 2005).The essential demand of such devices is compatibility with existing telecommunication systems, that is they must be of wide enough bandwidth (≥10 GHz) and able to be integrated seamlessly into such systems.Of the various nonlinear resonance mechanisms and media, which allow sufficiently long induced delays, stimulated Brillouin and Raman scattering (SBS and SRS) in optical fiber are deemed to be among the best candidates.Currently SBS is the most actively investigated and many experimental and theoretical papers on pulse delaying via SBS in optical fiber have been published in the last few years, see the review paper (Thevenaz, 2008) and references therein.In this process the pulse to be delayed is a frequency down-shifted (Stokes) pulse.This is transmitted through an optical fiber through which continuous wave (CW) pump radiation is sent in the opposite direction to prime the delay process.It is supposed that the Stokes pulse is amplified by parametric coupling with the pump wave and a material (acoustic) wave in the medium (Kroll, 1965), and the amplification is characterised by a resonant-type gain profile.The dispersion of refractive index associated with this profile (which is similar to that in Fig. 1) can then be used to increase the group index for optical pulses at the Stokes frequency (Zeldovich, 1972).Along with obvious device compatibility, there are several other advantages of the SL via SBS approach for optical communications systems: slow-light resonance can be created at any wavelength by changing the pump wavelength; use of optical fibre allows for long interaction lengths and thus low powers for the pump radiation, the process runs at room temperature, it uses off the shelf telecom equipment, and SBS works in the entire transparency range of fibers and in all types of fiber.Currently a main obstacle to applications of this approach is the narrow SBS gain spectral bandwidth, (Thevenaz, 2008), which is typically ≈ 120-200 MHz in silica fiber in the spectral range of telecom optical radiation (~1.3-1.6 μm) (Agrawal, 2006).This chapter reviews our ongoing work on the physical mechanisms that give rise to pulse delay in SBS.In section 2 the theoretical background of the SBS phenomenon is given and the main working equations describing this nonlinear interaction are presented.In section 3 ways by which the SBS spectral bandwidth may be increased are addressed.Waveguide induced spectral broadening of SBS in optical fibre is considered as a means of increasing the bandwidth to the multi-GHz range.An alternative way widely discussed in the literature, (Thevenaz, 2008), is based on spectral broadening of the pump radiation.However it is shown through analytic analysis of the SBS equations converted to the frequency domain that pump radiation broadening by any reasonable amount has only a negligible effect on increasing the SBS bandwidth.Importantly in this section we show that, irrespective of the nature of the broadening considered, the SBS gain bandwidth remains www.intechopen.
One of the key issues when dealing with slow light is the inevitable effect of dispersion, the result of which is to broaden a pulse upon propagation. Moreover, the dispersion tends to increase when the group velocity, the speed at which the pulse propagates, decreases. To see this, we note that if we write the group velocity vg ≡ c/ng, where ng is the group index, then we find that ng = n+ωdn/dω. Since for the materials we are interested in, the refractive index does not vary strongly in magnitude, and slow light is obtained when the derivative dn/dω is large and positive. However, as the variations in the magnitude of n itself are limited, the large derivative can only be maintained over a narrow bandwidth ∝ (dn/dω)−1. Therefore, a large delay implies a narrow bandwidth, and hence a limited pulse width. Here we discuss how to avoid this limit by using nonlinear effects in the form of gap solitons. Though this argument is quite simple, it can be made rigorous using the Kramers-Kronig relations. In this way it can be shown that the achievable delay in a linear, two-port device is subject to a limitation of the product of the delay and the bandwidth (Lenz et al., 2001).