Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics B

Simulation and measurement of millimeter-wave radiation from Josephson junction array*

Xin Zhang, Shenghui Zhao, Litian Wang, Jian Xing, Shengfang Zhang, Xuelian Liang, Ze Qiang He, Pei J. Wang, Xinjie Zhao, Ming He, Lu Ji

Published Jun 1, 2019• 1 citation
Publisher

Abstract

We report the circuit simulations and experiments of millimeter-wave radiation from a high temperature superconducting (HTS) bicrystal Josephson junction (BJJ) array. To study the effects of junction characteristic parameters on radiation properties, new radiation circuit models are proposed in this paper. The series resistively and capacitively shunted junction (RCSJ) models are packaged into a Josephson junction array (JJA) model in the simulation. The current-voltage characteristics (IVCs) curve and radiation peaks are simulated and analyzed by circuit models, which are also observed from the experiment at liquid nitrogen temperature. The experimental radiation linewidth and power are in good agreement with simulated results. The presented circuit models clearly demonstrate that the inconsistency of the JJA will cause a broad linewidth and a low detected power. The junction radiation properties are also investigated at the optimal situation by circuit simulation. The results further confirm that the consistent JJA characteristic parameters can successfully narrow the radiation linewidth and increase the power of junction radiation.

DOI
10.1088/1674-1056/28/6/060305

Related papers

Millimeter-wavelength radiation from arrays of discrete high-temperature superconductor Josephson junctions

Fangfang Song, M. Levitchev, Vadim A. Markelov +3 more

Josephson junction arrays could be competitive candidates for radiation sources in the frequency range from 0.5 to 1.5 THz. This is the range where compact solid-state continuous wave sources are most lacking. We investigated the millimeter-wave radiation from arrays of high-temperature superconductor bicrystal Josephson junctions embedded in a quasi-optical resonator. The novel approach of utilizing the intrinsic resonance modes of the substrate to improve the impedance coupling between the series array of discrete Josephson junctions and the quasi-optical resonator was investigated by experiments and electromagnetic field simulations. Radiation from the arrays containing up to 536 junctions was detected at about 80 GHz and liquid nitrogen temperature using a low-noise receiver. The detected maximum radiation power of the arrays was about 50 pW and the peak voltage agreed exactly with the Josephson current–voltage relation.

Superconductor Science and Technology•Feb 22, 2010•5 citations

Millimeter-wave self-radiation from high-Tc Josephson junction arrays

Kiejin Lee, Ienari Iguchi, Jeha Kim +2 more

We report the strong microwave Josephson radiation from an array of high-T/sub c/ junctions on a MgO bicrystal substrate from centimeter- to millimeter-wave ranges. The dc bias current was fed to the junction array having parallel geometry with the pair of junctions shunted by superconducting loops. The configuration of bias leads was a series of interlocking dc SQUID's geometry which guaranteed the oscillation of all junctions at the same frequency. The phase differences between adjacent junctions with different I/sub c/R/sub n/ products could be controlled by an external small magnetic field. For a five-junctions array, we observed the coherent output power of about 13 pW without external magnetic flux, which was nearly five times higher than that of a single bicrystal junction. We observed the Josephson linewidth of the self-radiation in the coherent state to be less than 1 GHz by adjustment of the external flux.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•6 citations

MIXING EXPERIMENTS AT W-BAND USING HIGH-TC JOSEPHSON JUNCTIONS

Oliver Harnack, Marian Darula, S. Beuven +1 more

We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.

•Jan 1, 1997•0 citations

On and off-chip detection of radiation from HTS Josephson junction arrays

Kiejin Lee, Ienari Iguchi, K. Y. Constantinian

We have investigated the mutual phase interaction between a single detector junction and a phase-locked three-junction array of high-T/sub c/ Josephson junctions. The YBCO Josephson junctions were fabricated on a MgO bicrystal substrate. In the array junction structure, the dc bias current was fed to the junction array having parallel geometry with each pair of junctions shunted by a superconducting coplanar microstrip superconducting loop. The configuration of bias leads was a series connection of interlocking dc SQUIDs geometry which enables all junctions to oscillate at the same frequency. We measured the radiation power of a Josephson-junction array using an off-chip coupled to a radiometer and on-chip coupled to a single junction from centimeter- to millimeter-wave ranges. Clear self-induced Shapiro steps were observed in the current-voltage curves of the detector junction. The power transfered to the single detector junction was estimated from the modulation of Shapiro step height. The maximum detected power level was about 7 nW at frequency 150-250 GHz. The Josephson oscillation power excited the resonant mode coupled to the coplanar microstrip loops.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•1 citation

Frequency-Locked Submillimeter Wave Generation from Josephson Junction Arrays

Insang Song, Kwang‐Yong Kang, Gwangseo Park

We fabricated a Josephson junction array with an additional inductive coupling line to detect the high frequency and power of Josephson self-radiation. The YBa2Cu3O y Josephson junctions are fabricated by a pulsed laser deposition method on bicrystal MgO substrates. We measured the submillimeter wave and the Josephson self-radiation power in an external waveguide system. The Josephson junction arrays showed the resistively shunted junction (RSJ)-like current–voltage characteristics and good frequency-locking of Josephson self-radiation. As the number of Josephson junctions increased, the maximum detected power was increased. We observed the maximum frequency of above 6 THz for Josephson self-radiation in the array with 11 Josephson junctions from the Shapiro steps under 22 GHz irradiation.

Japanese Journal of Applied Physics•Jan 1, 1999•5 citations

Millimeter-wave radiation in high-T/sub c/ Josephson junctions

Gerhard Kunkel, Gerd Hechtfischer, Michael Frommberger +8 more

We have investigated millimeter-wave radiation from single Josephson junctions and small phase-locked Josephson junction arrays. Josephson junctions were fabricated on sapphire bicrystal substrates. Emission could be measured up to 110 GHz. Resonances in ten-junction circuits yield linewidths narrower than 200 MHz. This type of array might be useful for applications in integrated receiver systems.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•10 citations
We report the circuit simulations and experiments of millimeter-wave radiation from a high temperature superconducting (HTS) bicrystal Josephson junction (BJJ) array. To study the effects of junction characteristic parameters on radiation properties, new radiation circuit models are proposed in this paper. The series resistively and capacitively shunted junction (RCSJ) models are packaged into a Josephson junction array (JJA) model in the simulation. The current-voltage characteristics (IVCs) curve and radiation peaks are simulated and analyzed by circuit models, which are also observed from the experiment at liquid nitrogen temperature. The experimental radiation linewidth and power are in good agreement with simulated results. The presented circuit models clearly demonstrate that the inconsistency of the JJA will cause a broad linewidth and a low detected power. The junction radiation properties are also investigated at the optimal situation by circuit simulation. The results further confirm that the consistent JJA characteristic parameters can successfully narrow the radiation linewidth and increase the power of junction radiation.
Josephson junction arrays could be competitive candidates for radiation sources in the frequency range from 0.5 to 1.5 THz. This is the range where compact solid-state continuous wave sources are most lacking. We investigated the millimeter-wave radiation from arrays of high-temperature superconductor bicrystal Josephson junctions embedded in a quasi-optical resonator. The novel approach of utilizing the intrinsic resonance modes of the substrate to improve the impedance coupling between the series array of discrete Josephson junctions and the quasi-optical resonator was investigated by experiments and electromagnetic field simulations. Radiation from the arrays containing up to 536 junctions was detected at about 80 GHz and liquid nitrogen temperature using a low-noise receiver. The detected maximum radiation power of the arrays was about 50 pW and the peak voltage agreed exactly with the Josephson current–voltage relation.
We report the strong microwave Josephson radiation from an array of high-T/sub c/ junctions on a MgO bicrystal substrate from centimeter- to millimeter-wave ranges. The dc bias current was fed to the junction array having parallel geometry with the pair of junctions shunted by superconducting loops. The configuration of bias leads was a series of interlocking dc SQUID's geometry which guaranteed the oscillation of all junctions at the same frequency. The phase differences between adjacent junctions with different I/sub c/R/sub n/ products could be controlled by an external small magnetic field. For a five-junctions array, we observed the coherent output power of about 13 pW without external magnetic flux, which was nearly five times higher than that of a single bicrystal junction. We observed the Josephson linewidth of the self-radiation in the coherent state to be less than 1 GHz by adjustment of the external flux.
We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.
We have investigated the mutual phase interaction between a single detector junction and a phase-locked three-junction array of high-T/sub c/ Josephson junctions. The YBCO Josephson junctions were fabricated on a MgO bicrystal substrate. In the array junction structure, the dc bias current was fed to the junction array having parallel geometry with each pair of junctions shunted by a superconducting coplanar microstrip superconducting loop. The configuration of bias leads was a series connection of interlocking dc SQUIDs geometry which enables all junctions to oscillate at the same frequency. We measured the radiation power of a Josephson-junction array using an off-chip coupled to a radiometer and on-chip coupled to a single junction from centimeter- to millimeter-wave ranges. Clear self-induced Shapiro steps were observed in the current-voltage curves of the detector junction. The power transfered to the single detector junction was estimated from the modulation of Shapiro step height. The maximum detected power level was about 7 nW at frequency 150-250 GHz. The Josephson oscillation power excited the resonant mode coupled to the coplanar microstrip loops.
We fabricated a Josephson junction array with an additional inductive coupling line to detect the high frequency and power of Josephson self-radiation. The YBa2Cu3O y Josephson junctions are fabricated by a pulsed laser deposition method on bicrystal MgO substrates. We measured the submillimeter wave and the Josephson self-radiation power in an external waveguide system. The Josephson junction arrays showed the resistively shunted junction (RSJ)-like current–voltage characteristics and good frequency-locking of Josephson self-radiation. As the number of Josephson junctions increased, the maximum detected power was increased. We observed the maximum frequency of above 6 THz for Josephson self-radiation in the array with 11 Josephson junctions from the Shapiro steps under 22 GHz irradiation.