Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

MIXING EXPERIMENTS AT W-BAND USING HIGH-TC JOSEPHSON JUNCTIONS

Oliver Harnack, Marian Darula, S. Beuven, H. Kohlstedt

Published Jan 1, 1997• 0 citations
OpenAlex

Abstract

We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.

Related papers

Microwave Heterodyne Mixing by Step-Edge Microbridge Josephson Junctions Using YBaCuO Thin Films

Yoshito Fukumoto, Hiroshi Kajikawa, Rikuo Ogawa +1 more

Current-voltage characteristics and microwave mixing properties of step-edge microbridge Josephson junctions (SEJJs) made of YBaCuO thin films were systematically investigated. The step-edge was formed on the surface of a MgO(100) substrate employing the common photolithograph and wet-etching techniques. YBaCuO thin film was deposited by the off-axis sputtering method, and the microbridge junctions were fabricated so as to cross the step-edge. The SEJJs showed typical DC and AC characteristics which were explained by the resistively shunted junction (RSJ) model. Mixing experiments were carried out in the K-band microwave region. An intermediate frequency (IF) output with the frequency range of 20 MHz~2.0 GHz was successfully obtained.

International Conference on Solid State Devices and Materials (SSDM)•Aug 28, 1991•0 citations

A wideband terahertz high- T c superconducting Josephson-junction mixer: electromagnetic design, analysis and characterization

Xiang Gao, Ting Zhang, Jia Du +3 more

Abstract This paper presents a wideband terahertz (THz) mixer based on a thin-film antenna-coupled high-temperature superconducting (HTS) YBa 2 Cu 3 O 7−x (YBCO) step-edge Josephson junction. The HTS mixer enables the flexible harmonic mixing operation at multiple THz bands with the same microwave local oscillator (LO) source, and features very wide intermediate-frequency or instantaneous bandwidth. In order to optimize the frequency down-conversion performance of the mixer, systematic electromagnetic design and analysis have been carried out to improve the power coupling of THz radiation as well as wideband transmission of microwave signals. Experimental characterization of a fabricated device prototype has demonstrated that the mixer exhibits good performance at both the 200 GHz and 600 GHz bands. Detailed measurement results including the DC characteristics, LO pumping requirement, frequency response, mixing linearity and conversion gain are presented in this paper.

Superconductor Science and Technology•Jun 30, 2017•42 citations

Microwave Heterodyne Mixing by Step-Edge Microbridge Josephson Junctions Using YBaCuO Thin Films

Yoshito Fukumoto, Hiroshi Kajikawa, Rikuo Ogawa +1 more

Current-voltage characteristics and microwave mixing properties of step-edge microbridge Josephson junctions (SEJJs) made of YBaCuO thin films were systematically investigated. The step-edge was formed on the surface of a MgO(100) substrate employing the common photolithograph and wet-etching techniques. YBaCuO thin film was deposited by the off-axis sputtering method, and the microbridge junctions were fabricated so as to cross the step-edge. The SEJJs showed typical DC and AC characteristics which were explained by the resistively shunted junction (RSJ) model. Mixing experiments were carried out in the K-band microwave region. An intermediate frequency (IF) output with the frequency range of 20 MHz∼2.0 GHz was successfully obtained.

Japanese Journal of Applied Physics•Dec 1, 1991•17 citations

Mixing at terahertz frequency band using YBa2Cu3O7−δ bicrystal Josephson junctions

J. Chen, Hiroaki Myoren, K. Nakajima +2 more

Using high-Tc Josephson junctions made of YBa2Cu3O7−δ deposited across MgO bicrystal boundary, at terahertz (THz) frequency band, we demonstrated both fundamental and harmonic mixing. Radiation from a far-infrared laser was coupled to the junction, which was integrated with a planar bow-tie antenna, via an extended hyperhemispherical silicon lens. Fundamental mixing manifested itself in the junction’s dc current–voltage (I–V) curve as a third Shapiro step in addition to those two induced by the THz laser lines from a slightly misaligned resonator. In harmonic mixing between a THz laser line and a microwave local oscillator, the highest harmonic number we could get was 490 with a signal-to-noise ratio of 9 dB at the intermediate frequency.

Applied Physics Letters•Aug 4, 1997•35 citations

Noise and Conversion Efficiency of High-T c Superconductor Josephson Mixers

Oliver Harnack, S. Beuven, Marian Darula +4 more

We report on experimental studies of the noise performance and conversion efficiency of high-Te Josephson mixers at frequencies between 90 GHz and 550 GHz. The heterodyne mixing experiments have been performed by using YBa2Cu307_8 step-edge junctions and bicrystal junctions on MgO (E--9.6) substrates. We studied the Josephson mixer performance for the case of internal pumping (selfpumping) and external pumping. Receiver noise measurements in a waveg,uide setup for the case of external pumping at 90-94 GHz gave formally calculated double-side-band (DSB) mixer noise temperatures (Tm) of about 2000 K at physical temperatures of 10 K. Similar measurements in a quasioptical setup at 4.2 K and at operation frequencies of 430 GHz and 546 GHz yielded mixer noise temperatures of 1200 K and 1100 K, respectively. Using the internal pumped mode, i.e. mixing without external local oscillator signal, we also obtained clear IF response in hot/cold-measurements. The formally calculated Tm were between 580 K and 2300 K.

Softwaretechnik-Trends•Mar 1, 1998•1 citation

HTS step-edge Josephson junction terahertz harmonic mixer

Jia Du, Andrew R. Weily, Xiang Gao +3 more

A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.

Superconductor Science and Technology•Nov 30, 2016•42 citations
We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.
Current-voltage characteristics and microwave mixing properties of step-edge microbridge Josephson junctions (SEJJs) made of YBaCuO thin films were systematically investigated. The step-edge was formed on the surface of a MgO(100) substrate employing the common photolithograph and wet-etching techniques. YBaCuO thin film was deposited by the off-axis sputtering method, and the microbridge junctions were fabricated so as to cross the step-edge. The SEJJs showed typical DC and AC characteristics which were explained by the resistively shunted junction (RSJ) model. Mixing experiments were carried out in the K-band microwave region. An intermediate frequency (IF) output with the frequency range of 20 MHz~2.0 GHz was successfully obtained.
Abstract This paper presents a wideband terahertz (THz) mixer based on a thin-film antenna-coupled high-temperature superconducting (HTS) YBa 2 Cu 3 O 7−x (YBCO) step-edge Josephson junction. The HTS mixer enables the flexible harmonic mixing operation at multiple THz bands with the same microwave local oscillator (LO) source, and features very wide intermediate-frequency or instantaneous bandwidth. In order to optimize the frequency down-conversion performance of the mixer, systematic electromagnetic design and analysis have been carried out to improve the power coupling of THz radiation as well as wideband transmission of microwave signals. Experimental characterization of a fabricated device prototype has demonstrated that the mixer exhibits good performance at both the 200 GHz and 600 GHz bands. Detailed measurement results including the DC characteristics, LO pumping requirement, frequency response, mixing linearity and conversion gain are presented in this paper.
Current-voltage characteristics and microwave mixing properties of step-edge microbridge Josephson junctions (SEJJs) made of YBaCuO thin films were systematically investigated. The step-edge was formed on the surface of a MgO(100) substrate employing the common photolithograph and wet-etching techniques. YBaCuO thin film was deposited by the off-axis sputtering method, and the microbridge junctions were fabricated so as to cross the step-edge. The SEJJs showed typical DC and AC characteristics which were explained by the resistively shunted junction (RSJ) model. Mixing experiments were carried out in the K-band microwave region. An intermediate frequency (IF) output with the frequency range of 20 MHz∼2.0 GHz was successfully obtained.
Using high-Tc Josephson junctions made of YBa2Cu3O7−δ deposited across MgO bicrystal boundary, at terahertz (THz) frequency band, we demonstrated both fundamental and harmonic mixing. Radiation from a far-infrared laser was coupled to the junction, which was integrated with a planar bow-tie antenna, via an extended hyperhemispherical silicon lens. Fundamental mixing manifested itself in the junction’s dc current–voltage (I–V) curve as a third Shapiro step in addition to those two induced by the THz laser lines from a slightly misaligned resonator. In harmonic mixing between a THz laser line and a microwave local oscillator, the highest harmonic number we could get was 490 with a signal-to-noise ratio of 9 dB at the intermediate frequency.
We report on experimental studies of the noise performance and conversion efficiency of high-Te Josephson mixers at frequencies between 90 GHz and 550 GHz. The heterodyne mixing experiments have been performed by using YBa2Cu307_8 step-edge junctions and bicrystal junctions on MgO (E--9.6) substrates. We studied the Josephson mixer performance for the case of internal pumping (selfpumping) and external pumping. Receiver noise measurements in a waveg,uide setup for the case of external pumping at 90-94 GHz gave formally calculated double-side-band (DSB) mixer noise temperatures (Tm) of about 2000 K at physical temperatures of 10 K. Similar measurements in a quasioptical setup at 4.2 K and at operation frequencies of 430 GHz and 546 GHz yielded mixer noise temperatures of 1200 K and 1100 K, respectively. Using the internal pumped mode, i.e. mixing without external local oscillator signal, we also obtained clear IF response in hot/cold-measurements. The formally calculated Tm were between 580 K and 2300 K.
A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.