Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Single-Flux-Quantum Based Event-Driven Encoder for Large-Pixel Superconducting Nanowire Single-Photon Detector Array

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki, Hirotaka Terai

Published Mar 16, 2019• 13 citations
Publisher

Abstract

We propose a single-flux-quantum (SFQ) based event-driven encoder for a large-pixel superconducting nanowire single-photon detector (SSPD) array with a row-column readout architecture. The designed SFQ encoder can acquire time-tagged address data with a high time resolution. To apply 32 × 32 pixel SSPD system with a row-column architecture, the SFQ encoder is equipped with two 32-channel input ports among which one is for positive pulses, whereas the other is for negative pulses. The number of Josephson junctions (JJs) in the designed circuit is 2780. The power dissipation and required total bias current are 0.21 mW and 170 mA, respectively, owing to the reductions in critical currents of the JJs and bias resistors. The circuit generates time-tagged address data by applying electrical pulses at room temperature not only in liquid helium but also in a 0.1-W Gifford-McMahon (GM) cryocooler.

DOI
10.1109/tasc.2019.2899845

Related papers

Scalable implementation of a superconducting nanowire single-photon detector array with a superconducting digital signal processor

Masahiro Yabuno, Shigeyuki Miyajima, Shigehito Miki +1 more

A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.

Optics Express•Apr 1, 2020•40 citations

High-time-resolved 64-channel single-flux quantum-based address encoder integrated with a multi-pixel superconducting nanowire single-photon detector

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki +2 more

We propose and demonstrate a 64-channel event-driven encoder based on single-flux quantum (SFQ) circuits for application to a multi-pixel superconducting nanowire single-photon detector (SSPD) system. Multi-pixel SSPD systems were developed to improve maximum count rates and realize ultra-sensitive imaging systems. An intelligent signal processor is required, which we designed based on SFQ circuits. We were able to obtain an address based on the reserve timing information for the photon detection that occurs in the SSPD, as well as read the time-tagged address information for the SSPDs through the SFQ encoder. The overall observed FWHM jitter was 56.5 ps.

Optics Express•Oct 24, 2018•65 citations

Cryogenic Signal Processing Using Single-flux-quantum Circuit for High Performance Multi-pixel Superconducting Nanowire Single-photon Detectors

Hirotaka Terai, Shigehito Miki, Taro Yamashita +2 more

Superconducting nanowire single-photon detectors (SSPDs) with a system detection efficiency (SDE) of over 80% are now commercially available and being used in compact Gifford-McMahon refrigerators. However, not only high SDE, but also total performance including a low dark count rate, high maximum count rate and/or low timing jitter are important for many applications. A multi-pixel SSPD combined with signal processing using a single-flux-quantum (SFQ) circuit is a very promising approach to improve the system performance of SSPDs. In this review, we introduce our recent activities on cryogenic signal processing using SFQ circuits to realize high-performance multi-pixel SSPDs.

TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)•Jan 1, 2017•0 citations

Proposal of a single-flux-quantum based event-driven encoder using a row-column readout architecture for a large pixel superconducting nanowire single photon detector array

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki +1 more

IEICE Technical Report; IEICE Tech. Rep.•Aug 2, 2018•0 citations

Single-flux-quantum signal processors monolithically integrated with a superconducting nanostrip single-photon detector array

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki +3 more

We developed a monolithic integration process for a superconducting nanostrip single-photon detector (SNSPD) and a cryogenic signal processor based on a single-flux-quantum (SFQ) circuit. Sixteen-pixel SNSPDs consisting of a 10-nm-thick and 100-nm-wide NbTiN nanowire were fabricated on a 3-in. Si wafer with an SFQ merger fabricated by the National Institute of Advanced Industrial Science and Technology Nb 2.5 kA/cm2 standard process 2. Subsequently, we illuminated the photons on the 16-pixel SNSPD array through an optical fiber and obtained a similar bias-current dependence of the detection efficiency with a single-pixel SNSPD without the SFQ merger. This indicates that the SFQ merger works correctly, and that the power dissipation of the SFQ circuit, which is estimated to be 200 μW, does not deteriorate the photon detection of SNSPD fabricated on the same chip with a size of 5 × 5 mm2. Furthermore, we measured timing jitter using a pulsed laser as the photon source. Owing to the careful tuning of the wiring length between each pixel of the 16-pixel SNSPD and each input port of the SFQ merger, the obtained timing jitter was 41.4 ps, which is approximately equal to or less than that of the single-pixel SNSPD.

Applied Physics Letters•May 1, 2023•12 citations

Scalable readout interface for superconducting nanowire single-photon detectors using AQFP and RSFQ logic families

Naoki Takeuchi, Fumihiro China, Shigehito Miki +4 more

We propose a scalable readout interface for superconducting nanowire single-photon detector (SSPD) arrays, which we call the AQFP/RSFQ interface. This interface is composed of adiabatic quantum-flux-parametron (AQFP) and rapid single-flux-quantum (RSFQ) logic families. The AQFP part reads out the spatial information of an SSPD array via a single cable, and the RSFQ part reads out the temporal information via a single cable. The hybrid interface has high temporal resolution owing to low timing jitter in the operation of the RSFQ part. In addition, the hybrid interface achieves high circuit scalability because of low supply current in the operation of the AQFP part. Therefore, the hybrid interface is suitable for handling many-pixel SSPD arrays. We demonstrate a four-pixel SSPD array using the hybrid interface as proof of concept. The measurement results show that the hybrid interface can read out all of the pixels with a low error rate and low timing jitter.

arXiv:2004.01380•Optics Express•May 1, 2020•24 citations
We propose a single-flux-quantum (SFQ) based event-driven encoder for a large-pixel superconducting nanowire single-photon detector (SSPD) array with a row-column readout architecture. The designed SFQ encoder can acquire time-tagged address data with a high time resolution. To apply 32 × 32 pixel SSPD system with a row-column architecture, the SFQ encoder is equipped with two 32-channel input ports among which one is for positive pulses, whereas the other is for negative pulses. The number of Josephson junctions (JJs) in the designed circuit is 2780. The power dissipation and required total bias current are 0.21 mW and 170 mA, respectively, owing to the reductions in critical currents of the JJs and bias resistors. The circuit generates time-tagged address data by applying electrical pulses at room temperature not only in liquid helium but also in a 0.1-W Gifford-McMahon (GM) cryocooler.
A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.
We propose and demonstrate a 64-channel event-driven encoder based on single-flux quantum (SFQ) circuits for application to a multi-pixel superconducting nanowire single-photon detector (SSPD) system. Multi-pixel SSPD systems were developed to improve maximum count rates and realize ultra-sensitive imaging systems. An intelligent signal processor is required, which we designed based on SFQ circuits. We were able to obtain an address based on the reserve timing information for the photon detection that occurs in the SSPD, as well as read the time-tagged address information for the SSPDs through the SFQ encoder. The overall observed FWHM jitter was 56.5 ps.
Superconducting nanowire single-photon detectors (SSPDs) with a system detection efficiency (SDE) of over 80% are now commercially available and being used in compact Gifford-McMahon refrigerators. However, not only high SDE, but also total performance including a low dark count rate, high maximum count rate and/or low timing jitter are important for many applications. A multi-pixel SSPD combined with signal processing using a single-flux-quantum (SFQ) circuit is a very promising approach to improve the system performance of SSPDs. In this review, we introduce our recent activities on cryogenic signal processing using SFQ circuits to realize high-performance multi-pixel SSPDs.
We developed a monolithic integration process for a superconducting nanostrip single-photon detector (SNSPD) and a cryogenic signal processor based on a single-flux-quantum (SFQ) circuit. Sixteen-pixel SNSPDs consisting of a 10-nm-thick and 100-nm-wide NbTiN nanowire were fabricated on a 3-in. Si wafer with an SFQ merger fabricated by the National Institute of Advanced Industrial Science and Technology Nb 2.5 kA/cm2 standard process 2. Subsequently, we illuminated the photons on the 16-pixel SNSPD array through an optical fiber and obtained a similar bias-current dependence of the detection efficiency with a single-pixel SNSPD without the SFQ merger. This indicates that the SFQ merger works correctly, and that the power dissipation of the SFQ circuit, which is estimated to be 200 μW, does not deteriorate the photon detection of SNSPD fabricated on the same chip with a size of 5 × 5 mm2. Furthermore, we measured timing jitter using a pulsed laser as the photon source. Owing to the careful tuning of the wiring length between each pixel of the 16-pixel SNSPD and each input port of the SFQ merger, the obtained timing jitter was 41.4 ps, which is approximately equal to or less than that of the single-pixel SNSPD.
We propose a scalable readout interface for superconducting nanowire single-photon detector (SSPD) arrays, which we call the AQFP/RSFQ interface. This interface is composed of adiabatic quantum-flux-parametron (AQFP) and rapid single-flux-quantum (RSFQ) logic families. The AQFP part reads out the spatial information of an SSPD array via a single cable, and the RSFQ part reads out the temporal information via a single cable. The hybrid interface has high temporal resolution owing to low timing jitter in the operation of the RSFQ part. In addition, the hybrid interface achieves high circuit scalability because of low supply current in the operation of the AQFP part. Therefore, the hybrid interface is suitable for handling many-pixel SSPD arrays. We demonstrate a four-pixel SSPD array using the hybrid interface as proof of concept. The measurement results show that the hybrid interface can read out all of the pixels with a low error rate and low timing jitter.