© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Technologies for superconducting nanowire single-photon detector array system

Shigehito Miki, Taro Yamashita, Hirotaka Terai, Kazumasa Makise, Zhen Wang

Published Jun 3, 2013• 1 citation

Abstract

We present the development of key technologies for realization of superconducting nanowire single photon detector array system, which enables high counting rates, and allow spatial and pseudo photon number resolution. Toward the realization of practical large-scale SSPD array system, primary issue is how to avoid heat flow into cryocooler system. One of the challenging tasks is the development of their readout electronics. In the conventional readout technique used for single pixel devices, the number of high-frequency coaxial cables increases proportionally with the number of arrays. This causes a significant increase in the heat load from room temperature, which makes the implementation of the SSPD arrays in a compact refrigerator difficult. To overcome this problem, we proposed applying readout electronics with superconducting single-flux-quantum (SFQ) logic circuitsWe show the implementation and successful operation of four pixels SSPD array connected to SFQ readout electronics with parallel bias scheme in a 0.1W GM cryocooler system.

DOI: 10.1117/12.2016750

Related papers

Parallel Bias and Readout Techniques Toward Realization of Large-Scale SSPD Array With SFQ Circuit

Taro Yamashita, Shigehito Miki, Hirotaka Terai +2 more

Toward the realization of a large-scale superconducting nanowire single-photon detector (SSPD) array system, we present the parallel bias operation of an SSPD array in which all elements are simultaneously biased in parallel by a single voltage source. We fabricated an SSPD array with uniform quality and implemented the device with/without single-flux-quantum (SFQ) readout circuit in a compact 0.1 W Gifford-McMahon cryocooler. By applying the time-resolved readout setup, we measured histograms of time-correlated single-photon counts to verify the parallel bias operation of the SSPD array with conventional and SFQ readout techniques. As a result, we confirmed crosstalk-free parallel bias operation of the four-element SSPD array by conventional and SFQ readouts.

IEEE Transactions on Applied Superconductivity•Jan 11, 2013•6 citations

Readout Electronics Using Single-Flux-Quantum Circuit Technology for Superconducting Single-Photon Detector Array

Hirotaka Terai, Shigehito Miki, Zhen Wang

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•63 citations

Scalable implementation of a superconducting nanowire single-photon detector array with a superconducting digital signal processor

Masahiro Yabuno, Shigeyuki Miyajima, Shigehito Miki +1 more

A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.

Optics Express•Apr 1, 2020•40 citations

Crosstalk-free operation of multielement superconducting nanowire single-photon detector array integrated with single-flux-quantum circuit in a 01 W Gifford–McMahon cryocooler

Taro Yamashita, Shigehito Miki, Hirotaka Terai +2 more

We demonstrate the successful operation of a multielement superconducting nanowire single-photon detector (SSPD) array integrated with a single-flux-quantum (SFQ) readout circuit in a compact 0.1 W Gifford-McMahon cryocooler. A time-resolved readout technique, where output signals from each element enter the SFQ readout circuit with finite time intervals, revealed crosstalk-free operation of the four-element SSPD array connected with the SFQ readout circuit. The timing jitter and the system detection efficiency were measured to be 50 ps and 11.4%, respectively, which were comparable to the performance of practical single-pixel SSPD systems.

Optics Letters•Jul 13, 2012•48 citations

Crosstalk-free operation of multi-element SSPD array integrated with SFQ circuit in a 0.1 Watt GM cryocooler

Taro Yamashita, Shigehito Miki, Hirotaka Terai +2 more

We demonstrate the successful operation of a multi-element superconducting nanowire single-photon detector (SSPD) array integrated with a single-flux-quantum (SFQ) readout circuit in a compact 0.1 W Gifford-McMahon cryocooler. A time-resolved readout technique, where output signals from each element enter the SFQ readout circuit with finite time intervals, revealed crosstalk-free operation of the four-element SSPD array connected with the SFQ readout circuit. The timing jitter and the system detection efficiency were measured to be 50 ps and 11.4%, respectively, which were comparable to the performance of practical single-pixel SSPD systems.

arXiv:1207.3902•Jul 17, 2012•5 citations

Cryogenic Signal Processing Using Single-flux-quantum Circuit for High Performance Multi-pixel Superconducting Nanowire Single-photon Detectors

Hirotaka Terai, Shigehito Miki, Taro Yamashita +2 more

Superconducting nanowire single-photon detectors (SSPDs) with a system detection efficiency (SDE) of over 80% are now commercially available and being used in compact Gifford-McMahon refrigerators. However, not only high SDE, but also total performance including a low dark count rate, high maximum count rate and/or low timing jitter are important for many applications. A multi-pixel SSPD combined with signal processing using a single-flux-quantum (SFQ) circuit is a very promising approach to improve the system performance of SSPDs. In this review, we introduce our recent activities on cryogenic signal processing using SFQ circuits to realize high-performance multi-pixel SSPDs.

TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)•Jan 1, 2017•0 citations

We present the development of key technologies for realization of superconducting nanowire single photon detector array system, which enables high counting rates, and allow spatial and pseudo photon number resolution. Toward the realization of practical large-scale SSPD array system, primary issue is how to avoid heat flow into cryocooler system. One of the challenging tasks is the development of their readout electronics. In the conventional readout technique used for single pixel devices, the number of high-frequency coaxial cables increases proportionally with the number of arrays. This causes a significant increase in the heat load from room temperature, which makes the implementation of the SSPD arrays in a compact refrigerator difficult. To overcome this problem, we proposed applying readout electronics with superconducting single-flux-quantum (SFQ) logic circuitsWe show the implementation and successful operation of four pixels SSPD array connected to SFQ readout electronics with parallel bias scheme in a 0.1W GM cryocooler system.

Toward the realization of a large-scale superconducting nanowire single-photon detector (SSPD) array system, we present the parallel bias operation of an SSPD array in which all elements are simultaneously biased in parallel by a single voltage source. We fabricated an SSPD array with uniform quality and implemented the device with/without single-flux-quantum (SFQ) readout circuit in a compact 0.1 W Gifford-McMahon cryocooler. By applying the time-resolved readout setup, we measured histograms of time-correlated single-photon counts to verify the parallel bias operation of the SSPD array with conventional and SFQ readout techniques. As a result, we confirmed crosstalk-free parallel bias operation of the four-element SSPD array by conventional and SFQ readouts.

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.

We demonstrate the successful operation of a multielement superconducting nanowire single-photon detector (SSPD) array integrated with a single-flux-quantum (SFQ) readout circuit in a compact 0.1 W Gifford-McMahon cryocooler. A time-resolved readout technique, where output signals from each element enter the SFQ readout circuit with finite time intervals, revealed crosstalk-free operation of the four-element SSPD array connected with the SFQ readout circuit. The timing jitter and the system detection efficiency were measured to be 50 ps and 11.4%, respectively, which were comparable to the performance of practical single-pixel SSPD systems.

We demonstrate the successful operation of a multi-element superconducting nanowire single-photon detector (SSPD) array integrated with a single-flux-quantum (SFQ) readout circuit in a compact 0.1 W Gifford-McMahon cryocooler. A time-resolved readout technique, where output signals from each element enter the SFQ readout circuit with finite time intervals, revealed crosstalk-free operation of the four-element SSPD array connected with the SFQ readout circuit. The timing jitter and the system detection efficiency were measured to be 50 ps and 11.4%, respectively, which were comparable to the performance of practical single-pixel SSPD systems.

Superconducting nanowire single-photon detectors (SSPDs) with a system detection efficiency (SDE) of over 80% are now commercially available and being used in compact Gifford-McMahon refrigerators. However, not only high SDE, but also total performance including a low dark count rate, high maximum count rate and/or low timing jitter are important for many applications. A multi-pixel SSPD combined with signal processing using a single-flux-quantum (SFQ) circuit is a very promising approach to improve the system performance of SSPDs. In this review, we introduce our recent activities on cryogenic signal processing using SFQ circuits to realize high-performance multi-pixel SSPDs.