Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

High-time-resolved 64-channel single-flux quantum-based address encoder integrated with a multi-pixel superconducting nanowire single-photon detector

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki, Taro Yamashita, Hirotaka Terai

Published Oct 24, 2018• 65 citations
Publisher

Abstract

We propose and demonstrate a 64-channel event-driven encoder based on single-flux quantum (SFQ) circuits for application to a multi-pixel superconducting nanowire single-photon detector (SSPD) system. Multi-pixel SSPD systems were developed to improve maximum count rates and realize ultra-sensitive imaging systems. An intelligent signal processor is required, which we designed based on SFQ circuits. We were able to obtain an address based on the reserve timing information for the photon detection that occurs in the SSPD, as well as read the time-tagged address information for the SSPDs through the SFQ encoder. The overall observed FWHM jitter was 56.5 ps.

DOI
10.1364/oe.26.029045

Related papers

Single-Flux-Quantum Based Event-Driven Encoder for Large-Pixel Superconducting Nanowire Single-Photon Detector Array

Shigeyuki Miyajima, Masahiro Yabuno, Shigehito Miki +1 more

We propose a single-flux-quantum (SFQ) based event-driven encoder for a large-pixel superconducting nanowire single-photon detector (SSPD) array with a row-column readout architecture. The designed SFQ encoder can acquire time-tagged address data with a high time resolution. To apply 32 × 32 pixel SSPD system with a row-column architecture, the SFQ encoder is equipped with two 32-channel input ports among which one is for positive pulses, whereas the other is for negative pulses. The number of Josephson junctions (JJs) in the designed circuit is 2780. The power dissipation and required total bias current are 0.21 mW and 170 mA, respectively, owing to the reductions in critical currents of the JJs and bias resistors. The circuit generates time-tagged address data by applying electrical pulses at room temperature not only in liquid helium but also in a 0.1-W Gifford-McMahon (GM) cryocooler.

IEEE Transactions on Applied Superconductivity•Mar 16, 2019•13 citations

Cryogenic Signal Processing Using Single-flux-quantum Circuit for High Performance Multi-pixel Superconducting Nanowire Single-photon Detectors

Hirotaka Terai, Shigehito Miki, Taro Yamashita +2 more

Superconducting nanowire single-photon detectors (SSPDs) with a system detection efficiency (SDE) of over 80% are now commercially available and being used in compact Gifford-McMahon refrigerators. However, not only high SDE, but also total performance including a low dark count rate, high maximum count rate and/or low timing jitter are important for many applications. A multi-pixel SSPD combined with signal processing using a single-flux-quantum (SFQ) circuit is a very promising approach to improve the system performance of SSPDs. In this review, we introduce our recent activities on cryogenic signal processing using SFQ circuits to realize high-performance multi-pixel SSPDs.

TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)•Jan 1, 2017•0 citations

Scalable implementation of a superconducting nanowire single-photon detector array with a superconducting digital signal processor

Masahiro Yabuno, Shigeyuki Miyajima, Shigehito Miki +1 more

A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.

Optics Express•Apr 1, 2020•40 citations

Photon number resolvability of multi-pixel superconducting nanowire single photon detectors using a single flux quantum circuit

Hou-Rong Zhou, Kun-Jie Cheng, Jie Ren +5 more

Superconducting nanowire single-photon detectors (SNSPDs) are typical switching devices capable of detecting single photons with almost 100% detection efficiency. However, they cannot determine the exact number of incident photons during a detection event. Multi-pixel SNSPDs employing multiple read-out channels can provide photon number resolvability (PNR), but they require increased cooling power and costly multi-channel electronic systems. In this work, a single-flux quantum (SFQ) circuit is employed, and PNR based on multi-pixel SNSPDs is successfully demonstrated. A multi-input magnetically coupled DC/SFQ converter (MMD2Q) circuit with a mutual inductance M is used to combine and record signals from a multi-pixel SNSPD device. The designed circuit is capable of discriminating the amplitude of the combined signals in accuracy of Φ 0/M with Φ 0 being a single magnetic flux quantum. By employing the MMD2Q circuit, the discrimination of up to 40 photons can be simulated. A 4-parallel-input MMD2Q circuit is fabricated, and a PNR of 3 is successfully demonstrated for an SNSPD array with one channel reserved for the functional verification. The results confirm that an MMD2Q circuit is an effective tool for implementing PNR with multi-pixel SNSPDs.

Chinese Physics B•Nov 15, 2021•3 citations

Timing discriminator based on single-flux-quantum circuit toward high time-resolved photon detection

Shigeyuki Miyajima, Shigehito Miki, Masahiro Yabuno +2 more

Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.

Superconductor Science and Technology•Oct 10, 2017•13 citations

Readout Electronics Using Single-Flux-Quantum Circuit Technology for Superconducting Single-Photon Detector Array

Hirotaka Terai, Shigehito Miki, Zhen Wang

Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•63 citations
We propose and demonstrate a 64-channel event-driven encoder based on single-flux quantum (SFQ) circuits for application to a multi-pixel superconducting nanowire single-photon detector (SSPD) system. Multi-pixel SSPD systems were developed to improve maximum count rates and realize ultra-sensitive imaging systems. An intelligent signal processor is required, which we designed based on SFQ circuits. We were able to obtain an address based on the reserve timing information for the photon detection that occurs in the SSPD, as well as read the time-tagged address information for the SSPDs through the SFQ encoder. The overall observed FWHM jitter was 56.5 ps.
We propose a single-flux-quantum (SFQ) based event-driven encoder for a large-pixel superconducting nanowire single-photon detector (SSPD) array with a row-column readout architecture. The designed SFQ encoder can acquire time-tagged address data with a high time resolution. To apply 32 × 32 pixel SSPD system with a row-column architecture, the SFQ encoder is equipped with two 32-channel input ports among which one is for positive pulses, whereas the other is for negative pulses. The number of Josephson junctions (JJs) in the designed circuit is 2780. The power dissipation and required total bias current are 0.21 mW and 170 mA, respectively, owing to the reductions in critical currents of the JJs and bias resistors. The circuit generates time-tagged address data by applying electrical pulses at room temperature not only in liquid helium but also in a 0.1-W Gifford-McMahon (GM) cryocooler.
Superconducting nanowire single-photon detectors (SSPDs) with a system detection efficiency (SDE) of over 80% are now commercially available and being used in compact Gifford-McMahon refrigerators. However, not only high SDE, but also total performance including a low dark count rate, high maximum count rate and/or low timing jitter are important for many applications. A multi-pixel SSPD combined with signal processing using a single-flux-quantum (SFQ) circuit is a very promising approach to improve the system performance of SSPDs. In this review, we introduce our recent activities on cryogenic signal processing using SFQ circuits to realize high-performance multi-pixel SSPDs.
A two-dimensional single-photon imaging system with high sensitivity and high time resolution is the ultimate camera and useful in a wide range of fields. A superconducting nanowire single-photon detector (SSPD or SNSPD) is one of the best candidates for realizing such an ultimate camera due to its high detection efficiency in a wide spectral range, low dark count rate without after-pulsing, and excellent time resolution. Here we propose a new readout scheme to realize a large-scale imaging array based on SSPD, where a row-column readout architecture is combined with a digital signal processor based on a single-flux-quantum (SFQ) circuit. A 16-pixel row-column readout SSPD array is fabricated and measured with an SFQ digital signal processor. We successfully acquired spatial information as encoded digital bit codes with the temporal information of the photon detection. The system timing jitter was measured as <80 ps for all 16 pixels even through the SFQ signal processor, indicating the potential for an imaging array with an extremely high time resolution.
Superconducting nanowire single-photon detectors (SNSPDs) are typical switching devices capable of detecting single photons with almost 100% detection efficiency. However, they cannot determine the exact number of incident photons during a detection event. Multi-pixel SNSPDs employing multiple read-out channels can provide photon number resolvability (PNR), but they require increased cooling power and costly multi-channel electronic systems. In this work, a single-flux quantum (SFQ) circuit is employed, and PNR based on multi-pixel SNSPDs is successfully demonstrated. A multi-input magnetically coupled DC/SFQ converter (MMD2Q) circuit with a mutual inductance M is used to combine and record signals from a multi-pixel SNSPD device. The designed circuit is capable of discriminating the amplitude of the combined signals in accuracy of Φ 0/M with Φ 0 being a single magnetic flux quantum. By employing the MMD2Q circuit, the discrimination of up to 40 photons can be simulated. A 4-parallel-input MMD2Q circuit is fabricated, and a PNR of 3 is successfully demonstrated for an SNSPD array with one channel reserved for the functional verification. The results confirm that an MMD2Q circuit is an effective tool for implementing PNR with multi-pixel SNSPDs.
Abstract We propose a new time discriminating method based on a single-flux quantum (SFQ) circuit to realize a high time-resolved single-photon detection scheme that uses a superconducting nanowire single-photon detector (SSPD). The timing discriminator consists of an SFQ comparator and an interface circuit for converting the output signals of an SSPD into SFQ pulses. Prior to connecting with the SSPD, we evaluated the timing jitters of the SFQ timing discriminator itself by applying external electrical pulses. The timing jitters of the SFQ timing discriminator were found to be dominated by the timing jitters in the interface circuit. However, it was estimated to be below 10 ps even with an input pulse amplitude of 20 μ A, which is close to the typical output amplitude of the SSPD.
Superconducting single-photon detectors (SSPDs) based on NbN nanowires possess properties such as high counting rate, low dark count rate and small timing jitter, which are promising characteristics for a quantum key distribution system. An SSPD array has recently attracted attention, because it can provide a higher counting rate, and spatial and photon-number resolutions. We propose readout electronics using single-flux-quantum (SFQ) circuits to process a large number of output signals from an SSPD array. We designed and tested an interface circuit between an SSPD and SFQ circuit, and successfully observed SFQ pulse generation for an input pulse with a current amplitude of 17.4 ~ 36.4 muA , which is comparable with an output current amplitude of the SSPD. The interface circuit was also operational for an input pulse duration of 1.6 ns, which is shorter than the typical recovery time of the SSPD.