Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Measurement Science and Technology

In situ determination of alkali metal density using phase-frequency analysis on atomic magnetometers

Han Yao, Hong Zhang, Danyue Ma, Junpeng Zhao, Ming Ding

Published Jul 6, 2018• 8 citations
Publisher

Abstract

Abstract The alkali number density inside the sealed vapor cell restricts the fundamental sensitivity of the atomic magnetometer and may decrease in the long term, thus motivating the investigation of an in situ density determination method on atomic magnetometers. This paper presents a method to measure the alkali number density, which is proportional to the spin-exchange relaxation rate, through phase-frequency analysis. The magnetic resonance response of the atomic magnetometer was actively strengthened at low polarization by increasing the oscillating field amplitude. To downplay the side effect of the transverse field broadening, phase-frequency analysis was applied to extract the transverse relaxation time limited by spin-exchange collisions. The experimental results coincided well with the saturated vapor pressure curve ranging from 413 K to 463 K. Calculated densities were approximately 0.779–0.992 times those of predictions. The density measurement accuracy was improved compared to traditional methods.

DOI
10.1088/1361-6501/aad1e0

Related papers

In-situ measurement of cell temperature by spin-relaxation rate analysis for an atomic magnetometer

Bingquan Zhao, Zhe Qi, Jianlong Wang +5 more

Abstract Alkali-metal vapor cells are the core sensing components of atomic magnetometers. To achieve high-sensitivity magnetic field measurements, the cells require heating and stabilization at high temperatures. Here, we propose an in-situ temperature measurement method for a vapor cell of an atomic magnetometer based on spin-relaxation analysis. This technique establishes a direct functional correlation between the cell temperature and the spin-relaxation rate under low pumping power conditions. Experimental validation within the temperature range of 90 °C–130 °C confirms the accuracy of this approach. We further investigate the effects of magnetic fields on measurement precision and demonstrate the long-term, high-precision capabilities of temperature detection. This non-invasive technique presents a critical advantage for precise thermal optimization of atomic magnetometers.

Chinese Physics B•Sep 17, 2025•0 citations

On-site monitoring of atomic density number for an all-optical atomic magnetometer based on atomic spin exchange relaxation

Hong Zhang, Sheng Zou, Xiyuan Chen +4 more

We present a method for monitoring the atomic density number on site based on atomic spin exchange relaxation. When the spin polarization P ≪ 1, the atomic density numbers could be estimated by measuring magnetic resonance linewidth in an applied DC magnetic field by using an all-optical atomic magnetometer. The density measurement results showed that the experimental results the theoretical predictions had a good consistency in the investigated temperature range from 413 K to 463 K, while, the experimental results were approximately 1.5 ∼ 2 times less than the theoretical predictions estimated from the saturated vapor pressure curve. These deviations were mainly induced by the radiative heat transfer efficiency, which inevitably leaded to a lower temperature in cell than the setting temperature.

Optics Express•Jul 21, 2016•21 citations

The Space Density Distribution of Alkali Metal Atoms in a SERF Atomic Magnetometer

Qiang Guo, Xuewen Li, Ning Zhang +4 more

The number density of alkali atoms in vaper cell is an important parameter for atomic magnetometer. The vapor cell is usually heated to a high temperature for the number density exceed to 1018m−3to achieve the spin-exchange-relaxation-free (SERF) process. The optical rotation of multichannel atomic magnetometers is affected by the number density distribution. We present an effective method for monitoring and analyzing the spatial distribution homogeneity of the atomic number density in the alkali metal cell within the SERF magnetometer. The numerical results from researching the model of electric heating films and ovens show that the temperature gradient increases with an increase in the cell temperature. This causes an nonuniform number density distribution based on the saturated vapor pressure curve. We present a laser absorption spectroscopy method by using the high-resolution beam profiling camera to record the power of the beam before and after the cell. An optimized optical system of the atomic magnetometer has been established by measuring the the number density variation in the spatial distribution in mm scale. The number density variation coefficient, which is introduced to evaluate the distribution homogeneity, increases from 0.0257 to 0.0333 when the temperature of the oven wall rises from 140°C to 190 °C, showing the same trend as the simulation results. The optical rotation distribution is calculated according to the magnetometer output signal formula. This study is of great interest for optimizing the oven structure and improving the stability of atomic spin polarization and sensitivity of the multichannel magnetometer.

IEEE Sensors Journal•Jan 27, 2022•13 citations

Measurement of Rubidium Vapor Density Based on Spin‐Exchange Rate

Huining Shang, Sheng Zou, Hong Zhang +1 more

Abstract An efficient method is proposed for quantifying rubidium vapor density by analyzing the spin‐exchange rate between alkali metals. This method effectively addresses two primary challenges in measuring alkali vapor density. First, it overcomes the limitation of absorption spectroscopy to measure vapor density under optically thick conditions, typically restricted to temperature higher than 420K, equivalent to alkali vapor density exceeding . Second, it mitigates the risk of disrupting shielding functionality due to the application of a strong magnetic field, often in the range of several tens of Gauss or higher, when employing the Faraday rotation for vapor‐density measurement. The spin‐exchange rate between atoms, inherently related to the vapor density, is evident in the electron‐paramagnetic‐resonance spectrum of spin‐polarized , thereby providing a possibility for measuring alkali vapor density. To eliminate overlap between two Lorentzian curves resulting from two decomposed components of an oscillating field, a small rotating magnetic field with identical amplitude and frequency but a 90‐degree phase shift along both the x and y axes is applied. This method is successfully employed to measure vapor density in the temperature range of 373–433 K, with the measured outcomes closely matching the saturation vapor curve.

Advanced Quantum Technologies•Mar 17, 2024•4 citations

In-situ determination of spin polarization in a single-beam fiber-coupled spin-exchange-relaxation-free atomic magnetometer with differential detection

Yintao Ma, Zhixia Qiao, Yao Chen +8 more

The electronic spin polarization of alkali-metal-vapor atoms is a pivotal parameter for atomic magnetometers. Herein, a novel method is presented for determining the spin polarization with a miniaturized single-beam spin-exchange-relaxation-free (SERF) magnetometer on the basis of zero-field cross-over resonance. Two separate laser beams are utilized to heat the cell and interrogate the vapor atoms, respectively. Spin polarization can be extracted by measuring the resonance response signal of the magnetometer to the transverse magnetic field under different irradiances. Results of these experiments are consistent well with the theoretical predictions with the maximum deviation less than 4%. The proposed method has the integrated advantages of possessing a simple configuration and in-situ measurement. Furthermore, combined with a homemade optical differential detection system with a factor of approximately three of the power noise suppression, the developed single-beam SERF atomic magnetometer with a measuring sensitivity of 32 fT/Hz 1/2 has been achieved. This demonstrated approach can help guide the development of chip-scale atomic magnetometers for bio-magnetic field imaging applications.

Optics Express•Jan 9, 2023•5 citations

Alkali Atomic Density Detection With Arbitrarily Polarized Light

Xuejing Liu, Menglu Wang, Yuhan Li +3 more

The atomic density of an alkali vapor cell is a critical factor in determining the performance of atomic magnetometers. This paper presents a novel method to detect the density of an alkali atomic ensemble under arbitrary polarization states. By establishing a comprehensive model that correlates the absorption spectrum with the incident light’s polarization, our approach enables real-time and flexible measurements across varying temperatures and polarization angles. Experimental validations are conducted by systematically rotating a quarter-wave plate and controlling the vapor cell temperature, thereby collecting transmission spectra at multiple polarizations. The results demonstrate that the proposed method simplifies density measurements while preserving high accuracy, laying a solid foundation for further research on Spin-Exchange Relaxation-Free (SERF) atomic magnetometers. This technique serves as a versatile and effective tool for in-situ monitoring of alkali metal vapor density in various sensor applications.

IEEE Sensors Journal•Apr 7, 2025•1 citation
Abstract The alkali number density inside the sealed vapor cell restricts the fundamental sensitivity of the atomic magnetometer and may decrease in the long term, thus motivating the investigation of an in situ density determination method on atomic magnetometers. This paper presents a method to measure the alkali number density, which is proportional to the spin-exchange relaxation rate, through phase-frequency analysis. The magnetic resonance response of the atomic magnetometer was actively strengthened at low polarization by increasing the oscillating field amplitude. To downplay the side effect of the transverse field broadening, phase-frequency analysis was applied to extract the transverse relaxation time limited by spin-exchange collisions. The experimental results coincided well with the saturated vapor pressure curve ranging from 413 K to 463 K. Calculated densities were approximately 0.779–0.992 times those of predictions. The density measurement accuracy was improved compared to traditional methods.
Abstract Alkali-metal vapor cells are the core sensing components of atomic magnetometers. To achieve high-sensitivity magnetic field measurements, the cells require heating and stabilization at high temperatures. Here, we propose an in-situ temperature measurement method for a vapor cell of an atomic magnetometer based on spin-relaxation analysis. This technique establishes a direct functional correlation between the cell temperature and the spin-relaxation rate under low pumping power conditions. Experimental validation within the temperature range of 90 °C–130 °C confirms the accuracy of this approach. We further investigate the effects of magnetic fields on measurement precision and demonstrate the long-term, high-precision capabilities of temperature detection. This non-invasive technique presents a critical advantage for precise thermal optimization of atomic magnetometers.
We present a method for monitoring the atomic density number on site based on atomic spin exchange relaxation. When the spin polarization P ≪ 1, the atomic density numbers could be estimated by measuring magnetic resonance linewidth in an applied DC magnetic field by using an all-optical atomic magnetometer. The density measurement results showed that the experimental results the theoretical predictions had a good consistency in the investigated temperature range from 413 K to 463 K, while, the experimental results were approximately 1.5 ∼ 2 times less than the theoretical predictions estimated from the saturated vapor pressure curve. These deviations were mainly induced by the radiative heat transfer efficiency, which inevitably leaded to a lower temperature in cell than the setting temperature.
The number density of alkali atoms in vaper cell is an important parameter for atomic magnetometer. The vapor cell is usually heated to a high temperature for the number density exceed to 1018m−3to achieve the spin-exchange-relaxation-free (SERF) process. The optical rotation of multichannel atomic magnetometers is affected by the number density distribution. We present an effective method for monitoring and analyzing the spatial distribution homogeneity of the atomic number density in the alkali metal cell within the SERF magnetometer. The numerical results from researching the model of electric heating films and ovens show that the temperature gradient increases with an increase in the cell temperature. This causes an nonuniform number density distribution based on the saturated vapor pressure curve. We present a laser absorption spectroscopy method by using the high-resolution beam profiling camera to record the power of the beam before and after the cell. An optimized optical system of the atomic magnetometer has been established by measuring the the number density variation in the spatial distribution in mm scale. The number density variation coefficient, which is introduced to evaluate the distribution homogeneity, increases from 0.0257 to 0.0333 when the temperature of the oven wall rises from 140°C to 190 °C, showing the same trend as the simulation results. The optical rotation distribution is calculated according to the magnetometer output signal formula. This study is of great interest for optimizing the oven structure and improving the stability of atomic spin polarization and sensitivity of the multichannel magnetometer.
Abstract An efficient method is proposed for quantifying rubidium vapor density by analyzing the spin‐exchange rate between alkali metals. This method effectively addresses two primary challenges in measuring alkali vapor density. First, it overcomes the limitation of absorption spectroscopy to measure vapor density under optically thick conditions, typically restricted to temperature higher than 420K, equivalent to alkali vapor density exceeding . Second, it mitigates the risk of disrupting shielding functionality due to the application of a strong magnetic field, often in the range of several tens of Gauss or higher, when employing the Faraday rotation for vapor‐density measurement. The spin‐exchange rate between atoms, inherently related to the vapor density, is evident in the electron‐paramagnetic‐resonance spectrum of spin‐polarized , thereby providing a possibility for measuring alkali vapor density. To eliminate overlap between two Lorentzian curves resulting from two decomposed components of an oscillating field, a small rotating magnetic field with identical amplitude and frequency but a 90‐degree phase shift along both the x and y axes is applied. This method is successfully employed to measure vapor density in the temperature range of 373–433 K, with the measured outcomes closely matching the saturation vapor curve.
The electronic spin polarization of alkali-metal-vapor atoms is a pivotal parameter for atomic magnetometers. Herein, a novel method is presented for determining the spin polarization with a miniaturized single-beam spin-exchange-relaxation-free (SERF) magnetometer on the basis of zero-field cross-over resonance. Two separate laser beams are utilized to heat the cell and interrogate the vapor atoms, respectively. Spin polarization can be extracted by measuring the resonance response signal of the magnetometer to the transverse magnetic field under different irradiances. Results of these experiments are consistent well with the theoretical predictions with the maximum deviation less than 4%. The proposed method has the integrated advantages of possessing a simple configuration and in-situ measurement. Furthermore, combined with a homemade optical differential detection system with a factor of approximately three of the power noise suppression, the developed single-beam SERF atomic magnetometer with a measuring sensitivity of 32 fT/Hz 1/2 has been achieved. This demonstrated approach can help guide the development of chip-scale atomic magnetometers for bio-magnetic field imaging applications.
The atomic density of an alkali vapor cell is a critical factor in determining the performance of atomic magnetometers. This paper presents a novel method to detect the density of an alkali atomic ensemble under arbitrary polarization states. By establishing a comprehensive model that correlates the absorption spectrum with the incident light’s polarization, our approach enables real-time and flexible measurements across varying temperatures and polarization angles. Experimental validations are conducted by systematically rotating a quarter-wave plate and controlling the vapor cell temperature, thereby collecting transmission spectra at multiple polarizations. The results demonstrate that the proposed method simplifies density measurements while preserving high accuracy, laying a solid foundation for further research on Spin-Exchange Relaxation-Free (SERF) atomic magnetometers. This technique serves as a versatile and effective tool for in-situ monitoring of alkali metal vapor density in various sensor applications.