Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)

High order harmonic mixing up to 2.5 THz using thin film Josephson tunnel junctions

M. C. Wicks

Published Oct 1, 1991• 0 citations
Publisher

Abstract

Thin film niobium nitride Josephson tunnel junctions have been used as harmonic mixers in experiments to measure the frequency of various submillimetre wavelength laser lines. The Josephson junctions were used as harmonic mixers with an 18-40 GHz microwave synthesiser providing the local oscillator signal. Harmonics up to the 140th of ∼18 GHz, generated within the junction, mixed with optically pumped laser lines up to 2.5 THz to produce output signals around 20 MHz. Results of frequency measurements and data on the performance of the mixing system, including signal to noise ratios and frequency response, will be presented.

DOI
10.1117/12.2297908

Related papers

Harmonic mixing in thin film niobium nitride Josephson tunnel junctions

M. C. Wicks

Beats between the harmonics of a microwave signal and various submillimetre laser lines above 890 GHz have been observed in the output from NbN Josephson junctions. Results of these mixing experiments will be described and discussed.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Dec 1, 1990•1 citation

Harmonic Mixing Using a HTS Step-Edge Josephson Junction at 0.6 THz Frequency

Jia Du, Colin M. Pegrum, Xiang Gao +4 more

A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.

IEEE Transactions on Applied Superconductivity•Dec 6, 2016•28 citations

Investigation of the Harmonic Mixer and Low-Frequency Converter Regimes in a Superconducting Tunnel Junction

K. V. Kalashnikov, Anton A. Artanov, Gert J. de Lange +1 more

We experimentally investigate different mixing regi-mes in Nb/AlOx/Nb and Nb/AlN/NbN tunnel superconductor-insulator-superconductor (SIS) junctions. The SIS mixers were studied with regard to the following modes of operation: in an extremely low-frequency range (0.1-20 GHz) and as high harmonic mixers; n ≈ 20-30 at signal frequencies of about 500 GHz that requires high power of a local oscillator. The quasiparticle and Josephson mixing regimes have been compared. We demonstrate that, in some applications requiring high conversion efficiency, the Josephson regime can be more preferable than the quasiparticle regime due to a larger output signal and better signal-to-noise ratio. As an example of such an application, we consider the phase locking of a THz oscillator using a cryogenic harmonic phase detector, which only ought to realize all of its benefits under the Josephson mixing regime. In addition, we demonstrate that the presence of the Josephson effect results in considerable increase in conversion efficiency at the expense of the dynamic range decrease; it was measured for low-frequency up- and down-convertors, which are promising for cryogenic multiplexing systems.

IEEE Transactions on Applied Superconductivity•Feb 6, 2018•6 citations

Millimeter Wave Harmonic Mixing in Thin-Film YBa2Cu3O7-x Josephson Junctions

Yoshizumi Yasuoka, Takashi Nozue, Tsutomu Yamashita

Harmonic mixing characteristics in thin-film YBa2Cu3O7-x (YBCO) Josephson junctions fabricated using photolithography were examined at the liquid nitrogen temperature (77 K) using 94 GHz millimeter wave radiation. As a result, a mixing signal (IF output) was obtained up to the harmonic number of 55 in harmonic mixing using the local oscillation (LO) wave as the microwave. The output strongly depended on the power of the LO and signal waves, and on the Shapiro step spacing induced by the LO wave. The IF output decreased in proportion to N -2 in the lower harmonic number region. However, the rate of decrease increased with an increase in the harmonic number.

Japanese Journal of Applied Physics•Nov 1, 1999•2 citations

Point-contact-type Josephson harmonic mixer for frequency measurement of far-infrared lasers

Yukinobu Miki, Eiichi Sakuma, Masanao Morimura

Point-contact-type Josephson junctions have been developed as a harmonic mixer to measure far-infrared (FIR) laser frequencies in a frequency chain up to the infrared region. The junctions were formed by mechanically pressing a niobium wire of 70 μm in diameter with a sharply etched tip against a niobium post of 2 mm in diameter. The voltage-current characteristics of the mixers were investigated under the irradiation of FIR lights from an optically pumped methyl-alcohol laser. The Shapiro steps for FIR lights up to 3.1 THz were observed. The mixing properties of the mixers were studied through harmonic mixing experiments of 50-GHz microwaves and the FIR lights up to the frequency of 3.1 THz. The conversion efficiency of the beat signals to the incident FIR power was found to vary as the — 4th power of the FIR frequency. From the mixing properties, the combination of the critical current Icof the junction and the product IcRnwhere Rnis the normal resistance of the junction, was found important to optimize the mixing performance.

IEEE Transactions on Instrumentation and Measurement•Jun 1, 1987•3 citations

Harmonic mixing at mm waveband in a high temperature superconducting grain boundary Josephson junction

Huabing Wang, Weiwei Xu, Qilin Cheng +4 more

Using a high Tc superconducting grain boundary Josephson junction, harmonic mixing experiments in the mm waveband were carried out, aiming at as large a harmonic number and as high a signal frequency as possible. The dependencies of intermediate frequency output on dc bias, harmonic number, frequency of local oscillator (LO), and other parameters were carefully studied. Until now, our best result was the mixing between the signal at 95 GHz and the 105th harmonic of LO at about 900 MHz. Preliminary experiments using a high Tc harmonic mixer and phase-locking loop were tried to stabilize the frequency of a mm wave source.

Journal of Applied Physics•Feb 15, 1994•16 citations
Thin film niobium nitride Josephson tunnel junctions have been used as harmonic mixers in experiments to measure the frequency of various submillimetre wavelength laser lines. The Josephson junctions were used as harmonic mixers with an 18-40 GHz microwave synthesiser providing the local oscillator signal. Harmonics up to the 140th of ∼18 GHz, generated within the junction, mixed with optically pumped laser lines up to 2.5 THz to produce output signals around 20 MHz. Results of frequency measurements and data on the performance of the mixing system, including signal to noise ratios and frequency response, will be presented.
A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.
We experimentally investigate different mixing regi-mes in Nb/AlOx/Nb and Nb/AlN/NbN tunnel superconductor-insulator-superconductor (SIS) junctions. The SIS mixers were studied with regard to the following modes of operation: in an extremely low-frequency range (0.1-20 GHz) and as high harmonic mixers; n ≈ 20-30 at signal frequencies of about 500 GHz that requires high power of a local oscillator. The quasiparticle and Josephson mixing regimes have been compared. We demonstrate that, in some applications requiring high conversion efficiency, the Josephson regime can be more preferable than the quasiparticle regime due to a larger output signal and better signal-to-noise ratio. As an example of such an application, we consider the phase locking of a THz oscillator using a cryogenic harmonic phase detector, which only ought to realize all of its benefits under the Josephson mixing regime. In addition, we demonstrate that the presence of the Josephson effect results in considerable increase in conversion efficiency at the expense of the dynamic range decrease; it was measured for low-frequency up- and down-convertors, which are promising for cryogenic multiplexing systems.
Harmonic mixing characteristics in thin-film YBa2Cu3O7-x (YBCO) Josephson junctions fabricated using photolithography were examined at the liquid nitrogen temperature (77 K) using 94 GHz millimeter wave radiation. As a result, a mixing signal (IF output) was obtained up to the harmonic number of 55 in harmonic mixing using the local oscillation (LO) wave as the microwave. The output strongly depended on the power of the LO and signal waves, and on the Shapiro step spacing induced by the LO wave. The IF output decreased in proportion to N -2 in the lower harmonic number region. However, the rate of decrease increased with an increase in the harmonic number.
Point-contact-type Josephson junctions have been developed as a harmonic mixer to measure far-infrared (FIR) laser frequencies in a frequency chain up to the infrared region. The junctions were formed by mechanically pressing a niobium wire of 70 μm in diameter with a sharply etched tip against a niobium post of 2 mm in diameter. The voltage-current characteristics of the mixers were investigated under the irradiation of FIR lights from an optically pumped methyl-alcohol laser. The Shapiro steps for FIR lights up to 3.1 THz were observed. The mixing properties of the mixers were studied through harmonic mixing experiments of 50-GHz microwaves and the FIR lights up to the frequency of 3.1 THz. The conversion efficiency of the beat signals to the incident FIR power was found to vary as the — 4th power of the FIR frequency. From the mixing properties, the combination of the critical current Icof the junction and the product IcRnwhere Rnis the normal resistance of the junction, was found important to optimize the mixing performance.
Using a high Tc superconducting grain boundary Josephson junction, harmonic mixing experiments in the mm waveband were carried out, aiming at as large a harmonic number and as high a signal frequency as possible. The dependencies of intermediate frequency output on dc bias, harmonic number, frequency of local oscillator (LO), and other parameters were carefully studied. Until now, our best result was the mixing between the signal at 95 GHz and the 105th harmonic of LO at about 900 MHz. Preliminary experiments using a high Tc harmonic mixer and phase-locking loop were tried to stabilize the frequency of a mm wave source.