Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Harmonic Mixing Using a HTS Step-Edge Josephson Junction at 0.6 THz Frequency

Jia Du, Colin M. Pegrum, Xiang Gao, Andrew R. Weily, Ting Zhang, Yingjie Jay Guo, C. P. Foley

Published Dec 6, 2016• 28 citations
Publisher

Abstract

A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.

DOI
10.1109/tasc.2016.2636081

Related papers

A wideband terahertz high- T c superconducting Josephson-junction mixer: electromagnetic design, analysis and characterization

Xiang Gao, Ting Zhang, Jia Du +3 more

Abstract This paper presents a wideband terahertz (THz) mixer based on a thin-film antenna-coupled high-temperature superconducting (HTS) YBa 2 Cu 3 O 7−x (YBCO) step-edge Josephson junction. The HTS mixer enables the flexible harmonic mixing operation at multiple THz bands with the same microwave local oscillator (LO) source, and features very wide intermediate-frequency or instantaneous bandwidth. In order to optimize the frequency down-conversion performance of the mixer, systematic electromagnetic design and analysis have been carried out to improve the power coupling of THz radiation as well as wideband transmission of microwave signals. Experimental characterization of a fabricated device prototype has demonstrated that the mixer exhibits good performance at both the 200 GHz and 600 GHz bands. Detailed measurement results including the DC characteristics, LO pumping requirement, frequency response, mixing linearity and conversion gain are presented in this paper.

Superconductor Science and Technology•Jun 30, 2017•42 citations

HTS step-edge Josephson junction terahertz harmonic mixer

Jia Du, Andrew R. Weily, Xiang Gao +3 more

A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.

Superconductor Science and Technology•Nov 30, 2016•42 citations

Terahertz harmonic mixer based on HTS Josephson junction

Mei Yu, Weiwei Xu, Jin Shi +3 more

High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Aug 29, 2021•0 citations

0.34- THz High-Temperature Superconducting Josephson-Junction Mixer with Superior Noise and Conversion Performance

Xiang Gao, Jia Du, T. Zhang +1 more

We present, in this work, a new thin-film antenna-coupled high-temperature superconducting (HTS) Josephson-junction terahertz (THz) mixer that demonstrates superior performance at frequencies around 0.34 THz. A novel dual-meander-slot thin-film antenna is designed to significantly improve the antenna-junction impedance matching and thus more efficient coupling of the THz signal power. Theoretical and experimental investigations are carried out to evaluate the mixer performance. This mixer can be applied to the sensitive THz wireless receivers.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Sep 1, 2018•3 citations

600-GHz high-temperature superconducting sub-harmonic mixer coupled using a double-Y-type slot integrated lens antenna

Xiang Gao, Huanxin Li, Ting Zhang +4 more

In this paper, we present a quasi-optically coupled 600-GHz high-temperature superconducting (HTS) sub-harmonic mixer for communication and sensing applications. The mixer features an innovative double-Y-type slot integrated lens antenna, which can efficiently couple the radio frequency (RF) and local oscillator (LO) signals with a small frequency ratio by exciting the half-wave and full-wave resonant current modes on the slot, respectively. Considering the low impedance characteristics of HTS Josephson junctions, a coplanar-waveguide stepped impedance transformer is utilized for minimizing the mismatching loss. A cascaded filter network is designed to prevent the high-frequency signal leakage at both bands while coupling the intermediate-frequency (IF) signal output efficiently. Based on this antenna design and an established HTS step-edge junction technology, a 600-GHz mixer prototype was designed, fabricated and measured, which was compared with the simulation results. The achieved conversion gain and noise temperature are the best performance specs as reported to date for HTS harmonic mixers at comparable frequencies and operating temperatures.

Optics Express•Aug 30, 2022•5 citations

Mixing at terahertz frequency band using YBa2Cu3O7−δ bicrystal Josephson junctions

J. Chen, Hiroaki Myoren, K. Nakajima +2 more

Using high-Tc Josephson junctions made of YBa2Cu3O7−δ deposited across MgO bicrystal boundary, at terahertz (THz) frequency band, we demonstrated both fundamental and harmonic mixing. Radiation from a far-infrared laser was coupled to the junction, which was integrated with a planar bow-tie antenna, via an extended hyperhemispherical silicon lens. Fundamental mixing manifested itself in the junction’s dc current–voltage (I–V) curve as a third Shapiro step in addition to those two induced by the THz laser lines from a slightly misaligned resonator. In harmonic mixing between a THz laser line and a microwave local oscillator, the highest harmonic number we could get was 490 with a signal-to-noise ratio of 9 dB at the intermediate frequency.

Applied Physics Letters•Aug 4, 1997•35 citations
A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.
Abstract This paper presents a wideband terahertz (THz) mixer based on a thin-film antenna-coupled high-temperature superconducting (HTS) YBa 2 Cu 3 O 7−x (YBCO) step-edge Josephson junction. The HTS mixer enables the flexible harmonic mixing operation at multiple THz bands with the same microwave local oscillator (LO) source, and features very wide intermediate-frequency or instantaneous bandwidth. In order to optimize the frequency down-conversion performance of the mixer, systematic electromagnetic design and analysis have been carried out to improve the power coupling of THz radiation as well as wideband transmission of microwave signals. Experimental characterization of a fabricated device prototype has demonstrated that the mixer exhibits good performance at both the 200 GHz and 600 GHz bands. Detailed measurement results including the DC characteristics, LO pumping requirement, frequency response, mixing linearity and conversion gain are presented in this paper.
A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.
High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.
We present, in this work, a new thin-film antenna-coupled high-temperature superconducting (HTS) Josephson-junction terahertz (THz) mixer that demonstrates superior performance at frequencies around 0.34 THz. A novel dual-meander-slot thin-film antenna is designed to significantly improve the antenna-junction impedance matching and thus more efficient coupling of the THz signal power. Theoretical and experimental investigations are carried out to evaluate the mixer performance. This mixer can be applied to the sensitive THz wireless receivers.
In this paper, we present a quasi-optically coupled 600-GHz high-temperature superconducting (HTS) sub-harmonic mixer for communication and sensing applications. The mixer features an innovative double-Y-type slot integrated lens antenna, which can efficiently couple the radio frequency (RF) and local oscillator (LO) signals with a small frequency ratio by exciting the half-wave and full-wave resonant current modes on the slot, respectively. Considering the low impedance characteristics of HTS Josephson junctions, a coplanar-waveguide stepped impedance transformer is utilized for minimizing the mismatching loss. A cascaded filter network is designed to prevent the high-frequency signal leakage at both bands while coupling the intermediate-frequency (IF) signal output efficiently. Based on this antenna design and an established HTS step-edge junction technology, a 600-GHz mixer prototype was designed, fabricated and measured, which was compared with the simulation results. The achieved conversion gain and noise temperature are the best performance specs as reported to date for HTS harmonic mixers at comparable frequencies and operating temperatures.
Using high-Tc Josephson junctions made of YBa2Cu3O7−δ deposited across MgO bicrystal boundary, at terahertz (THz) frequency band, we demonstrated both fundamental and harmonic mixing. Radiation from a far-infrared laser was coupled to the junction, which was integrated with a planar bow-tie antenna, via an extended hyperhemispherical silicon lens. Fundamental mixing manifested itself in the junction’s dc current–voltage (I–V) curve as a third Shapiro step in addition to those two induced by the THz laser lines from a slightly misaligned resonator. In harmonic mixing between a THz laser line and a microwave local oscillator, the highest harmonic number we could get was 490 with a signal-to-noise ratio of 9 dB at the intermediate frequency.