Achieving individual qubit readout is a major challenge in the development of scalable superconducting quantum processors. We have implemented the multiplexed readout of a four transmon qubit circuit using nonlinear resonators operated as Josephson bifurcation amplifiers. We demonstrate the simultaneous measurement of Rabi oscillations of the four transmons. We find that multiplexed Josephson bifurcation is a high-fidelity readout method, the scalability of which is not limited by the need of a large-bandwidth, nearly quantum-limited amplifier as is the case with linear readout resonators.
High-fidelity quantum nondemolition qubit measurement is critical to error correction and rapid qubit feedback in large-scale quantum computing. Maximizing high-fidelity dispersive readout in superconducting qubits commonly requires passing a short and strong pulse through the qubit's readout resonator, which is then processed by a sufficiently high bandwidth, high saturation power, and quantum-limited amplifier. We have developed an amplifier design pipeline that combines time-domain simulation of the untruncated device Hamiltonian, fabrication constraints, and maximization of saturation power. We have realized an amplifier based on a modified trilayer (Nb-Al-
AlOx-Nb) fabrication suite at NIST, which utilizes an array of 25 rf superconducting quantum interference devices embedded within a low-
Q resonator powered by a high-power voltage pump delivered via a diplexer on the signal port. We show that, despite the intensity of the pump, the device is quantum efficient and capable of high-fidelity measurement limited by state transitions in the transmon. We present experimental data demonstrating up to $\ensuremath{-}91.2\phantom{\rule{0.2em}{0ex}}\mathrm{dBm}$ input saturation power with 20-
dB gain, up to 28-MHz instantaneous bandwidth, and phase-preserving qubit measurements with $62\mathrm{%}$ quantum efficiency.
A transmon qubit embedded in a high-impedance environment acts in a way dual to a conventional Josephson junction. In analogy to the AC Josephson effect, biasing of the transmon by a direct current leads to the oscillations of voltage across it. These oscillations are known as the Bloch oscillations. We find the Bloch oscillations spectrum, and show that the zero-point fluctuations of charge make it broadband. Despite having a broad-band spectrum, Bloch oscillations can be brought in resonance with an external microwave radiation. The resonances lead to steps in the voltage-current relation, which are dual to the conventional Shapiro steps. We find how the shape of the steps depends on the environment impedance R, parameters of the transmon, and the microwave amplitude. The Bloch oscillations rely on the insulating state of the transmon which is realized at impedances exceeding the Schmid transition point, R > RQ = h/(2e)2. When a Josephson junction is embedded into a highly-resistive environment, it loses its superconducting properties and starts to behave as an insulator. This results in voltage oscillations across the current-biased junction - the Bloch oscillations. Here the authors develop a fully quantum theory of this effect.