This paper proposes a scheme and design of cryogenic multiplexing control chip (MCC) which enables one microwave cable to control many superconducting qubits. Designed based on adjustable inductor, MCC is a non-reciprocal device which generates microwave signals between 4 and 8 GHz and constructs XY control circuit to operate qubits. The effects of filters, isolators, power splitters, qubits and load impedance on MCC are analyzed in the frequency-domain simulation. And in time-domain simulation, the response time, Gaussian pulses, single-sideband, amplitude and frequency compensation of MCC are examined. The MCC can be integrated with the superconducting qubits on the same package at 20 mK temperature stage, and output specific microwave pulses used to drive the superconducting qubits without crosstalks. The MCC can greatly reduce the number of microwave control lines and is beneficial to the development of large-scale superconducting quantum processor.
Large-scale quantum computers with more than
105 qubits will likely be built within the next decade. Trapped ions, semiconductor devices, and superconducting qubits among other physical implementations are still confined in the realm of medium-scale quantum integration (
∼100 qubits); however, they show promise toward large-scale quantum integration. Building large-scale quantum processing units will require truly scalable control and measurement classical coprocessors as well as suitable wiring methods. In this blue paper, we introduce a fully vertical interconnect that will make it possible to address
∼105 superconducting qubits fabricated on a single silicon or sapphire chip: Pin-chip bonding. This method permits signal transmission from DC to
∼10 GHz, both at room temperature and at cryogenic temperatures down to
∼10 mK. At temperatures below
∼1 K, the on-chip wiring contact resistance is close to zero and all signal lines are in the superconducting state. High-density wiring is achieved by means of a fully vertical interconnect that interfaces the qubit array with a network of rectangular coaxial ribbon cables. Pin-chip bonding is fully compatible with classical high-density test board applications as well as with other qubit implementations.
We report the development of flux memory for use with superconducting circuits. This technology stores persistent currents in superconducting loops on-chip to be used to provide flux biasing for superconducting circuits, like qubits. We developed three types of flux memory and draw comparisons among them for circuit design. We demonstrate the utility of flux memory by using an in-situ flux detector and characterize each approach and further demonstrate that once flux is set in a memory cell, benchtop DC control sources can be powered off, leaving the on-chip flux bias in place. We propose that flux memory can be arranged in a two-dimensional configuration to multiplex control signals and reduce how line counts scale (N^2 devices -> 2N control lines), and our experimental results pave the path to the proposed scalability. We demonstrate the use of flux memory to flux bias a transmon qubit and show the tunability of the qubit state to a target frequency which remained stable on-chip for 20 hours.