We present an atom-based approach for determining microwave electric and magnetic fields by using a single rubidium vapor cell in a microwave waveguide. For a 87Rb cascade three-level system employed in our experiment, a weak probe laser driving the lower transition, 5S1/2→5P3/2, is first used to measure the microwave magnetic field based on the atomic Rabi resonance. When a counter-propagating strong coupling laser is subsequently turned on to drive the Rydberg transition, 5P3/2→67D5/2, the same probe laser is then used as a Rydberg electromagnetically induced transparency (EIT) probe to measure the microwave electric field by investigating the resonant microwave dressed Autler-Townes splitting (ATS). By tuning the hyperfine transition frequency of the ground state using an experimentally feasible static magnetic field, we first achieved a measurement of the microwave electric and magnetic field strength at the same microwave frequency of 6.916 GHz. Based on the ideal relationship between the electric and magnetic field components, we obtained the equivalent microwave magnetic fields by fitting the inversion to the measured microwave electric fields, which demonstrated that the results were in agreement with the experimental measurement of the microwave magnetic fields in the same microwave power range. This study provides new experimental evidence for quantum-based microwave measurements of electric and magnetic fields by a single sensor in the same system.
We demonstrate a multi-parameter sensing scheme for free space microwave electric and magnetic fields in single vapor cell based on the atom-based microwave detection techniques. A weak probe laser though a rubidium vapor cell first acts as magnetic probe to measure the microwave magnetic field via atomic Rabi resonance of the ground state hyperfine transition. When another strong coupling laser is subsequently counter-propagated and overlapped with the probe laser in the same atomic vapor cell, the probe laser is then used as electric probe to measure microwave electric field by off-resonant microwave dressed Rydberg Autler-Townes splitting. We achieve measurement of microwave electric and magnetic fields without any complicated tuning methods at the clock frequency of 6.835 GHz. Based on the inherent relationship between microwave electric and magnetic fields, and their good linear response characteristics in respective suitable power ranges, the equivalent microwave magnetic fields are derived from linear fitting of the measured electric fields, which are in agreement with the calibrated experimental results within the same power range. This work provides an effective approach for extending the power dynamic range of atom-based microwave quantum sensors.
Research of hot atomic vapor systems has a long history. Recently, much-improved technologies, such as lasers, microwaves and digital/analog control systems, have led to exciting progress in this reviving field. Due to its cryogenic-free and vacuum-free deployment potential, room-temperature and quantum-enabled sensing devices using gaseous atoms have become a popular research topic, and engineering such devices has received considerable attention. Proof-of-principle experiments have been performed demonstrating new ideas such as quantum-enhanced motion sensors, next-generation magnetometers, Rydberg enabled microwave sensors, etc. This thesis focuses on my work related to electromagnetic-field sensing using Rydberg atoms in vapor cells, where Rydberg atoms are excited and detected by electromagnetically induced transparency (EIT) spectroscopy. I first investigate the detection of strong magnetic fields (
sim 1~T) in the Paschen-Back regime. The diamagnetic (quadratic) response of the Rydberg levels makes the atoms sensitive to small fluctuations in field strength on a large background. By implementing an isotope-mixed cell, we demonstrate that accurate measurement, within a relative uncertainty of
pm0.12%. Many Rydberg-enabled radio frequency and microwave sensing applications require a capability of zeroing or intentional tuning of small DC electric fields inside the vapor cell. For this purpose, I explore an in-situ DC electric-field sensing and tuning method without using any bulk or thin film electrodes. I find that the photoelectric effect on the vapor cell walls (with invisible, atomic Rb aggregate layers covering the surfaces) can generate tuning fields up to 0.8~V/cm, with an inhomogeneity of about 2%. The spatial distribution of these fields can be directly monitored by quadratic Stark shifts of the Rydberg atoms. This work may inspire new approaches for DC-field control in miniaturized, metal-free atomic vapor-cell devices. Like many other quantum measurements on hot gaseous samples, short interaction time and other technical decoherence processes are the major factors which limit the precision and, in certain cases, the accuracy of the metrological results. In order to study these effects in the context of EIT, I performed an EIT experiment using a
Lambda-type quantum system consisting of the hyperfine ground states and the first excited electronic state of the Rb atoms contained in a buffer-gas-free thermal vapor cell without anti-relaxation coating. Technical line-broadening effects due to inhomogeneity of stray magnetic fields, laser frequency jitter, transverse beam intensity distribution, interaction time distribution, and atom-wall/impurity gas collisions are studied. Experimental results and numerical simulations are compared. These results provide crucial information and quantitative insights for vapor cell sensor design. The development of compact and multi-functional spectroscopy vapor cells is widely considered to be a critical engineering step towards manufacturing field-deployable sensors for real life applications. My R&D efforts towards fabrication of glass spectroscopy cells with integrated, highly-conductive silicon components are presented in the last part of my thesis. I explored various technical challenges and successfully developed a proof-of-principle prototype from scratch. The device allows the application of electric fields inside the cell for particle trapping and for tuning Rydberg transitions. Further, the highly-conductive silicon components enable microwave polarization filtering for microwave sensing applications, plasma-physics studies, etc. Preliminary experimental/technical data and simulations are presented. In summary, in my thesis I report on a comprehensive study of several spectroscopic and field sensing applications of Rydberg and ground-state atoms in vapor cells, as well as forays into novel methods to engineer vapor cells with embedded electrodes.