Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

The Japan Society of Applied Physics

Improvement of Operating Stability in Small SSPDs with SFQ Readout Circuits

Kemmei Kajino

Published Feb 6, 2014• 0 citations
OpenAlex

Related papers

Demonstration of SFQ readout operation for realizing SSPD array

Hirotaka Terai, Shigehito Miki, Taro Yamashita +2 more

IEICE Technical Report; IEICE Tech. Rep.•Oct 12, 2010•0 citations

Evaluation of crosstalk in SSPD array integrated with SFQ readout circuit

Taro Yamashita

The Japan Society of Applied Physics•Feb 13, 2013•0 citations

Scalable Readout Circuit for SSPDs using AQFP and RSFQ Logic Families

Naoki Takeuchi, Fumihiro China, Shigehito Miki +4 more

The Japan Society of Applied Physics•Jan 28, 2020•0 citations

Evaluation of timing jitter of SSPD-SFQ system toward high time resolve coincidence circuit

Miki Shigehito, Shigeyuki Miyajima, Masahiro Yabuno +2 more

IEICE Technical Report; IEICE Tech. Rep.•Sep 27, 2017•0 citations

A Compact Voltage Pulse Multiplier for SFQ Circuit Readout

Sasan Razmkhah, Ali Bozbey, Pascal Febvre

•Sep 1, 2019•0 citations

Low-jitter single flux quantum signal readout from superconducting single photon detector

Hirotaka Terai, Taro Yamashita, Shigehito Miki +2 more

We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.

Optics Express•Aug 17, 2012•41 citations
We developed a single-flux-quantum (SFQ) readout technology for superconducting single-photon detectors (SSPDs) to achieve low-jitter signal readout. By optimizing circuit parameters of the SFQ readout circuit, the input current sensitivity was improved below 10 μA, which is smaller than a typical critical current of SSPD. The experiment using a pulse-pattern generator as an input pulse source revealed that the measured jitter of the SFQ readout circuit is well below the system jitter of our measurement setup for the input current level above 15 μA. The measured jitter of the SSPD connected to the SFQ readout circuit was 37 ps full width at half maximum (FWHM) for an SSPD bias current of around 18 μA, which is a significant improvement on 67 ps FWHM jitter observed in conventional readout without an SFQ readout circuit.