Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Qubit Measurement with a Nonlinear Cavity Detector Beyond Linear Response

Catherine Laflamme, Aashish A. Clerk

Published Feb 28, 2012• 0 citations
OpenAlex

Related papers

Weak Qubit Measurement with a Nonlinear Cavity: Beyond Perturbation Theory

C. Laflamme, Aashish A. Clerk

We analyze the use of a driven nonlinear cavity to make a weak continuous measurement of a dispersively coupled qubit. We calculate the backaction dephasing rate and measurement rate beyond leading-order perturbation theory using a phase-space approach which accounts for cavity noise squeezing. Surprisingly, we find that increasing the coupling strength beyond the regime describable by leading-order perturbation theory (i.e., linear response) allows one to come significantly closer to the quantum limit on the measurement efficiency. We interpret this behavior in terms of the non-Gaussian photon number fluctuations of the nonlinear cavity. Our results are relevant to recent experiments using superconducting microwave circuits to study quantum measurement.

arXiv:1206.4757•Physical Review Letters•Sep 19, 2012•24 citations

Large gain quantum-limited qubit state measurement using a two mode nonlinear cavity

Saeed A. Khan, Aashish A. Clerk

Bulletin of the American Physical Society•Mar 19, 2013•0 citations

Weak measurement of qubit oscillations with strong response detectors: Violation of the fundamental bound imposed on linear detectors

HuJun Jiao, Feng Li, Shi-Kuan Wang +1 more

Qubit measurement by mesoscopic charge detectors has received great interest in the community of mesoscopic transport and solid-state quantum computation, and some controversial issues still remain unresolved. In this work, we revisit the continuous weak measurement of a solid-state qubit by single electron transistors (SETs) in nonlinear-response regime. For two SET models typically used in the literature, we find that the signal-to-noise ratio can violate the universal upper bound ``4,'' which is imposed quantum mechanically on linear-response detectors. This different result can be understood by means of the cross correlation of the detector currents by viewing the two junctions of the single SET as two detectors. Possible limitation of the potential-scattering approach to this result is also discussed.

arXiv:0806.2502•Physical Review B•Feb 24, 2009•8 citations

Nonlinearities in the quantum measurement process of superconducting qubits

I. Serban

•Jan 1, 2008•1 citation

Back-action of a driven nonlinear resonator on a superconducting qubit

Maxime Boissonneault, Andrew C. Doherty, Florian R. Ong +4 more

We study the backaction of a driven nonlinear resonator on a multilevel superconducting qubit. Using unitary transformations on the multilevel Jaynes-Cummings Hamiltonian and quantum optics master equation, we derive an analytical model that goes beyond linear response theory. Within the limits of validity of the model, we obtain quantitative agreement with experimental and numerical data, both in the bifurcation and in the parametric amplification regimes of the nonlinear resonator. We show in particular that the measurement-induced dephasing rate of the qubit can be rather small at high drive power. This is in contrast to measurement with a linear resonator where this rate increases with the drive power. Finally, we show that, for typical parameters of circuit quantum electrodynamics, correctly describing measurement-induced dephasing requires a model going beyond linear response theory, such as the one presented here.

arXiv:1111.0203•Physical Review A•Feb 3, 2012•41 citations

Quantum Limited Amplification and Detection with a Non-Linear Cavity Detector

Catherine Laflamme, Aashish A. Clerk

Bulletin of the American Physical Society•Mar 21, 2011•0 citations
We analyze the use of a driven nonlinear cavity to make a weak continuous measurement of a dispersively coupled qubit. We calculate the backaction dephasing rate and measurement rate beyond leading-order perturbation theory using a phase-space approach which accounts for cavity noise squeezing. Surprisingly, we find that increasing the coupling strength beyond the regime describable by leading-order perturbation theory (i.e., linear response) allows one to come significantly closer to the quantum limit on the measurement efficiency. We interpret this behavior in terms of the non-Gaussian photon number fluctuations of the nonlinear cavity. Our results are relevant to recent experiments using superconducting microwave circuits to study quantum measurement.
Qubit measurement by mesoscopic charge detectors has received great interest in the community of mesoscopic transport and solid-state quantum computation, and some controversial issues still remain unresolved. In this work, we revisit the continuous weak measurement of a solid-state qubit by single electron transistors (SETs) in nonlinear-response regime. For two SET models typically used in the literature, we find that the signal-to-noise ratio can violate the universal upper bound ``4,'' which is imposed quantum mechanically on linear-response detectors. This different result can be understood by means of the cross correlation of the detector currents by viewing the two junctions of the single SET as two detectors. Possible limitation of the potential-scattering approach to this result is also discussed.
We study the backaction of a driven nonlinear resonator on a multilevel superconducting qubit. Using unitary transformations on the multilevel Jaynes-Cummings Hamiltonian and quantum optics master equation, we derive an analytical model that goes beyond linear response theory. Within the limits of validity of the model, we obtain quantitative agreement with experimental and numerical data, both in the bifurcation and in the parametric amplification regimes of the nonlinear resonator. We show in particular that the measurement-induced dephasing rate of the qubit can be rather small at high drive power. This is in contrast to measurement with a linear resonator where this rate increases with the drive power. Finally, we show that, for typical parameters of circuit quantum electrodynamics, correctly describing measurement-induced dephasing requires a model going beyond linear response theory, such as the one presented here.