Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1206.4757 · Physical Review Letters

Weak Qubit Measurement with a Nonlinear Cavity: Beyond Perturbation Theory

C. Laflamme, Aashish A. Clerk

Published Sep 19, 2012• 24 citations
arXivHTMLPDF

Abstract

We analyze the use of a driven nonlinear cavity to make a weak continuous measurement of a dispersively coupled qubit. We calculate the backaction dephasing rate and measurement rate beyond leading-order perturbation theory using a phase-space approach which accounts for cavity noise squeezing. Surprisingly, we find that increasing the coupling strength beyond the regime describable by leading-order perturbation theory (i.e., linear response) allows one to come significantly closer to the quantum limit on the measurement efficiency. We interpret this behavior in terms of the non-Gaussian photon number fluctuations of the nonlinear cavity. Our results are relevant to recent experiments using superconducting microwave circuits to study quantum measurement.

DOI
10.1103/physrevlett.109.123602

Related papers

Back-action of a driven nonlinear resonator on a superconducting qubit

Maxime Boissonneault, Andrew C. Doherty, Florian R. Ong +4 more

We study the backaction of a driven nonlinear resonator on a multilevel superconducting qubit. Using unitary transformations on the multilevel Jaynes-Cummings Hamiltonian and quantum optics master equation, we derive an analytical model that goes beyond linear response theory. Within the limits of validity of the model, we obtain quantitative agreement with experimental and numerical data, both in the bifurcation and in the parametric amplification regimes of the nonlinear resonator. We show in particular that the measurement-induced dephasing rate of the qubit can be rather small at high drive power. This is in contrast to measurement with a linear resonator where this rate increases with the drive power. Finally, we show that, for typical parameters of circuit quantum electrodynamics, correctly describing measurement-induced dephasing requires a model going beyond linear response theory, such as the one presented here.

arXiv:1111.0203•Physical Review A•Feb 3, 2012•41 citations

Quantum-limited amplification with a nonlinear cavity detector

C. Laflamme, Aashish A. Clerk

We consider the quantum measurement properties of a driven cavity with a Kerr-type nonlinearity that is used to amplify a dispersively coupled input signal. Focusing on an operating regime that is near a bifurcation point, we derive simple asymptotic expressions describing the cavity's noise and response. We show that the cavity's backaction and imprecision noise allow for quantum-limited linear amplification and position detection only if one is able to utilize the sizable correlations between these quantities. This is possible when one amplifies a nonresonant signal but is not possible in quantum nondemolition qubit detection. We also consider the possibility of using the nonlinear cavity's backaction for cooling a mechanical mode.

arXiv:1011.5938•Physical Review A•Mar 7, 2011•48 citations

Large gain quantum-limited qubit measurement using a two-mode nonlinear cavity

S Khan, R Vijay, I Siddiqi +1 more

We provide a thorough theoretical analysis of qubit state measurement in a setup where a driven, parametrically-coupled cavity system is directly coupled to the qubit, with one of the cavities having a weak Kerr nonlinearity. Such a system could be readily realized using circuit QED architectures. We demonstrate that this setup is capable in the standard linear-response regime of both producing a highly amplified output signal while at the same time achieving near quantum-limited performance: the measurement backaction on the qubit is near the minimal amount required by the uncertainty principle. This setup thus represents a promising route for performing efficient large-gain qubit measurement that is completely on-chip, and that does not rely on the use of circulators or complex non-reciprocal amplifiers.

arXiv:1408.0226•New Journal of Physics•Nov 14, 2014•1 citation

Crossover from weak- to strong-coupling regime in dispersive circuit QED

I. Serban, E. Solano, Frank K. Wilhelm

We study the decoherence of a superconducting qubit due to the dispersive coupling to a damped harmonic oscillator. We go beyond the weak qubit-oscillator coupling, which we associate with a phase Purcell effect, and enter into a strong coupling regime, with qualitatively different behavior of the dephasing rate. We identify and give a physicaly intuitive discussion of both decoherence mechanisms. Our results can be applied, with small adaptations, to a large variety of other physical systems, e.g. trapped ions and cavity QED, boosting theoretical and experimental decoherence studies.

•Jan 1, 2007•7 citations

Crossover from weak- to strong-coupling regime in dispersive circuit QED

I. Serban, E. Solano, Frank K. Wilhelm

We study the decoherence of a superconducting qubit due to the dispersive coupling to a damped harmonic oscillator. We go beyond the weak qubit-oscillator coupling, which we associate with a phase Purcell effect , and enter into a strong coupling regime, with qualitatively different behavior of the dephasing rate. We identify and give a physicaly intuitive discussion of both decoherence mechanisms. Our results can be applied, with small adaptations, to a large variety of other physical systems, e.g. trapped ions and cavity QED, boosting theoretical and experimental decoherence studies.

arXiv:cond-mat/0606734•Europhysics Letters (EPL)•Oct 25, 2007•10 citations

Dispersive regime of circuit QED: Photon-dependent qubit dephasing and relaxation rates

Maxime Boissonneault, Jay Gambetta, Alexandre Blais

Superconducting electrical circuits can be used to study the physics of cavity quantum electrodynamics (QED) in new regimes, therefore realizing circuit QED. For quantum-information processing and quantum optics, an interesting regime of circuit QED is the dispersive regime, where the detuning between the qubit transition frequency and the resonator frequency is much larger than the interaction strength. In this paper, we investigate how nonlinear corrections to the dispersive regime affect the measurement process. We find that in the presence of pure qubit dephasing, photon population of the resonator used for the measurement of the qubit act as an effective heat bath, inducing incoherent relaxation and excitation of the qubit. Measurement thus induces both dephasing and mixing of the qubit, something that can reduce the quantum nondemolition aspect of the readout. Using quantum trajectory theory, we show that this heat bath can induce quantum jumps in the qubit state. Nonlinear effects can also reduce the achievable signal-to-noise ratio of a homodyne measurement of the voltage.

arXiv:0810.1336•Physical Review A•Jan 23, 2009•301 citations
We analyze the use of a driven nonlinear cavity to make a weak continuous measurement of a dispersively coupled qubit. We calculate the backaction dephasing rate and measurement rate beyond leading-order perturbation theory using a phase-space approach which accounts for cavity noise squeezing. Surprisingly, we find that increasing the coupling strength beyond the regime describable by leading-order perturbation theory (i.e., linear response) allows one to come significantly closer to the quantum limit on the measurement efficiency. We interpret this behavior in terms of the non-Gaussian photon number fluctuations of the nonlinear cavity. Our results are relevant to recent experiments using superconducting microwave circuits to study quantum measurement.
We study the backaction of a driven nonlinear resonator on a multilevel superconducting qubit. Using unitary transformations on the multilevel Jaynes-Cummings Hamiltonian and quantum optics master equation, we derive an analytical model that goes beyond linear response theory. Within the limits of validity of the model, we obtain quantitative agreement with experimental and numerical data, both in the bifurcation and in the parametric amplification regimes of the nonlinear resonator. We show in particular that the measurement-induced dephasing rate of the qubit can be rather small at high drive power. This is in contrast to measurement with a linear resonator where this rate increases with the drive power. Finally, we show that, for typical parameters of circuit quantum electrodynamics, correctly describing measurement-induced dephasing requires a model going beyond linear response theory, such as the one presented here.
We consider the quantum measurement properties of a driven cavity with a Kerr-type nonlinearity that is used to amplify a dispersively coupled input signal. Focusing on an operating regime that is near a bifurcation point, we derive simple asymptotic expressions describing the cavity's noise and response. We show that the cavity's backaction and imprecision noise allow for quantum-limited linear amplification and position detection only if one is able to utilize the sizable correlations between these quantities. This is possible when one amplifies a nonresonant signal but is not possible in quantum nondemolition qubit detection. We also consider the possibility of using the nonlinear cavity's backaction for cooling a mechanical mode.
We provide a thorough theoretical analysis of qubit state measurement in a setup where a driven, parametrically-coupled cavity system is directly coupled to the qubit, with one of the cavities having a weak Kerr nonlinearity. Such a system could be readily realized using circuit QED architectures. We demonstrate that this setup is capable in the standard linear-response regime of both producing a highly amplified output signal while at the same time achieving near quantum-limited performance: the measurement backaction on the qubit is near the minimal amount required by the uncertainty principle. This setup thus represents a promising route for performing efficient large-gain qubit measurement that is completely on-chip, and that does not rely on the use of circulators or complex non-reciprocal amplifiers.
We study the decoherence of a superconducting qubit due to the dispersive coupling to a damped harmonic oscillator. We go beyond the weak qubit-oscillator coupling, which we associate with a phase Purcell effect, and enter into a strong coupling regime, with qualitatively different behavior of the dephasing rate. We identify and give a physicaly intuitive discussion of both decoherence mechanisms. Our results can be applied, with small adaptations, to a large variety of other physical systems, e.g. trapped ions and cavity QED, boosting theoretical and experimental decoherence studies.
We study the decoherence of a superconducting qubit due to the dispersive coupling to a damped harmonic oscillator. We go beyond the weak qubit-oscillator coupling, which we associate with a phase Purcell effect , and enter into a strong coupling regime, with qualitatively different behavior of the dephasing rate. We identify and give a physicaly intuitive discussion of both decoherence mechanisms. Our results can be applied, with small adaptations, to a large variety of other physical systems, e.g. trapped ions and cavity QED, boosting theoretical and experimental decoherence studies.
Superconducting electrical circuits can be used to study the physics of cavity quantum electrodynamics (QED) in new regimes, therefore realizing circuit QED. For quantum-information processing and quantum optics, an interesting regime of circuit QED is the dispersive regime, where the detuning between the qubit transition frequency and the resonator frequency is much larger than the interaction strength. In this paper, we investigate how nonlinear corrections to the dispersive regime affect the measurement process. We find that in the presence of pure qubit dephasing, photon population of the resonator used for the measurement of the qubit act as an effective heat bath, inducing incoherent relaxation and excitation of the qubit. Measurement thus induces both dephasing and mixing of the qubit, something that can reduce the quantum nondemolition aspect of the readout. Using quantum trajectory theory, we show that this heat bath can induce quantum jumps in the qubit state. Nonlinear effects can also reduce the achievable signal-to-noise ratio of a homodyne measurement of the voltage.