IEEE Transactions on Applied Superconductivity

Superconducting Nanowire Single Photon Detector for Coherent Detection of Weak Signals

Yury Lobanov, Michael Shcherbatenko, Alexander V. Semenov, Vadim V. Kovalyuk, Oliver Kahl, Simone Ferrari, Alexander A. Korneev, Roman V. Ozhegov, N. Kaurova, Boris M. Voronov, Wolfram H. P. Pernice, Gregory N Gol'tsman

Published Dec 26, 2016• 6 citations

Publisher

Abstract

Traditional photon detectors are operated in the direct detection mode, counting incident photons with a known quantum efficiency. Here, we have investigated a superconducting nanowire single photon detector (SNSPD) operated as a photon counting mixer at telecommunication wavelength around 1.5 μm. This regime of operation combines excellent sensitivity of a photon counting detector with excellent spectral resolution given by the heterodyne technique. Advantageously, we have found that low local oscillator (LO) power of the order of hundreds of femtowatts to a few picowatts is sufficient for clear observation of the incident test signal with the sensitivity approaching the quantum limit. With further optimization, the required LO power could be significantly reduced, which is promising for many practical applications, such as the development of receiver matrices or recording ultralow signals at a level of less-than-one-photon per second. In addition to a traditional NbN-based SNSPD operated with normal incidence coupling, we also use detectors with a travelling wave geometry, where a NbN nanowire is placed on the top of a Si3N4nanophotonic waveguide. This approach is fully scalable and a large number of devices could be integrated on a single chip.

DOI: 10.1109/tasc.2016.2645132

Related papers

Coherent detection of weak signals with superconducting nanowire single photon detector at the telecommunication wavelength

Michael Shcherbatenko, Y. Lobanov, Alexander V. Semenov +6 more

Achievement of the ultimate sensitivity along with a high spectral resolution is one of the frequently addressed problems, as the complication of the applied and fundamental scientific tasks being explored is growing up gradually. In our work, we have investigated performance of a superconducting nanowire photon-counting detector operating in the coherent mode for detection of weak signals at the telecommunication wavelength. Quantum-noise limited sensitivity of the detector was ensured by the nature of the photon-counting detection and restricted by the quantum efficiency of the detector only. Spectral resolution given by the heterodyne technique and was defined by the linewidth and stability of the Local Oscillator (LO). Response bandwidth was found to coincide with the detector’s pulse width, which, in turn, could be controlled by the nanowire length. In addition, the system noise bandwidth was shown to be governed by the electronics/lab equipment, and the detector noise bandwidth is predicted to depend on its jitter. As have been demonstrated, a very small amount of the LO power (of the order of a few picowatts down to hundreds of femtowatts) was required for sufficient detection of the test signal, and eventual optimization could lead to further reduction of the LO power required, which would perfectly suit for the foreseen development of receiver matrices and the need for detection of ultra-low signals at a level of less-than-one-photon per second.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIEMay 15, 20170 citations

Waveguide integrated superconducting single-photon detector for on-chip quantum and spectral photonic application

Vadim V. Kovalyuk, Simone Ferrari, Oliver Kahl +6 more

With use of the travelling-wave geometry approach, integrated superconductor-nanophotonic devices based on silicon nitride nanophotonic waveguide with a superconducting NbN-nanowire suited on top of the waveguide were fabricated. NbN-nanowire was operated as a single-photon counting detector with up to 92 % on-chip detection efficiency in the coherent mode, serving as a highly sensitive IR heterodyne mixer with spectral resolution ( f/df ) greater than 10 6 in C-band at 1550 nm wavelength.

Journal of Physics Conference SeriesNov 1, 2017218 citations

Superconducting Nanowire Single Photon Detector With Efficiency Over 60% for 2-μm-Wavelength

Hui Zhou, Yiming Pan, Lixing You +6 more

We demonstrate superconducting nanowire single photon detector (SNSPD) for the wavelength at around 2 μm. The linewidth of the NbN nanowire is squeezed to 56 nm to increase the intrinsic response efficiencies at longer wavelengths such as 2 μm. Serially connecting avalanche architecture is applied to increase the signal-to-noise ratio (SNR) of the response signal. Further, the optical cavity is optimized to improve the absorption of the device. A silica single-mode fiber is adopted to introduce photons to the SNSPD at a temperature of 2.25 K using a Gifford-McMahon cryocooler. The SNSPD exhibits detection efficiencies of 58%, 67%, and 63% at wavelengths of 1550, 1700, and 2000 nm, respectively, with dark count rate of ~12 kcps, which is reduced to 2 cps when the attached fiber pigtail is all placed inside the 40-K cryostat. The detection efficiency at 2000 nm is 2.5 times greater than that of the best previously developed detector with an efficiency of 25%. Our SNSPD is promising for practical applications in molecular science and earth meteorology.

IEEE photonics journalNov 29, 201911 citations

Broadband waveguide-integrated superconducting single-photon detectors with high system detection efficiency

Martin A. Wolff, Fabian Beutel, Jonas Schütte +4 more

Fast and efficient detection of single photons with high timing accuracy is a crucial requirement in most quantum optics experiments and enables novel sensing and imaging solutions. Superconducting nanowire single-photon detectors (SNSPD) achieve technology-leading performance in terms of detection efficiency, dark count rate, timing jitter, and detector dead times. However, conventional SNSPDs with high system detection efficiency typically rely on resonant enhancement of the absorption efficiency, thus only achieving attractive detector benchmarks over narrow spectral windows. Waveguide-integrated SNSPDs allow for leveraging the wideband material absorption in superconducting nanowires by absorbing light in a traveling-wave geometry but have been limited to low system detection efficiencies due to interface losses when coupling to optical fibers. Here, we show how high system detection efficiencies of 22%–73% are realized over a broad wavelength range from 532 nm to 1640 nm in a single waveguide-integrated SNSPD device. We accomplish efficient coupling between optical fibers and waveguide-integrated nanowire detectors by employing a 3D interface, produced in direct laser writing, that relies on total internal reflection for achieving a broad transmission bandwidth. We further find low timing jitter of 25.7 ps and detector decay times of 9.8 ns, allowing for single-photon counting with high repetition rates up to 100 MHz. Our work paves the way for an efficient single-photon detector solution that combines the spectral requirements of an extremely wide range of quantum optics experiments in a single device. The coupling approach and SNSPD-integration with nanophotonic circuits are further well-suited for realizing large-scale detector arrays.

Applied Physics LettersApr 12, 202143 citations

Superconducting single photon detectors for quantum information processing

Robert A. Kirkwood

Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.

Jan 1, 20171 citation

Next generation superconducting nanowire single-photon detectors

Kleanthis Erotokritou

Single photon detection advanced rapidly in the last decade. The superconducting nanowire single-photon detector (SNSPD) is an emerging technology, which offers low dark count rates, broadband sensitivity from visible to mid-infrared wavelengths and very high quantum efficiency. All these features are appealing for future emerging applications in remote gas sensing, quantum key distribution and quantum information processing. By enclosing the detector in an optical cavity, tuned to the operating wavelength, the total system detection of the SNSPD is improved. Based on the cavity design, the detector absorption is boosted at the desired experimental wavelength. Devices have been fabricated and tested, in this thesis, with enhanced detection efficiency at near-infrared, infrared and mid-infrared wavelengths. NbTiN detectors fabricated on Ta2O5 / SiO2 distributed Bragg reflectors (DBR) for front-side coupling exhibit a system detection efficiency of ≈ 90% at λ = 940 nm for the best device measured. SNSPDs were also fabricated in NbTiN on metallic mirrors for back-side coupling for 1550 and 2333 nm experimental wavelengths. The first design exhibited a system detection efficiency of ≈ 84.5%, at λ = 1550 nm for the best device measured. The second exhibited low system detection efficiency since the device suffered from unexpectedly high dark count rate mainly due to blackbody radiation at 2.2 K. However, it was possible to measure the timing jitter of this device at 350 mK indicating a FWHM of 84 ps. Another technique to improve the total system detection efficiency of the SNSPD, is by fabricating a hairpin-shaped nanowire atop a single mode waveguide. In this design, photons travel through the waveguide and via evanescent coupling are absorbed in the nanowire. These SNSPD devices have been designed to thread along single mode Si ridge waveguides using a hairpin-shaped nanowire structure, which offers enhanced coupling and absorption efficiency via evanescent coupling. These ultra-thin superconducting MoSi detectors are precisely patterned on top of a single mode Si waveguide (600 nm) with alignment error less than 40 nm. Low temperature electrical and nano-optical characterization was carried out using a two-stage pulse tube (PT) coldhead, using an additional 4He / 3He sorption pump, low vibration characterization of SNSPD devices at 350 mK was carried out. Characterised devices exhibit low dark count rate <5 counts per second and timing jitter of ≈ 83 ps full width half maximum (FWHM) at wavelength (λ) = 1550 nm and at critical current ≈ 30 µA.

Jan 1, 20190 citations